Having problems with your Frigidaire 24 in. FDB836GF Built-in Dishwasher ?

What keeps the door from dropping fast? Is there a retention devise to counter balance the door? What part(s) could break and cause this problem?


Answers :

There is a spring at the bottom of the door on each side.Pull the dishwasher out a few inches and you should see it from the side. Parts 1,2 and 3 are the hinge and spring on this diagram. http://www.appliancepartspros.com/partsearch/model.aspx?model_id=109266&diagram_id=236108#d236108
Repair Help & Product Troubleshooting for Frigidaire 24 in. FDB836GF Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What keeps the door from dropping fast? Is there a retention devise to counter balance the door? What part(s) could break and cause this problem?


There is a spring at the bottom of the door on each side.Pull the dishwasher out a few inches and you should see it from the side. Parts 1,2 and 3 are the hinge and spring on this diagram. ... Frigidaire 24 in. FDB836GF Built-in Dishwasher

My kitchenaid dishwasher keeps blowing the thermal fuse behind the door.. Have replaced it 4 times. Now it will run through one cycle and blow fuse. Any suggestions on what other part could be causing this problem?


... Dishwashers

Dishwasher FGHD2471KBO What could cause this whinning noise. We have replaced the draining mechanism and has not cured the problem, Could you please tell us what other moving parts could cause this problem


... Frigidaire Dishwashers

Hi...I have a Westinghouse Freestyle 921 Dishwasher...9 years young...Model SB921SG...that has recently been leaking from the bottom right hand side front corner of the door when performing its usual heavy duty cycle...It appears that the main door seal has significantly perished and is causing the problem...Therefore I have purchased a new Door Gasket part no.0208400069 from a recommended spare parts agent in Brisbane and after several attempts to re-fit this gasket/seal to the door...I still h


... Dishwashers

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

I have a whirlpool dishwasher type 280-2 and the detergent door will not open automatically anymore. The compartment is thoroughly cleaned and wont even open if its empty so gook or over filling is not the problem. I believe I probably knocked off some part that makes it open at the proper time. If someone could explain how the process works and/or submits a picture of the parts, I could perhaps deduce what is missing. Thank you in advance as this is driving me nuts!


... Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Hi, I have a Miele G681 dish washer with an intake/drain light problem. I've read all posts about similar problems I could find both on this forum and others but I'm afraid I still can't figure my problem out. The intake/drain light starts blinking mid way into the dishwashing process. The dish washer fills up, rinses, drains, water is hot, everything seems to function just fine. Some time after the tablet drops from its door mounted container, and the time estimate reaches 46 minutes r


... Dishwashers

There is soap left at the end of a cycle from the dispenser. It is trailing down the door and standing in a puddle at the bottom of the dishwasher. The soap that is not in the trap door seems to wash away, but not the soap that comes out once the trap door pops for the main wash. Any ideas on how to fix this or what could be causing the problem?


Try different detergent types--liquid instead of powder, capsules instead of liquid. Don't put large dishes near the door that might block spray. Check the spray holes in the spray arms for blocking. ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

I have a Bosch SMU2046UC/14 dishwasher that makes some noise but will not start the wash cycle. I found that the noise was from the timer motor by removing the front of the door. The timer continues to run and but only advances until half way through the wash cycle where it stops permanently. Is this a problem with the timer or could something else be causing this problem.


HI. The timer motor mechanism regulates the length of time power is to be routed to each component. If the timer motor does not advance properly, it can result in a wide range of problems. Common symptoms will usually include sticking in a cycle(fail ... Bosch 24 in. SMU40 Built-in Dishwasher

Kudc10fxss4 I have a KitchenAid KUDC10FXSS4 w/o any power. Circuit breaker is on, and it's getting power. But there are no lights on the display. I called a parts place to see if I could order a thermal cut off fuse. But the representative stated there is no fuse listed for this model. Any ideas on what would be causing a loss of power? Seems odd/wrong to me that there wouldn't be a fuse. If there is a fuse, would it be located in the door (the control is built into the door, such


... KitchenAid Dishwashers

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

Kitchen-aid model#KUDI01ILBL6.Clean lite constantly flashes but I cannot run cycle.I have had problems with the door latch for the last 3 or 4 months.Wondering if that could be part of the problem.The door is shut when we are trying to run cycle but dishwasher won't start.


HELLO THERE AND THANKS FOR USING FIXYAYes this is certainly a problem when the door will not latch properly.See the door needs to latch properly to allow the door latch solinoid to complete the circuitOften times the latch just ... KitchenAid Dishwashers

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers

I have a Philco dishwasher Svelta DWN17 which works well but has lost its spring or counterweight for the door. The door now drops open when not locked for washing. I am having difficulty finding a servicing firm for this machine and would try to fix it myself if I could find a part and get some details on how to go about it. Can you help, please? Alan Wright


... Dishwashers

I have two problems with my GUI1500 dishwasher. The 1st is that when water starts entering the dishwasher I hear a loud hammering/vibrating sound. It's strange, but the sound will stop if I turn on a faucet in the house. The other problem I have is that the soap dispensor will no longer stay closed. The Plastic tab that holds it shut has basically disintegrated. Will this cause the dishes to not come clean? Can this part be replaced? I don't see any visable screws holding it onto the door.


Hi - welcome to FixYa,\015\012\015\012The first problem isn't a fault with the washer, it's a plumbing problem called "water hammer", which is a resonating vibration through your pipes. It's usually caused by a toilet flush valve, but can ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

I have an ASKO D3250 and it has recently started making a loud noise from the pump area. It starts as soon as the cycle begins and doesn't stop even if you open the door. It seems to stop about 90 seconds into the cycle. Noise is best described as a noisy solenoid but could also be some sort of actuator that is stuck. What part is the problem?


All power and sounds should stop when any dishwasher door is opened.Your door switch may be stuck causing it to continue.The 90 second sound at the beginning of the cycle is the water pump extracting any residual water before taking on cl ... Asko 24 in. D3250 Built-in Dishwasher

Our dishes have white film on them. 5 repairmen have said they have no idea to the cause. We have tried everything vinegar, rinse aids etc. Could it be a pressure problem due to a plumbing default in the building of our home? We are not sure whether the top spinner rotates fast enough as well as the top glasses have always had this cloudy, greasy residue.


On an empty cycle fill the machine and use some C.L.R or other lime and scale remover in the machine and let it wash through the cycle.\015\012\015\012try putting more water in the tub once the fill cylcle has completed and the wash cycle ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have model KUDS301VBL2, we have noticed a build up of sludge at the lower front of the dish washer, below the door. We have to keep an eye on it and wipe it off often. could this be caused by a faulty disposal unit in the dish washer. I have double checked the level from front to back and all the drain hose and air gap. I have found no problems.


... KitchenAid Dishwashers

Bosch shx99a15uc - The soap dispenser was not working, I removed the door panel and noticed burnt circuits on the dispenser. I replaced the dispenser and have the same problem. What else could be causing the dispenser not to open?


... Bosch 24 in. SHX99A15UC Stainless Steel Dishwasher

I have an 8 year-old Kenmore 665.16912 dishwasher. Worked fine until two days ago. Then it stopped working altogether: nothing lights up on the front panel. I have checked the 120 in the electrical box, the door switch is working, the thermal fuse is working and there is 120 volts at the white and black connections to the timer control board. I bought a new timer control board for $120 and that did not fix the problem. What else could be causing the unit to completely stop working?


If all are really good then the only thing it con be is the display (8269205) $25.00 part, if it's bad dishwasher wont run ... Kenmore 16912 Built-in Dishwasher

The door now drops hard when opening. In the past the door would drop slowly and was "not heavy" . I found a rubber piece on the floor just below the door. It looks like a rectangular washer . I am assuming the rubber piece helped slow down the drop of the door. Is this a correct assumption? Is this an easily repaired problem? Your help would be greatly appreciated


... Whirlpool GU2700XTSS / GU2700XTSY Built-in Dishwasher

I have a Maytag MDB7600AWB dish washer. I have a door leak, dripping from the right side. I can not see anything that would allow it. It seems like it could be coming from the inside of the door. Also, there is heat and condensation on at the top of the door, above the leak. It could be that steam is coming from the top right and dripping down the door. Could you give me some idea about fixing the problem.


HI,Check for the following troubleshooting steps:Some leaking around-under-from the door on dishwashers can be traced back to a split in the spray arm. If the lower spray arm develops a split in it, the spray arm can turn too ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

The door has always made a horrible noise that I could not get to go away (I shot some WD40 into all available places). I learned to live with the noise. NOW, the spring on the door has obviously broken. I am afraid someone will open the dishwasher and hurt a small child with the falling door! I see where you addressed the broken spring problem. Do you think I could fix the horrible noise at the same time? Do you think this is something my husband could fix?


... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

Hi I have a maytag dishwasher and a maytag fridge my fridge has been nothing but problems it has flooded my house twice in the past 9 years, the part on the inside are braking that hold the shelves in place and my dishwasher is on a recall that i just found out today. IT has a part called vent inlet that is cracked and the part is no longer available,so is part can i use it with out it in and I need to have a repair person in to fix what ever the problem is that has caused house fires I have no


... Kitchen and Much More Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1055 seconds