Having problems with your Frigidaire PLDB998A Built-in Dishwasher ?

I have pldb998ac frigidaire dishwasher. The rinse light stays on, and it won't start. Last night it was pretty loud while running the dishwasher, smelled a bit like plastic, and today only the rinse light. The heating element seems to turn on as well when the door is closed. Help - any ideas?


Answers :

Repair Help & Product Troubleshooting for Frigidaire PLDB998A Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have pldb998ac frigidaire dishwasher. The rinse light stays on, and it won't start. Last night it was pretty loud while running the dishwasher, smelled a bit like plastic, and today only the rinse light. The heating element seems to turn on as well when the door is closed. Help - any ideas?


... Frigidaire PLDB998A Built-in Dishwasher

Our dishes smell like vomit after they have dried. We run them through the dishwasher, they seem to smell okay. Then when Dry, the smell returns. We have tried vinegar and tang rinses to no avail. We have turned up the heat of our water to scalding, that hasn't helped. We have disconnected drain hose and there is no smell there. What can we do to get rid of this awful smell? There is no food in any filters, heating element is clean except for some hard water stains. We have a whirlpool 575-0 qu


... Whirlpool Dishwashers

My Omega Eurolux Dishwasher (mode: DW211P/1) won't stop cycling, It sems to get stuck during the wash cycle and continues for hours, until I turn it off. If I turn the dial to rinse it rinses fine. It doesn't seem to heat the water at all, there is no steam when I open the door. I have put a new heating element in, but this doesn't seem to be heating up at all. When I open the door mid wash cycle the element is cold to touch.


... Dishwashers

My plastic tub on my Whirlpool GU2500XTPSO dishwasher seems to have a small dimple in the plastic below the heating element. It looks like a metal utensil or something may have fallen and was leaning


... Whirlpool Dishwashers

Fills with water, sounds like it starts to pump water then stops, then start again. It attempts to start pumping water 3 or 4 times them turns off leaving the water in the tub. I have read about the water needing to heat up for the cycle to advance. When I check the water that is left in the tub it is warm but not hot. The heating element is not hot either. I did a continuity test on the heating element and it seems to check out ok. I also did a continuity test on the red wire from the heating e


You have a wash pump problem. can be 1 of 3 things. most likely something is caught in the pump impelor if not the wash pump motor may be faulty or ceized or it could be the capacitor for the wash pump motor is faulty. you can try removing the wash p ... Maytag MDB7100AWB Dishwasher

Whirlpool model GU2400XTPQ7 (Canada) plastic tub has discoloration from heat element......plastic directly under the element has dried out and cracked....it almost looks like it has been eaten away......now I have a leak! Virtually impossible to fix without replacing the entire plastic tub. Of course because the machine is four years old, the warranty has expired. Is this a common problem? Heard of this before?What now???


... Whirlpool GU2400XTP Built-in Dishwasher

I have a whirlpool dishwasher DU915WKSO: when I turn the dishwasher on, the heating element comes on but no water comes into the unit. I recently replaced the garbage disposal and th dishwasher worked fine for a time or two. Since then I have only been able to get water in it once. Like I said, the heating element works but no water in the dishwasher. Thanks for any help.


... Whirlpool DU1055XTS Built-in Dishwasher

I have washed and rewashed my dishes with no soap and my glasses have a horrible white film and any of my plastics now have white film almost as if the soap is not rinsing off. I have resorted to hand washing and some of the glasses seem to be etched with this white residue....difficult to remove. Please help! I have read possible heating element problems but I just ran the dishes thru a wash cycle with no soap and when I opened the door the heating element seems to be functioning fine -- all


Hi,The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Table top Can the heating element be adjusted on this model? It heats the water at a higher temperature than my portable one. Would like to turn down the temperature setting some.


... Haier 17 in. HDT18PA Built-In Dishwasher

I have a JDB1090AWS about 3 years old. We noticed a smell and found cutting boards and plastic cups melted. Machine was off. Had to turn off the breaker. Checked both leads to element & have power even with machine off. Not sure if it could be the limiting thermostat; I assume that is to shut the heat down when it gets too hot. Element is on though when it shouldn't be to begin with. I did have to tighten the water supply. Had some water underneath, but all wires seemed dry. Any tests I should t


The heat element can only get so hot.It's timed so it doesn't exceed a period of on, exposing dishwasher contents to continuous high temps.Watch the timer and take note how long it broils your cookware.Good luck. ... Dishwashers

Kenmore dishwasher 665.13843K601 ser. FU4806977 STOCK 13843K TYPE 575-0 Tried to turn it on won't start/ run/ perform any functions The following buttons light up but will not perform functions; Smart wash and heated dry also lights up like it should, pots and pans, normal, fast wash, high temp, sani rinse The following buttons do not perform functions or light up Quick rinse, Turbo ZOne, Delay Hrs., Cancel/Drain, Start/Resume I killed the power to it for 1 minute for reset but d


The touch pad is not working. Pull the front kick plate from font/bottom of machine and there is a 'TECH SHEET'. This has a complete diagnostic sequence for you to go through and verify the functions for you. ... Dishwashers

GE PDW9700 - Heating Element turns on by itself and Burns my dishes


Have experienced this problem on some zanussi machines. what is happening is that the machine continues thro cycle thinking there is water in machine when there is not. can be caused by:slow pump rate caused by blockage especially near the drai ... GE Profile PDW8400J Built-in Dishwasher

My Bosch SHI4306UC dishwasher will not stop running in the rinse mode. I was wondering if it will not advance because the heater is not working well enough to increase the water temp to complete the cycle. Is this most likely the heating element and something that can be fixed by a homeowner? Thank you for your help, Steve


... Dishwashers

Long cycles My dishwasher (approx 7 years old) will run in the wash cycle for hours...until I physically turn the nob to "rinse"; then it will stay in that cycle until I advance the knob to the final (expel water) stage. I checked the filter and the blades - no obstructions. Also, when completed, the dishes are hot, so I know the heating element is working.


Http://www.thisoldappliance.com/library/bosch_dw_guide.pdf\012\012\012 ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a GE Triton XL dishwasher that is not spraying water onto the dishes. I just reset the power, and that didn't help. Putting it on the rinse only or wash cycle fills the bottom with water, but it sounds like a trickle vs. the spray. The heating element comes on and the soap door opens, but there's not spraying. I made sure there was nothing clogging the water line or other parts. What do you think is wrong?


... GE Tritonr XL GSD6260JCC Dishwasher

Our kenmore quietguard smells like burning plastic when it runs. Nothing is stuck on the heating element.


... Dishwashers

Maytag MDBH970AWS Heating element won't turn off. Dishwasher heating element won't turn off. Have to shut off the breaker to make it cool down. Heating element gets hot as soon as you flip the breaker back on


The heater relay is located on the control board, a faulty relay or a faulty control board would cause the problem you have described. The fix is to replace the control board. Parts for your unit should be available from most appliance parts retail ... Maytag 24 in. MDBH970AWS Built-in Dishwasher

The dishwasher is not cleaning. It has left a residue all over the dishes especially colored plastic ware glasses. like it doesn't rinse but i have ran the extra rinse cycle and residue is still there. It has actually stained the dishes. Then ceramic dishes are not clean. And ones on the top rack feel like there is a coating on them that does not come off unless you rinse by hand.


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... GE Tritonr XL GSD6260JCC Dishwasher

Doesnt seem like water is heating and element not getting hot


Sounds like you checked the basics. Do you have hard water? Our element got covered with calcium over time and didn't heat efficiently anymore. I was able to chip some off, then ran the dishwasher with LemiShine a few times. The element worked much b ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Replacing heating element in Kitchenaid dishwasher KUDI01TJBL0


... KitchenAid KUDI01TBK Dishwasher

I have a six year old dishwasher that started leaking water out of where the heating element is attached on the lower part of the unit. It appears as though the heating element has melted through the plastic. Is this a flaw in the design and is there a recall on this?


Dont use it!!!!!!!! ring the manufacturer with the serial number ect phone number should be on appliance booklet or get it from a dealer ... Dishwashers

Hello, I would appreciate if you have any suggestions regarding my GE dishwasher. It turns on and seems to want to work but the rinse cycle does not produce any water, it makes noises like the water is coming out and rinsing but when I open the dishwasher the dishes are not wet. I've checked the water valve, turned the control panel off and on, I'm wondering if it is just clogged, any suggestions? Thank you.


Hi,\012Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher ... Dishwashers

Hobart AM14/1 free standing dishwasher with booster. Booster will not heat up beyond 41C. All three heating elements check ok with Ohm meter. High limit not tripped. Temperature screw up at maximum, when you turn the screw, you can hear thermostat click at lower temperature on and off. When turning on main power for dishwasher, heater in dishwasher works fine, but no relays click in the booster tank area. Have not checked for power at booster, have checked all fuses with meter and are ok. Ple


... Hobart AM14-253 Free-standing Dishwasher

Most plastic ware like plastic glasses and some of the other dishes but not all come out with a hard to remove white coating no matter how much rinse agent I use. I use Cascade Complete powder for soap and Cascade Crystal Clear rinse agent what Bosch recommends the exact amount according to the owners manual. This problem started about a month ago, before that the machine worked well.


... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

The dishwasher smells like something is burning when it is running. We have checked and nothing is stuck on or around the heating element. There is however and white residue on the heating element.


... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1323 seconds