Having problems with your Galaxy Dishwashers ?

Galaxy dishwasher model 665.740120..how to operate?


Answers :

Repair Help & Product Troubleshooting for Galaxy Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Galaxy dishwasher model 665.740120..how to operate?


... Galaxy Dishwashers

Bosch dishwasher model shx36l fails to stop pumping. The drain was clogged. I cleared the drain. Dishasher backed up, water overflowed. Clog has been fixed. Dishwasher will not stop trying to pump water out. There is NO water inside dishwasher. I wish to run another load however unit fails to respond. Pump is operating even when front door to doshwasher is open. Turning the power button to OFF is the only remedy to stop drain pump from operating. How to fix?


... Bosch Integra® 500 SHX46A0 Dishwasher

The lower spray arm came off during a dishwasher cycle and melted. The dishwasher is okay but I need a replacement spray arm for a Sears Galaxy dishwasher model number 587.15139400 I have searched google for replacement parts for this model and have not found a place where I can get a lower spray arm. Any help would be appreciated.


Sears parts dept ... Sears 24 in. 14181 Built-in Dishwasher

Dishwasher inoperative The lights that indicate the wash cycle are flashing along with the 6 hour delay light. I have tried to cancel the cycle but it does not work. I shut off the breaker to try and reset the operation and that does not work. The dishwasher will not work and I cannot reset or cancel the flashing operations. Kenmore Quite Guard 3 Model 587 15072200


... Kenmore 15522 Built-in Dishwasher

Sears Galaxy Dishwasher model # 665.740020 - Galaxy Dishwashers


... Galaxy Dishwashers

Portable Dishwasher Hello, We just got a used Haier portable dishwasher, model HDP18PA and while the hose connnects fine to the sink, the water isn't going into the dishwasher and is coming out of the connection. Does that make sense? It looks like, if it operates properly, the water should be sucked into the dishwasher but the connector isn't pulling the water in. Help! Thank you! Tara


You have to have a good seal. Get a hose washer from your local hardware store and replace both of them on the hose if they are like a garden hose. If you still don't get any water to the unit, post again and I'll step you through it. ... Dishwashers

Bosch Dishwasher I have just moved into my flat where there is a Bosch dishwaher installed in the kitchen. I have tried on a number of times to get the dishwasher to start a programme but for some reason it fails to start. It does switch on but I dont know how to operate it. I dont have a manual for it so have not a clue what to press to get the programmes running. I would be grateful if you could help. Bosch Dishwasher logixx Model Number SGS6952GB/13 Installed 2001


Dear Saps,\015\012Go to https://portal.bsh-partner.com/portal(bD1kZSZjPTAwOQ==)/PORTALFRAME.HTM for a pdf download for an Intr ... Dishwashers

We have the Whirlpool dishwasher ,Model: ADG6 955. used it smoothly last night but this afternoon, it just will not start up. The green 'START" button keeps flashing and the dishwasher just does not start operation. I tried to reset it by holding onto the start button for a few seconds. The dishwasher stops and nothing more. KIndly advise


... Whirlpool Dishwashers

I have a GE dishwasher with the following model number: GSD3230F00WW. Last night, while the dishwasher was in the clean cycle, a buzzing/grinding sound came from underneath the dishwasher. I removed the access panel to try to isolate the sound. It appeared to come from a solenoid that was connected to an arm that opened and closed something. I am not sure if the solenoid is bad or if there was something that was preventing it from operating properly. I moved the arm to which it was connected


The part you are referring to is the pump out solenoid. ( part # WD21X10071) When the dishwasher is suppose to pump out, power is applied to the solenoid and it swings a flap inside the pump assembly to divert the pumped water out the ... GE Dishwashers

I HAVE A MAYTAG DISHWASHER, MODEL #MD 86709AWW2, SERIAL #F10702631. THERE IS POWER GOING TO IT BUT THE SELECTION BUTTONS AREN'T LIGHTING UP. THEREFORE THE DISHWASHER WILL NOT OPERATE. IS THERE A RE-SET ANYWHERE ON THIS DISHWASHER? IF NOT, WHAT DO I NEED TO DO?


Hello &\015\012Welcome to FixYa\015\012\015\012The problem\015\012is with the control board that needs replacement. You can press and hold the NO\015\012HEAT DRY button for 20 seconds to reset the control, if the proble ... Maytag Dishwasher

I have a Bosch Dishwasher, Model SHE46C06UC. No mater what cycle I start it in, it simply activates the drain and continues to run without ever starting. Within the last week prior to the dishwasher not working, I noticed a low hum/vibration emitting from the dishwasher. I've clean out the screen and drain filter, removed the pump cover to check for any debris. I've manually added water and it does drain. Additionally, the drain cycle continues to operate even with the door open.


First thing you may want to check is the door switch. You can pull it off and measure the resistance with an ohmmeter. If you get good reading while pushed in and none while switch button is released, then it is a good start. Next, you may want ... Dishwashers

DIHR model DS50 no instruction on how to operate the dishwasher and can't get it to go through it's cycles or instruction on electrical hookup . had electrition wire it but he wasn't sure it was right because no instructions Bought it new but when they deliver it there was nothing but the dishwasher .I can't get them to do nothing to help me.So I have a dishwasher I can't use.


... Dishwashers

I have a fisher and paykel single door dishwasher model dw918 td. The other day its door spring collapsed and the door had a free fall. The dishwasher operated fine. But we have accidentally opened the door and let it free fall under its weight a few times. Last night the dishwasher began its cycle and stopped after 10 minutes - no beep, no alarm, display was fine. it just stopped. I opned and closed door a few times. Pressing the start/stop button only resulted in a beep but no action. I let


... Fisher and Paykel Dishwashers

I have a Kenmore elite dishwasher model #13923K012 that the cancel/drain light is stuck on. How do I get it off so I can operate the dishwasher?


Unplug the power cord, wait 10 seconds, and plug it back in ... Kenmore Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

I have tall tub model: LDF7920WW. It is not drying thoroughly; the walls are full of condensation & dishes are damp. I operate the dishwasher late at night & unload the following morning. I am not sure if my dishwasher was properly hooked up by a reputable plumbing company in my city. The authorized repair service tells me the problem with my D/W is that I am not using a rinse agent. I do not use chemicals like these in my home, let alone on my dishes. Is this the only probability of my


... LG 24" XL Tall Tub Built-In Dishwasher - White

I have a Bosch dishwasher model SHE4AP02UC/06, serial number FD901102579 that has been used twice since installation. When I select the Regular Wash cycle, the Regular Wash LED and the Active LED come on. The machine washes the dishes and then when it stops making noise. At that point the Active LED goes off and the Clean LED comes on with the Regular Wash LED. These LED's do not go off. There is no signal saying that the dishwasher is finished. Is this the way it is supposed to be operating or


Ya id say until u open the door after it has washed ... Bosch Dishwashers

Our GE built in dishwasher Model GHD6310L18WW had no lights on and would not operate. i checked the breaker panel and found it was OK and 120vac were flowing to the unit. i then turned the braker off for 30 seconds then back on .this made the time remainig LED display sow 106 and the Normal wash Cycle LED is lit as well as the extra Heat LED . the unit will bot operate though


... GE Dishwashers

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

I have a smeg dishwasher model PL 312 S and the timer seems to operate but now water enters or any motor functions. The on light is lit and the timer motor runs and that is all that seems to be operational.


... Smeg Dishwashers

Power went out momentarily while dishwasher was filling with water. power back on and dishwasher will not operate. Model Quitpower 3


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check for the following if your dishwasher\015\012is not working-- ... GE Dishwashers

Have an old GE dishwasher, model VRB501X, need some info on how to operate it. It's a very basic model with 84 kwh. Not sure which year it is. We have not used it, since my husband bought the house, back in 1998.


... GE Dishwashers

AEG Favorit 675 Once you press the on button, the inlet solonoid opens and the container below the dishwasher fills but nothing happens after that.I'am an electrical contractor who would love a circuit diagram to this model so i can follow the squence of operation, it is my own dishwasher.


See this manualpag 19-21http://www.serviceforce.co.uk/pdfs/U04142.pdfSergio ... Dishwashers

I have a Maytag dishwasher model MDBTT60AWW. None of its wash modes will work when pressing their respective buttons. The Fields Service Test functioned normally with the exception of the "heated dry" and "sanitize" LEDs not being lit. Tried to perform the Manual Function Test, but none of the components would operate upon pressing the respective keys for testing their operation.


Hi, \015\012Sounds like either the control board or the keypad.Try removing power from the unit to see if it will reset.\015\012Now try running the diagnostics…RIBBON CABLE CLEANING ... Maytag 24 in. MDBH955AW Built-in Dishwasher

Frigidaire professional series dishwasher model pld2850rdc3 does not fill complete with water. not enough water to operate center and top spray arms. water supply good, tricked the door so it will operate open to see what is happening, water flows free into unit, just not enough.


... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1855 seconds