Having problems with your Frigidaire PLD4555RFC Dishwasher ?

PLD4555RFC: Low Rinse Agent Light Will Not Go Out

\015 Just installed a new Frigidaire PLD4555RFC dishwasher. The problem I am having is that the orange Low Rinse Agent light will not go off. The rinse agent is full, in fact we overfilled it a couple times to be sure. I tried turning power on and off and the light is still illuminated. I ran the Water/Service test and did not get an error. However, I did get a message (Lo) at the end of the cycle that the dishwasher still thinks the Rinse Agent needs to be filled.\015\012\015\012Any ideas? I will contact Frigidaire as well as the dishwasher is only a week old.\015

Answers :

I've disconnected the sensor in the dispenser for my new Frigidaire \012dishwasher. The setup is too unreliable in my opinion and is a potential\012 source of headaches. I had the same problem. I studied the design and \012it's too easy for the floating magnet sensor in the rinse aid reservoir to \012stick thereby not actuating what is called a reed switch to toggle the \012control card LO ckt light. Mine has the electronic control front panel.
Repair Help & Product Troubleshooting for Frigidaire PLD4555RFC Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

PLD4555RFC: Low Rinse Agent Light Will Not Go Out


I've disconnected the sensor in the dispenser for my new Frigidaire \012dishwasher. The setup is too unreliable in my opinion and is a potential\012 source of headaches. I had the same problem. I studied the design and \012it's too easy for the float ... Frigidaire PLD4555RFC Dishwasher

I have a Frigidaire Model Number GLD4355RFS1 Serial Number TH80493988 Dishwasher. It quit working when the Rinsing Agent Low light came on. We filled the rinding Agen dispenser with hopes that it would come back on. The Rinsing Agent Low light went off but the unit never came back to life. When the room is totally dark, you can just barely see the lights in the LED display and other lights. It will not come back on. I tied turing the power off and the "PH" alert is displayed in t


... Frigidaire Dishwashers

My Frigidaire dishwasher leaks the rinse agent into the tub. Therefore, the low rinse agent light is always on.


It may leak because:\015\0121. Seal is bad. (o-ring?)\015\0122. a spring on mechanism may be loose, missing or broken.\015\0123. the container that holds the fluid may be cracked.\015\012\015\012find schematic and parts ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Frigidaire Gallery Series Dishwasher - unit stops near the final rinse cycle without draining - "ER" on front display, all led indicators on front display also lit (e.g. low rinse agent, etc.), and the "Hi Temp Wash" light is lit, regardless of cycle setting at beginning of cycle - rinse cycle seems to function normally


HI,check your drain hose first for kinks or food blockage also check the\015\012tail at the disposal or wherever you drain hose connects. Second there\015\012may be a blockage in the pump itself take it off and check. If all of\015\012thi ... Dishwashers

Model #PLD4555RFC0 The control panel lights on the front are all flashing and start cancel button will not change anything. flashing Er with wash, dry, clean, and and S showing. Top controls have China/Crystal light flashing and Low rinse agent light flashing. Nothing seems to work


... Frigidaire Dishwashers

I have a Frigidaire dishwasher (FDB2810LDC1) and a Er code appears in the display with the sensing, rinsing agent low, sanitized, and clean lights all flashing as is the child lock light. After seeing the Er code, I opened the dishwasher and thought I heard the detergent tray open but most of the detergent was gone with a little remaining. This has happened before and we have had the electronic panel replaced twice. Could it be something else like something blocking the detergent tray from op


... Frigidaire Dishwashers

My Frigidaire Model FDB2810LDC1 dishwasher will not stop running. Seems to complete a normal cycle and different cycles can be selected with normal time countdown but at end only rinse agent low light remains lit and sounds as if pump is still running. If opened, water appears to be streaming from rotator arms. Have cycled power but symptoms remain.


... Frigidaire Dishwashers

I have a Bosch SHE4AM15UC diswasher. The rinse agent comes out at the gasget. The rinse agent light does not come on anymore windicating it needs more agent.


I would have to say the sensor may be fouled up and need to be cleaned if you are concerned about the light. If the rinse agent is coming out of the gasket I would look for small cracks around the dispenser, then the door panel may need to be replac ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

SHE4AM15UC/05 dishwasher will not start When I turn on light for regular wash lights up but will not start after I push start button. When I turned it on the rinse agent light was on, I added some and that light is no longer on but after several tries it will no start. Electricity went out yesterday but dishwasher was no on when it went out..


... Bosch SHE4AM15SS Stainless Steel 24 in. Dishwasher

The rinse agent light is on and the water will not spray out


NO WILL STILL WORK IS ONLY A FLOAT SWITCH TO WARN YOU,HOWEVER RINSE AGENT DOES AID THE DRYING PROCESS SO WITHOUT YOURE DISHES WILL BE WET AND SMEARY ... Bosch 24 in. SHU43 Built-in Dishwasher

Bosch SHU 6800 Refill rinse agent light stays on


... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

SAMSUNG DW 7933 LOW RINSE LIGHT ALWAYS ON


... Dishwashers

I can't figure out where the agent goes-there's a little arrow that can be moved around-no room that i can see and the agent doesn't seem to go in the rinse agent light is on


It goes straight into unit beside where you put detergent just fill it up till you cant get in anymore,the arrow is for adjusting dosage and 3 is the medium setting ... Bosch 24 in. SHU43 Built-in Dishwasher

We have a kitchenAid dishwasher -- just installed last year new-- we cannot get the rinse aid low light to go off. We have filled it up to where it can no longer hold anymore and the light is still on. I have tried to cut the power on/off and it still remains on. Any suggestions on how to get the light to go off? thank you.


Check to see if the "Heat Dry/Lock" button is lit up. If it is, press the button and hold it for four seconds to unlock your dishwasher controls.Close your dishwasher door firmly and press the "Cancel" button. Wait two minutes for your Ki ... KitchenAid Dishwashers

Hi, The rinising agent low light is on and the


... Frigidaire 24 in. GLD2350RCC Professional Built-in Dishwasher

Bosch SHE43M dishwasher displays code E1, Auto Wash light flashes, Regular Wash light flashes, Refill Rinse Agent solid


... Bosch Dishwashers

Low rinse light comes on and the lock lights up


... Samsung Dishwashers

Bosch SHE43M02UC Dishwasher, display shows 1, quick wash light blinks, rinse agent light on.


... Bosch Dishwashers

It won't complete a full wash cycle keeps stopping part way through and low rinse aid, low salt lights flashing even though both are full ??? Pamphlet says this might also mean there is a kink in the inlet hose but that seems fine as well. Have had the dishwasher 3 weeks and it has completed about 4 cycles without stopping ???


Check water valve to see if it has something blocking water supply ... Dishwashers

I have a frididaire proffesional series aquasurge with speed clean dishwasher # PLD4375RFC3 dishwasher there is an Er code that just keeps flashing the china/crystal light is flashing as well as the low rinse light. it used to sound like it was running when you would close the door but nothing was happening inside. any ideas?


... Frigidaire 24 in. PLD3465REC Stainless Steel Built-in Dishwasher

How do you get the child lock off? New Bosch dishwasher The active, Rinse Agent and Wash light are red, but when you push the start button the Child Lock light come on.


... Bosch Dishwashers

My Frigidere dishwasher 400 Series AquaSurge w/Speed Clean has an error light Er S It indicates low rinse aid but I have filled the dispenser..I can't get the start/cancel button to work or to mov


... Dishwashers

Rinse agent light stays on the machine keeps running countsdown to 1 doesnt get hot i replaced the circuit board


... Bosch SHI6805 Dishwasher

Model #SHU6805UC. Does not start. "CL" in readout display. Refill rinse agent light on.


... Bosch Evolution 800 SHE68M0 Built-in Dishwasher

I have a Bosch Integra 500 - just installed. The fill rinse agent light is rapidly blinking and the washer does not run.


... Bosch Integra® 500 SHX46A0 Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1141 seconds