Having problems with your Frigidaire Dishwashers ?

I have a Ultra Quiet III dishwasher from Frigidaire. As of the last two washes/cycles it isn't draining. This all happened last night didn't have a chance get to deep into it but was wondering if there is an acutal point I need to focus on?


Answers :

Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Ultra Quiet III dishwasher from Frigidaire. As of the last two washes/cycles it isn't draining. This all happened last night didn't have a chance get to deep into it but was wondering if there is an acutal point I need to focus on?


... Frigidaire Dishwashers

I just bought a used Kenmore standalone dishwasher and ran it for the first time. The dishes on the top did not get clean and the soap did not come out of the closed soup dish. at one point I took a shower and was wondering if that might have influenced the water pressure enough to cause the problem. Is the soap supposed to open during the wash and could the poor water pressure prevent the top shelf from getting properly washed?


The inlet filter is probably clogged. Try letting it fill up. Open the door to stop it right after it starts to wash Pour a gallon or two of hot water in and see it it works better Stop and do this everytime it goes to fill up. If the door opens ... Dishwashers

Within the last month our GU1200 is noisy and not getting the dishes clean....I did pull out some melted clogged debrise from the "dish module". WOndering if something else is still in side? and how do I dismantle the lower spray arm to get inside and see?


THERE SHOULD BE SOMETHING HOLDING IT DOWN, JUST BE SURE THAT YOU REMEMBER THE SEQUENCE OF PARTS. THE MELTED PARTS ARE FROM THE DRY CYCLE WITH PLASTIC LAYING ON THE ELEMENT. SOMETIMES THERE IS A PLASTIC THREADED PIECE OTHER TIMES IT IS A METAL SCREW ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

Cleaning My dishwasher always leaves behind these brown small peices of crime. I use about 1 tsp of dry poweder (the repair told me to last year) and that helped with all the streaks on the dishes. I clean the traps often, clean off my dishes to the point as I might as well just do them by hand, and still I get these food particles or whatever it is. We have a good working water softner. I get so frustrated and it seems like such a waste of time. Any suggestions? Teree


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

Miele Dishwasher G643SCVi- Get a whistling sound when the dishwasher starts. Lasts for 20 seconds, stops, and continues again for 20 seconds. It does this 3 or 4 times and then it is normal. I have not done anything at this point to fix the problem.


... Miele Dishwashers

My Whirlpool Gold dishwasher has been wonderful until recently. In the last 2-3 weeks, the top rack of dishes does NOT get clean - AT ALL. It appears that the spray arm is not moving, or at least not moving much. What can I do myself to check this out and possibly take things apart to see if something is clogged?


Take a tork #20 screwdriver and remove the screen go all the way to the choper and make sure its not broken on clogged. ... Dishwashers

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

This is the worst dishwasher I have ever owned and I have owned a dishwasher for the past 50 years. The loading is absolutely the worst. Washing? Lousy. I really can not say a good thing about it. The last two dishwashers I owned were Kitchen-aids. They lasted 20 years each and the loading was wonderful. The rinse hold was wonderful. Cleaning was wonderful. This Bosch is absolutely awful.


Yes, it would be a logical piece of advice if this individual would use his nouse and mention a model!!!! ... Bosch Dishwashers

GE 18" dishwasher getting VERY loud. Well over 100db. Is this a sign it is dying or can I get it fixed? It has gotten louder in the last year. It still washes about the same but sounds as if it is on its last legs. Is this something you are aware of and is a serviceable issue / parts or is it fatal?


May not be fatal. Could just need a new motor. ... Dishwashers

Blocked Rotors I often get little pieces of rice in my rotor arms and am wondering whether my filter may have a screen missing. At the bottom end of the removable tubular filter screen there is no mesh disc, and I was wondering whether there should be one there. If so how do I get one? Cheers Jim


Hello jameso1WelconeYou said, I often get little pieces of rice in my rotor arms and am wondering\015\012whether my filter may have a screen missing. At the bottom end of the\015\012removable tubular filter screen there is no mesh d ... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

We have run our dish washer several times, however, the dishes are not getting cleaned. We first ran it on "normal wash." The second and third time we ran it on "pots and pans." Not only are the dishes not getting cleaned, but the soap is hardly getting dissolved. We use liquid dish soap too. I noticed this last time, at the end of the wash, the soap was getting built up on the front-right (when facing the machine) and had turned into a solid clump; almost like plaster. I don't have a manual so


First idea goto your local home depot they make a product called AFFRESH for front load washing machines and dishwashers run this tablet inside your dishwasher with no dishes on the inside on the hotest setting this usually takes out all build up wit ... Dishwashers

Have spent $300 in the last week on Haier HDW101ss repairs. It still isnt fixed. The repair guy 'thinks' it is now a faulty timer. The unit hangs at certain points in the cycle. At these points the timer (ticking) noise stops but the machine carries on washing. It will hang at this point indefinately. I have taken the timer out, and it looks brand new (the unit is only 4yr old). Any advise, does this sound like a timer issue, or could it be something else? Where can i source a cheap (2nd hand)


... Haier Dishwashers

My unit used to send steam out of the top but no longer gets hot. I'm sure the coil should be replaced. This unit was pricey and is used every 7-10 days over the last 14 or so months. My last unit lasted 15 years. How difficult is it to change the heating coil? How much is the suggested retail price?


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The Heating Element not W ... Whirlpool GU2400XTP Built-in Dishwasher

My dishwasher is leaking from underneath, front left as you look at it. If i go underneath it, there appears to be a seal on the outside (it does not appear to be the one that runs along the bottom of the inside of the dishwasher) that has come away at one point. Do you know a) how to get the front panel off (the bit that makes it look built in),b) how can i get another one of these seals. I assume if i get one we can just fit it into place. Many thanks, Robyn J


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012p80897 ... Neff 24 in. S5453X1 Built-in Dishwasher

I recently bought a condo with Fridgidaire appliances. The previous owners did not leave the manuals. (which I was wondering how I could get copies) My problem is with my dishwasher Model# FDB700BFSO, Serial#TH73478655, I like to use the short wash, so I turn the dial to that section, but to get on the right spot for it to fill is very difficult. I find I'm going past and around, trying very slowly to get it just right with the correct setting. Hope this isn't too confusing. All I want to d


... Electrolux Dishwashers

Soap gets stuck inside the soap dispenser, so that at the end of the cycle, there is a clump of soap still in the dispenser. We have also noticed that the rubber seals at the back of the dishwasher (the ones that the spin arms plug in to) are getting worn. Will get new gaskets this week, but wondered if the soap dispenser isn't another problem.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

I have an aeg favorit4001ovi dishwasher and the beeping alarm keeps going off not long after cycle starts it doesn't even get to the point where the tab gets used. this happens alot have had engineer out and suggested that the sprinkler jets are blocked. have checked and checked these, nothing in them. cannot get it to complete a wash at moment . only just over a year old!


... AEG Dishwashers

No water my kenmore dishwasher is not getting any water. when we try to select normal wash or water miser cycle, the motor turns on, I can tell water is getting to the dishwasher because i can hear it running under the sink and feel it in the flexpipe that feeds the dishwasher. It is not getting anything inside though. Just wondering if you have any ideas. Thanks


SOUND LIKE YOU HAVE EITHER A FLOAT THAT IS STINKING OR A WATER INLET VAVLE THAT HAS FAILED. THE FOAT IS THE LITTLE MUSHROOM LIKE DOME WHICH IS PLACED AT THE FRONT LEFT SIDE UNDERNEATH THE BOTTOM RACK PULL UP GENTLY ON THE FLOAT UNTIL U HEAR A CLICK ... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

I have a 2006 tall tub kitchenaid dishwasher which over the last 6 months has been leaving residue on the dishes, esp. glasses. We have had it serviced twice. Last Wed was the last time and he found food plugging the screen, but we are still getting dishes with residue. Any suggestions?


Try changing the type and brand of detergent. We had similar problems with a Maytag dishwasher which was solved by the above. The glasses in particular seemed to have a sand-like texture in the debris, yet drinking water showed no such problem. Hope ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

My dishwasher is not draining. I tried to take apart inside and get to the drain, but was unable to get beyond a certain point. Could not get down to the drain.


Hello, the blockage is most likely in the check valve, remove the kick plate under the door and then remove the drain pipe. once the drain pipe is removed unscrew the part it was attached to counter clockwise. now check to see that the check valve fl ... Kenmore Dishwashers

The power washer worked fine last year but I can't get it started


Gas over 30 days old should never be used in any small gas engine. Old gas will not kill it forever but the carb and tank need to be drained and cleaned. The easiest way to do that is usually by removal. Also try to remove the spark plug and clean it ... Briggs & Stratton Pressure Washers

How do you get the last piece covering the rip cord spool off?


It is not a rip cord, please do not use as a parachute, It is a pull cord. My quess would be the remaining part is snapped into place. Trying pushing the side walls towards the center or away. ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Smeg Dishwasher Hello I have a smeg dishwasher - built in, push button. It has stopped working - the program start and you hear it drain but that's as far as it gets, no water appears to be getting in. A couple of times the last 2 program buttons flash or the rinse light is on when we open it. let me know if you have any thoughts on this - I'd really appreciate it. thanks Diane


Replace the timer/control board ... Dishwashers

We came home from holidays a few years ago and the dishwasher (Westinghouse 905) just didn't turn on. We've tried it repeatedly since then and are unable to get it to turn on. The power point works for other appliances. Should we replace it or could someone fix it? And is it a plumber or electrician you get to fix dishwashers?


Appliances that sit without use, usually have more problems than just the original problem.\015\012\015\012In your case I would first check the power conection on the dishwasher. located under the machine\015\012\015\012If thi ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1109 seconds