Having problems with your Frigidaire 24 in. FDB1050RE Built-in Dishwasher ?

Panel lights are on, but nothing is happening. No water entering the machine and no spinning etc.


Answers :

I can fix this\012
\012What is the last thing you did before this problem started?\012
\012Bruce
Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Panel lights are on, but nothing is happening. No water entering the machine and no spinning etc.


I can fix this\012\012What is the last thing you did before this problem started?\012\012Bruce ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Dishwasher model en50242 after cleaning both filters and turning on the valve etc no water is going into machine. The control panel shows 2 lights one above the tap sign the other above the programe light. The pump runs for a few seconds then stops and nothing further happens. We are in a high water calcium area.


... Siemens Dishwashers

Siemens auto 3 in 1 dishwasher stopped working. lights are on. Machine is humming for a while, but no water enters the machine. Water tap is turned on, filters are clean, no bends in the hose. timer is counting down as during normal washing cycle, but nothing happens


... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

Zanussi zdt6053 in built dishwasher not starting. When pressing the control panel on/off button the 65 deg normal wash light comes on. When pressing the program selection button nothing happens. When closing the door the machine does not start up. Is there a fault in the control panel circuit board? Would water pressure prevent the machine from operating?


... Zanussi 23 in. ZDi6053SX Built-in Dishwasher

Our dishwasher beeps twice when the start button is pressed but then doesn't do anything and there is no other noise from anywhere (eg, motor/pump). There are no error codes displayed and the display appears normal (ie lights up and shows time for program completion etc). When the problem first occurred the machine was full of dirty water. We have turned the dishwasher off and on at the wall, checked/cleaned all filters, drained the dirty water and still nothing happens (it doesn't even fill


... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

My Kenmore Elite suddenly stopped filling with water. I pushed start but when I checked it hours later the soap dispenser door had opened, the soap is just lying in a puddle, and nothing is clean but the clean light on the front panel is blinking. I tried again to no avail. Any ideas? I've had the machine since it first came on the market and have had other issues with it--it never drains completely, it makes sounds like someone revving a sports car engine when the drain pump is engaged, my dish


Https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a4 ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Bosch dishwasher causes short circuit trip when door closes. Plug and socket checked and ok, water outlet checked and no blockages. Panel lights come on ok when machine switched on, able to select washcycle etc ....trip happens immediately door closed.


... Bosch SHU5315UC Dishwasher

I have a Bosch SHU43C. I have a leak it seems to come out from the door. I removed the front panel. Inspected the seal and all seemed smooth and not damaged in any way. So I decided to run the machine. Waited for a few minutes and the water leaked from both corners at the same time. The water settled in the rubber trough under the door. After a few more minutes the water leaked over the trough and onto the foor. Is there to much water entering the machine? What limits the water entering


... Bosch 24 in. SHU43 Built-in Dishwasher

My Frigidaire 4000 Dishwasher panel board is lighting up with almost all lights on/flashing. When the door is closed the pump engages and ther is no water in the machine. If we put water in it drains successfully. The following is flashing on the control panel: washing, drying ER, clean and s. Up top lighted up is china crystal and rinse only. What is going on?


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi


It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

Whirlpool dishwasher DU945PWPQ2 four year old machine - never used. Water lines are attached properly and are clear. When dishwasher is turned on the wash cycle light turns on. cycle completes but water does not enter the machine.Water does not enter the machine.


... Dishwashers

Defy dishmaid dishwasher does not start wash cycle. Several attempts to reset dishwasher has been done. Machine has been unplugged for several days and switched on again and still does not work. The start/stop switch have been kept in for about 5 - 10 seconds to reset. When the machine is set to do washing, the water enters the machine and wash light shows green and machine remains like that with water inside the machine. The start/stop button is again pressed for 5 -10 seconds to drain the wate


... Dishwashers

I have a Siemens Aqua Vario. The machine stopped in the middle of a program and there's water left in the bottom of the machine. The light's still on as if the machine was running, but nothing happens. I have tried to restart the machine, but nothing seems to happend. What can be the problem and what can I do?


... Dishwashers

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

Fisher & Paykel DW60. Fault: Will not start regardless of program selected. E.g. if "heavy duty" pressed, only light will flash, if "normal" is pressed, only this light will flash etc. All hoses (water and drain) have been checked and no crimps or blockages found at either end. All usual methods tried (e.g. cleaning strainers and filters, turning power off for a while etc). Finally, while lights are working, the machine makes no noise at all when a pogram is selected.


... Dishwashers

Smeg DF612S All starts well but after 40 minutes stops with a beep and will not progress to the main wash cycle. Instead all programme lights come on (located on the left), along with the first 2 phase lights (the first two of the lights on the right hand panel). This indicates error code 3 (cannot pump out water), but water is entering and draining perfectly. Please advise.


Check to make sure there r no kinks’ in the drain line or\015\012that it is not clogged it sounds like the sensor is tripping because there is\015\012too much strain on the pump just like a breaker. ... Smeg 24 in. DWI612 Built-in Dishwasher

GLDB958AQ0 Lights on panel light up then go off after a few seconds upon startup. Sometimes they stay on and the timer in the display window counts down the minutes, but in either case no sounds come from the dishwasher nor does any water enter the unit. The water is turned on and there are no kinks in the supply line. I removed the water valve and could not blow through it. Upon applying current to the valve I could blow through it but it still seemed restricted. Should I be able to blow thr


... Frigidaire 24 in. GLDB958A Energy Star® Built-in Dishwasher

I have a Gallery 900 series GLDB958AS dishwasher. The cycle status lights (just right of the "time remaining" status window) continually blink. None of the buttons on the front panel work and every 10 minutes or so the water pump starts up for about a minute then shuts off. No water enters the dishwasher. I tried turning the power off then on but there is no change. Every so often a random cycle light will blink or light up for a minute, then turns off.


It seems that there is error on the program controller unit. All you need to check if that if there is moisture build up on the panels thus causing the programs to go harewire.\015\012So remove the panel and disconnect the wires, check all lead ... Frigidaire 24 in. GLDB958A Energy Star® Built-in Dishwasher

My GSD3600 GE Dishwasher will not finish/start a cycle. The washer filled with water and during the cycle I heard a pop like someone knocked something over in the kitchen. I smelled an electrical burning smell. All the lights and the buttons work on the front panel, but when I try to start I hear an electrical buzz like it is trying to start, but nothing happens and after 3 seconds the electrical buzzing stops and the lights on the panel flash. I removed the dishwasher and found that when I hit


Hello Greg,\015\012\015\012Your diagnosis is pretty good, but the buzzing suggests it may be the capacitor for the pump motor that has failed rather than the pump motor itself. The capacitor phase-shifts the AC current for starting the mo ... GE 24 in. GSD3960LSS Stainless Steel Built-in Dishwasher

Dishwasher will not finish/start a cycle. The washer filled with water and during the cycle I heard a pop like someone knocked something over in the kitchen. I smelled an electrical burning smell. All the lights and the buttons work on the front panel, but when I try to start I hear an electrical buzz like it is trying to start, but nothing happens and after 3 seconds the electrical buzzing stops and the lights on the panel flash. I removed the dishwasher and found that when I hit the start butt


... GE 24 in. GSD3960LSS Stainless Steel Built-in Dishwasher

Indicator lights say there is no water entering the machine. The pipe sounds and feels like there is water flowing but it is not getting into the machine itself


If water is flowing, then you should see water enter the DW. You should also feel the water line becoming warm or hot, depending on if metal (copper), insulated metal (copper), or plastic.If the water valve is partially restricted due to accumu ... Fagor LFA-073 IT Dishwasher

Hi there,i have a brand new but 3 year old,diplomat 8332,just fitted it,it does the pre was ok,pumps out the water,goes to next stage,you can hear water entering the machine,shortly after it has started the main wash,it starts to cut out intermittantly,then F2 code appears,and a bleep.i have taken the lower panel off and checked for leaks and to see if the valve was free,all ok,also relay click in front panel,safety cut out ? any ideas please.


... Dishwashers

Bosch Exxcel Diswasher SGS43E08GB/43. Top spray bar won't spin. All arms, spray holes, ducts, filters, etc are clean and free from obstructions. Water comes out of the holes on the top bar but it won't spin. Water pressure inside the machine with all the bars and ducts removed seems good. Bottom bar works fine. Any ideas please?


Try starting the washer, then opening to door and checking the water level in the bottom of the machine, as far as I know, there should be enough water there to disolve the tablet when it sits in the bottom. if not that much, bung in a few cupfulls a ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?


... Miele G892SC SS Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2037 seconds