Having problems with your Frigidaire Dishwashers ?

I opened my Frigidaire Galaxy dishwasher and a black rubber like liner I believe came out and 2 plastic tabs came off at the base. I believe it goes around the opening and the tabs held the bottom of it in on both sides of the door. What do I do?


Answers :

Today is the 15th and my dishwasher did the exact same thing.
I am not sure how the plastic tabs com in to play though. Any help would be greatly appreciated.
Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I opened my Frigidaire Galaxy dishwasher and a black rubber like liner I believe came out and 2 plastic tabs came off at the base. I believe it goes around the opening and the tabs held the bottom of it in on both sides of the door. What do I do?


Today is the 15th and my dishwasher did the exact same thing.I am not sure how the plastic tabs com in to play though. Any help would be greatly appreciated. ... Frigidaire Dishwashers

The spring came off the door. how do you put it back on it was on the side of the dishwasher.when you open it just flops down find the spring on the floor.do you have picture of where it goes


Remove the bottom toekick panel from the front of the dishwasher.Look just inside and you will see spring mounting holes on the bottom support frame.The spring goes from a hole to the hole in the lower door hinge.If I had a model nu ... Maytag Dishwashers

My bosch dishwasher's (model she45m) front control panel broke. When opening the door, some plastic broke and the front control panel cover came loose. I believe the latch is preventing the plas


... Bosch SHE45M06UC Built-in Dishwasher

Door mechanism door has 2 springs on each side, on the right the spring works on its own. But come to the left side and it has a long belt type piece of metal,the spring and a hook type piece that makes up how the door opens and closes.this left side has come apart and dont know how it goes together,therefore the door just drops very sharply to the dismay of my partner.plz reply to [email protected]


Wind metal strap around plastic bush and hook above hinge ... Candy 24 in. CD622 Free-standing Dishwasher

I believe there are counter weights on the main door that allow you to open the door a few inches. Mine will only open the the full [down] open position. What typically goes wrong and how do I fix it? Also there is a streak of sopa leading from the rinse aid fill location. Where do I look to find parts. One of the plastic spacers on the handle broke.


Most of my exprience has been that there is a pully/spring arrangement for the door tension. You'll have to pull your D/W out far enough to see and adjust.\015\012Regards, --W/D-- ... LG Dishwashers

The door spring must of came loose or broke off.The door falls open if you don't hold it as you open it. Before I start dismantling the dishwasher to repair this is it inside the door or on the side of the dishwasher.


You can probably change that from the underside Dave. But you may need to pull the unit out. It should be exposed from the side ... Jenn-Air JDB6510 Built-in Dishwasher

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

The door wont stay shut on frigidaire 4300. I have cleaned all around including gasket. Halfway through the wash cycle, cycle stops and we get CL code for open door. If we push on door, it goes for another few minutes.


Something is wrong with the door latch. Replace or make adjustment. ... Frigidaire Dishwashers

I have a KitchenAid but model # KUDI24SEWH1. Can not find it on your list although another model without the last letters 'WH1' is on it. Anyway, my nephew ordered the parts he said needed to be replaced. One was the top water feed tube and bearing which he had no problem replacing when the part came in. But, he is having a very difficult time opening up the front door to replace the soap dispenser. Removed the 6 screw (three on each side) and the two at the top of the door but that is as far


You don't Use the WH2 just the first 6 letters and numbers.\015\012Jim ... KitchenAid KUDI24SE Built-in Dishwasher

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a du1145xtpq7 whirlpool dishwasher. Out of the blue it quit working completely. The sensing and washing lights light up, but when it goes to the next step of just washing nothing happens. The soap dispenser door opens and there is water in the bottom of the dishwasher. It wasn't making any irregular noises, unless I'm just used to them since it came with the house. Any advice you have would be appreciated. Thanks.


... Whirlpool Dishwashers

Have a 4 year old Kenmore Dishwasher Model # 74382. No problems at all until last week I went to start it and it would not turn on. Lights on the control panel were on with exception to the start light. I opened and shut the door to make sure it clicked and pressed the start button again and nothing. I tapped around the panel with the side of my fist and pressed it again and it began working. Well today different story I went to start it and it did the same thing. I tapped all over front of the


The problem is more likely the door switch is failing or out of adjustment/loose. You will need to remove the door panel. This is easy to do. There is a video at ... Kenmore 24 in. 74382 / 74384 / 74389 Built-in Dishwasher

We have a MDB4651AWW dishwasher. It is very loud, we have the bottom front panel that seals the dishwasher at the floor but cannot figure out how to install it. One way it does not fit, the other way it won't let the door open and close properly. The noise is terrible and it has been that way for three years. We don't believe there is anything wrong with the dishwasher, figure the bottom panel will deaden the sound. can you show us how it goes?


... Maytag Dishwashers

Bosch sgs43eo2gb dishwasher. wash programme completes, water drains out, but machine goes on draining, forever, stuck at around 50 minutes on the facia clock. there is no leak on the machine and everything else has been cleaned and operates perfectly. ie,fills correctly,heats correctly and drains fully but won"t stop draining & refill. Cancel programme and reset and it works perfectly until end of wash cycle again, when it continues to drain even with the door open. There is no leak in the machi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. Please once again check that the hoses are not kinked or drain pump and filter ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

We have a Hobart dish washer in our bar area and when it sits over night there is a pool of water on the floor in the morning. When we open the door and look at the upper right corner in the rear of the machine we have a steady flow of water running down the rear wall. When looking at thge machine where the black 1 inch water hose comes up from the floor there is a plastic T in the line with an electric wire the goes into the side of the T. I am guessing tha that is a sensor valve that is suppos


The model is most likley a lx18,lx30,lx40.The fill solenoid valve is stuck open.Remove the 2 screws on the bottom front where the pressure gauge is.Turn the circuit breaker off.When you remove the cover you will see a bronze valve with a red hose goi ... Hobart Dishwashers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

I have a Zanussi ZSF 2420. Every other wash or so the door for the powder does not open. If I actually open the dishwasher to check, sometimes it opens then and the washing powder tab falls out. Sometimes I open the machine and the door is open, but the powder tab has not fallen into the machine. Any solutions to this?


... Zanussi 24 in. ZSF6120 Free-standing Dishwasher

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

I have a mitsubishi cp 9800 dw a erra that work great a error came up that stated after fixing error open and close door. I tryed to open door and it won't open. How can i get the door to open?


... Dishwashers

Opened door and unit did not have electrical power (lights did not come on either unit). Called serviceman. He stated there was no electricity to unit(s). Called electrican. He stated wiring to the dishwasher had power. Called serviceman again. He came out and dishwasher worked. He did nothing to it. I opened the door and the lights(buttons) came on. Unit worked for a few days and this morning, there was again, no power to the unit. What is likely wrong with this dishwasher?


... Fisher DD603B / DD603W / DD603H Dishwasher

The door handle is broken which enables the opening of the door. Therefor we can't open the door and need to replace the handle but dont know how . The handle is situated inside the door and there are no screws around it to to take it apart. It is an Indiset DG5000 model. There are screws at the edges of the door.


I had a similar problem with a similar model.\015\012Insert a fine screwdriver into the small space immediately abive the handle. Press the inside end down firmly and the lock should release.\015\012I ran mine for about 3 weeks, this wa ... Dishwashers

Short in door,touch control all light up when door is partially open,but goes out when door is closed and unit will not work. kitchenaid dishwasher.when door is open all lights are on for the cycle you press,but if you close the door the lights go out and dishwasher will not work


You have a broken wire in the harness that comes up through the door. It will be found by carefully moving individual wires till the symptom is duplicated. Not an easy thing when all the wires are tied together and moving one moves several. Been ther ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Granddughter stood on dishwasher door and now it goes down too far when opening. Spring assembly (pulley type) is FINE...but door goes so far down bottom shelf nearly breaks dishes when pulling out


This happens when people leave the door down, I've seen it many, many times, sometimes the door/hinge assembly can be replaced or even bent back, sometimes it totals out the unit...Good luck !\015\012\015\012RMK...\015\012Retired GE ... Dishwashers

Frigidaire model F71C12PHS0 is not washing, it goes through the cycle and when the door is opened the soap container is open with soap still in it. We have run it with the door open to see if it is spraying and it is. The heat is working because when we open it at the end of cycle it is hot. Yet soap is still there and dishes are not clean. Thanks to anyone who can help me trouble shoot this.


... Frigidaire 18 in. FDR252RB Built-in Dishwasher

Hi _ We have a Stoves DW616 dishwasher which has started leaking water on filling from around the front door. The BGas engineer replaced the seals around the door with those from a Hygena which he said were the same and it worked fine for a few days and then a further deluge. He has now said there is a seal at the base of the door (just about invisible) and although he got a further Hygena seal this would not fit and he says that as it's obsolete the machine should be written off. Before I 'bin


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1280 seconds