Having problems with your Fisher and Paykel DS603SS Stainless Steel Built-in Dishwasher ?

The door won't open or close without excessive force.

\015 As per the trouble-shooting guide, I determined that the drawer lock is in the off position. It feels like the drawer is binding at the top.\015

Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel DS603SS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The door won't open or close without excessive force.


... Fisher and Paykel DS603SS Stainless Steel Built-in Dishwasher

The door won't open or close without excessive force.


Feeling like going to the bump when closing the drawer because the sagging rubber seal from the top lid pressing again the top groove of your inner tube when closed.Theis syntoms needs to be addressed since it is very near for a coming problem: ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

I have a kenmore ultra wash dishwasher mdl nbr 665.1304 that wont close. the lock appears to be stuck but the door is open and i cant get it to close. any help would be appreciated. i am a single m


... Kenmore Dishwashers

Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help


... Dishwashers

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

Spring on dishwasher door causes it to open without resistance. Door offers resistance when we close it, but not when it's opened.


Sound as if the catch has broken. They are often quite fragile. Fortunately they can be purchased quite cheaply on the internet. ... Dishwashers

I have a Electrolux dishwasher EID6305. Everytime I close the door it wants to start a cycle even though j haven't pressed anything. Pushing start/cancel button doesn't cancel it. What's the best way to open the door an close it without starting a cycle?


... Dishwashers

We have a KitchenAid KUDS24SEBL1 dishwasher. The latch is stuck somehow and we cannot open the door. Is there a way to force the door open without breaking it?


... KitchenAid Dishwashers

The door is stuck closed on my Vulcan Dishlex 500 ECO Dishwasher. i have tried to lever it open with a spatula applying downward pressure on the internal latch w and simultaneously lifting the door upward...no joy... it simply wont open.


Hi just read your posting.What you need to do is to get a pointy small knife and put it between the door and frame and move it till you stop at the internal latch.Now lever the latch up and pull the door open.The part you need to change is the t shap ... Dishwashers

Ge dishwasher model num.GSD2400G01.soap dispenser not opening during cycle.took it apart to replace broken handle.now i have a hard time opening and closing door.when door is closed,it wont let the soap out.dont know if gear-like parts are lineing up or not.please how can i fix this problem.


Hi\015\012If the soap dispenser door doesn't closes on your GE dishwasher then disconnet the dishwasher from power and check the spring & plastic tab under the timer. Check the plastic tab, it breaks often and will not let the soap door t ... Dishwashers

Door wont close - I have taken off hinges and they look ok. Is it possible that the hinge opening on the inner door has been stretched when I overextended the door with heavy turkey pot


It is very likely the control lock has been set on the oven. This means the door latch is unable to enagage with the oven lock. If you have turned off the power at the circuit breaker and there is no change, then you may try the Cancel button on the ... KitchenAid 24 in. Built-In Superba Series Dishwasher w/ ProScrub Built-in Dishwasher

Thermador dishwasher lights go on when door is open but go off when door is clossed the motor hums when door is closed but the unit will not operate there is water in the bottom but it wont drain


... Thermador DWHD43 Dishwasher

AEG Favorit 80820 dishwasher tablet door opens as soon as switched on and door closed. When you put the power on and select a wash and then close the door the small grey dishwasher tablet inside the door can be heard to open as soon as the door is closed. Normally this door remains closed until asked to opened automatically by the dishwasher at the correct point in the selected wash program.


... AEG 24 in. Favorit 80820 Free-standing Dishwasher

Hotpoint ultima fdd914 door wont close. wont seem to catch just keeps popping open


... Hotpoint-Ariston FDD914 24 in. Built-in Dishwasher

I have a fridgidaire dishwasher model # FDB 1450chc2 andon the control panel the red lights are flashing and washer wont start ?? when I open the door the lights go out but when I close the door and push start the washing lights start to blink but doesnt start to work ?? Need help thanks [email protected] Brian


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.


If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers

I have an electronic operating Kitcheaid Dishwasher. It has a tendency to stop in the middle of a cycle without warning. This can happen at different times of the day and at different stages of washing. We open the door, make sure the racks are pushed in tight and close and hold the door tight for a few moments. The dishwaser comes back on, but this can repeat in the course of one wash.


I would try adjusting the strike which is a little metal piece coming off of the tub that goes into the door when you close it. the strike may not me latching properly ... Dishwashers

Door wont close. I checked to be sure nothing is in the way. I have tried running thru the cyles to see if i could un hinge the spring but with no luck. the open button is locked iin the open position.


The door latch is broken and can be replaced. Look up the part on searspartsdirect.com and search that part number on ebay for better prices if available.Eric ... Kenmore 16522 Built-in Dishwasher

Cranky dishwasher I have to admit my wife's solution is the only one that works. Our ten-year-old Superba built-in usually starts a normal cycle part-way through, at the wash part, without filling or opening the dispenser door. Therefore the dishes come out with the soil now baked on. Closing the door, selecting normal and start results in a pump-out sound, or at least just the pump running to wash the dishes. The dishwasher ignores any cancel button push,and the light does not come on over t


You want to make sure that the dishwasher is level and secure first of all. Then I would look into the door latch assy. Sounds to me that you are not making all the latch switches when closing normally. When you are slamming it, you are making the s ... KitchenAid KUDS24SE Built-in Dishwasher

Moffat dishwasher The door has come repositioned on the left side and it will not shut properly and when the door is all the wway open, the bottom rack will not pull out smoothly without lifting it up slightly. Haven't tried it since the problem arose as I was afraid that it would leek. also I didn't want to force it back into position for fear that I ould break it. I bought it Aug., 2006. It is a Moffat Model #MHDD210LOOWW.


... Dishwashers

My Maytag Quiet Series 300 seems to be locked with the door open ... cannot close the door ... How do I get the lock to release ? ... I don't want to force it in case it breaks.


With a tiny flat head screw driver push the latch inward ... Dishwashers

How to reset the locking mechanism on the kitchenaide dishwasher? My grandson stuck a screwdriver in the opening on the door and the latch appears to have closed and now wont allow the door to shut.


You need to take the door apart to do so ... KitchenAid 24 in. KUDG25SH Built-in Dishwasher

Hi, I'm working on a KUDI02FRSS0 for my neighbor. She complained the door flew open one day during a wash and the door had been very heavy since. A quick check on the internet, and I thought it would be simple... I installed an 8194001 balance kit. Both cords had broken. However, the door was very hard to close, and once you did close it, it would tend to pop open by itself shortly thereafter. When the door popped open, thanks to the new balance kit, it would not fly open as it had p


Is it possible that the door hinges or springs are installed backwards or upside down? Just a guess. Good Luck to you. ... Dishwashers

Got a Frigidaire model FDB750RCS0. Now it was running for a couple of min then I hear a clicking sound. Thought it might be something hitting the propeller. I opened the door and nothing. Closed it and now it wont even work. Thought the breaker got tripped but not even that. Now when I had it set back to the cancel part, the Clean Light comes on very dim where as before it use to be bright. Any solutions?


... Frigidaire 24 in. FDB750RC Slim-Line Built-In Dishwasher

My GE 24 in Profile PDW8280JSS door wont open: Now the "clean" light is on. I tried cutting power for over an hour, I have run wash cycles, the lock handle will not move. The unit did not have much in it, when I last closed it, so I don't think it is jammed. Any ideas?


Hello & Welcome to FixYaFlashing clean light is reset by pressing two buttons in sequence 3-4 times, to reset your dishwasher press these buttons in sequence: ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1176 seconds