Having problems with your Frigidaire Dishwashers ?

The heating coil is all white from calcium. How can I "clean" it. I also find it in the sprinklers little holes. Getting hard already


Answers :

This can possibly be resolved by runnig rinse cycle with calcium remover product,< don't know if brands are ok to say > the element might not clean up to good ,but the ,"sprinklers", being clogged will prevent dishes getting clean < the wash arms deliver the water to do the cleaning > not a tried and proven method , but easiest thing to try. Hard water in some cases can only be defeated by a good system to remove it.
Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The heating coil is all white from calcium. How can I "clean" it. I also find it in the sprinklers little holes. Getting hard already


This can possibly be resolved by runnig rinse cycle with calcium remover product,< don't know if brands are ok to say > the element might not clean up to good ,but the ,"sprinklers", being clogged will prevent dishes getting clean < the wash ... Frigidaire Dishwashers

Kenmore 17362 dishwasher was making a bad noise and now the motor seems to be locked up. I might have already un-jammed the motor by removing the cover on the bottom (inside), and turning the knife impeller on the outside of the screen, but I can see lint type material in the hole on the other side of the impeller. Hard to explain, but it is in the hole in the center of the unit and there is a screen like the knife impeller has behind it. I could clean this lint if I could get the door off. How


... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

I purchased my KARCHER G2500VH last summer. I used it one time for about an hour. I tried to start it today, seems like its not getting gas. I checked the gasline to make sure gas was flowing. I removed the sparkplug, poured a little gas into the engine through the plug hole. Replaced the plug, pulled the rope and it started for about two seconds. I also poured fresh gas in tank. Cannot get to start.


Have tried to start our BlackMax 2700psi pressure washer, it is not getting gas to the carburetor, what to do? ... Pressure Washers

Hi! My bosch SHE43 built in dishwasher is about 2.5 yrs old, dishes aren't getting clean anymore. We have *really* hard water so I use the max rinse agent, but doesn't help. I clean the little canister filter with each wash, and just washed off that grate in the bottom. I also just cleaned the trap under the sink, but it didn't look bad at all. The problem is a grit left on glasses and things just not getting all the way clean. When I remove the grate at the bottom, there's a bit of water


Hello. Let's begin by tossing two cups of vinegar into the empty dishwasher and running it on it's hottest and longest cycle. Always run the hot water in the sink faucet until it is as hot as it gets before starting up the machine. Let that cycle ... Bosch SHE43C02UC Dishwasher

Spotty dishes Hi. I recently bought a new home only to find that we have very hard water.( I believe it was 23) Unfortunately, we do not have a whole house filter/softner yet, and it affects everything. Right now I am wondering if I wash my dishes in the dish washer with vinegar, will that work to get them clean and eliminate the hard water spots and clouding? Also, do you have any suggestions for doing the laundry? I have gotten filters for my showers, since it felt like I was swimming every t


Hi, there is a new product out that is affordable and works great. it is a filter system just for your dishwasher. you can get it at dishwasherfilter.com. i have it and after the first load was blown away how clean my dishes got. ... GE 24 in. GSD2000Z Built-in Dishwasher

I have a Frigidaire UC DW Model FDB250RHB2 The unit is not a year old. It is not getting dishes very clean. I read similar posts. I found that there is water coming from top nozzle but not a very impressive stream. It is weak enough that most of the water misses the funnel on top rack. Also not top or bottom arms spin. Last week when i would quick peek during wash cycle there seem to be water coming out of top arm's holes but no spin. We also are getting heavy white staining on glass ware


... Frigidaire FDB520RH Builtin Dishwasher

I am not happy with the racks in my new Bosch dishwasher! The bottom rack is not right! The silverware basket is in the back right corner and the silverware catches on the seal on door and it is hard to get to. The tongs are two close together and point the wrong way? The upper rack's tongs are also to close together also. I don't seem to be able to get larger dishes in with these tongs in the way. Having never used the mdl 9000359119 Rev B I had no idea. Buying a Bosch ment quality to me


... Bosch Dishwashers

Have a dd603 with an issue...took off the arm and the metal silver disk (the ones with holes) to get to the wash impeller-(the thing with blue blades) the wash impeller will not spin-which I think is part of my problem, since i looked at the lower drawer and was able to spin the blue blades easily...was also able to pull it right out. Cant pull out the upper wash impeller!!!! Really want to get this fixed before my husband gets home and I get the lecture about how I purchased a cool looking d


Lol I don't know a lot about dishwashers, just do him good and tell him afterwards, and then hire a mechanic to look at it.Why would you want to pull the propellers off anyway? The top one doesn't pull off because it's screwed on, and the botto ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

Whirlpool Quiet partner 1dishwasher (model DU1055XTSQ2) that is not filling all the way--water supply is working correctly. Also, the water is not getting hot, the heater coil looks very mottled.


... Whirlpool DU1055XTSQ Built-in Dishwasher

I have a Briggs and Stratton power washer Quantumpower 5hp water driver series 1750 PSI 2.0 gal min model # WGV1721 . I got it used and it was always a bit hard to start but always started. Pull cord frayed and broke I bought new cord and a neighbor replaced for me. Now it does not want to do anything when pulled. I can't get top cover off that has screws with round holes instead of phillips or standard slots to get to pull cord winding


Spray well with WD-40 or similar, and take a small chisel, on it's edge, and hit hard enough to allow chisel to dig in to head of screw, making a "V" like slot in the head, then angle chisel slightly and start tapping in direction of loosening(counte ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I can get the motor to start but it idles rough and does not get to full throttle before shutting itself off. Also very little water pressure coming out of gun at highest throttle speed when it does run very briefly.


You need to probibly just clean out the carb. ... Pressure Washers

Pressure gun there is a large spring which is in front but there is also a very little sping, I think it is called a helical spring where does that spring go handle does not work properly without the spring trying to find diagrams but cannot find have a Karcher 3.98


... Karcher 1750 Psi Elec Pressure Washer

I HAVE A GE DISHWASER MODEL#GSD2200G02WW I WANT TO CHANGE THE PUMP BUT CAN'T FIND A REPAIR MANUAL I CALLED A REPAIRMAN AND THEY WANT $300 TO CHANGE THE PUMP CAN ANYONE TELL ME WHERE TO GET A REPAIR MANUAL OR TELL ME HOW TO CHANGE THE PUMP IT DOESN'T LOOK THAT HARD PAUL


... GE Dishwashers

Dishwasher Problem... Hey, I'm sorry I can't seem to find this information anywhere else. I'm having a similar problem with my dishwasher (also a kenmore quiet guard) and I wanted to try to clean the filter. I'm not sure how to remove the lower arm of the dishwasher. There is a kind of plastic-screw in the middle of the lower arm, is that what holds it on? I'm afraid to try twisting it because I don't want to break it. How did you get it off of yours? I hope I'm not bothering you! Thank you, Je


You are right. The plastic screw needs to be removed. I have a Quiet Guard 4. My procedure is as follows:\015\0121. Remove baskets. Need to pop off the 'keepers' at the ends of the top slidding shelf supports.\015\0122. Remove bott ... Dishwashers

The little holes in the arms have food stuck in them and I can"t get it out. I have tried toothpicks and tweezers but it just pushes it back in. The dishes are coming out dirty. Solution ?


Refer user manual. Remove the spray arm and clean. If you have a vaccum cleaner try sucking the particles from the main opening end. ( ie where the water flows to the arm)Clean your drain filter and remove all the debris manually from the ... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

My dishwasher is putting little black spots on my clean dishes, hard to get off


Aluminum untensils have rubbed against the dishes,use a mild abbrassive cleaner to eliminate marks....... how do i let inlet water out of my candy dishwasher ... GE Dishwashers

My Bosch dishwasher detergent dispenser lid will not stay closed or opens shortly after starting the wash cycle. I cleaned around the part (hard crusties) and broke a the little blue release tab. Any advice on where to get the parts/how to repair?


Contact the authorized BOSCH service provider. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Low Pressure It runs, and sprays water, but doesn't have near the pressure it had. Its also losing water out a weep hole on the water pump. Manual says check the screens, but I took it apart and didn't find any. Any suggestions?


Sounds like you may need new pump seals. ... Campbell Hausfeld PW2575 Pressure Washer

Top "spinner" has some water flow but doesnt spin. Doesnt seem to be enough pressure to get it moving, would the pump be on the way out , i have checked all holes for blockage and also ran some cleaner through machine.


Hi,That problem can have many and varied solutions...I have tried to put together in this tip the most common and easiest to checkout problems. For many of the spray arm problems the ... Asko D1776 Stainless Steel Built-in Dishwasher

DWI410 Thanks for your help Tresilla. Unfortunately, no such capacitor evident in my machine. Do you think that a smeg technician could successfully run a diagnostic check? I'm reluctant to throw the machine away, but I also don't want to pay a lot for a visit if there's little chance of him/her finding the problem.


There will be a capacitor. usually attached to the motor but sometimes mounted at the back. it is a cylindrical object about 3-4 ins long and about 11/2 ins diametersmeg tech should be able to find the problem but will be expensive ... Smeg 18 in. DWI410 Built-in Dishwasher

We getting the error message LE on the dishwaser model #LDF6810ST. The repair Official repair man that came out to supposedly fix the dishwasher called LG to find out what was wrong with it and they told him to tell us that we need to replace the motor and wiring harness and the Technician told us to order the "motor and wiring harness" charged us $100 and left and the dishwasher that is only 2 years old and we paid a little over $800 for is still broke. Now when trying to order the "motor and w


Motor assy pn# 4681ED1004A is the motor you will need. ... LG Dishwashers

Asko D3120 I have resolved the problem of pum always running by tilting the dishwasher but now I have a new problem of the pump not draining the water in the bottom of the dishwasher. I thought it was clogged so I removed the screen and filters but did not stick my hand in the hole to clean... I used the plunger for at least 30 mins. Then I tried to pour a little CLR because I have hard water. NOTHING please help me


In the bottom where the filter are, you can see a yellow 'thing'. Remove this and stick one finger in an try to rotate the pump wing. Try to remove particals that is blocking the pump.\015\012Or there is something in the drain hose. Try to drai ... Asko 24 in. D3120 Dishwasher

I just moved into a house with a Roper dishwasher. I could not find a users manual that would tell me what type of soap that could be used in this machine (powder or liquid?) and where to put the soap in the washer. Please help me so I can get my dishes clean (and then I would also be a member of the "clean plate club".


The dishwasher will clean best if you use a name brand powder. As you look at the inside of the door of your dishwasher, you should find some sort of dispenser cup or tray, with a lidd that closes some how.You do not need to fill the c ... Dishwashers

No water Thanks for the try, but I have already replaced the inlet valve. Still no water. I also checked and confirmed that I am not getting 120v to the inlet valve and/or float switch.


Check your heat dry options I have seen them short out a lot and that will prevent the water valve from getting 120v. ... Frigidaire 24 in. FDB126RB Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1165 seconds