Having problems with your Frigidaire 24 in. GLD2150RCC Built-in Dishwasher ?

DISHWASHER STARTED MAKING NOISE AND DID NOT DRAIN COMPLETLY, BUT KEPT WORKING FOR MONTHS THEN ONE DAY IT JUST WOULDN'T COME ON NO LIGHTS NOTHING, CHECKED THE BREAKER IT WAS ON LESS THAN 2 YRS OLD


Answers :

Repair Help & Product Troubleshooting for Frigidaire 24 in. GLD2150RCC Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DISHWASHER STARTED MAKING NOISE AND DID NOT DRAIN COMPLETLY, BUT KEPT WORKING FOR MONTHS THEN ONE DAY IT JUST WOULDN'T COME ON NO LIGHTS NOTHING, CHECKED THE BREAKER IT WAS ON LESS THAN 2 YRS OLD


... Frigidaire 24 in. GLD2150RCC Built-in Dishwasher

I have a 5 year old kenmore 665 15689 dish washer that wont come on at all . No lights no nothing . Before it stopped working the lights on the desplay were not coming on but it seamed to be washing normaly . I checked the breaker and even turned the power off for 5 min.


Theres a fuse in the back of the panel. ... Kenmore 24 in. 15689 Built-in Dishwasher

Model # KUDSO1DLSS1 Kitchenais dishwasher - had a burnt electric smell coming from the area of the touch pad (not the vent). Did "some" research and decided to replace the control board - smell went away - ran 3-4 cycles over a few days and then - no lights - tried a new control board (thinking the old defective) - nothing - replaced the thermal fuse - nothing - what next????


... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

Woke up this morning and the unit acts as if it has no power. no lights, no sounds, nothing. I checked the power and it has power. I checked the wire nuts in the box with the power coming in and they are fine...it is only 1 and a half years old...Please help.


... Haier ESD311 24 in. Built-in Dishwasher

My dishwasher's buttons will not work at all. Nothing is lighting up. I have already checked the breaker (not tripped, but I turned it off and then on again just to rule that out)... I assume that it is some control panel (the manufacturer said that it is a covered part... but I will have to pay the tech to come and install). Just trying to determine if it would be something that I can do myself and save some $. the unit is only 3.5 years old...


... KitchenAid Architect? II U SERIES KUDS03ST Stainless Steel Built-in Dishwasher

I have a GE Quiet Power 3 that has completly died. I cannot get a light to come on or anything to beep when pressing buttons. I checked the circuit breaker and outlet and they are both working fine. I tried pressing and holding the reset button on the front control panel and nothing. It seems to have just died at 2 years old. Anyone have a solution? GE wants $80 just to look at it.


A dead set simply means a cut off of power supply. Open the back cover of your dishwasher . Locate the area where the AC cord is located and look for the plastic fuse holder which is usually installed in one of the AC cord line open it and replace t ... Dishwashers

I have a 10 year old Electrolux Dishlex Global 300. It doesn't complete a cycle, beeps many times then all lights go off and it stops. Then you cannot select a program to restart. It then beeps consistently throughout the day when not even in use. A repairman has tried adjusting electric wire connections, the door handle and checked for motherboard diagnostic faults (which shows nothing). Any ideas?


Hi mndl, it sounds like what happened to mine, it was the flood switch F1good luck slappa ... Dishwashers

Our dishwasher was working fine (about 3 yrs old). Woke up in the morning and went to unolad it. There was a small amount of water in the bottom and it does not respond. No power, lights, nothing. I checked the breaker and it had not tripped. Any suggestions?


First turn off the breaker. Once you have the power off, take off the bottom panel.You will see where the electric wire comes into the dishwasher, it should have a small cover over the connections.Take off the cover and you will most likely find that ... LG Dishwashers

I have an 8 year-old Kenmore 665.16912 dishwasher. Worked fine until two days ago. Then it stopped working altogether: nothing lights up on the front panel. I have checked the 120 in the electrical box, the door switch is working, the thermal fuse is working and there is 120 volts at the white and black connections to the timer control board. I bought a new timer control board for $120 and that did not fix the problem. What else could be causing the unit to completely stop working?


If all are really good then the only thing it con be is the display (8269205) $25.00 part, if it's bad dishwasher wont run ... Kenmore 16912 Built-in Dishwasher

Amana dishwasher, model adb2200aws, ser #, 26650464e. history: quit running, no lights, nothing. replaced the door switch, ran for three days, replaced the switches on both sides of door switch, ran three days, quit. replaced the circuit panel , ran one time, quit. not lights, nothing. when I take it apart sometimes, that is take off inside cover on door, it might run or not. seems like the current isn't getting in as no lights will come one.


I have the same problem with mine as well but I found out that if you take a space heater to it and warm the control panel up for about 5 minutes, everything works great. This model of dishwasher seems to be problematic in any environment under 70-75 ... Amana Dishwashers

Maytag MDB6600AWW Unit is approx 3 years old it was finishing a load and stopped part way through sticking on heated dry. I don't know if it was there in the cycle or if the diagnostics on the board sent the message there. The light now will not shut off or move from the heated dry. I have disconnected 120 volts, removed the panel to check wiring, removed board and reassembled nothing resets the heated dry light and nothing works. I have gone through manual function test, sales floor demo test,


Have you tried pushing heated wash, heated dry, heated wash then heated dry? Sometimes this will reset it. ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

Built in model MDB5601AWB- about 3 years old. The touch panel stopped working..no lights would come on when touched. Tried it a couple of days later. Lights came on..finished a cycle. after satying in the wash mode for a few hours. Then lights started flashing on and off. At that point I shut it off at fuse box since I couldn't get lights to stop blinking and haven't trusted to use since


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. From what you have described it seems to be the ... Maytag Dishwashers

I have a candy futura cdf322-80 dishwasher,done a load as normal then i put it on the next day and there was nothing no lights came on nothing, i checked the fuses and the socket they were fine,so i had an engineer out who said there was power going to the machine so he said it was the contol panel which is situated behind the temperature and programme buttons so i bought this part and replaced it but still there is nothing.


I would check for myself if there was power going to the machine. If it acts the ways your does, then either the control panel or the power supply is at fault. Slight possibility a wire that runs between the two may be faulty, but not as common ... Dishwashers

DISHWASHER I have a problem with my CDA - CW494 dishwasher (6 ½ years old) You can switch it on and the lights come on. Then when you go to shut the door the lights switch off and the dishwasher doesn't start. If you move the door up and down the lights switch on and off. My husband has checked all wiring connections and they seem fine.


One of the switches in the door latch are not making contact properly. before you take the door apart make sure the dishwasher is 100% level. this can affect the door lat switches ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a bosch dishwasher classixx its less than a year old, the 'check water' light comes on and it doesn't complete the cycle. Water is left in the bottom unable to drain away. I have checked pipes as best i could, but couldn't locate filters or remove hose from m/c. unfortunately i have no instruction manual.. help please..


If its less than a year old why dont you contact the manufacturers service team it will still be under guarantee as the bosch guarantee is 24 months you can dowload a copy of the instruction maual free of charge from the bosch or bsh home appli ... Bosch 24 in. SRS43C12 Classixx Slim-Line Free-standing Dishwasher

Opened door and unit did not have electrical power (lights did not come on either unit). Called serviceman. He stated there was no electricity to unit(s). Called electrican. He stated wiring to the dishwasher had power. Called serviceman again. He came out and dishwasher worked. He did nothing to it. I opened the door and the lights(buttons) came on. Unit worked for a few days and this morning, there was again, no power to the unit. What is likely wrong with this dishwasher?


... Fisher DD603B / DD603W / DD603H Dishwasher

Hi i have a smeg df 410 sdx 450 wide dishwasher that is coming up to three years old ,the fault it has developed is that it wont switch on ,press the button and nothing happens,no lights or the normal beep.240v is getting to the button and when the button is pushed on 240v comes out the other side and goes to the various pcb's but the appliance wont do any thing,can you please give me some ideas.


... Dishwashers

My dishwasher ran this morning with no problems. This evening it won't work at all. No lights come on at all, as if there is no power. I checked the circuit breaker box and all is well there. I flipped the breaker just to double check, but nothing. Sadly, I cannot find my instruction manual. Do you have any ideas?


The manual is no problem you can download it from this site.\015\012The problem you are experiencing will not be described in ... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

Have a Whirlpool Quite Partner II DU1145XTPBA 1 1/2 old just stop working no lights will come on at all. There is standing water in the bottom. We have replaced the thermal fuse and still nothing. What else can we do this dishwasher is not even 2 years old.


Re-verify the thermal fuse.If the new wire that came with the fuse was not used the fuse will blow again.Check the door switch for continuity.The power to all parts goes through the door switch first.Open the wire terminal box ... Dishwashers

I have a Kenmore Ultra wash dishwasher model # 665.13692K600. It was working fine one day then all of a sudden I have nothing. No lights no nothing. I have tried shutting the breaker off and it didn't work. It is only two years old, if you have any idea that would be great. Thanks!!


You probably blew your thermal fuse that is attache to the main circut board, you can buy the thermal fuse seperatly. it is located in the console. ... Dishwashers

Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?


... Miele G892SC SS Dishwasher

Our Bosch Classic Electronic dishwasher ( approx 2 yrs old) will not fill with the "Check water supply" light on. We did have the water turned off for a few hours prior to using the dishwasher. Have cleaned the filter - unable to check the pump.


... Dishwashers

DU100XTPS7: In "pots and pans" and "normal" cycle water fills during "soaking" phase, but does not transition to "washing" phase at all; In "light" cycle the water fills during soaking, then light comes on for washing phase but nothing happens - have had the washer for 3 years and worked fine until 2 days ago - thanks in advance for any info


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Our dishwasher just died. It quit. the lights on the top won't come on and when you push them, nothing happens. It started and ran fine earlier, and when my wife checked on it...it was dead. There is a little bit of water in the bottom that didn't drain. What is the problem? Also...I checked the breakers and they are all good. Tom


I would check if your getting power to the motor ? Follow the electrical cord that you plug into the outlet you will have to take the cover off.Your going to have to use an electrical tester follow the cord all the way to where the wire connects.( Ma ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1663 seconds