Having problems with your Frigidaire PLD4375RFC Dishwasher ?

Brand new frigidaire dishwasher model #FGHD2433KF1 door will not close. HELP.


Answers :

Repair Help & Product Troubleshooting for Frigidaire PLD4375RFC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Brand new frigidaire dishwasher model #FGHD2433KF1 door will not close. HELP.


... Frigidaire PLD4375RFC Dishwasher

Frigidaire Dishwasher Model FGHD2433KF1 will not let us cancel out ER msg on front door screen. it says to call 800 # if that occurs..they are closed. we cannot cancel out anything..it continues to run when door closes. help


Hi,Disconnect the Power Supply, say for 5 minutes and then Turn ON the machine. Do you see any Error Message again?If yes, let me know the Exact Error Message so that i could tell you the meaning and the Fix for the same. ... Frigidaire Dishwashers

I have a Frigidaire Aqua Surge with Speed Clean dishwasher. The model # is FDB4315LFCO The serial # is TH64297242. There always is a smell in the dishwasher. Even when I have just washed the dishes, when I open it it smells. Also when there are just a few dishes in and I close the door and reopen it, it smells. I rinse everything very well before I put the dishes in. I have tried cleaning it with a dishwasher cleaner and that didn't help. HELP!!!!!


HELP s on it way . it is or may be a install problem . take a look at the drain and how it connected to the disposal . If where it connects at that point the hose is going down hill then when the disposal is se ... Frigidaire Dishwashers

I have a Bosch Dishwasher, model SHX57C05UC/21. I can not open the door fully; it seems to catch on something when its halfway open. Any ideas why this is happening? The DW was purchased brand new in 2005. Thank you for your help.


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Brand new frigidaire PLD 285-5RFC1 dishwasher. There is a leak coming from the lower right. Supply line was replaced as we found a tiny defect in the flexible hose. It appears that the leak is from the door seal. Your help is needed! ASAP!


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My Frigidaire fghd2433kf1 starting flashing PF occasionally. I would open and close the door and it would go away. It became more frequent until two days ago when the dishwasher stopped mid cycle and flashed PF. When I opened and closed the door, everything went dead and the dishwasher no longer works. It acts like it has no power coming into it. I checked the breakers and the wires connecting the power into the dishwasher. No luck. I replaced the control panel, but not the control board. It did


... Frigidaire FGHD2433KF Builtin Dishwasher

I just installed a new Kitchenaid dishwasher (Model KUDE60FVSS3). After filling with soap, closing the door and starting the machine, it fills with water, waits a couple of minutes and then I can hear low humming noices coming from down below. After opening the door it appears that neither spray arm has turned as if to wash. This dishwasher was purchased new a few years ago and kept in storage as our basement was being finished. This dishwasher has never completed one cycle. Any and all inf


If you have a garbage disposal, there is a plug in the dishwasher that has to be removed for the washer to drain. ... KitchenAid KUDE60FVSS 24 in Builtin Dishwasher

Hello,I hope you can answer the question below for me. My dishwasher is a Hotpoint model BFI680 - integrated. I want to replace the old interlocking assembly with a new one as the spring has broken and I can not close the dishwasher door. I have trouble removing the old interlocking assembly though. I can not see any screws that keep it into place as with other models. Instead, it looks like that it is "clipped" to the dishwasher door via the two inner side round holes at the bottom. Tried to re


... Hotpoint 23 in. BFI68 Built-in Dishwasher

Our Kitchenaid dishwasher model # KUDP021R will not start. We close door, select wash and press start. The control lock light at the top which is lit flashes a few times and then stays lit. Dishwasher remains silent. An aside which may be helpful is that the door has always seemed to be not quite straight...as though it had to warp a tiny bit to close and lock.


The problem you have already identified could be the door switch is not closing when you shut the door. Please confirm your dishwasher is KUDP02I (i and not 1).\015\012\015\012One way to check is find out the door switch on the door panel ... KitchenAid Dishwashers

Hello, My GE dishwasher stopped draining. Model Number: VSD2304JOOWW I emptied out the dishwasher of the liquid, removed the cover and checked the filter. (Didn't look bad.) Checked the drain pipe under the sink and there was a little debris (slime) but very minimal. The garbage disposal was installed at the same time as the dishwasher 3 years ago (brand new place). What else could it be? Any advice would be helpful as my new home seems to be falling apart and it is getting pretty e


Drain pump either disconnected or jambed ... GE Profile PDW8400J Built-in Dishwasher

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers

Frigidaire dishwasher model GLD2250RDC0 leaks from the bottom of the door. Just replaced the bottom gasket. Not helping. Noticed that the foam insulation on the bottom of the door is soaked. So, if it's not coming through from the gasket, what's causing the leaking on the inside of the door and through the foam insulation? Thanks for any help you can provide.


You may want to check the door alignment itself. Many people open and close the door improperly and when they load it sometimes they put pressure on the door in one corner or the other. Check to make sure the door is completely shut and shut proper ... Dishwashers

Hi, we are trying to install our new Bosch dishwasher model: SMU68M05AU. I am surprised to see packing foam and flimsy edging across the top edge that meets up to the stainless steel door edge when its closed. I can not find detailed installation instructions. Is there not a strip that goes across the top to meet the door as the top looks very ugly? The dishwasher door protrudes from the under bench cupboard space so the top part is in view and exposed.


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Bosch Dishwashers

My dishwasher will not start. It is a frigidaire / electrolux FDB1050REQ. I have checked thepower....and reset the circuit breaker.......then pushed the start button.....the light comes on on the front of the washer like normal but no water starts filling. I have jiggled the anti water overfill device but still nothing. HELP!!! The front of the dishwasher says Frigidaire, however, the inside of the door where the model# is says Electrolux


... Frigidaire Dishwashers

We have a brand new KUDE60FVSS dishwasher that is being installed and it is POURING water out one side of the door. The handyperson checked all the connections and we cannot figure out if it's the work or the new dishwasher. Is there some secret drainstop or something that needs to be closed?


... KitchenAid KUDE60FVSS 24 in Builtin Dishwasher

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

2 brand new Kenmore elite dishwashers - All hookups checked and correct. Start buttons blink - cycles will not start. 1 washer ran for about 10 seconds - then the light started blinking. Troubleshooting in manual says light will blink if the door is not closed. They seem pretty closed. Dishwashers leveled and plumb. Tried it mounted, and unmounted. No Luck. Thanks


These dishwashers have a safety feature. The door has to be closed within 3 seconds of pushing the start button. If the cycle is interrupted at all by opening the door or pushing something while started you will have to push the start button to resum ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.


... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

I bought a Frigidaire Dishwasher on November 2006. Model #PLD4375RFCO. (I paid K&N Sales $549.00) In October 2008 I called your toll free Number to report Er code was flashing. You recommended Best Service. I called them and the repairman said the"vent was not closing - fault on Drying fan - vent is closed. Sensor bad on assembly." I needed a new drying fan assembly (for $148). With his service fee and labor after he returned to put in the new assembly, the total paid to Best service was $318.25


... Dishwashers

My Frigidaire dishwasher model #FDP1050REB, brand new, won't work


Check for a lock out option if it has none then there is a problem with the control panel it will tell you in the owners manual also if it has the lock out button and how to disable it \015\012\015\012good luck for mom ... Dishwashers

My dishwasher door doesn't close properly. It has a panel on the outside and this seems to weigh down the door so it drops. I want to know if the door can be replaced. The model number is ACG9544 (at least I think so, some of the numbers are difficult to see! It could be ADG954 A, or ADG) Can you help?


Take the lower pannel off the bottom and look to see if you have a broken spring.you can order a new one on the sears website. ... Whirlpool Dishwashers

Frigidaire dishwasher PLD2855RFC rinse aid leaks around cap. How to fix? New cap? Is this a recurring problem? I have found rinse aid on door below cap (residue) plus have found rinse aid itself on dish below dispenser. I have to refill the rinse aid reservoir about every 7 or 8 wash loads. Also, the dishwasher is very noisy when running (should be quieter). Not very happy with this model ...


... Frigidaire PLD2855RFC Dishwasher

I have a Frigidaire dishwasher 7 yrs old, model FDB635RBS0 al small black piece broke off so the door will not latch shut when closed. Is this easily repairable? What's the average life expectancy of this model? Thanks so much Tom [email protected]


... Frigidaire Dishwashers

Model KUDI24SEWH2 - the dishwasher was operating, I opened the door to add another dish. When I closed the door, there was a small click and nothing happened. The lights indicated to me there was rinsing and drying going on, but in reality, nothing happened.rn We were told it might be the thermal fuse, but have just check that and it is fine. It will fill, just not pump or drain. Any help?


... KitchenAid Dishwashers

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2075 seconds