Having problems with your Frigidaire FDB700BFC Built-in Dishwasher ?

Dishwasher dial sticks durring wash. Will run or hours.


Answers :

Repair Help & Product Troubleshooting for Frigidaire FDB700BFC Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher dial sticks durring wash. Will run or hours.


... Frigidaire FDB700BFC Built-in Dishwasher

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

1)My Candy DFI 50 is not washing properly, it leaves residue on the pots. 2)The programme controller on my DFI 50 seems to be sticking. Sometimes the dial doesn't move at all or takes 'hours' to run a programme. Thanks


Hi,The scum, film and white residueproblems have started since the reductionof phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your dish ... Candy DFI Plan Built-In Dishwasher

Frigidaire FDB710LCS0 Dishwasher dial seems to stick?


I had the same problem. Turn the HIGH TEMP buttons off. Simply turning them off corrected this problem for me. Mine got stuck in two places and I had to manually turn the dials or the washer would run all night. ... Dishwashers

Dishwasher stalls I have a Bosch dishwasher model # SHU4006UC/U06. The dial stops after going through one cycle and the dishwasher continues to run that cycle and will not advance unless we manually advance the dial. After advancing the dial the dishwasher will stall until we have manually advanced the dial until reaching the "9 o'clock" position. It will then continue until the dry cycle is complete. Thanks!! I have the same problem. I took out the timer control and spraid it with contact clean


If the cycle doesn't complete, check these:Water-heating cycle ... Bosch SHU4006 Dishwasher

Dishwasher stalls I have a Bosch dishwasher model # SHU4006UC/U06. The dial stops after going through one cycle and the dishwasher continues to run that cycle and will not advance unless we manually advance the dial. After advancing the dial the dishwasher will stall until we have manually advanced the dial until reaching the "9 o'clock" position. It will then continue until the dry cycle is complete. Thanks!!


The Timer might not be bad. If one of the two thermostats is bad, the Dishwasher will exibit the same symptom. The thermostats are 141 deg. F and 161 deg F.They only cost $20 each. The Control Module is close to $200. ... Bosch SHU4006 Dishwasher

Kenmore built-in Dishwasher #15149 runs for 3 hours or more


... Kenmore Dishwashers

Bosch dishwasher Dishwasher runs much longer than timer, stays at 88 minutes for an hour! When I open it and then close again, timer will say 90 minutes! It will run for hours till cycle is completed! Most of the time dishes are still wet.


Hello guest. seems you have a leak in the base. Looks as though motor is washing dishes but actually its the drain pump thats been activated which doesnt allow the timer to proceed forward. ... Bosch 24 in. SHU53 Built-in Dishwasher

Dishwasher runs several hours


OK, that several hour wash cycle seems to be very abnormal and, the only way this can happen is if the timer control mechanism is damaged. this is referred to as a Overrun error.\015\012\015\012simply replacing the timer will fix this issue. ... Frigidaire Dishwashers

I have an Inglis dishwasher.Serial number-FC3312512,Model number-IBU37002 or it could be IBU37062.I do not know how old the dishwasher is, as I justed moved in to my house this October,and the dishwasher came with the house.Last night I reset the options on the dishwasher,and had the cycle running on heavy duty.About 1 hour after the dishwasher was running this very bad smelling--like smoke- steaming odour was coming out of the door vent of the dishwasher.The smoke alarm went off in my house,and


... Dishwashers

Kenmore My dishwasher was in my home when I purchased my home. It is a Kenmore Ultra wash 2, I am not sure which settings to use for basic dishwashing. When I run it it runs for over 1 hour. I don't want it to run that long.


Make sure you run water in your sink until it is hot before you start the dishwasher. On the newer dishwashers they will fill and drain until the water is hot enough so it takes longer if it starts with cold water. Normal time for a basic wash coul ... Kenmore 15129 Built-in Dishwasher

Frigidaire FDB520RHB Dishwashers : We bought this dishwasher about 3 months ago. Today I ran the washer before I left to do errands and when I returned, I believe the washer had finished its cycle. But about an hour later, I noticed it had started up on its own? It then proceeded to run for almost 3 hours before my husband canceled the cycle. We were kind of waiting to see if it would stop on its own, which is why we let it go so long. I think it usually takes about 1 1/2-2 hours to wash. Could


Try to run the dishwasher on a short cycle like rinse and see if it finishes the cycle.It is likely the heater or hot water temperature is not reaching the desired level and this could cause the extended wash cycle. Feel water temperature ins ... Dishwashers

My dishwasher runs 2 hours as a complete cycle. I think it is never going to finish but I have not stopped it in mid cycle. Dishes are very clean but they should when it runs this long. I hear it change cycles so I know it is not stuck on 1 cycle. It also makes a lot of noise. 2 hours of noise. HELP!!! How long it it suppose to run?


That means that the machine does not detect that one condition to continue the cycle is met.Sometimes\015\012 when this happen unesperience repairers replace the timer board , an \015\012expensive part that rarely fails. The timer b ... Whirlpool DU1055XTS Built-in Dishwasher

Crosley CDC610B Freestanding dishwasher The dial hums when I try to start the dishwasher. If I open the door and bang on the inside of where the timer is a few times, then slam it shut, the dishwasher kicks in and runs the cycle normally. This has been happening the last three times I've run the machine. Any ideas? Thanks!


... Crosley CDC610 Free-standing Dishwasher

Blanco BFDW4X Dishwasher - dial will run any of 3 cycles down right side, and then click back to start position, but will not automatically run the rinse down left side of dial, have to turn the knob manually. Also looking for a manual for this.. Susan [email protected]


... Dishwashers

I have a Bosch dishwasher Model number SHU4302UC. The dishwasher takes about four hours to wash dishes. During the rinse cyle it can be running for over an hour and I will open it to look in side and find that the bottom is full of soap sudds. I believe it is taking too long to wash even though it does a good job.


Possibilities are that of an inefficient heating element ie..scaled up if hard water area especially. whilst the cycle is being completed then the components are working... so other than the element check the drainage for blockages (slow draining add ... Bosch Dishwashers

Bendix dishwasher dh090. my dishwasher keep sticking on the 3rd mark. what ever programme i put it on once it gets to the wash part it sticks and stoppes working until i start turning the dial till it gets past the wash cycle and then it finishes of the cycle


... Tricity Bendix 18 in. DH090 Free-standing Dishwasher

Frigidaire Dishwasher model # FDB635RBB0, dishwasher keeps running for hours, the dail seems to stop part way through its cycle, the heating delay light is on. I tested the heating element & electricity runs through it, could it be the thermostat.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

CI am having a problem getting our Miele G575 dishwasher to run through a wash cycle. It definitely has power, the water is on and there is no water in the bottom of the dishwasher. When you turn the dial to start a cycle, it hums but doesn't fill with water and doesn't progress through any cycle. We have tried all positions of the dial and have had no luck? Any ideas??


You said it does not progress...meaning the dial does not eventually move? it may be waiting on a water level sensor to be tripped. The dishwasher is just not filling. The water valve solenoid may be stuck or defective. or a wire may have come of ... Dishwashers

Dishwasher runs for appx 14 min & stops washing half way thru wash cycle. Timer contunies to run. No drain pump out (nothing). Let dishwasher set idle for appx 1 hour and it will re-set. Set timer forward to end of wash cycle and it will complete rinse and final rinse. Then go to dry. Timer works ok.


This sounds like something is stuck in the drain pump. You can remove the inner cover to look for obstructions. You have a dual purpose motor it does the both circulating and draining. The blockage is causing it to overheat and trip the thermal prote ... Whirlpool DU840CWD Dishwasher

E4 error light comes on, dishwasher won't run, this apparently means water is on a sensor, have removed water from collection tray in bottom, tilted machine backward to dry out sensor, left for 24 hours, machine still won't run. Currently a very small new counter top but a useless dishwasher.


The problem is related to the floater assembly inside the dishwasher. It is filling up with gunk and stop working properly. I found out the hard way after a good spill. The solution is easy but takes a bit of time.1. Unplug the power and water h ... Danby DDW497W 22 in. Countertop Dishwasher

Bosch Dishwasher I currently own a Bosch dishwasher. One of the selling points, if I'm remembering right, of the dishwasher was it was supposed to super heat the hot water that is coming in from the tap. I have 3 problems. We have to rinse the dishes by hand before putting them in the dishwasher, Otherwise they won't come out clean. The dishwasher will run for four hours sometimes longer. It doesn't seem like it is heating the water any hotter than what comes out of the tap.


Your control board is bad. ... Bosch 24 in. SHU43 Built-in Dishwasher

Kenmore 665.16529000 When we put the dial to pots and pans the diswasher fills up and cycles through, when the dials moves to normal wash, it fills up and cycles through again. When the dial gets to light wsh we can hear the motor running but nothing is happening, but the soap door opens soon after. The heating light comes on and the inside of the dishwasher gets so hot that it has melted our big plastic tumbler cups on the top rack and makes the counter top extremely hot to the touch. The dial


... Dishwashers

Dishwasher wash cycle runs 1+ hours seems to repeat


... Kenmore Dishwashers

Portable dishwasher: water will not shut off will run for over a hour


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2166 seconds