Having problems with your Frigidaire 24 in. FDB1050RE Built-in Dishwasher ?

Dishwasher FDB1050REMO - built in, no power and no lights. Tried the breaker and nothing, is there a reset function on this model? Any ideas?


Answers :

No reset on unit but items to check is have a voltage meter remove the lowest kick plate open the wire connection box it may just be a bad wire nut. Do you have voltage if so then the problem is the thermal fuse located on the pcb controller between the outter door panel and the inner door panel
Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher FDB1050REMO - built in, no power and no lights. Tried the breaker and nothing, is there a reset function on this model? Any ideas?


No reset on unit but items to check is have a voltage meter remove the lowest kick plate open the wire connection box it may just be a bad wire nut. Do you have voltage if so then the problem is the thermal fuse located on the pcb controller between ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Own a Frigidaire Dishwasher Model Number FDB4315LFSO and now after about 2 years suddenly the display will not light and function anything. Without pulling the power panel off the whole line circuit seems to have power as they have my disposal unit tied into same electric line and that runs and so does everything else and no breaker is tripped. Is their a reset somewhere to check or any ideas what can casue the display panel not to function any commands at all. Nick


... Dishwashers

Whirlpool dishwasher model #DU1100XTPSB wont work and the clean button flashes 7 times and pauses, any idea? I shut the power off to it at the breaker to see if it would reset, didnt work


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

My electrolux dish washer model eidw6105gso stopped before it completed the cycle. All the selection lights were flashing and i could not get any functions to change. I killed the power at the breaker to try to reset and that didn't work either. I removed the panel on the front on the bottom to see if there was a reset button and found another display that is showing a light on the turbidity location. what is this and what might i do to get my washer back working?


... Electrolux Dishwashers

I have a Kenmore Ultra wash dishwasher model # 665.13692K600. It was working fine one day then all of a sudden I have nothing. No lights no nothing. I have tried shutting the breaker off and it didn't work. It is only two years old, if you have any idea that would be great. Thanks!!


You probably blew your thermal fuse that is attache to the main circut board, you can buy the thermal fuse seperatly. it is located in the console. ... Dishwashers

KitchenAid 24 in. KUDI02CRBS stainless Steel Built-in Dishwasher: Just stopped working before Christmas. I had washed a load a day before, and the next day I couldn't use the Rinse Cycle. The lights turn on for Normal and Heavy, but nothing happens when I press Start. I played with the breakers a couple times, to try to "reset" the machine, but it didn't do any good. I really don't want to be spending a lot of money on that dishwasher, especially after reading all the horror stories abo


... KitchenAid 24 in. KUDI02CRBS stainless Steel Built-in Dishwasher

Model PLD4555RFC2 dishwasher stopped running. Reset the breaker but nothing happens. No power on touchpad. Does the control board or the console panel need to be replaced?


To check this you would take off the lower kick panel and go down the bottom of the machine where the power wire plugs into your machine and first assure that power is going to the machine. if you do have power going to the machine yet the touchpad h ... Frigidaire PLD4555RFC Dishwasher

Kitchen aid dishwasher model#KUDSO1FLSSO CLEAN LIGHT BLINKS7 TIMES- I DID THE RESET SANIRINSE-ENERGY SAVER-DRY ETC... CLOSED DOOR NOTHING. WE DID HAVE TO REPLACE THE ELECTRONIC CONTROL ASSEMBLY (PART# 8564542 ) BY THE " CONZ"AREA IT WAS BURNED AT THE TOP BY THE "T" AREA. NOT SURE IF THAT HELPS MY HUSBAND IS OUT WITH FRIENDS TONIGHT HE GAVE UP WE HAVE UNPLUNGED THE UNIT AND MY HUSBAND SAID HE EVEN DID OUR BREAKER- HE CAN FIX ANYTHING BUT THIS IS REALLY STARTING TO p... HIM OFF AND WANTS


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Dishwasher does not seem to have power. I have a Kitchen Aid, under counter unit, 9 years old, model KUDS01I. I used it 2 nights ago with no problem. When I push a button, nothing happens, no lights show, etc. It is plugged into the lower half of a duplex socket with disposal plugged into the top. Disposal works, so the problem seems to be with the dishwasher. That also eliminates any issues related to breakers or ground fault indicators, etc. Is there a reset button on the dishwasher? Is there


... KitchenAid Dishwashers

I have a KitchenAid drawer dishwasher model kudd01dppa and it has a mind of its own starting and stopping in the middle of the night/day and chiming all different beeps and sounds like its computer is glitching out. We had a service person out and they changed the main computer board and it seemed to fix it for a few days then started again. They gave up. They also tried some sort of reset or reboot but nothing has fixed this intermitten but long term problem. Any ideas?


"it seemed to fix it for a few days then started again" (sic) OK, well if this is so, then in my experience you are getting some, sort of Power Bourne Spike, Surge, or Transient, problem. If there is nothing else it can possibly be. Use a Pow ... Dishwashers

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

We had a power failure so the unit was flashing a PF error message. I turned the circuit breaker on and off and the thing just stopped- no more flashing lights...no there there. Is there a reset function and where would that be? Or is it truly dead? I have also been looking for two days for a replacement. As an expert, do you have information on reliability on newer models? The best rated I've researched even through CR are both loved and hated by consumers. Traditionally, repairmen ha


Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing. Now th ... Frigidaire Dishwashers

Whirlpool model 927 built in with electrical push button panel won't start. I have tryed unplugging for 30mins to reset which didn't work. When the panel buttons are held in for about 5 secs the red light flashes. I don't know how to check for panel or motor failure. Any ideas?


... Dishwashers

I have a Kenmore undercounter dishwasher..model 665.16022400. The "normal wash" light keeps blinking..nothing will work on it..I tried reseting didn't work, killed the breaker for a while, didn't work. I tool the panel off and reseated the ribbon connection to the electronic board..didn't work. I'm not sure if I should be replacing the electronic board, or the control panel that contains the buttons. None of the buttons appear to be stuck. thanks - Andrew


Hi,This is a common problem. As i cannot diagnose the machine myself, it would be tough to exactly comment on the fault. However, more often it is an issue with control panel keypad assembly.You need to replace that.Let me kno ... Kenmore 16024 Built-in Dishwasher

My dishwasher will not start. It is a frigidaire / electrolux FDB1050REQ. I have checked thepower....and reset the circuit breaker.......then pushed the start button.....the light comes on on the front of the washer like normal but no water starts filling. I have jiggled the anti water overfill device but still nothing. HELP!!! The front of the dishwasher says Frigidaire, however, the inside of the door where the model# is says Electrolux


... Frigidaire Dishwashers

I have a kenmore 665.13719k601, i used the delay switch and now i found water in the bottom of the machine. the cycle most have stopped while i was away. when i returned there was water sitting in the bottom of the machine. The water is clean... I can not drain due to no access to power on the machine. I checked the breaker but it was on, so i reset it anyway... nothing.. any idea's


... Kenmore 13719 / 13712 Built-in Dishwasher

Smeg diswasher model numbe4r DF612SDX. Just coming up for two years old, various codes re error messages. E2, E5, E8. We have taken off the front panel where the buttons are - nothing obvious. We have taken the bottom off and tried to locate a reset button, but can't find one. We have cleared all the filters inside and checked the water intake and the filter there. Out of ideas, can anybody else suggest what we can try?


Any signs or sounds on the machine you here when the problem occur? ... Dishwashers

My dishwasher just stopped working in the middle of the wash cycle. It seems to have no power to it. I have checked all the circuit breakers and reset them all and still nothing. Any ideas?


Your hard wiring maybe bad, or a wire nut came off call electritian or someone who knows electricity ... Whirlpool 24 in. GU980SCG Built-in Dishwasher

Ge dishwasher model gld5560l00ss --when you hit start nothing happens - if you hit start again , light on any selected switch begins to blink. have tried rebooting control that was suggested in owners manual by tripping breaker and then resetting after 30 seconds, ( this did not change anything). machine makes no noise but lights do come on.


... GE Dishwashers

Model DU948 Whirlpool dishwasher stuck, won't start, has power and water. Tried pressing cancel but another button and that one blink constantly and nothing happens. we've reset the circuit breaker.


... Whirlpool DU1055XTSQ Built-in Dishwasher

Kenmore Elite Drawer Dishwasher model 465.13329600 Normal Wash and High Temp Wash buttons stay lit, as does green Lock button. The Start/Resume button and the red button on the front of the drawer keep flashing. I've tried key combos suggested above, but nothing seems to work. Even tried shutting it off at the circuit breaker to reset it, and that didn't work either. This ****** was purchased in 2006 or 2007, and hasn't been used very much. WTF?


... Kenmore Dishwashers

For the GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher, I reset the breaker on the service panel, the unit is on but I press a wash cycle and press start and nothing happens. Is there a fuse inside the control panel of the dishwasher?


... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

Admiral Model W10140278. Will not start any washing process. I can hear a relay click but nothing happens. Breaker is on and there is 120VAC at the dedicated plug. Any ideas?


... Admiral Dishwashers

I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?


... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1591 seconds