Having problems with your Frigidaire 24 in. FDB126RB Built-in Dishwasher ?

I have a frigidaire dishwasher model # fdb1050 which is leaking a small amount of water from the right hand corner of the door. I assume it is caused by the door seal but I cannot tell. Do you have any suggestions


Answers :

Hi,\012Yup.. it's the door seal...\012
\012Here is a tip that I wrote about dishwashers and them leaking.

Leaking Dishwasher

heatman101
Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB126RB Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a frigidaire dishwasher model # fdb1050 which is leaking a small amount of water from the right hand corner of the door. I assume it is caused by the door seal but I cannot tell. Do you have any suggestions


Hi,\012Yup.. it's the door seal...\012\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101 ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

Leaking at bottom of front door with suds and water coming out. Cannot find the model number. Seals on door (3 sides) are fine. Cannot see a seal for under the door.


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012dafhrw ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Our Hotpoint Aquarius Dishwasher BF11, built into the kitchen units is leaking steam from the door ( and starting to cause the wooden floor to bend ). Can I get a door seal for this model ? It's probably 11 years old, being in the house when we bought it. And, is fitting a door seal a simple job for an amateur ??? !! Thanks


... Hotpoint Dishwashers

My Hotpoint diswasher suddenly stopped working last night. It seems like it has no power to it, as the motor or pump does not seem to come on at all. Obviously when I get home from work, I will check the obvious first - making sure it has power to it, connections are secure etc. (I had a wire break before) If it does have power, I would assume checking the door switch and timer is next. Any suggestions, and any suggestions for checking the door switch and timer??


Sounds like your on the right track. I would use an ohmeter to check the resistance of the door switch by placing the meter probes on each side of the switch. Test while opened and closed position. Same with timer ... Hotpoint Dishwashers

Hi...I have a Westinghouse Freestyle 921 Dishwasher...9 years young...Model SB921SG...that has recently been leaking from the bottom right hand side front corner of the door when performing its usual heavy duty cycle...It appears that the main door seal has significantly perished and is causing the problem...Therefore I have purchased a new Door Gasket part no.0208400069 from a recommended spare parts agent in Brisbane and after several attempts to re-fit this gasket/seal to the door...I still h


... Dishwashers

I noticed the black residue on the clean dishes.also anwhen I checked I saw the bottom of the door seal breaking down, melting so as the seal around the center filter. I was washing in high temperature always. This started after 5-6 mo. What causing the seal melt? The dishwasher is designed for 160 F hot water than why is melting? Modell MDB8951 SS


I had exact problem with a similar model.Mine was about 8 months old. I could have ordered a replacement seal but it would have done the same thing after a few months (according to the shop where I buy/order anything that runs on electricity, most an ... Maytag 24 in. MDB8951AWS Stainless Steel Built-in Dishwasher

Hotpoint hda 3420 dishwaher. when turning, on the motor hums and doesn't kick in like usual. manual says caused by non use. "must keep the seal moist" put water in the unit, thinking it might get the seal moist. bottom filled and unit has not worked for days. assuming it's this seal: where is it? how do i get at it? what is replacement difiiculty? how much is the part? thanx ron [email protected] or [email protected]


Hi,Before thinking about replacement... pour a couple of cups of water in the dishwasher and let them soak the seal for overnight...Then if it don't go give the motor a spin...just to make sure it will go...if that don't work ... Dishwashers

I have a dd605 disher. The bottom drawer is leaking to the laower chassie causing a F1 code. The clear seal does have sand in it that I cannot get the sand out without removing the seal. Does anyone know how to remove this seal? Thanks


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

My Maytag MDB 4000 dishwasher is leaking from the door at the lower left front corner. The seal seems to be OK and the water is at the proper level. It runs out of the door when the cycle shifts and on other occasions. Any idea what might be causing it?


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101 ... Maytag 24 in. MDB4000 Built-in Dishwasher

My Magic Chef Dishwasher, Model DU2JV, leaks badly from the lower edge of the door. The gasket, which runs along the top and sides of the machine to seal the door at those points, seems intact. Please advise since I cannot use the machine as it is.


Hi,\015\012I had to replace the gasket on my own dishwasher and many others even though there was no visible reason why it was leaking. But first check the float switch, that also can allow the water level to get too high and cause it to leak. ... Magic Chef Dishwashers

Water leak when the dishwasher is on rinse, it leaks water around the door.. I have replaced the door seal and it still leaks.. any suggestions


Check the gasket seating. It should be uniform.Hope the correct dimension gasket is used! ... Dishwashers

I have a Hotpoint Super Plus dishwasher 7820. It worked well for a long time. Towards the end of the cycle it leaks a lot of water from the underside of the door, so it seems. I have fitted a new door seal. No success. What may be the cause?


The door seal has to be in a proper position completely around the door (including the bottom area of the door). If not, it will leak. Also, there are two black corner baffles/seals (located in each front corner inside the tub area) that may also b ... Hotpoint Dishwashers

I have a Miele dishwasher and the filter assembly appears to be locked in position and cannot be removed. It appears as though the lever to unlatch it is hitting a stop before rotating sufficiently to allow for filter assy removal. Wife noted it may have been a bit difficult to reinstall just prior to this occurance. Any suggestions on root cause and solution?


... Dishwashers

Noisy dishwasher My Indesit IDL530 occasionally makes a loud, high pitch noise during the wash cycle. The noise will stop when gentle pressure is applied to the outside of the diswasher door around the area of the tablet dispenser. Any suggestions to the cause of the noise?


SOME DETERGENT DISPENSERS ARE ACTIVATED BY A SOLENOID THAT IS ELECTRICALLY CHARGED. IT WOULD BE POSSIBLE THAT IS WHERE THE NOISE IS COMING FROM. IF YOU WANTED TO CHECK, REMOVE THE DOOR PANEL AND SEE IF THERE IS A ROUND ITEM AT THE DISPENSER ASSEMBLY ... Dishwashers

EDW5500DSS wont completely drain water Okay so now that my dishwasher runs, when it finishes a cycle it has a nice puddle of water at the bottom that never drains completely out. I am assuming its a relay or something because I looked for a floating switch (did not find), I can hear a pump sound as if it wants to pump the remaining water out, but, it doesn't. I really want to solve this problem soon so I can order the new door seal and needed part together. Checked the line out and of course i


The srainer over the pump could be clogged not letting the water drain quick enough. Be sure the screen is cleane out. I believe you would have already checked and cleaned this. I believe it is the impeller on the pump that pumps the water that is ei ... Dishwashers

There is water under the doors during every cycle but I cannot find why. There is also water under the machine causing the anti flood to activate.


The door gets bent outwards when loading and unloading so it doesn't make a good seal (gradually over time).... open machine and gently lift (pry) up on the inside base of the door. you will probably see that it is bent down a bit (it doesn't take mu ... Dishwashers

Hotpoint DF56 dishwasher seems to be leaking from around hinge area both sides have renewed door seal but has not solved problem. Suggestions.


... Hotpoint 24 in. DF56 Free-standing Dishwasher

Kenmore Model 1590 Dishwasher, 1985, sitting unused since about 1994. Takes water into tub but never goes through any washing/rinsing cycles; water stands in bottom (I stop it below door level). A click, like a solenoid activation from the timer area, but motor never does anything. Removed the shroud covering what I assume is the impeller, which was stuck, but freed it by turning several times...made no difference. Suggestions??


... Kenmore Dishwashers

When the dishwasher is running, it releases some steam to the outside door which causes streaks that I can not rub out...any suggestions?


I would try "Bar Keepers Friend", it works very well ... Kitchen and Much More Dishwashers

Leaking dishwasher My Ariston LSI61 dishwasher is leaking from both right and left hand sides at the bottom. I have replaced the main bottom door seal but it continues to leak. Any suggestions.


... Ariston Technologies L63 Free-Standing Dishwasher

Just purchsed G1173Vi - failed to fit due to exiting pipework on wall being directing in line with the inlet hose which is located directed above the waste hose. Had no problems fitting previous 2 dishwashers, is this common? Pipes are sealed to the machine Can you suggest a solution? obviously I cannot move exiexisting pipework.


Hi there!\015\012\015\012You say - "obviously I cannot move exiexisting pipework."\015\012, but I would consider it necessary if you need to fit this machine.\015\012\015\012The only other option is to fit a diferent m ... Miele Dishwashers

I have ge dishwasher thats 3 years old and I'm having problems with it leaking from the bottom of the door. I replaced the seal once but I can't tell what else the problem could be. Any suggestions?


It could be overfilling. check the overflow float inside. if it is stuck down, the water level will get to high. the seal is not meant to be under water. it just stops splashing water. if it moves freely, it is okay. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1050 seconds