Having problems with your Frigidaire Dishwashers ?

My frigidaire dishwasher will not shut off the water being pumped into the dishwasher. It just keeps pumping in even after the required fill time and will not shut off, eventually I have to turn off the shut off so that it doesn't overflow. The float is working ok. Is this a sensor,circuit board?


Answers :

Repair Help & Product Troubleshooting for Frigidaire Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My frigidaire dishwasher will not shut off the water being pumped into the dishwasher. It just keeps pumping in even after the required fill time and will not shut off, eventually I have to turn off the shut off so that it doesn't overflow. The float is working ok. Is this a sensor,circuit board?


... Frigidaire Dishwashers

I have a Gallery 900 series GLDB958AS dishwasher. The cycle status lights (just right of the "time remaining" status window) continually blink. None of the buttons on the front panel work and every 10 minutes or so the water pump starts up for about a minute then shuts off. No water enters the dishwasher. I tried turning the power off then on but there is no change. Every so often a random cycle light will blink or light up for a minute, then turns off.


It seems that there is error on the program controller unit. All you need to check if that if there is moisture build up on the panels thus causing the programs to go harewire.\015\012So remove the panel and disconnect the wires, check all lead ... Frigidaire 24 in. GLDB958A Energy Star® Built-in Dishwasher

One day the diswasher was working fine...the next time it turned it on it ran for about 3 min. then shut off and seemed to have no power. I checked the breaker...it was fine. A few days went by and all of a sudden the lights were blinking on the panel. So I pushed the cancel drain button. The water drained out and I then proceeded to load the dishwasher and turn it on again thinking it was just a fluke when it shut off earlier in the week. It did the same thing...ran for about 3 min and then shu


... Whirlpool GU2200XTSS Built-in Dishwasher

Hobart lx18h Our commercial Hobart dishwaser stops working after running a few cycles. After pressing start the LED display will continually blink and nothing will happen. We'll turn it off and on again a few times to reset it and it will start up again eventually. We've had an appliance guy look at it multiple times. He's replaced a part or two for it but the problem continues and he isn't much help. Anyone else had any similar issues with this model of dishwasher?


... Dishwashers

We have a Bosch dishwasher. The manual says for models SHV46C13, SHX43C0 so I guess it is one of those. It stopped working and when I opened it there was a bunch of cloudy soapy water on the bottom. The power was not coming on at that point. I have noticed that lately when I go to push the on button, the light will go on and when I shut it it doesn't start. After a couple times of turning it off and on it will run normally. This has only happened a couple times though....


... Bosch Dishwashers

I've had a Miele G892 SCU PLUS dishwasher for a long time. Today a problem started that results in a flooded floor. Water keeps flowing into the dishwasher - even when the unit is turned off. It seeps in very slowly, but within15 minutes there is enough to overflow & flood the floor. My guess is that there must be some kind of sensor that isn't working, or the coresponding mechanical switch that shuts off the water is worn or slightly stuck open a bit? Anything I can do / check, short of the re


... Miele Touchtronic G892 Built-in Dishwasher

Dacor MDV24 dishwasher. I press cancel to turn it off and it works but after approx 10 seconds the start and normal button comes back on and beeps. I tried shutting the breaker and holding the cancel button for a long time but it still always comes back on. Got any suggestions?Motherboard or faulty buttons?


Hello &\015\012Welcome to FixYa\015\012\015\012If you have\015\012also checked the door lock-latch assembly and that is fine then yes it is the\015\012control board that is bad and needs replacement. Please get back to ... Dacor Millenia MDV24 Built-in Dishwasher

Electrolux ESL63010 integrated dishwasher 10 months old- works for a few seconds, then stops and beeps continously. & the End indicator light flashes once. I turn it off, cancel programme, set it again, shut the door -it starts and goes on to complete the programme and washes the dishes perfectly. It has been doing this 'performance' for a week now -every time I use it- can you shed any light please


... Electrolux Dishwashers

Start button flashes green but does not turn on. cancel button works for 2 minutes ( sounds like it is trying to drain) then shuts off. still can run the dishwasher. if I press any other button, such as pots and pans, the "time remaining" just has 2 lines. then it just repeats as above.


Most likely you have answered your question already... the drain pump is either obstructed or has failed... these units these days have plastic impellers inside and often go bad causing the drain motor to go bad... if the unit does not drain it will ... Whirlpool Dishwashers

My De Dietrich dishwasher turns on but then turns off after a couple of minutes with no water entering dishwasher. I found some instructions and turned on and off 5 times (and unplugged). This worked once and full cycle ran but not the second time. Not sure if it is worth paying 165 call out charge or getting new machine as 7 years old


... De Dietrich 23 in. DVF110J Built-in Dishwasher

I have a whirlpool dishwasher DU915WKSO: when I turn the dishwasher on, the heating element comes on but no water comes into the unit. I recently replaced the garbage disposal and th dishwasher worked fine for a time or two. Since then I have only been able to get water in it once. Like I said, the heating element works but no water in the dishwasher. Thanks for any help.


... Whirlpool DU1055XTS Built-in Dishwasher

Whirlpool dishwasher model #DU1100XTPSB wont work and the clean button flashes 7 times and pauses, any idea? I shut the power off to it at the breaker to see if it would reset, didnt work


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

My Hoover dishwasher HFI 3015 is not working. When you turn it on, the P1 and 'out of salt' light is flashing and bleeping constantly. I believe that it may have run out of salt yesterday, but I have filled it this morning and there is plenty of Dishwasher salt in the compartment now and it is overflowing with water. I have tried turning the machine on and off, but each time I turn it on I get this bleeping and flashing and can't stop it. Any ideas?


... Hoover Dishwashers

Our Frigidaire Dishwasher buttons stopped working. If we push normal cycle it will not select as well as other cycles. The last time it happened the maintenance guy came and turned it on and off and it started working again. That didn't work this time. We still can't select some of the wash buttons


You will have to replace that selector switchhttp://tclaundryrepair.com/ ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Neff dishwasher i have a slimline dishwasher. when turned on and door shut it sounds to be working but no water is getting in to clean . water valve is turned on .any ideas of what could be the problem?


Hi cewins,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: you have a slimline dishwasher. when turned on and door shut it sounds to be working but no water is getting in to clean . water valve ... Neff Dishwashers

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

Just had a Bosch dishwasher installed in my new kitchen. The plumber who installed it ran it and it worked. Now we cannot get it to run. We have tried everything. Restarted several times, turned the circuit breaker off and on, changed the cycle and nothing works. The light comes on but it does not get water or run. What are we doing wrong. The dishwasher is brand new out of box but we bought it 4 years ago and remodeling was delayed. Model #SHU5314UC/U06 FD#8001


Test the door switch. It can be faulty or misaligned. You can also check the back of the unit and/or remove the rear panel and take a look at the thermal fuse. It may be bad not allowing enough current flow to operate the machine. ... Bosch SHU5316UC Dishwasher

I have a Miele Dishwasher 2430 Sci. It's been not used for 5 months and when I returned it worked fine for several times (at least 6). NOW the intake/drain light keeps blinking. I have already cleaned out the drain and replaced it properly (there was nothing in there and it was clean). No water is coming into the dishwasher?however I know that the water hook-up is on (the first thing I checked). I turned the water on and off several times and AM SURE it's on now. What else could be


The usual course of events is to check and clean the filter, check and clean the water pump and well, check and clean the waste pipe and any connection to a sink or waste disposal system, then check the inlet warer pressure, then the machine level / ... Miele G2430SCi Dishwasher

Hi. I have an innovation Fagor dishwasher. worked perfectly the first time. Next to the display screen is a place "op" and "fin". when i turned it on the second time the "op" light blinks continiously and no other button such is the operate button works. thanks


... Fagor LFA-013 Stainless Steel Built-in Dishwasher

I have a fridgidair dishwasher model FDB4315LFBO and none of the buttons are working this is the second time this happened and last time i removed the cap for the rinse aid and heard a rush of air then everything started working. I already turned off the power to reset things and the PF light flashed until i opened the door then it went back to everything being dead.


Sounds like something has burnt in the main powerboard. ... Dishwashers

Our dishwasher won't start (model number 665.16049401). We had a similar problem last summer and a repairman came and fixed it. The problem was that the water level had gotten too low and so the machine locked itself off. This made sense as, at the time, I remembered filling the pool, running laundry and someone taking a shower all at the same time that I turned the dishwasher on. I am guessing this is the same thing that has happened now. The repairman put in a code and the machine worked. Can


Hello,\015\012\015\012ahhhh, you're taking about the reset sequence.\015\012okey dokie :)\015\012\015\012Here it is:\015\012Push the NORMAL WASH then HEATED DRY buttons in that sequence two to three t ... Kenmore Dishwashers

Frigidaire Dishwasher won't start (lights cycle but no water/motor) Model Number: FDB1050REB2 Brand: Frigidaire Our dishwasher is 1.25 years old and already not working (grrr!). When it is turned on, the lights cycle through like a normal wash cycle, but the motor isn't engaged nor does any water cycle through. This happened about a month ago and I took everything apart to make sure all of the connections were secure and it started working again...not this time. Any ideas?


... Frigidaire Dishwashers

Just had a Bosch dishwasher installed in my new kitchen. The plumber who installed it ran it and it worked. Now we cannot get it to run. We have tried everything. Restarted several times, turned the circuit breaker off and on, changed the cycle and nothing works. The light comes on but it does not get water or run. What are we doing wrong. The dishwasher is brand new out of box but we bought it 4 years ago and remodeling was delayed.


Do you have the manual?What is the exact model #?Thanks~! ... Dishwashers

I was told by a repairman that the seals around the motor swelled because I had gone on vacation for two weeks and not used the dishwasher. He charged $85 to turn the motor manually and restart the dishwasher. The dishwasher is 5 years old. Does this mean I can never leave for two weeks at a time and come home to a working dishwasher?


No. The unit most likely had some debris stuck in the macerator. The seals are water lubricated and its possible that some detergent dried between the seals. Detergent is a lot like glue when it dries. You are probably using the factory recommend ... GE Dishwashers

We have started experiencing a problem with our Kenmore Elite 655.15982 dishwasher. Each time we close the door, NoHeatDry lid would go on immediately. It would stay as is of would go flashing. If you touch any button, LockOn lid would go on. Then no other buttons would respond. And often both NoHeatDry and LockOn indicators would be flashing... We tried turning machine for an extended time on the fuse, etc. At times it would work for some time and then cycle get stuck again at the same p


These errors are due to a faulty control board and needs to be replaced. If its still underranty get it fixed before it expires as it is a costly repair to replace. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2368 seconds