Having problems with your Frigidaire Dishwashers ?

I used the dishwasher a couple of days ago and then today I could not turn it on the unit seems to have electric to it and I am thinking it might be a fuse. the circuit breaker seems ok


Answers :

Check where the power comes into machine and the door switches.
Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I used the dishwasher a couple of days ago and then today I could not turn it on the unit seems to have electric to it and I am thinking it might be a fuse. the circuit breaker seems ok


Check where the power comes into machine and the door switches. ... Frigidaire Dishwashers

Own a Frigidaire Dishwasher Model Number FDB4315LFSO and now after about 2 years suddenly the display will not light and function anything. Without pulling the power panel off the whole line circuit seems to have power as they have my disposal unit tied into same electric line and that runs and so does everything else and no breaker is tripped. Is their a reset somewhere to check or any ideas what can casue the display panel not to function any commands at all. Nick


... Dishwashers

I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?


... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH

I have a Bosch SGI4005 AU/07. When it completes the end of the cycle it trips the houes electrical circuit breaker. It continues to trip the circuit breaker for an additional 5 minutes then all is well. It will do the entire wash. Is this a common problem and has someone got a wiring circuit diagram for this unit.? Any assitance is appreciated.


... Bosch Dishwashers

Bci450 My dishwasher has been always giving me lots of trouble. It is the BCI450 model from hotpoint. Whenever it reaches the washing stage for steam, it seems to beep alot. Many times they replaced the Circuit board but this problem comes back after 2 months. What could be the reason this is caused? Today they replaced the rubber thinking that water vapour might be reaching the circuit. I got this repaired about 7 times already and each time they replaced the circuit board.


... Hotpoint Dishwashers

Kitchenaid (KUDM01TJWH0) Shortly aftter starting my kitchenaid (KUDM01tJWH0) dishwasher, smoke began coming out of the door. I opened the door and smelled a strong electrical smell. It is now completely dead. I drained the water out of the water line, thinking it might be plugged, but still nothing. What should my first move be to determine the cause? Breakers are fine. I think it is was purchased approximately 2001. Thank you!


Wires where thy bend at bottom of door and heating element....water in motor ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

The problem started with it not draining correctly and leaving water in the bottom - my husband took it apart and found a bolt in the drain. He removed it and now it won't start. It appears to not have power to the electrical panel- we have reset the breaker several times - left the breaker off for 10 minutes thinking it might erase the memory - I've asked for instructions to reset and I keep getting info that is very far removed from this model. I know it has a protocol because a repair


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012The reset on your dishwasher is as follows, ( I can't locate your particular model number...but its madw be whirlpool so there are only a couple of possible sequences ) however depending ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My Kitchenaid dishwasher Model KUDPO1FLSS3 stopped working. The electrical works, as we checked the breaker and the little lights on the panel turn on, but the machine will not start. We're thinking there might be a problem with the connection where the door closes. We've checked out everything we can think of, but no luck. The plastic panel is worn away in places, so some of the buttons are exposed-can't imagine that matters, though. Help!


... KitchenAid Dishwashers

I have a ge profile pdw7800 which will not start. the problem seems to be with either the circuit board, or the touch panel. Some buttons on the touch panel work, and others dont. Please advise if this is the touch panel, or if you think it might be with the circuit board. Thanks, Dave Nosker.


I'm having the same problem with my GE PDW7800's touchpad. the buttons to the right of the Start button are dying. I'm now having to play a dance between with the "button lock" mode and Time Delay to get it started. Unfortunately, the capacitive to ... GE 24 in. Profile PDW7800 Built-in Dishwasher

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Unit went dead. There is no power (electric) to it. I checked the circuit breaker and even changed the breaker, but no power. Removed the bottom foot panel and did not see any reset button. I don't know what else to look for.


The electronic control board has failed & needs to be replaced,by someone who knows what there doing.GOOD LUCKECO KIZZA ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

My kenmore dishwasher, model 665.16473300 has stopped working. Now the lights just flash at the Smart Wash, Normal Wash, and Cancel. I've reset the power and it just comes back. I've taken the drain area apart and made sure there are no obstructions. The buttons seem to respond, as after I reset the unit (breaker), only the Smartwash button is flashing. I push cancel and then it starts flashing. So I think the buttons work, but it's locked up.


IS THE WATER TURNED ON TO THE DISHWASHER ... Dishwashers

3 problems: 1. lower drawer is hard to close; seems to be sticking on something. 2. lower drawer retains water (2 inches) after completing a cycle. 3. F1 fault code on both drawers with alert occurred when washers were not in use. I had to turn off the electric circuit breaker to make it stop.


Ok where to start, first thing the bottom draw is hard to close because they use 2 little motors on either side to pull a lid with a seal on it down on top of each draw when u start it to keep the water in, if its hard to close the motors are damaged ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Dishwasher is reading "overfilling", but no water is in unit. Door can open, noise of motor or pump continues and will not shut off even with the Power switch. Only way to stop noise is to turn off the circuit breaker at the electrical panel. What does this sound like to you?


HI- The flood switch has been tripped. It is located under the unit and is not really accessible except by a Tech. The most likely cause it poor draining; if there is a little water left over from each part of the cycle then eventually the water ... Asko 24 in. D3530FI Built-in Dishwasher

Amana Dishwasher Model #ADB1500AWB3 (Purchased 7/2009) worked fine on Friday, and last night would not turn on, no green lights at all. We check circuit breaker, and electrical outlet but they were working fine. Do you know what might be wrong?


... Dishwashers

Maytag 6 yr old Dishwasher - Model LR111721 Standing water in bottom of unit. Front panel lights do not come on. Checked circuit breaker in basement & it is getting power. Last time we used it it seemed to make a bit more noise than ususal.


... Maytag Dishwashers

Have a 15 day old Thermador Dish washer direct wired to the circuit breaker, replacing a DW that was there for 10 years. Wiring is the same age. The unit will not turn on and I took the cover off the electric cover the hot wire had melted the connection. what's going on? model DWHD630gcm


... Thermador DWHD630GCP Dishwasher

The dishwasher will not turn on. The timer lights are on even when I turn off the circuit breaker it is one whrn the electricity comes back on the latch seems to be ok. how do I get to the timer.


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

OUr ASEA Cylinda dishwasher doesn't seem to have any power. The manual suggests the fuse might be blown. THe circuit breaker is fine. Is there a fuse on the machine that can be replaced?


You need to trace the power cord into the machine to confirm this case. It will lead you into the circuit and if power is not present to the controller section there can be a fuse before the circuit.Remove power to the machine and remove panel to ... Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Bosch Dishwasher about 10 years old, model SHV4803UC/U07. Yesterday it stopped working along with no lights on the selector buttons. I have reset the circuit breaker ( which did seem to not be off at any rate). It seem not to be getting any power if it's not the circuit breaker what else could cause this?


... Bosch Dishwashers

Hi, I have a Karcher K3 pressure washer. 18 months old, used maybe 6 hours total. For the past 3 hours of use the compressor/pump seems to cycle audibly but pressure at outlet hose seems constant, hence I did'nt worry. Now it does not start with switch on. I now hear a buzzing sound from the unit. The unit was last used 6 weeks ago. The unit was stored in the garage away from frost, it does not leak water so I don't think there is any frost damage, but just this buzz. Any suggestions would


... Karcher K3.68MR Electric Pressure Washer

Have an electrical circuit that has stopped working. Romex circa 1930. The breaker is fine. There are 4 ceiling lights and 3 outlets on the circuit. There is power through the hot wire leaving the breaker. Tried wiring to a different breaker to be sure. Still no power


If there is power leaving the box, you have a broken/damaged wire somewhere.If all the lights and outlets do not work - the problem is with the common (return) (white) or a broken/damaged wire before the first item in the circuit.If the b ... Dishwashers

Frigidaire dishwasher Rylee, the circuit breaker is fine. There is no fuse on the dishwasher according to the owners manual, the parts manual and the wiring diagram. There is no timer selector switch on this model. While I changed the control circuit board, the only other thing I can think it would be is the control panel with the buttons on it. What do you think


Hi Todd,As a rule:\015\012\015\012Black Smoke = Unburnt Fuel, incomplete combustion, bad mix\015\012Blue Smoke = Burning Oil\015\012White Smoke = Water Va ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

The unit is a Maytag model MDB5601AWW which it has recently began to lose power at the touch pad. The electrical breaker has been checked to confirm normal voltage. Additional investigation suggests that the unit can be reset by (1) disconnecting the power at the breaker, (2) disconnecting and reconnecting the ribbon cable that interfaces the touchpad with the control board. However, the problem reoccurs after a few normal wash cycles.


It sounds to me then that the display board or touchpad needs replacing,you havn't said that it's not doing it's cycles.so it's not causing any washing or cycle problems.i would replace the display board. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0769 seconds