Having problems with your Frigidaire Dishwashers ?

Frigidaire dw m# fdr252rbb1 stalls in the middle of the light wash cycle and just keeps washing and won't advance. I replaced the timer and it does the same exact thing even without the knob attached


Answers :

Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Frigidaire dw m# fdr252rbb1 stalls in the middle of the light wash cycle and just keeps washing and won't advance. I replaced the timer and it does the same exact thing even without the knob attached


... Frigidaire Dishwashers

On fitting a replacement program knob. A black wire to the indictor lamp became disconnected. Which connection on the timer board shoud it be attached. Zanussi Aquasave DW 924 Product No 911814018 Type 91181-2a Ser No 44300894


I have reviewed your problem and have the fallowing for you to access.\015\012The indicator lamp is probably a LED. \015\012If you have a volt meter, take a voltage reading at the other connection point of the le ... Dishwashers

How do i replace the timer knob on my simpson eziset 52b890. The handle part of the knob on our dishwasher has snaped off .


... Dishwashers

We need to replace the little rubber latch that keeps the dispenser door closed on our Kitchenaid dishwasher. Do we need to replace the whole detergent dispencing unit or just the latch. And if we do have to replace the whole thing, do you know how it attaches and have advice for that repair? Type is Kitchenaid KUDS01IJ


Check here ... KitchenAid Dishwashers

I have a dish washer matsui model mf2w/a and the timer seems to be sticking causing the machine not to wash correctly, the machine carries on doing the same thing until i manually move the timer control knob on to the next setting , do you think the timer isfaulty or another component .


If your Matsui MF2W/A timer stops earlier in its cycle, turn off the water and unplug the machine. Pull it out and put it on its back. Remove the base panel. Remove the anti-flooding interlock. Unplug the two cables feeding the heater element ... Dishwashers

I have an older Maytag model #WU482. For some reason it will not drain and will only run using the economy mode. I can hear the timer ticking at all other cycles and it does click between cycles. I recently replaced the drain float and the machine had been working fine after. The motor is working and the belt is good. I think the kids were playing with the timer knob. Could this cause a problem with the timer motor? Or does this sound more like a pump out issue, impeller? I'm thinking its


First,inspect the drain float. Make sure it rides on the micro switch correctly or it will not take on water.Check the float micro switch for continuity. Check for power at the water valve when it calls for water. Remove the wire harness from the tim ... Maytag 24 in. PDB1420 Built-in Dishwasher

Karcher 2.56 keeps pulsing on and off whenever high pressure nozzle is attached. I have tried different nozzles and same thing is happening. when i press the lance without any attachment it works fine


Make sure you have bled all air from the system. Also make sure you have sufficient water supply; if house water pressure is too low or if your hose is too long or doesn't allow full flow, you may not be getting enough water to the unit. ... Karcher Pressure Washers

Replace timer maytag la710 - Maytag Washer Timer 205637 2-05637 W/ Knob Assembly Tested & Works


... Maytag Washer Timer 205637 2-05637 W/ Knob Assembly Tested & Works

Low Pressure with no hose attached, pressure is good, attach hose without wand and pressure drops 50%. Have had pump apart 10 times, have checked bypass valve, have even removed bypass and filled passage way so water could not bypass wihout any change. Am down to thinking pump casting is cracked allowing bypassing to happen. Does each of the three piston chambers have a check valve so one piston is not pumping back into another piston chamber?


I worked at a tool rental while attending college and had the opportunity to work on a variety of pressure washers, however, they were of the commercial type. Commercial washers are slightly different in that they usually have seperated components fo ... Karcher 2500 PSI Pressure Washer

OUR LG MODEL#6810BB WONT DO ANYTHING BUT TURN ON....FIRST, PROBLEM WAS THE DISHES WOULDNT DRY...SO THE HEATER COIL WAS REPLACED....AND THEN 2ND THE MOTOR WAS REPLACED....AND NOW IT WONT EVEN DO A THING...OTHER THAN TURN ON...


HOW OLD IS YOUR DISHWASHER? ... LG LDF6810 Built-in Dishwasher

I have error E:15 with a flashing water tap sign - I've tried the following: a) Clean filter at the bottom - now flushes out with b) remove power - return power c) remove and clean fiter for incoming water at a sort of valve Nothing! when I attach power it continues to flush out (even without water) if I put water in it evacuates without problems. The tap does supply water I've check and with more than sufficent flow and pressure! ...Help .....Thanks Gary


Hello Gary,\015\012\015\012You didn't specify the brand or model number of the dishwasher, but I suspect it's a Bosch, in which case the E:15 error with the flashing tap sign and the drain pump running continuously means the anti-flood pr ... Dishwashers

I just replaced the heating element and it was working fine for about a week. Yesterday, the soak and scour light (which I've never even used) started blinking constantly. The dishwasher, Model GU2400XTPB3, won't let me even enter the reset code. I need to know if it's something we can fix without paying for another part/service by finding a manual. Thank you.


... Whirlpool Dishwashers

My dishwasher has power but does not turn on to any cycle when the control knob is in that position. It was adding water and starting to wash, but not going through the whole cycle and not rinsing and drying. Now it has water stuck in it. I hear sounds underneath like it's trying to go to the next cycle (a clicking noise), but then it doesn't. I put a new timer in it, but it was doing the same thing before that.


Hi just check out the following solutions that i provide u right now.. it will be a perfect fix for ur problem..\015\012\015\012\015\012\015\012\015\012\015\012first of all make this check\015\012 \015\012Door switch\015\012\015\012\015\ ... Dishwashers

Dispenses all soap without help. just keeps running until all soap goes into sink... I originally thought the batteries were old so replaced, refilled with soap and same thing happened. Help


... Simplehuman Dishwashers

My daughter accidentally turned on our GE GLDA690 dishwasher. I can't seem to cancel it out without actually starting the cycle. I opened the door before the cycle started but now it is sitting there beeping. The obvious thing is to load it with dishes and run it. But it is just the two of us and we don't really have a load full. Owner's manual is no help. Even turning off the circuit breaker will not stop this infernal beeping. How do I cancel it? Why isn't there a cancel button?


... GE GLDA690MWW / GLDA690MBB Built-in Dishwasher

My G865 Miele dishwasher goes partway through the cycle then gets hung up and runs without advancing. We left it running when we left for vacation and it was still running when we came back. I'm assuming it is the timer mechanism. The dishwasher is ten years old but has been run only every other day or so. Is it worth fixing or is it better to replace?


It will cost alot to get repaired,10 years old you got money out of this one. ... Miele 24 in. G865 Built-in Dishwasher

Whirlpool DU900,09,10,11,15,20,30,DUL100 Hi, I'm not sure what exact model mine is, but those are the models listed on the manual. I opened the washer and the whole upper part of the wash tower was laying on the dishes! I took everything out, and began trying to think logically, and re-assemble the thing; nothing appears to be broken. page 17 of the manual is the only place that even shows this set up, but it's just a part description. As I am looking at the picture, I realize that the spray tow


... Whirlpool 24 in. DU920PW Built-In Dishwasher

Kenmore QuietGuard I'm not exactly sure how it happened but somehow the piece that keeps the round spinny thing in place broke off. The dishwasher still works but it doesn't clean or rinse as well as it did. Do I need to call Sears and have them come out to replace the bolt or is there something that I can rig up from the local hardware store.


If u can get orginal bolt cheak locak store applices see if they have any in back room then u could if u cant get right bolt have them get u one ok thx for using fix ya ... Kenmore 24 in. 15142 Built-in Dishwasher

We had a power failure so the unit was flashing a PF error message. I turned the circuit breaker on and off and the thing just stopped- no more flashing lights...no there there. Is there a reset function and where would that be? Or is it truly dead? I have also been looking for two days for a replacement. As an expert, do you have information on reliability on newer models? The best rated I've researched even through CR are both loved and hated by consumers. Traditionally, repairmen ha


Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing. Now th ... Frigidaire Dishwashers

No power going to the water valve or the pump - the only thing working is the motor did replace the timer but didnot solve the problem checked all relays switches what wrong


The water-inlet valve lets water enter the machine. First Check to see if the valve is getting water. Make sure it's not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you g ... GE Dishwashers

I have purchased a repalcement detergent dispenser-assembly and do not know how to take old one out and relpace with new part. The new part has a face plate that snaps on to the screw mounted base plate assembly which attaches to the door. I need to know how to remove the old dispenser and install the new dispenser without breaking parts and scratching the door. Is there a schematic or exploded repair view I can check out or even written directions?


Hello\015\012& Welcome to FixYa\015\012\015\012To replace the detergent\015\012dispenser you can check this video. The video gives you step by step\015\012instructions:\015\012\015 ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

NEFF S4443 top spray bar not rotating, no water. Bottom spray bar rotates and sprays water. Checked and replaced fine/course mesh filters. Will pump to empty and refill on pre-wash (rinse). Seems the pump may have two outlets one feeding the bottom spay bar (nearest from of machine) and one just behind which feeds the upper spray bar. Running without spar bars attached (including mechanism feeding to bar, water is only being forced out of the from outlet. Any ideas before I start taking it apart


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

The timer on my Kenmore model # 363.14252100 broke and I am replacing it. Is there any special way to detach the old timer from the wiring. It seems stuck on.


... Kenmore Dishwashers

I am working on a d8 dishwasher and found the cycle timer (49 sec/ 11 sec) faulty. Ordered a replacement timer from russell food equipment. The new timer is different mounting and timer motor specs. Can you tell me if this timer is the proper replacement. New part number cpn14480


... Dishwashers

GSD500X-73WB Dishwasher: Automatic timer has stopped working. It is still possible, though, to work the dishwasher manually by turning the dial. How much will it cost to replace the timer? I guess that it is the whole control unit including the timer that would need replacing.


... GE 24 in. GSD500X Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1069 seconds