Having problems with your Frigidaire PLD4375RFC Dishwasher ?

Dish washer gets to hot in pot scrubber mode

\015 Hi I asked you about a Frigidaire dishwasher over heating. It didn't melt the plastic it distorted it so it must be heating in the dry mode to hot?\015

Answers :

Did it distort the spray arm? A lot of times if it's the spray arm that melted it's possible that it was jammed while trying to heat the water and the heat from the element would warp it.
Repair Help & Product Troubleshooting for Frigidaire PLD4375RFC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dish washer gets to hot in pot scrubber mode


Did it distort the spray arm? A lot of times if it's the spray arm that melted it's possible that it was jammed while trying to heat the water and the heat from the element would warp it. ... Frigidaire PLD4375RFC Dishwasher

Purchased in 2003. Dishes were exquisitly clean till 2008. Our water heater temp was set at 140 temp. This heater was replaced with a heater now set at 125 temp. In the past two years dishes are nowhere as clean on the the normal start setting. Should I go to the Pots and Pans start setting to get hotter water or should I turn up my water heater? All this is assuming that water is not hot enough. Does the washer heating element ever burn out?


Try turning on your water at the sink for a while on hot let it run then start the wash cycle that should help. what that will do is let the cold water run out of the pipes and therefore you will have a hot water start. ... Kenmore Dishwashers

We have run our dish washer several times, however, the dishes are not getting cleaned. We first ran it on "normal wash." The second and third time we ran it on "pots and pans." Not only are the dishes not getting cleaned, but the soap is hardly getting dissolved. We use liquid dish soap too. I noticed this last time, at the end of the wash, the soap was getting built up on the front-right (when facing the machine) and had turned into a solid clump; almost like plaster. I don't have a manual so


First idea goto your local home depot they make a product called AFFRESH for front load washing machines and dishwashers run this tablet inside your dishwasher with no dishes on the inside on the hotest setting this usually takes out all build up wit ... Dishwashers

Dishwasher I have a whirlpool dishwasher that does not appear to be getting hot water. The washer water is cold initially and only seems to get warm once the heater in the base of the machine heats it. The hot water supply line does not get hot so I presume no water is being supplied. Is the water supposed to be hot at the start. If yes could this be caused be a faulty inlet valve and if so how can I check. The dishes are dirty especially on the top rack. Thanks for your help. David


Gendos is on track with his question. I have the same dishwasher and it doesn't get enough hot water to clean the dishes and runs for hours because the heating element wasn't designed to heat water, just maintain it. The only solution we have found ... Whirlpool GU2400XTP Built-in Dishwasher

Some of the dishes on the top & bottom are not coming clean. Is there a filter that gets plugged? I am not cramming dishes in & I run the hot water to really hot before I start the washer. I also rinse the dishes before putting them in. HELP!


It sounds like water supply problem hose may not feed enought water ... Kenmore 24 in. 15079 Built-in Dishwasher

I have model GU3600XTSY2. Sometimes the pots and pans light flashes for no reason. Sometimes I can push that button and it stops. However, the cycle I select to wash the dishes is constantly interupted by the pots and pans (P&P) light flashing. If I push the P&P button, the wash cycle usually starts where it left off. Sometimes it will go back to the beginning of the cycle and begin all over again and get caught in a loop; start washer, P&P flashes, push P&P, begins cycle from beginning, P&


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

The soap dispenser opens while in cycle but it doesn't wash the dishes they come out greasy and the entire washer is dirty It does get hot but dishes come out dirty Model FP4702799 Serial KUDIO 1ELB L3


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

Water in the dish washer is not getting hot, any ideas? i do have hot water coming from the sink, but none out of the dishwater, just cold.


Hello, welcome to Fixya.\015\012\015\012The problem you're describing is unfortunately a common one with B/S/H/ built dishwasher's. That includes Bosch, Thermador, Siemens, and Gaggenau.\015\012\015\012Here`s the most likely reason why it has detecte ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Hot water water is not getting hot in the dish washer anymore. what could be the problem?


Check the machine heater element and associated parts. ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Quiet Guard Delux Model 665.13742K601 Dishes are not getting clean although some areas in the washer get cleaner than others. Detergent dispenser is not being fully cleaned and is caked with detergent after operating. In addition, the only "Cycle" light that seems to be working is the "Pots and Pans" cycle and the status lights also seem not to be functioning.


... Kenmore Dishwashers

Doesn't clean my dish washer seems to work fine but when its finished the tablet i put in the door is still in one at the bottom of the dishwasher and the dishes aren't cleaned properly. i've checked it about halfway through and the water does get hot. please help.


Is your water heater set at 120 degrees if not set it to it ... Hotpoint 23 in. BFI62 Built-in Dishwasher

NOT ENOUGH WATER FILLING UP IN WASHER. EVERYTHING ELSE WORKING BUT DISHES NOT GETTING CLEAN AS NOT ENOUGH WATER RELEASED INTO WASHER AT START. WHEN I ADD TO POTS OF WATER IN THEN WORKS FINE??


The presostat or whater level sensor is not good ... Dishwashers

I have a Bosch dishwasher she44c05uc/40 It is 3-4 years old. Recently I noticed that the cycle times have gotten much longer. Since then there is a sewer smell in the washer especially when starting a new cycle it comes out of the disposal. I'm wondering if the pump isn't heating the water hot enough. I've also noticed that the dishes aren't getting near as clean as they were before all this started. Especially stuck on food. It used to clean everything now dishes almost need rinsed.


Hello,Welcome to FixYa ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Dish Washer, Model GLDL560N1055, S/NAR 808556B. Dishes and other items are not drying. They are still wet not damp. Brochure says try "Hot Start,Hot Wash or Added Heat options. Do I use Hot Start and Hot Wash at same time? Why must I use options rather then the normal control? I purchased 7 addtional GE appliances, recently, and Dish Washer only problem.


... GE Dishwashers

6 yr old kenmore dishwasher does not clean dishes well. there are no restrictions on both power washer arms, both spin well, but I'm not getting hot water, only warm. any suggestions? John


Check the drain, filter, and make sure there is no food stuck in there. Also, check out www.applianceart.com for dishwasher door options. ... Dishwashers

Electrolux dish washer esl 6115 dose not get hot water or dry


... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Drain Clogged I have a Kenmore Quiet Guard Plus dish washer. The water will not drain from the unti. I believe the drian in the dish washer is pluged. I removed the 8 screws from the pump/strainer unit at the bottom of the unit I removed the top that the screws were holding donw, but can't figre out how to get to the drain to unplug it. The center metal unit is exposed and nut head is exposed. What do I do next to get to the drain hose to unplug it?


You might try pouring liquid plummer in the drain part and jet it set it shouold eat through whatever is in there ... Dishwashers

The top rack dishes do not get cleaned. I have run the vinegar rinse. The bottom rack dishes get cleaned. It doesn't even look like the top rack dishes get wet. I ran the washer without the top rack in and I think water was coming down from the top. What can I do?


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

We used our LG diswasher to clean our grill grates, which was a bad idea, because now the unit will not clean the dishes. We cleared the washer arms of debris, but the unit still is leaving the dishes on both racks dirty and is leaving the liquid soap dispensed into the unit undissolved on the door of the unit. There are no kinks in the water inlet, and water is getting into the unit, but the dishes are not getting cleaned.


Hi\015\012\015\012\015\012Thanks for using FixYa. Please make sure the dishes are loaded properly or\015\012dishwasher is not overloaded. Also check that the dishwasher is filling\015\012properly. It will fill with water up to ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Does not get dishes etc. clean no matter how loaded. Must pre-wash by hand to get all food off or will not come out clean. Why have a dish washer? Is there any secret to how to get it to clean? Or do we give up on this thing and replace it. Only 3 years old. Any recommendations? We assummed the newer dishwashers would not need pre-rinse by hand but would clean.


Hi,This is a good washing machine if it is working properly. There could be a couple things that have happened to make this not work well. You should not have to pre-wash or rinse anything, just scrape and load. First thing is ... Whirlpool GU2400XTP Built-in Dishwasher

Even though I turned up the thermostat on my hot water heater, the water in the dishwasher does not seem to be hot enough. Mold is growing in the food grinder and even though I choose the heat dry option, the dishes are never dry. Yet, when I touched the element, I got burned. The dishes are not getting clean because it doesn't seem to be hot enough to cut the grease.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a Kenmore dish washer model # 363.14051692. This dish washer was working fine and someone stopped it in the middle of a cycle. After that, we can't get the washer to start back up. Where is a reset button on this model, or is there one?


... Kenmore Dishwashers

My dish washer isn't cleaning the dishes well. There are little particals inside of every cup and on dishes after it is done. I just emptied and and now I'm running it with bleach. But before I started it I looked at the drain hose under the sink. The drain hose had water in it. The drain hose is going uphill from the dishwasher to the sink so I don't know if this is normal to have some water in the drain hose when the washer completes since it's not would have to pump uphill to get to the garba


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

I got a whirlpool dish washer Adp4407. When the machine is switched on it carries out the cycles but seems that the hot water cycle is not working and the dishes are still unclean even after completin


... Dishwashers

Bosch sgs5312gb/07 dishwasher not getting hot - was stuck on rince mode - have got it off that setting - tried to use it - stays on wash and is not getting hot


If you open up the control panel (access by removing the front door panel) you'll find a circuit board and the relay. I suspect you'll find that a solder joint on the relay has burnt out - if so, easy to fix with a blob of solder - good luck ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1526 seconds