Having problems with your Galaxy Dishwashers ?
What is demensions of galaxy dishwasher in inches
Repair Help & Product Troubleshooting for Galaxy Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
What is demensions of galaxy dishwasher in inches
... Galaxy Dishwashers
I bought a galaxy 665 portable dishwasher, and the hose seems to be too short - only about 20 inches. Is this correct?
We replaced our flooring a few years back with ceramic flooring which our floor approx. 3/4 inch. We now want to replace our dishwasher but find that the opening is now 335/8 and the standard height of a dishwasher is 34 inches . We also have a granite countertop. The tile floor does not extend underneath the current dishwasher. how can we install the new dishwasher???
Hi,Rather than Going for Different Adjustments,you could Buy a Dishwasher with Small Height. Bosch have so many Dishwasher's that could Actually Fit within those Dimensions without any problem.Even Hotpoint and Hoover have Mod ... Dishwashers
I have a kenmore Ultra Wash Dishwasher, Model 15825691. We were recently hit by lighting. Once hit, the dishwasher started up. Since then, all cycles work, however, at the end of any cycle, the dishwasher continues to run and fill the bottom of the washer up to about two inches and then cuts off, so when we open the washer, there is approx 2 inches of water inside no matter what. I have pressed the "Cancel/Drain" button, in which drains the water after two minutes, but when that is finished, the
There must be a problem wit the fill valve. Check which valve the water enters. Check first the wiring to the valve of the water inlet or where the water comes out to fill the washer. Check for physical evidence of damage on the solenoid (or contr ... Kenmore 24 in. 16539 Built-in Dishwasher
Sears Galaxy Dishwasher model # 665.740020 - Galaxy Dishwashers
... Galaxy Dishwashers
Meale dishwashers I have just moved from one house to another. my new house has a one half inch water supply my old houe had 3/4 inch connector When I hook up my dishwasher the indicator light comes on and the washer will not fill. ????????
Check that you have water supply to the pipe that connects the dishwasher to the wall, \015\012\015\012when you switch the dishwasher on, dose it buzz quietly, if so there is no water coming to the machine, the fault is with the plumbing, if there is ... Miele 24 in. G646SC Plus Free-Standing Dishwasher
New kenmore dishwasher and it is sitting too low there is a quarter inch at hole at the top of the dishwasher under the counter. It seems to be tight in the space; can we cut off the metal bracket that screws in under the counter. That way we can raise the dishwaster the quater inch. I think it is tight enough not to move around without the top screws. What is your opinion?
Hello,No do not remove this bracket. if you remove this bracket the dishwasher will tip forward when you ope the door!Why would you want to change anything by cutting a bracket? What is the matter with it!is your dishwasher doing so ... Dishwashers
There was a plastic dishwasher part lying loose in the bottom of my dishwasher this morning. Can't figure out where it belongs. probably inch and 1/2 round , 1/2 inch high. Top of spray tower maybe?
Probably the holder for the bottome rotating spray arm. Mine just broke off this morning too. Trying to locate parts supplier that isn't in the states and has a picture of the part. Don't want to replace the whole assembly which would be costly. ... GE Dishwashers
Dishwashing machine not fully draining (2 inches of water remain). I have an open problem concerning this problem. I have a new pump. dishwashing machine not fully draining (2 inches of water remain) For this machine.
Following a cycle, a small pool of clean water inside the tub is\015\012typical. Excessive water means the pump isn't pumping water out\015\012properly, the drain hose isn't carrying it to the drain pipe, or the\015\012house's drain lines are backed ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher
Re: Bosch Dishwasher Model SHX46B06UC/14 (year 2003) Good afternoon, I have water dripping into my dishwasher when it is not in use, approximately up to 1/2 inch over a few hours. The water collects at the bottom inside the dishwasher. I have to shut off the dishwasher water supply so that it does not overflow. Other than that, the dishwasher works perfect! Any idea as to what has to be replaced? Can I do it myself or do I have to call a technician. Thanks very much for your help.
HI. This type of issue will be the result of mechanical failure. This failure will be within the inlet assembly. Debris may be keeping the solenoid valve from closing correctly, thus, producing the steady drip a ... Dishwashers
Leaking dishwasher I replaced the door gasket, and I still have leaking from under the dishwasher. There is such steady droplets from the bottom of the tub of the dishwasher, it is almost a steady stream of water. It is dripping from about 13 inches deep into the dishwasher from the front door.
... Kenmore 24 in. 17372 / 17374 / 17379 Built-in Dishwasher
Bosch dishwasher Over the weekend my drains backed up into the dishwasher. After cleaning the drains I ran the dishwasher 3 times. Under the screen there is still about an inch of water. I never noticed this before because I never removed the screen before. Can you tell me if this is normal or is there a problem with the dishwasher. The water in the little area below the screen is clean.
Its normal. its there to keep moisture around the rubber seals so they dont dry out. ... Dishwashers
When we do not use the dishwasher for a week or more water seems to back up into the tub. The water has a foul smell to it and can be as much as an inch or so deep. The dishwasher drain hose is attached to an insinkerator disposal. By the way this dishwasher is only a couple of months old and we have had to have it serviced three times. No one has been able to explain the water accumulation and it can not be demonstrated unless the washer sits unused for a while.
... KitchenAid KUDS40CVSS Builtin Dishwasher
I have a Frigidaire dishwasher, Model # FDB1050REB2, Serial # TH74114244. I push the start/cancel button and the washing lite just blinks, and nothing happens. There is also 1-2 inches of water at the bottom of the dishwasher. What can I do. I installed the dishwasher myself. It worked fine up to this point.
Sounds like the control panel has failed . but ck the drain pump for a plug . if it cant drain the the prosser knows and the flashing is the trouble code .. mm ... Dishwashers
The dishwasher does not pump all of the water out. There is an inch or two left in the bottom of the dishwasher after the cycle has completely run. The control panel has been recently replaced on this dishwasher and it did not correct the problem. Help?
You likely have a dirty or faulty water level sensor in the machine that needs to be cleaned or replaced. ... Dishwashers
Our Hotpoint Dishwasher Model HDA200X-73BA has two little white plastic pipe stubs poking out of the bottom of the dishwasher. During one of the cycles--(I don't think it is the drain cycle)-- some water is being released from one of these pipe stubs and then it stops and the other one runs some water. They each only run for a few seconds, but the water is just running on the floor. These little pipe stubs are about one half inch in diameter and project out of the bottom of the dishwasher about
Hello. go to the sears direct website, click on the blue link below, and enter your model number. ou can then access an excellent parts diagram which will show these stubs and what may be missing from them. Joe\015\012\015\012 ... Hotpoint Dishwashers
The lower spray arm came off during a dishwasher cycle and melted. The dishwasher is okay but I need a replacement spray arm for a Sears Galaxy dishwasher model number 587.15139400 I have searched google for replacement parts for this model and have not found a place where I can get a lower spray arm. Any help would be appreciated.
Sears parts dept ... Sears 24 in. 14181 Built-in Dishwasher
Dishwasher opening Due to a kitchen remodel with a slanting floor, I have a dishwasher opening that is only 33.5 inches high at the front where the new tile stops. Most dishwashers say they need 33 7/8" but Boshe and Jenn-Air seem to fit maybe. Any thoughts?
You can remove the feet from the bottom of the dishwasher ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher
Bathtubs was not listed in the "pick an expert" list, so choose dishwashers as closest thing to a bathtub. I have a whirlpool bath tub (don't know the make, but it is only 4 years old) It works fine but have a question - near the top of the bathtub there is a screaw in cap type of thing. It is a disk with a threaded bit on the back. The disk is about 1-1/4 inches in diameter and the threaded bit on the back is about 1/2 inch diameter and 1 inch long. Is this for allowing extra air into the syste
This would be a plumming issue. i do not know the answer you are looking for ... Dishwashers
Leaky Dishwasher I recently moved into a new house that has a brand new Magic Chef dishwasher. We haven't even had a chance to use it, but last night discovered water leaking from the bottom onto the floor. When I opened the door, there was about 3-4 inches of water inside. I baled as much of the (slimey) water out as I could, and that stopped the leak. Now afraid to run the dishwasher for fear that it might leak even worse. E71195 Type 777-0
... Magic Chef 24 in. DC4000 Free-standing Dishwasher
Dishwasher for 32 inch cabinets
Miele makes a G600 series that are 32 1/4 " tall - that would probably be your best bet. ... Dishwashers
My water is not draining from my dishwasher. it has 2 inches of water in the bottom after my wash cycle. it is even throughout the bottom, so my dishwasher is balanced. This is a brand new washer.
If the drain line is connected to a disposer, check to make sure the plug has been removed from the disposer. (typically, the plastic plug inside the tube where the drain hose connects onto disposer needs to be knocked out) If this OK, look for a k ... KitchenAid Dishwashers
Dishwasher repair Dear Guru, I hope you are well this evening. I have a Whirlpool Quietwash Plus dishwasher (940 Series) that will randomly have water sitting in after running through a washing cycle. In addition, some mornings there will randomly be a couple inches of water sitting in the bottom without every running the washer. Need assistance. Any help will be appreciated. Thank you for your time. J
Without model unablr to look up exact unit, but in genreral, either ther is a blockage/clog in oyour drain line not alowing complete drain of cycle, as far as never really washing, i would look into perhaps a faulty/ sloppy door switch assembly. if f ... Dishwashers
My hot point dishwasher is not draining,after all cylces are complete there's always 2 or 3 inches of water on the bottom of the washer, what is causing this? I have a Hotpoint dishwasher 24" built in. The switch won't come on just hums. When I oprn the door ther is 2" of water on the bottom? Any solutions . Where is the reset button on serial number hda430vww, hda400vba> Thank you!
Whirlpool dishwasher: Model DU920PWKT0; 8 years old Lately, have noticed not full drainage of water at end of cycle... about 1 inch standing (thus 2 inches at the sump). Glasses have had noticeable film on them. Ran the rinse cycle a number of times to explore problem. When I interrupted the cycle, the water on the bottom was soapy, yet no new soap had been introduced. I even colored the water "left" in the tub to see if it was replaced by fresher water. Although it was going through t
Find the 'tech sheet' behind the front 'kick plate' of the machine. This doc will give you a troubleshooting procedure for that specific machine. Check drain line and make sure it's clear and not kinked. Is filter clean?Has machine ... Dishwashers