Having problems with your Frigidaire Dishwashers ?

MY DOOR ON DISHWASHER LEAKING FROM BOTTOM PUT NEW DOOR GASKET ON AROUND DOOR


Answers :

Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

MY DOOR ON DISHWASHER LEAKING FROM BOTTOM PUT NEW DOOR GASKET ON AROUND DOOR


... Frigidaire Dishwashers

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

The insultation on the bottom of the door is wet. My repairman said water is getting behind the soap dispenser and the rubber gasket around the dispenser is hard. The dishwasher is only 4 years old. Is this possible. The insulation at the bottom of the door is wet. Oddly, this is an intermittant problem. The past two days, with a small load of dishes, there was no leak. Help!!


A reader on another forum found, after much effort, that the solution may be very simple: don't load flexible cutting boards on the right-hand side of the machine.The boards can block an outlet on that wall, presumably leading to a buildup ... Bosch Dishwashers

I have a Kitchenaid KUDS25SHBL1 dishwasher that is leaking from the bottom of the door. I replaced the main gasket around the body that the door seals against, and it is still leaking.


Have you removed the outer door to check if the leak is coming from inside the door . also check the bottom door seal ? also check the around the soap dispenser as I have had to silicone around them to keep them from leaking before..let me know if th ... Dishwashers

Hi...I have a Westinghouse Freestyle 921 Dishwasher...9 years young...Model SB921SG...that has recently been leaking from the bottom right hand side front corner of the door when performing its usual heavy duty cycle...It appears that the main door seal has significantly perished and is causing the problem...Therefore I have purchased a new Door Gasket part no.0208400069 from a recommended spare parts agent in Brisbane and after several attempts to re-fit this gasket/seal to the door...I still h


... Dishwashers

I don't have a model number right now, but the front door on my Admiral dishwasher is leaking at the bottom. I have changed the gasket inside the door panel at the bottom but it still leaks. This is a rental property and the renters did a job on this dishwasher. I was wondering if they may have pulled another lower gasket off that I didn't know existed. Something like a windshield wiper. The seal I changed was a foam strip 3 x 22 approx. Thanks for your time, Joan


It may not be the door that is leaking if this is an older admiral or whirlpool dishwasher the lever that holds the soap door closed has a little rubber seal that after time will let water in during the wash cycle it the runs down the inside of the d ... Admiral Dishwashers

How do I fit a new door gasket to a Hoover DT999 dishwasher (the short horizontal seal at the bottom of the door, not the longer one which wraps around the inside of the body of the machine)?


Well I just did this (ew!)basically it just pulls out of a slot downwards (when doors open) but there's not much space so I took out a few screws to free the door up a bit.So - sitting with the machine in front of you and door ... Hoover 24 in. DT999 Free-Standing Dishwasher

I have a Maytag dishwasher which is leaking on both sides of the door. I put a new gasket in, but it is still leaking. Any suggestions? Thanks, Tom


The dishwasher stopped leaking after being run a few more times with the new gasket in place ... Maytag 24 in. MDB3700 Built-in Dishwasher

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

Frigidaire dishwasher model GLD2250RDC0 leaks from the bottom of the door. Just replaced the bottom gasket. Not helping. Noticed that the foam insulation on the bottom of the door is soaked. So, if it's not coming through from the gasket, what's causing the leaking on the inside of the door and through the foam insulation? Thanks for any help you can provide.


You may want to check the door alignment itself. Many people open and close the door improperly and when they load it sometimes they put pressure on the door in one corner or the other. Check to make sure the door is completely shut and shut proper ... Dishwashers

Leak around bottom door gasket


No, you don't need to remove the door to replace the gasket. It is usually a pressure fit and will just push into the alloted space. Take notice of where the originial one begins and ends before removing it. ... Frigidaire Dishwashers

HDT 18PA 17 in. Haier Dishwasher... leaking at bottom of door. Need a new gasket. How do I order one and from whom do I order?


Hi,\012That is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy ... Haier 17 in. HDT18PA Built-In Dishwasher

New kitchenaid dishwasher leaks shortly after cycle starts open door and bottom is full up to gasket


... KitchenAid Dishwashers

Leaky Dishwasher I recently moved into a new house that has a brand new Magic Chef dishwasher. We haven't even had a chance to use it, but last night discovered water leaking from the bottom onto the floor. When I opened the door, there was about 3-4 inches of water inside. I baled as much of the (slimey) water out as I could, and that stopped the leak. Now afraid to run the dishwasher for fear that it might leak even worse. E71195 Type 777-0


... Magic Chef 24 in. DC4000 Free-standing Dishwasher

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Leaking dishwasher I replaced the door gasket, and I still have leaking from under the dishwasher. There is such steady droplets from the bottom of the tub of the dishwasher, it is almost a steady stream of water. It is dripping from about 13 inches deep into the dishwasher from the front door.


... Kenmore 24 in. 17372 / 17374 / 17379 Built-in Dishwasher

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

Maytag Dishwasher Quiet Series 300 Door Leak: Model No. MDB8600AWG: The door leaks both from just beneath the touch pad at the top of the door, leaving a streak down the center face of the door (minor annoyance) as well as from the bottom left and right corners, more of a concern. I have cleaned both door gaskets and tried to reseat the inside door panel, to no avail. There appears to be a way to adjust the door travel (the door sags almost completely to the floor when opened), but I have yet to


... Dishwashers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

How to install a gasket on a kenmore dishwasher. I have a Kenmore dishwasher and have put the gasket around the door but there's extra pieces on both ends and can't figure out where to attach them on the underside of the door.


... Kenmore Dishwashers

My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area.


Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub c ... Kenmore Dishwashers

Hotpoint dishwasher HDA467-02 AD leaks suds/some water at the bottom of the door ONLY during the wash cycle. There is no leaking during the rinse cycle. Have replaced the bottom flange gasket (Part WD8X5100). The leaking stopped for awhile then started again. Float switch moves freely. Any ideas?


Tilt dw back ... Hotpoint 24 in. HDA2000Z Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2524 seconds