Having problems with your Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher ?

Dishwasher fills with water then stops, won't do anything else.


Answers :

Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher fills with water then stops, won't do anything else.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My dishwasher started to fill with water, probably close to 2 inches, then it stopped altogether. Now the motor makes a humming noise...it won't do anything else. Help!


That is the model number ... Dishwashers

My ge dishwasher will fill with water but it wont do anything else not wash rinse or drain


Power from the houseIs there power getting to the dishwasher? This can be difficult to test, because dishwashers are usually wired directly to an electrical circuit, rather than plugged into the wall. But at least check for a blown fuse or a tr ... GE 24 in. GSD2000Z Built-in Dishwasher

Miele dishwasher pump wont stop wont fill with water


... Miele Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

Smeg Dwi409c dishwasher is stopping 3 minutes into cycle with no fault lights or anything, I hear it fill with water but then stops, but I do notice the water is not draining which I assume is why it is stopping, correct me if I am wrong. Have removed the filter but still not draining. Any ideas?


... Smeg Repair Pcb / Module Dwi409c

Hi, I have a Siemens SE44 dishwasher with Aquastop, which I bought recently. It was doing great for first 3-4 wash cycles and then it stopped functioning :( Now all it does is let the water in, and then drains it out- it doesnt do anything else. I can hear the water going in and then the machine drains the water,and this repeats. I tired resetting the dishwasher, checked the drain pipe, aquastop etc, and all seem to be in order to me. Any suggestions? Many thanks, stonerockyy


... Dishwashers

I have a Dishlex Global 300 dishwasher that stopped working mid-cycle. I had to sponge out all the water. Now none of the buttons do anything and none of the lights come on. When I turn it on at the power outlet it gives a single beep, but I cant get it to do anything else. I've opened it up and there is no water or dampness anywhere inside. Any ideas?


It is your control board inside your dishwasher. ... Dishwashers

Hotpoint dishwasher FDL570G.R is filling with water but wont wash the dishes,we've checked pipes,cleaned filters etc. but still wont work.It makes noise like its heating but wont do anything after that,it will just drain when we turn it off. It is only 4 months old.


... Dishwashers

After selecting a program, the dishwasher beeps for a while and the 3 buttons on the left flash too. Program wont start, water wont fill and nothing happens. THe lights keep flashing but the beeps stop for about 30 secon ds then start again. Help me Please.


Basically the dishwasher is telling you there is a fault - Not so useful I know! Plug out the machine and leave it for five minutes and see will it reset. If that does not work, you will need to reset it manually. To do this consult the manual. If yo ... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Just installed bosch SHE68E15UC dishwasher today and during first cycle E15 error came up and unit will not go into another cycle or allow me to program anything else - sanitize and rinse aid lights are blinking - water went into the machine and it started filling the bottom and wasnt draining - i then adjusted the filter and the water drained - but e15 error persists - what should i do - is it install issue or machine issue - please help- thank you so much


... Dishwashers

Diswasher stop working, it fills with water but doesnt do anything else. you hear clicking and clunging as you turn the knob is there anything that can be done


Look very closely at the wash motor shaft extension on your dishwasher. You’ll need to disassemble from the spray arm downward to get to it. A plastic shaft extension was installed from the factory. If something too hard got caught in the cutte ... GE Dishwashers

Asko dishwasher Rotu emailed with some helpful info, so here is the additional you requested. The dishwasher continues to fill as long as the water is turned on to the appliance and then it will drain. For some reason this cycle continues. The repairman said it needed a new control board. Is this the case and is there anything else I can do?


You could have a bad fill valve that doesnt close. Try unplugging the unit or turning off the power at the cuircuit breaker. (not the power button) If it still fills when you turn on the water, it just has a bad fill valve. If it does not fill, take ... Asko D1776 Built-in Dishwasher

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

My dishwasher fills with water and then stops. it thinks that it is washing but never actually washes anything. It dumps the detergent out and everything but the spray wands never spin and water never circulates. Does the problem lie with the circulation pump or motor? Thanks in advance.


Take the filter off the top of the spinner assembly. Take the cover off the motor shift down in there . spin the shift by hand and see if it spins freely. If it doesn't you may have broken glass or other hard objects that prevent the motor from spinn ... Dishwashers

I have a bosch S10R1B dishwasher, and when i turn it on it runs and makes a bit of noise for about a minute and then when it should start filling with water it just stops. i've checked the filter and the floater, and there was water in the chamber where the floater goes, which i removed by dipping a rag in and then wringing it out over and over again. didn't change anything.


Hi\015\012\015\012\015\012\015\012When the\015\012Dishwasher is not filling in, you'll need to check for the water inlet valve & the filter screen. When water is filling your dishwasher, a float\015\01 ... Dishwashers

Hi, we have a Blanco dishwasher model number BFDW4. The dishwasher has stopped working, it fills with water then stops. We tried cleaning all the filters and we tipped it on it's side on a 45 degree angle to drain the water out of the Overflow reservoir but the machine continues to stop working after filling with water. Please help. Regards. Jayne


Hi,\015\012\015\012Sounds like you may have something jamming the circulation pump from turning. A dishwasher has steps in the cycle to complete before it moves onto the next step. once the unit fills with water it then circulates the wat ... Fisher DS603W / DS603B / DS603I Dishwasher

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

Maytag dishwasher wont stop filling with water


If unit continues to fill even with power removed then the water valve is faulty. if not a md # will help. ... Maytag Dishwashers

Kenmore dishwasher model 587.1414 -- stopped after filling with water, but dial continues countdown


... Dishwashers

I have an LG dishwasher, model LDS 5811ww. The machine fills with water, then stops filling when the error code IE comes on. I have cleaned the inlet filter and the whole inside of the tub, by taking apart the sump filter. There is good water pressure filling the tank. When I turn off the power and restart any cycle, the pump will empty the tank, then begin filling the tank again...until it is stopped by the error code IE again coming on. The other thing I notice is the water level in the tub.


Sounds like you either have a dirty or faulty water level sensor or water temp sensor. Most likely a dirty or faulty water level sensor ... Dishwashers

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

My kenmore dishwasher will run part way thru the wash cycle, stop and the hi temp and heat dry lights will flash back and forth and not do anything else. When you open the washer it will have water in it that has not pumper out. It seems that the light wash cycle will work after trying the regular or heavy wash. The washer is 1 1/2 years old. model # 587.15259402


First cut power for ten minutes by unplugging power cord or tripping circuit breaker.If that does not work try the following reset.Press in succession:High temp-air dry-high temp-air dry - High temp-air dry-high te ... Dishwashers

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

Grinding The situation: I have had my Whirlpool DU915PWPB1 for 2 1/2 years, it isn't the greatest dishwasher but does the job good enough. Recently, the water will fill, the washing cycle will run but then when that part stops it goes into a whirring that seems like a motor is going but nothing is moving. I have removed the Filter Modual in an attempt to find out what the grinding would be. There doesn't seem to have anything in the way or under the filter. I have ascertained that the grin


Noise probably not from there when reassembled the plate will not be direct contact with screen noise is probably from wash motor itself..suggest checking owners manual for warranty info ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2524 seconds