Having problems with your Frigidaire Dishwashers ?

Frigidare the hold light stays on and we cannot start the dishwasher . numbers on manual are TH93556807 and FGHD2433KFO


Answers :

With the "hold light on", try turning off the electricity to the dishwasher via the wall switch, plug, etc. Then see if you can resume a normal cycle. If not, you may have a problem with the electronic control board. If so, contact an appliance service company.
Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Frigidare the hold light stays on and we cannot start the dishwasher . numbers on manual are TH93556807 and FGHD2433KFO


With the "hold light on", try turning off the electricity to the dishwasher via the wall switch, plug, etc. Then see if you can resume a normal cycle. If not, you may have a problem with the electronic control board. If so, contact an appliance ser ... Frigidaire Dishwashers

My frigidaire dishwahser was set to run a normal wash cycle and heat dry. It never ran, the soap is still in the holder and the lock beneath the heat dry option is lit. I'm unable to cancel or select any other options. I cannot get the dishwasher to run. Do you have a solution? I have tried holding down a number of the buttons in different combonations but still can't get the light to go out or start a wash cycle.


Looks like a number of things are happening.\015\012\015\012It would be easier if you can provide the model no. of your frigidaire dishwasher.\015\012\015\012I am assuming you have turned the mains power off and on. ... Frigidaire Dishwashers

I can't get my electrolux dishwasher to run. It seems as though the touch pad is not responsive. It says to reset holding down the sanitize button, I do that it beeps but doesn't do anythng. All of the buttons are not lit up. I have to hold the delay start button along with the sanitize button to light the buttons up, still the buttons don't seem to be responsive, I touch the start and the lights go away and flashing numbers appear. Et 19 66 02 34 Any help would be appreciated.


... Electrolux EIDW6405HT Builtin Dishwasher

When starting my Bauknecht GSFP 5586 dishwasher the program is set for rinsing and the start light flashes two blinks, then again two blink etc. I cannot get the program to change. When I hold the Start button for 2 seconds, the progress light flashes at END for a moment then reverts back to the double blink sequence. I have checked the filter and it is well seated and clean. What can I do to start the program selection again?


Ok, so I had the exact same problem with the exact same model. NOT 7 blinks and to buttons that you do not have.\012I will tell you what I did as I do not know what (if any) of what I did fixed it (it could be luck but I do not think so).\012 ... Dishwashers

The control lock light goes on as soon as I press the cycle to start the dishwasher. The dishwasher does not start, presumably because the control lock stays on. I do not know how to disable the control lock function. Pushing and holding the button for 3 seconds does not disable it.


Hello &\015\012Welcome to FixYa\015\012\015\012To unlock the\015\012controls press and hold the HEATED DRY button for 20seconds. If the problme\015\012returns then only option is touch pad replacement. Please get back t ... Maytag Dishwasher

Have whirlpool gold dishwasher made in Mexico, the control lock light stays on, when i push it and hold it just blinks three times and then stays on steady and then does the same over and over, before it did this I noticed the lights for different cycles flashing randomly, and even pushing cancel button once in a while would start the machine up....I have tried to unplug the machine and then plug back in, but nothing is helping....any ideas??


... Whirlpool Dishwashers

I have a Maytag Quiet Series Dishwasher although it is not stainless steel, it is white. My dishwasher, shuts, and the lights come on when I push it but it will not start! Yesterday after a few attempts pushing cancel and so on, I smelled a STRONG concentrated smell of the liquid dishwashing detergent inside the dishwasher, but it never came on. Can you help, I cannot find the manual for this appliance, it came withour home when we purchased it in 2006, and it was brand new.


Here is the manual.\015\012\015\012http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Ca ... Maytag 24 in. MDB5601AWS Stainless Steel Built-in Dishwasher

Dishwasher does not start it seems there's no water coming in the tub. I got a trouble shooting manual from ejunkie.com and tested the coil of the water valve which read 1000 Ohms, which means it's OK. Then I hot wired the coil while connected to the water line and the valve opened and I had water flowing [ in a bucket] I have tried to start the test program [hold power scrub plus and regular switch at same time then start button] and lights start flashing you hear drain pump come in then the un


... Bosch SHV4803 Dishwasher

Dishwasher will not start cycle it is locked and will not unlock. door panel suggestion says press and hold energy saver dry pad x3 seconds that is not an option on this model. what can we do.... the numbers 8573025 and the other is 8573030 the numbers on the door we also have additional numbers from our user manual that is part no 8269551


... KitchenAid Dishwashers

My Asko D1996 Dishwasher will not start. The control panel has 3 lights staying on - position #1, 6 and 7 and are unresponsive no matter what buttons are pushed - even after turning the power off at the breaker, the outlet and the on/off button.I've tried holding down the start button for several seconds to reset but this did not work. I have also cleared the drain, filters and removed any water and pushed and held the Start button to reset.


... Asko Dishwashers

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.


... Beko Dishwashers

My dishwasher has no connection. The entire "board" is without lights. I cannot start the machine. My biggest problem is getting support from local service! I have not talked to anyone who will help! The service depart. does not return my phone calls! Dishwasher was purchased two years ago this month, Model number:MDBH945AWW


... Maytag Dishwashers

Our Bosch SGS 53E02 AU/30 Dishwasher has the Tap Light on all the time while the Dishwasher is filling up. It appears as though water cannot get through and takes a long time to fill. It also does not allow the wash cycle to start and the powder door does not open. Can you also get any Service manuals for this model?


... Bosch Dishwashers

The lock on light wont go off. We can not start the dishwasher. We have tried holding the noheat option for several seconds and have turned off the circuit box for several minutes and neither one made the lock on light stay off.


That is the correct button to push to turn the control lock off. You can try to reset the control by removing power for two minutes. If the dishwasher is doing the same thing, most likely the touch pad has a shorted button or a bad connection on the ... Kenmore Dishwashers

My bosch dishwasher control panel displays 0H on the time delay. When I start it the OH go to 2H. It then starts running and does not stop. The cycle minutes don't display. It's model number SHU5302UC 14. I do not have a manual and cannot find one online. Thanks


Check to see if your unit has a recall on it because if it does you will get a free control module from bosch.\015\012your problem is the control module. thermador .com is the site to lookup. gaggenau,bosch,thermador they are the same ccompany. ... Bosch 24 in. SHU53 Built-in Dishwasher

I have a Jenn Air high end dishwasher. It is very ambiguous on what model, type or serial number is but the number next to ''type:'' is 776-0 and there is a an E39927. jov1270awy and a 49022. None of he numbers or references have any description that indicates their purpose. Symptom: We can not get the dishwasher to start up. The buttons for choosing what type of wash will light up but when the power button is pressed it does not light up and the dishwasher will not start. Needless to say the ki


... Jackson Dishwashers

My westpoint dishwasher wym-1211s.mx start beeping and the red light is flashing on the intense setting about 5 seconds after I have turned it on. I cannot find the online manual for the model I have


... Westpoint Dishwashers

My Frigidaire dishwasher will not start. It was working fine about a month ago. The lights on the panel are working and I had the water line checked and it is o.k. I cannot find a serial number but the book that came with it is for the 500, 1100, 1400 & 1500 series with fully electronic control.


My Frigidaire 500, 1100, 1400, 1500 & 2400 Series Dishwasher was purchased a month ago and it will not start either. The 8 second lock under "Heat Dry" is lit, but nothing happens when you press any of the other buttons. Any ideas? ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

I have a frigidaire dishwasher fdb520rhb2. Lately, at the end of the cycle the high temp wash and heat dry light will start blinking. The cycle does not finish. Cannot find the error codes in manual. Thanks.


... Frigidaire Dishwashers

We have a Miele G863SCVI Plus. We have a problem with the Inlet/Drain light staying on. Originally, if we turned the dishwasher off and then on again it would work. Now it won't. I have cleaned the filter out but wonder if there is something else that needs cleaning. I have never had a manual and cannot download it from the websites that say they have it. I would really appreciate it if you can help me


Hi.Check that the drain hose is responding to specifications. This machine suffers from siphoning problems caused by incorrect drain settings. Siphoning means that the water flow back inside the machine from drain hose, causing drain ligh ... Miele 24 in. Incognito G863 SCVi Built-In Dishwasher

Dishwasher will not turn on. We think the start button is the problem, having checked everything else we could think of. We cannot find the manual. The light on "clean" keeps b;inking as well, but there is no button for this.


Hi,This is a common problem.Read :-http://servicematters.com/clean_led/8178496.pdfYou need to have an Acrobat Reader to view this file.Take a look at the Video :-http://servicema ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

KitchenAid Dishwasher I have a KitchenAid Model KUDS25SH Serial FKO531820 "CHILD LOCK" Light Stays on I have tried what is suggested in the manual of holding the ENERGY SAVER DRY button in for 4 seconds, it did not work, I have turned off the power to the washer, that did not work, any suggestions for this guy who is tired of doing dishes? Thank you. Nick


Nick,\015\012It sounds like you have tried all the normal things for this. It is possible that you have a stuck key on the panel. Try pressing all the buttons several times to see if they may be stuck. It may just pop it loose. If that does ... KitchenAid 24 in. KUDP01DL Built-in Dishwasher

Dwf 416 ikea whirlpool dishwasher red salt light on never used salt in 10years cannot overide it just beeping constantly checked sensor guide in manual tried every setting on dial nothing gets it to work or be start beeping


... Dishwashers

Light by lock symbol stays on and cannot reset to start dishwasher


... Whirlpool Gold 24 in BuiltIn Dishwasher w Adaptive Wash Cycle Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2701 seconds