Having problems with your Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher ?

Frigidaire fdb520rhc0a lights just blink and then says it is washing but nothing is happening


Answers :

Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Frigidaire fdb520rhc0a lights just blink and then says it is washing but nothing is happening


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"


... Kenmore Dishwashers

Dishwasher lights up when Normal Wash is pushed, also heat dry - but when start is pushed all three lights (Normal wash, heat dry and washing) blink then go out and nothing happens. This occurred after a 2 hour delay was attempted last night and no washing ever happened.


What is the make and model so we can better assist you? In the mean time shut power off to the unit briefly, then turn it back on and try a normal cycle. Will be watching for a make and model here. ... Dishwashers

Kenmore Ultra Wash Dishwasher Model 665.15779 LOCK ON light blinking on control panel, unable to use washer. If buttons were locked, LOCK ON light should be lit continually not flashing. If you press and hold NO HEAT DRY button to disengage lock, nothing happens. If you press the CANCEL button it begins to blink in unison with the LOCK ON light. How can I stop the light from blinking to allow button function again?


... Kenmore Dishwashers

Kenmore 665.1601 dishwasher has normal wash light blinking an stops working then after a long while the start light start light starts blinking an if you press it nothing happens


... Kenmore Dishwashers

GE MODEL 5900N10BB. TWO LIGHTS ON FRONT ARE BLINKING-THE HOT START AND NORMAL WASH- DOOR IS OPEN, BLINKING LIGHTS AND PERIODIC SINGLE BEEP. WHEN I CLOSE DOOR, FLASHING CONTINUES, THERE IS A SOUND BUT NO WATER - NOTHING HAPPENING


Hi. I am actually having the exact same problem. Anyones help would be greatly appreciated.\015\012Thank You ... GE GLD5900NWW / GLD5900NBB / GLD5900NCC Dishwasher

Dishwasher won't start. I add dishwashing liquid, close the door, touch normal wash, it blinks CL CL Cl CL CL with the sensing and washing lights lit and when I push START, all lights go out and nothing happens.


... Dishwashers

Plumbed in new dishwasher wash light and pre wash light flashing nothing happening ! manual says longer inlet time possible cause -faucets not opened?


Hello lozjojo,\015\012Based on your problem description, you either have no water pressure at the inlet valve or the inlet valve isn't operating and allowing water in. Prior to installation, did you make sure you removed ALL the packing materia ... Dishwashers

My Whirlpool Quiet Partner 111 dishwasher Model # GU2500XTPS7 control panel won't respond. There are 4 lights on, the normal wash light, heat/dry light, the lock light, and the start/resume light is blinking. I have held the heat/dry button for 5 sec. trying to unlock it and nothing happens.


Disconnect your circuit breaker for 20 minutes and then reset. It should reset your dishwasher. ... Whirlpool Dishwashers

My frigidaire dishwasher (FFBD2405KB) is not working... when I press the wash button, it will blink, but nothing happens. I've tried it on all settings, but nothing works. It's obviously getting power since the lights are working. I've cleaned the drain thoroughly and made sure there were no obstructions. Any ideas?


... Frigidaire Dishwashers

Green clean light keeps blinking. kenmore elite will not turn on. I hit normal wash, heated dry several time till all lights come - nothing happens


... Kenmore Dishwashers

The clean light blinks 7 times an stops then repeats also if you set up to wash nothing happens. What does the brinking light mean?


\015\012Crack open door \015\012\015\012Within 3 seconds push Hi-Temp Scrub, Heat Dry, Hi-Temp Scrub, Heat Dry\015\012\015\012Close and latch door\015\012\015\012P ... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

We've got Beko DE 2542 FW Slimline dishwasher. Everything switches on as it is supposed to but nothing happens. Rinse aid and Salt indicator red light is not on, because we've filled them up. Switched on dishwasher, green light for "On" comes on. Selected programme level, pressed start. Green light comes on for "Wash" Nothing happens - we've left it overnight but nothing happens. What seems to be the problem? Look forward to hearing the solution.


... Beko DE2541FW 18 in. Portable Dishwasher

I have a Kenmore model 587-16192400. When I press start nothing happens. When I press start again the "washing" light begins blinking continuously until I hit cancel. Anything I can fix?


... Kenmore 24 in. 16199 / 16194 / 16192 Built-in Dishwasher

DU1055XTPQ3 built in Dishwasher... panel has power "cancel" button when pushed you can hear the pump running but on wash the light blinks about 3 times and goes out, nothing happens. Is there a sensor or something in the panel that needs replaced? Jim


Hi\015\012\015\012First try resetting the dishwasher by pressing the AIR DRY button and hold it for 15 seconds. After this if it blinks again 3 times then the control needs replacement. Hope this helps...please post back for further assistance. ... Whirlpool Dishwashers

All buttons light up and nothing happens wont start.. Or sometime you hit pan wash cycle and all it does is blink


Hi, \015\012\015\012\015\012This is mainly due to control panel failure. This unit does not vent from the front like most do, so there needs to be some clearance above the top of t ... Frigidaire PLD2855RFC Dishwasher

Kenmore dishwasher Mod 665 13852K601. MANUAL WASH and CANCEL lights are blinking simultaneously. I unplugged washer and plugged back in. Same thing. Nothing happens when any button is pushed. What's going on?


... Kenmore Dishwashers

I press the start button and the washing light just blinks nothing else happens


Sounds like a faulty latch...the dishwasher thinks that the door is open, so it just keeps flashing the lights until it's closed. I'd order and replace the latch ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a whirlpool dishwasher thats a quiet partner 2. the cancel drain light keeps blinking and nothing else is happening. i try to unlock it and then the normal light starts blinking also and still nothing happens. i called a local repair shop and they said i need to change the control board so i did and its still does the same thing. can you give me an idea of where i need to start to fix my problem?


Can you here the pump running or check to make sure there is no water in the base... ... Dishwashers

I have just moved into a new house with an Asko Dishwasher. It is not working. I program it, the icon for the cycle I have chosen lights up in red, I press start, that lights up in red, the water runs in for about 30 seconds and then nothing more happens. This happens on every wash cycle that I attempt to use. It does not appear to be on time delay as that icon does not light up. Also I have left it for a number of hours after I have tried to start it and still nothing happens. I would appreciat


... Asko Dishwashers

Maytag mdb6601aww push normal wash button-- nothing happens. push other wash cycles, the lights flash about 30 times then stop-- then nothing happens. tried clearing codes. hi temp wash then heated dry , hi temp wash then heated dry. same problem. also tried normal wash then heated dry 3 times in 6 seconds--- same thing. also tried unplugging unit waiting 10 minutes with no luck. thanks


... Maytag 24 in. MDB6100A Built-in Dishwasher

My Kenmore ULTRA WASH dishwasher model #1603* does not respond to any command. When I select a desired washing I only get a blinking light on my selection and nothing else. If I select ''Cancel/Drain'' it blinks as well. I receive no response at all if I select ''Start/Resume''. To stop the blinking I must turn off the circuit breaker. When I restore the power, the control board is not lit, however, selecting any of the wash cycles and the blinking starts once again. The manual refers to a blink


Replace timer/program module\015\012Vitally ... Kenmore Dishwashers

I have a Bosch SHE6AP05UC dishwasher. All of a sudden when I turned it on to wash a load the clean light and the quick wash light came on and when you push the wash button nothing happens. When you turn it off and on those 2 lights come on solid and you can't wash. How can I reset or what can I do to troubleshoot this?


... Bosch SHE6AP05UC 24 in Builtin Dishwasher

I have the kitchenaid dishwasher model #kudv03ctss0.the clean light stay blinking and when i hit the start it just blinks and then stops but the clean light stay blinking constantly.if i hit the cancel button i hear a um noise as if it going to turn on but nothing happens and the light stays blinking. what do you think might be the issue .


Dear friend,\015\012ngfam at you service! happy to assist!\015\012It's an electronic problem!The lights are called codes and need to be diagnoed by a factory service person!!We sell appliances for 65 years an ... Dishwashers

We have a Whirlpool GU980 Series Dishwasher. All the lights work. No matter what setting I use, it fills up, and then nothing happens. The "washing" light will be turned on, but nothing happens. I try to drain the machine, it will make a sound like it's going to begin a process, then it just stops. Do these things just "die" after some time? This machine is 7 years old.


Sounds like something is caught in the pump impeller. you will need to take the pump apart inside the tub. ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1070 seconds