Having problems with your Frigidaire 24 in. FDB1050RE Built-in Dishwasher ?

Causes interference with radio, tv

\015 My frigidare dishwasher model fdb 1050re causes interference with my under counter radio. I am in the process of trying to get it replaced because it is still under warranty. However, my old Maytag did not cause this problem. Any solutions? Thank you Jim\015

Answers :

You could possibly add a metal shield around the electronics in the dishwasher and ground the shield with a wire to the dishwasher chasis. Don't know if this would reduce the EMR enough to stop the interference with the radio, but there's a chance it would.
Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Causes interference with radio, tv


You could possibly add a metal shield around the electronics in the dishwasher and ground the shield with a wire to the dishwasher chasis. Don't know if this would reduce the EMR enough to stop the interference with the radio, but there's a chance i ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

I have a kitchenaid model KUDS01JBT dishwasher. The Chopper Assembly keeps pluging up causing the dishwasher not to wash properly. Can I remove the chopper Assembly and run the dishwasher without causing any further problems to the dishwasher or will it cause other problems with the pump etcetera? Thank you for your assistance. Sincerely, Pat


\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

I have an 2002 Eclipse with a locked out radio. The dealer told me to turn the key to on w/o starting the engine, turn everything on and in an hour or so the radio would rest. After 2 hours and a dead battery the radio is still locked. I tried disconnecting the battery for a few minutes and that did not work either. Do you have any ideas?


Call the Mitsubishi 1800 manufacturer # and give them your VIN so they can give you the unlock code for the radio. ... Dishwashers

WE HAVE A 3 YEAR OLD BOSCH DISHWASHER WHICH NOW HAS PRESENTED US WITH A PROBLEM. DURING A WASH CYCLE IT APPEARED TO MAKE SLIGHT NOISE WHEN WE DECIDED TO INTRRUPT THE CYCLE BY OPENING THE DOOR AND CHECK THE CAUSE OF THE PROBLEM. WE NOTICED THE WATER IN THE APPLIANCE HAD NOT DRAINED. WE PROCEEDED TO CHECK THE FILTER WHICH SEEM TO BE FREE OF ANY REMANANTS OF FOOD AND ANY OBJECTS. THEN WE FOLLOWED WITH THE CHECK ON THE PUMP FOR SAME AND FOUND NOTHING THAT WOULD CAUSE A BLOCKAGE. WE DECIDED TO R


... Bosch Dishwashers

There is a flap hanging from behind the door of my dishwasher that is causing my unit to leak. Is having this flap normal and could it be causing the leak?


... GE Profile PDW8400J Built-in Dishwasher

MOISTURE AND HEAT ESCAPE FROM DOOR SIDES CAUSING PROBLEMS WITH ADJOINING CABINET DOORS. WHAT IS CAUSING THE CONDENSATION / MOISYURE LEAK?


Unfortunately, dishwasher generate a lot of heat and water vapor. Some manufactures are now including a pressure sensitive mylar / aluminum strip to be attached above the door under the counter to prevent water vapor and or heat damage to wood or com ... Frigidaire Dishwashers

Diswasher TYP NBKH, SERVICE 8546 892 10010 Problem: For all programs except rinse and charge 1/2 for all programs. Pre-rinse and rinse for 50 Bio, 60 and 70 OK. Downloading water to wash causes multiple knocking (on the left side dishwashers) and simultaneous blinking light (relais?). Opening doors and adding water (different amounts - from 0.5 to 2 l) brings the normal work of dishwasher back. Rinse with cold water after washing OK. Final cleaning with hot water causes knocking again. After r


... Dishwashers

We have an ariston LS 620A dishwasher. For the last year every few months the dishwasher seems to cause a short in our electrical box causing all the power to go out in our house. It is only when the dishwasher is on that this occurs. We turn the power back on and everything, tv computer etc starts then turn the dishwasher on and everything shorts out again. We have had an electrician in who said that there was no electrical problem and that it was the dishwasher. After 2 months or so the dishw


The problem seems to be water seepage into the electrical contact.If the heater has lost its insulation this problem could accur( element to body )Disconnect the heater and give a try without any load and soap. If itperf ... Ariston Technologies Dishwashers

Turn water on then actuate wand trigger. Pressure washer leaks when wand trigger is actuated and has very low pressure/flow output. After releasing trigger the pressure cycles on - off at approx 1 second interval. I suspect that the plasstic oulet tube is leaking causing low pressure leak out of bottom when trigger is actuated and causes pressure switch to cycle when the trigger is released. Any Help? This pressure washer is approx 18 months old!


You gave a very close solution yourself for the problem. But other leakages can cause such symtoms.Forexample a leaking head or a leaking chemical inlet. These can be caused because the spill valve (pressure control valve) is stuck. When this valve s ... Karcher PSI Electric Pressure Washer

I would like to know how old this dishwasher is? Mod HDA2000Z05WH and serial is SV826876Y. Would the wheels coming off bottom rack cause the motor to burn up causing washer to not work. There is a hard cap over something in the left corner on the bottom . Imwould like to know what is under that cap?


... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

My zanussi zdf131 has not caused any problems during the last year or so since i purcheased it, but now all the dishes etc come out with a "bloom" of white over everything. I've checked all filters etc, run several cleaning programmes but I've now noticed that the salt level does not seem to be going down. I check it every week & refil but this time the salt has been in the reservoir for several weeks & doesn't seem to have changed - could this cause the problem & if so why is the salt level not


... Zanussi Dishwashers

My dishwasher has no power . I had work done on the floor which caused vibrations. My water connection was leaking which I fixed but I found out that It has not power. Not sure if the vibration caused some wires to disconnect. What should I check before I pay $130 for a repair man to diagnose the problem.


Call the technician. Have him state on the bill that whoever did your floor caused the electrical malfunction ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Hi my Candy dishwasher model CDI 1012/2 is filling with water then after a few minutes if bleeps and the error code meaning according to the manual is "Longer inlet time. possible cause Faucets is not open" The tap is fully open and the dishwasher is now full of dirty water. Could you please suggest an alternative cause?


... Candy Dishwashers

MY SUPERBRA D/W JUST BLEW THE FUSEABLE LINK AFTER BEING REPLACED OVER SIX WEEKS AGO..REPLACED THE LINK AND D/W WORKED FINE..NOW HAS BLOWN AGAIN WITH NO VISIBALE ISSUES THAT WOULD CAUSE IT..ANYONE HAVE AN IDEA WHAT WOULD CAUSE THIS?


Plenty of ideas !!! 1st, if the voltage to the unit is too low or the size of the electric line is too long or too thin, then the electric will raise the current to try to compensate for the lack of voltage, and the fuse only knows or senses when th ... Dishwashers

MATSUI DISHWASHER MS160SL. IT STICKS HALFWAY THROUGH THE WASH PROGRAMME. IT IS NOT GETTING HOT. DONT KNOW IF ONE PROBLEM IS CAUSING THE OTHER IE IF THE ELEMENT NOT HEATING IS CAUSING THE PROGRAMME NOT TO MOVE ON.


I have the same problem and have found that it is caused by as you suspected a burned out heater element. they can be purchased on the web for £15.95 at partmaster .co.uk ... Dishwashers

Ntldr missing hello i'm VEJESTER NEFTHALY i'm from PHILIPPINES my problem is my computer had a problem cause of virus ms-dos... HOW CAN I RECOVER "NTLDR" missing in my running program.... ???? thanks... but i have already a solution for this but i wan't have more information about this one...... and also for the virus UST scandal.avi.exe... and xmss.exe I WAN'T ANTIVIRUS... cause when i kill this kind of virus i'm just using manual configuration processes in dos... thanks.. for information....


Ssue : NTLDR missing\015\012 \015\012Solution :\015\012 \015\0121) Insert your windows XP CD into your CD/DVD drive. \015 ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

Samsung dishwasher not drying dishes--possible ventilation fan not running long enough.Possible cause or causes?


If the dry cycle has a problem, check these:---\015\012 \015\012\015\012Heating element\015\012\015\012\015\012\015\012Your dishwasher has an ... Dishwashers

Pressure is probably low cause the upper shelf is not cleaning or getting wet. Possible causes? Is it less expensive to just buy new? It is not older then 6 years?


Check the harness to the motorCheck start capacitor on the left side of the wash motor ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Kenmore Elite Dishwasher, Model 665.15979992 No Heat Dry Button/Light: The dishwasher will not work. Have tried to no avail the various alternatives listed in this thread and others. Here's what the dishwasher is doing: To start off, the red light on the "No Heat/Dry" button is on - sometimes it's on steady; other times it blinks depending on whether other buttons have been pushed. Pushing any other button also causes the "Lock On" red light to come on. Pushing the "Cancel" button causes all


Have you checked the thermal cutoff switch located inside the door by doing a continuity test to it if this is sounding like where your problem are is coming from on this diagram ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

A GE triton dishwasher causes hammer noise when stops filling. The sink faucet works fine as do all the other faucets in the house. I cleaned all of the traps in the dishwasher. Because the sink works, I don't think it is a sink valve problem. I turned off the water to the house and drained the system, the air chambers should be good. Is there some component of the dishwasher that could be causing the noise? Would cleaning the pump help? If so, how would I do that?


The cause of the hammering noise, (slamming) is due to the water inlet valve on the Dishwasher (DW) shutting off abrutly once the DW reaches the proper amount of water.\015\012\015\012If this is an older DW, you might want to replace the ... GE Dishwashers

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

We lost electricity very briefly today which caused the dishwasher, washing, drying, clean buttons to blink when the electricity came back on. I opened the door to do a load of dishes hours after the electricity came back on and the basin was filled with water which caused water to spill out of the dishwasher. The basin was empty last night when we used it. It seemed to fill up when it was not running.


It seems unit fill valve is stuck open and water is coming in even when machine is off.fill valve opens up only when u start the unit.2 chks this u can open the door and look at the hole inside from where water comes in.if water is coming in with do ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Ran dishwasher first time, water must have been coming into it cause dishes got mostly clean. There was a melting smell, did not look into it cause dad said it was normal. Was told it had too many d


That looks to be a float switch cover. It goes over that tube on the left front of the wash basin. It along with the switch(in kick-panel below) controls water level in the washer. with out it the basin may overfill and leak past door seal, which is ... Dishwashers

Dishwasher FGHD2471KBO What could cause this whinning noise. We have replaced the draining mechanism and has not cured the problem, Could you please tell us what other moving parts could cause this problem


... Frigidaire Dishwashers

Would a vent problem cause the water to back up in the tub and cause the toliet to bubble?


A vent would cause an odor problem but not a back up problem. There should be a clean out between the house and septic tank, if it is full the blockage is down the line, if its dry the blockage is in the house. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0349 seconds