Having problems with your Frigidaire Dishwashers ?

Timer on washer stuck at 99 minutes. how do I

\015 Timer on washer stuck at 99 minutes. how do I reset it?\015

Answers :

Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Timer on washer stuck at 99 minutes. how do I


... Frigidaire Dishwashers

I have a Whirlpool ADP 5777 WH dishwasher I need to know if I can reset the dish washer, it is the timer which is stuck, so you can change the dial on the left for the various washes, eco, etc. but the time of the wash does not change!! Stuck at 2 hours 47 minutes!! I have tried turning the machine off at the powerpoint and turning it back on but that has not fixed it


... Whirlpool Dishwashers

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

The washer cycle stopped without warning, i thought the timer or the timer motor but it is not the timer works fine and so is the motor. but the timer motor runs til the washer motor starts than is the timer stops and the washer is working but not cycling so no rince or drain or soap etc... just pumping water. if you can tell me what might be the problem, thank you. like i said the timer stops when the washer motor start.


... Jackson JPX-300L Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

The washer is very noisey and sounds like the washer hands keep getting stuck. I've checked the bottom and there is nothing stuck.


The noise is definitely in the motion of the arm or the movement of the drive. It is important that you are able to get a first hand view and observe the origin of the sound while trying to turn the drive manually.\012So switch off ... Kenmore Dishwashers

I have a dish washer matsui model mf2w/a and the timer seems to be sticking causing the machine not to wash correctly, the machine carries on doing the same thing until i manually move the timer control knob on to the next setting , do you think the timer isfaulty or another component .


If your Matsui MF2W/A timer stops earlier in its cycle, turn off the water and unplug the machine. Pull it out and put it on its back. Remove the base panel. Remove the anti-flooding interlock. Unplug the two cables feeding the heater element ... Dishwashers

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

The dishwasher won't start, its stuck, pots/pan button is blinking, & the timer has (2)_ _ bars blinking. I tried to reset/pushed the start/resume button nothing happened. I pushed the cancel/drain button still nothing happened. I close the door tight..nothing. I check the trays if there something stuck inside..nothing. I unplug/replug the power cord nothing? my wife was using it when this got stuck about 3 weeks ago.


Did you hold the start/resume button for at least 3 seconds if this works the dishwasher will start ok but if there is a fault it will fail again best you contact your nearest service agent good luck ... Whirlpool GU2400XTP Built-in Dishwasher

The timer on my Kenmore model # 363.14252100 broke and I am replacing it. Is there any special way to detach the old timer from the wiring. It seems stuck on.


... Kenmore Dishwashers

Why does the timer function on the DF62 not work. i simply turn the timer to 4 hour delay and set the washer to come on but when the time arrives it doesn't click on


... Hotpoint Dishwashers

Timer get stuck and won't finish wash unless you manaully tur the timer


You need to replace the timer. ... Dishwashers

I have a bosch dishwasher model she46c. the float stuck and the pump ran and almost burned out smelled burnt. got washer to restart everything works but pump is noisy. replaced pump but it is still noisy. What do I need to check? nothing is stuck in pump. thanks ron


... Dishwashers

Bosch SHU43C My Bosch SHU43C is stuck with the drain pump running. I ran the self-test and it gave me the fault code 4 wich indicates a filling fault. The washer is empty and all wash cycles display the correct number of minutes for the cycle. It counts down to 0, but the pump continues to run. Does this indicate a stuck float, or is the problem with the control board? Where is the float located? Are diagrams/pictures available on-line anywhere? I've done some searching, but haven't found any. R


My SHU43C is just over 3 years old. I had a similar problem recently. First, there were a few floods. Then, the Bosch only drained non-stop. Even when I used the Cancel Drain buttons the drain pump would run without stopping. When I ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Candy CS 455M slimline dishwasher which is 3 years old. The program button has stopped moving round I put dishwasher on and went to work and it was still washing the dishes when I got home from work 8 hours later. I thought it might have stuck and been a one off but no it happens every time is it the timer? is a new timer easy to fit?


... Candy 17 in. CS455 Built-in Dishwasher

Bosch dishwasher SHU3032UC/U12: Gets stuck mid cycle. Timer does not move, but will continue if turned manually. Will stick again. Thought it might be the timer (control unit), but now am wondering if it could be the heating element or thermostat.


Hello, Welcome to FixYa. Based on you description of the timer not advancing you`re on the right track when you said "Thought it might be the timer (control unit), but now am wondering if it could be t ... Dishwashers

We have a Whirlpool Gold Dishwasher, Model #GU1500XTLB1 that is having a problem with the timer. It seems to get stuck at different numbers for a long time. Last night it was on 53, then got stuck on another number a while later.


... Whirlpool Dishwashers

I recently tried to fix my ge potscrubber dishwasher that wasn't running, I pushed the fin portion of the motor that was stuck in place. The washer runs great but now leaks near the pump but only when the washer is on/draining.


This is a common problem with this pump. The only solution is to replace the pump assembly. The price is between 75 and 100 dollars for the pump (usually). This motor also had issues with the fins breaking off and becoming lodged in ... Dishwashers

I have a Fisher and Paykel dishdrawer model ds603. Not sure eactly what happened but my son says that the cycle stopped last evening (and only tells me this morning!). Dishes though appeared to be clean and there was a small amount of water at the bottom. I tried opeing the washer and it was hard to open as though the drawer was stuck on something. I removed the drawer and checked the rollers and they are fine. I realised then that the drawer is getting stuck on the inside lid that provides the


The best thing to do is to remove the rack,drawer completly,and close it up,see if it will come on,and run all threw the cycle.If it does,then put the rack,drawer on the track.The rollers could be,well,not snapped all the way on.It will be in that ar ... Fisher Dishwashers

Bosch dishwasher I am looking for a wire diagram for a Bosch dish washer mod # SMU2046UC SER# ? FD 7609 470358 my problem is the timer will run but there is no operation at any point on the timer dial, and I cant find a wireing diagram for this unit. so that I can try to trouble shoot this problem.


... Dishwashers

It sounds like drain cycle is stuck. Is there some type of reset button? I tried unplugging the washer but when I plug it back in the drain cycle is stuck


Hello,Welcome to FixYa.Based on your description " It sounds like drain cycle is stuck. Is there some type of reset button? " , the good news...It is likely noth ... Asko D1796FI Built-in Dishwasher

Pull cord stuck on my pressure washer. - Briggs & Stratton Pressure Washers


Need to remove assembly to find problem. ... Briggs & Stratton Pressure Washers

Reseting Timer How do I reset the timer for the PDW7800 dish washer?


Press cancel should reset control board.if not unplug for 5 min.there is no button to reset it! if dose not reste may be bad board ... GE 24 in. Profile PDW7800 Built-in Dishwasher

My GE dishwasher timer gets stuck and doesn't move. I replaced the solenoid already as the water wouldn't drain. Would replacing the timer fix the problem for good?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Timers usually won’t go bad however,\015\012if every other part of the dishwasher seems to b ... Dishwashers

#3 light stuck on (heat) washer will not run, Befor the washer froze I did hear a noise every 6 seconds for a whileand wan't sure where it was comming from, I think I know now.


To fix this issue qwith my dishwasher, i held the heated-dry button for 3 aseconds (light flassed while i was doing it), and the light cleared. I canceled the cycle and then was able to start it and and let it run normally. ... Maytag 24 in. MDB9750AW Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0926 seconds