Having problems with your Fisher DD603FCSS Dishwasher ?

How do you get the bottom drawer out for repair?


Answers :

Pull out the draw all the way. Down both sides there are two plastic square buttons. push those in and at the same time push the rails back towards the dishwasher. it should come off the rails.
\015\012
\015\012undo the pipes and pull the drawer away.
Repair Help & Product Troubleshooting for Fisher DD603FCSS Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kitchenaid kuddo1dppa I own a KitchenAid KUDD01DPPA, 2 drawer dishwasher. I am not a technician, however I have had a lot of experience in repairing various appliances and am savvy with electronics and mechanical technical issues. Here's the problem: I was getting rinse error codes in both drawers, pulled the bottom drawer out, removed the cover to the circuit board and used a dryer to dry up the moisture on the flood switch. Now I am getting Fill Failure error code on both drawers. I have g


Test this steps and fix it. God bless you\012 \012 Water Inlet Valve\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

I am having problems with the bottom drawer not draining in my Fisher Paykel dishwasher. How do I drain the water? the last time a repair man came for this same problem, he was able to punch the keys in a certain order to get it to drain.


You can do 2 things: If this problem persists it means that the "flap" that prevents the water from draining into the drawer needs to be replaced, unfortunately this is a common problem with this model if you are a frequent user. In the meantime wha ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

How do you get the bottom drawer out for repair?


Pull out the draw all the way. Down both sides there are two plastic square buttons. push those in and at the same time push the rails back towards the dishwasher. it should come off the rails.\015\012\015\012undo the pipes and pull the d ... Fisher DD603FCSS Dishwasher

I have the two drawer dishwasher. It's about 10 years old. The top drawer continues to work OK but for the last three attempts when I run the bottom drawer water gets out into the drip pan below and gives the F1 signal. I can dry the drip pan out and clear the F1 signal so the top drawer works. But running the bottom drawer causes water to leak again with the resultant F1 signal. There is very little water in the bottom drawer (just a little in the filter bowl) so I think the pump is pumping


Hi,Unless you keep using the wrong detergent or keep putting dishes that \015\012are to tall in there. i would have to say your actuators ar bad and its \015\012not letting the lid go down to seal it all the time.There is no adjustment. Y ... Fisher and Paykel Dishwashers

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

Hi, I have a Fisher Paykel DD603I (integrated) dishdrawer unit. The bottom drawer soap dispenser has water in it after it runs (and leftover soap), and there is a small amount of water sitting in the bottom of the drawer. The dishes don't get totally clean. I have removed and cleaned the spray arm, drain filter, filter plate and bottom of tub. Found nothing clogged or particularly dirty. Put all the parts back in and everything moves freely. Ran it empty, and same problem occurred.


Hi Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doe ... Fisher and Paykel Dishwashers

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Drawers Stuck I've had my dishwasher for a couple of years now. All of the sudden the drawers are extremely difficult to open. I have to use all my strength to pry open the drawers so I can get the dishes out.  It started out as only the bottom drawer having the problem and now both drawers are having it.  It seems to be running fine because the dishes that were in the drawer before it got stuck were cleaned.  And there is nothing blocking the drawer from opening.  It seems like the seal that c


I turned off the electrical breaker for about 8 seconds and it rebooted itself ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Fisher and Paykel Dishwasher, bottom drawer gets water in it. This drawer is seldom used and when used the water empties completely. However, it always has water standing in it. I run the rinse cycle and it gets all the water out but after time the water is back. It is enough to cover the large removable metal cover.


... Fisher and Paykel Dishwashers

We have the Model DD605 ss dishdrawer. We have been getting an F2 message with beeping on the upper drawer. The bottom drawer still seems to be working. We have checked the top and bottom impellers and they appear to spin freely. What else could be the problem. Thanks, Brian


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Bottom drawer cant get drawer out to get screws out from side walls


Look on the bottom side below the front. You will find two clips that can be pushed in to remove the drawer. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The top drawer started getting very loud - maybe the water pump? Now it looks as if no water is getting into the drawer so dishes remain dirty. The bottom works fine, and is not loud when running.


Yes it is likely the pump rotor is seized. I am assuming the water goes in to the drawer but does not get moved around by the washer arm. This i ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Fisher & Paykel 2 drawer dishwasher: I too cannot get power to top drawer. 4 days ago we had an F1 code. My husband pulled out drawer, wiped up water, and dried it out. Put it back in overnight, and both drawers worked fine. Now the bottom drawer is okay, but no power to top. Help!


He might have unplugged something in the proccess of drying the bottom ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The upper and lower dish drawers leaves a puddle of water under each (maybe 6" in diameter) after the shortest cycle. There is a small amout of water left in the clear protective housing on the underside of the upper drawer. There is a hole at the bottom of the housing that lets the water out. Maybe there is a slightly loose hose? If so how do you get the housing off and tighten it? I presume the lower drawer may be doing the same thing, but I can't see it with out removing the drawer. How do yo


The drawers slide on a pair of rails on each side of the housing.\015\012\015\012see installation manual pag ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

I have a dishdrawer (2) and following the use of a dishwasher cleaner, the bottom drawer appears to have developed a blockage. It will not empty, gets to the pump out part of the cycle and shows the red error code F3, to which there is no reference in the trouble shooting guide. The top drawer has also developed minute leak, sufficient enough to leave dribble marks on the lower drawer and over time, a white deposit on the floor. Is there anything we can do for the blockage problem before reso


Remove the small basket from each drawer and lift up the removable plastic cover and take the drain filters out , empty them of food by products and try it again.. If you've never cleaned them then that's your problem with the drain process.. Hope th ... Fisher and Paykel Dishwashers

On our double drawer dishwasher, we are getting a code--which illustrates no water--this is for the top drawer, the bottom drawer, works fine--and the water supply is on--please help.


Sorry to read about your problem, I hope this helps you out.you must have a defective water inlet valve, for the 2nd drawer. or a bad control relay for the valve.I tried to help you. Please help me and Rate/Vote on my response ... Fisher Dishwashers

I have a Fisher and Paykel dishdrawer model ds603. Not sure eactly what happened but my son says that the cycle stopped last evening (and only tells me this morning!). Dishes though appeared to be clean and there was a small amount of water at the bottom. I tried opeing the washer and it was hard to open as though the drawer was stuck on something. I removed the drawer and checked the rollers and they are fine. I realised then that the drawer is getting stuck on the inside lid that provides the


The best thing to do is to remove the rack,drawer completly,and close it up,see if it will come on,and run all threw the cycle.If it does,then put the rack,drawer on the track.The rollers could be,well,not snapped all the way on.It will be in that ar ... Fisher Dishwashers

Hi My F&P dishdrawer flooded. Dried it all out etc, the top drawer doesn't complete the cycle and it beeps continually even when it's not running. I am wondering if I can reset the drawer using the front buttons to get it back to factory default. Bottom drawer works fine. There is no error code on the screen only the lock icon which won't go away. Any ideas?


Not sure if you tried turning the power off at the main switch. Lock icon can gone away if you press the necessary keys as shown in the user guide. Also the sequence of keys to press for getting factory defaults of different options is also in the us ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Top drawer runs for a while, the timer stops after two minutes and then I get a U2 code. Bottom drawer working fine.


Hi there,Usually a U2 code means there is a problem with closing the draw fully, and hence the dishwasher thinks the door isnt closed and will not start up. This could be because A) there is something impeding the draw from closing (check ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Hi. The water from the top drawer of my fisher and paykel DD605 dishwasher will not drain away The bottom drawer is workimg perfectly. Please can you advise on repair? Thanks.


Hi \015\012Dishwasher not draining issue usually occurs due\015\012to kinked drain pipe, clogged drain filter or drain pump. First make sure that\015\012the drain going towards the bottom is not clogged and re ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Hi, I have a Fisher and Paykel DD603 dishwasher. The bottom drawer works fine but the top drawer doesnt work at all. It appears normal until the start button is pushed and then I get 3 very quick beeps followed but a 4th slightly longer beep. Then nothing happens, any ideas or help would be much appreciated. Thanks Neville.


... Fisher and Paykel 24 in. DD603MFC Built-In Dishwasher

Bottom drawer works fine but the top drawer does not. It keeps alarming when we try to us it. We keep getting U1 alarm


U1 alarm is related to an issue with filling water into the dishwasher. If there is water already in the dishwasher you will need to empty it manually with a small container. Check if the sprayer arm is moving freely. You should turn off the mains su ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

This is the 2nd time I've had problems with my dish drawer. After I cleaned the filter and replaced it, I had standing water on the bottom of the drawer. The last time this happened, I had someone come to repair it - ended up it was me. I didn't put it together properly. This time I did the same thing I was told to do. I still have the standing water. What should I do. By the way, the coils are not kinked in the back either. Can you please give me some advice? Please respond to me at F


Unfortunately I have to respond to you through this post per policy of fixya.com. This s to ensure we have a visibility on the quality of the solution and also allow other consultants to help if necessary.\015\012\015\012Water standing a ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Rusted drawers Please advise where we can get replacement drawers as the bottom tray where plates are stacked has rusted with the plastic coating peeling off.


Go to any used appliance shop and see if they have any for sale or if they can order one for you ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

My fisher dd6031 bottom drawer doesn't seem to get rid of all the water,,and it keeps beeping and will keep beeping through the night if you don't catch it...we have been putting it through another rinse cycle to get rid of the water....can you help? Thanks, Maria


You will have to take the filter plate out the motor rotor out. Then clean the rotor cavity and replace in reverse order.\015\012\015\012Are you getting any error codes?\015\012Does the beeping stop if you turn the power off and on? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0746 seconds