Having problems with your GE 24 in. GSD2120C Built-in Dishwasher ?

Dishwasher has always had a knocking noise, very annoying. Has nothing to do with dish placement. sounds like something is hitting the door. But I tied clothes around the racks and started it and it still knocked, so I don't think it is the racks hitting the doors.


Answers :

CHECK THE SPRAY ARMS ROTATE FREELY AND ARE SECURE--DOESN'T WOBBLE TO HIT TRAYS-- DOES IT DO THE KNOCKING WHEN DRAINING OR JUST WASHING.
Repair Help & Product Troubleshooting for GE 24 in. GSD2120C Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher has always had a knocking noise, very annoying. Has nothing to do with dish placement. sounds like something is hitting the door. But I tied clothes around the racks and started it and it still knocked, so I don't think it is the racks hitting the doors.


CHECK THE SPRAY ARMS ROTATE FREELY AND ARE SECURE--DOESN'T WOBBLE TO HIT TRAYS-- DOES IT DO THE KNOCKING WHEN DRAINING OR JUST WASHING. ... GE 24 in. GSD2120C Built-in Dishwasher

My dishwasher emits a dead animal smell immediately after filling. I have a 20-year-old KitchenAid KUDS220T3 dishwasher. The racks are a little corroded, but it still cleans dishes just fine. About two months ago, it started smelling like a dead animal immediately after the dishwasher fills with hot water, during the time the water is being heated, but before agitation begins. The smell appears to be coming from around the door. If I open the door, everything inside the dishwasher smells fine.


This vent that you are describing is to allow air to flow in for the heat/dry cycle. Some times little creatures want to "mark" their territory by "spraying". Spray some type of cleaner like ammonia into it and **** it out with vacuum a few times. Mo ... KitchenAid Dishwashers

Whirlpool Dishwasher GU2548XTP- Dishes still dirty after it has run, especially the top rack. 5 (?) yrs old. Runs and grinds intermittently, no water seen under unit. Sometimes I add more water when it grinds, then it runs very quiet. Sometimes it doesn't seem to fill enough. Water supply good, inlet screen inspected not clogged. Not a lot of pressure shooting the water around the inside of the unit, as the detergent that bleeds through the slotted half of the detergent flip door isn't r


The inlet valve is OK, therefore the control board was not the problem. The impeller pump is noisy and inefficient, and must be replaced.Here is the part: ... Dishwashers

How to seal a small hole inside the door of dishwasher from the metal end of the top rack hitting along the inside of the door.


... Frigidaire Dishwashers

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

The dishwasher detergent is not dissolving. There is rinse aid in the dispenser - sometimes the door opens and the detergent comes out and sometimes it doesn't. If the detergent does come out then it is just sitting in the rack - should it drop to the bottom of the dishwasher? I have checked the door cleaned out around it to make sure the hook and release are working. I opened the door and the water is hot.


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

TOP ARM HANGING DOWN-Dishwasher's working fine, problem is that the wash arm/spray thing at top is lower than it used to be, we only noticed because when pulling out the top rack the top arm/spray thing at top gets hit by the rack. Work around has been lifting rack up at angle to get past this, but everyone at some point forgets to do this and we are worried eventually something will break. HELP???


... Dishwashers

My dishwasher is a Smeg model STA 6143, and the door won't close. It seems fine until the last few centimeters, then it jams and won't close easily. If you press hard, it'll shut but not latch. Nothing appears to be stuck anywhere. We've tried jiggling the door but it seems somehow to be misaligned, although there's no reason why it should all of a sudden appear to be so. The electronics work fine, the racks fit fine (we also removed them, and the door still won't close), and nothing appear


... Dishwashers

Leaking from under the door. replaced the gasket around the door but it is still leaking from the door


I found this website repairclinic.com and found the "foam seal" part of the door that is supposed to stop the water from leaking out. I also went to partselect.com and got a diagram of the door whick also told me that I maybe get door seal (btm). ... Maytag Dishwashers

A built in whirlpool dishwasher is leaking around the door seal, right side to be more specific. cleaned the seal, and along the bottom and it still leaks. Is there an adjustment that can be made to tighten the door. I wouldnt think it would be the seal itself do to being less than 2 years old. Thankyou for this service.


Hi,There is no adjustment per say on this door or seal. If water spray directly on the door it can cause this, what I mean by that is if the spray arm, either the upper or lower is stuck and continually sprays in one place it can cause th ... Whirlpool Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

The door on my Frigidaire dishwasher recently began opening too far. It slants toward the floor, a few degrees past level. Looking at it, however, nothing seems to be broken or missing. The springs are still in place just fine. The door stops when the metal arm hits the stopper, so I don't know how it ever stopped at the level.


I have the same problem. The springs look intact. Maybe some stepped on the door when it was opened and it stretched the springs. I'm going to replace them and see what happens ... Dishwashers

On normal wash cycle the dishes are still greasy and there is food debris on the inside door the machine has water and runs through its cycle but the dishes especially the top rack is still dirty.rnThanks Kimi


Depending upon the age of the DW, you may have a restricted or bad pump. You also could have a restriction in the drain line that goes to your sink. ... Kenmore Dishwashers

I bought a used GE Triton XL d/w with no manual. It worked great but now it is not cleaning anything, when the cycle is over the soap cup is open but half of the soap is still inside of the cup. I opened the d/w during a cycle and the dishes are wet top and bottom racks so I know it's getting water but the dishes are still filthy. Why is the soap not working? It's like water is spraying everywhere but the door where the cup is!


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... GE Tritonr XL GSD6260JCC Dishwasher

I have a Kitchenaid KUDS25SHBL1 dishwasher that is leaking from the bottom of the door. I replaced the main gasket around the body that the door seals against, and it is still leaking.


Have you removed the outer door to check if the leak is coming from inside the door . also check the bottom door seal ? also check the around the soap dispenser as I have had to silicone around them to keep them from leaking before..let me know if th ... Dishwashers

I have a GE dishwasher model number GLD55OOLOOWW. It was starting a start cycle and i opened the door to put more dishes in and my finger must have hit a button on the door and now two lights flash off and on and it wont reset itself. It has been on for several hours and still blinking and beeping every so often and unplugging it does not help. Any suggestions how to solve this problem. Thank you.


Try pressing the cancel button ... Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Water leak when the dishwasher is on rinse, it leaks water around the door.. I have replaced the door seal and it still leaks.. any suggestions


Check the gasket seating. It should be uniform.Hope the correct dimension gasket is used! ... Dishwashers

I have a candy cd622 dishwasher and it leaks !! when the water reaches the bottom of the door it starts to pour out, I have taken the door appart and cleaned all the crud and muck out, the rubber seals around the sides and accross the bottem are not perrished or broken but it still leaks !! please help


... Dishwashers

I have just purchased a smeg dishwasher model SA8210X-! and i am unable to put plates on the bottom rack without the fan hitting it when spinning around. Is there a way to fix this problem?


... Smeg Dishwashers

Hi - previous issue unfortunately still there. dishwasher loses power intermittently. banging the area around the buttons sometimes resolves. i have now shorted the door switch sensor and replugged all the connectors.


There may be a loose wire or solder joint on the control panel if you have to bang around the control panel area. Otherwise a bad thermal fuse could cause this. ... Bosch 24 in. SGS43E08 Exxcel Built-in Dishwasher

I bought a Kenmore Elite dishwasher last April and the heating element does not seem to be working. It did in the beginning but now when I open it up....the top rack plastics are still wet and the door is too. What can I do?


Have you checked the heating element to make sure no calcium has built up or limescale. Clean it diluted detergent and vinegar. Run the washer twice empty after that, and use litmus paper to check for regular ph levels in water to determine if chem ... Dishwashers

Whirlpool ADG 7550 integrated dishwasher not cleaning properly. Ive checked the filter and there are no signs of blockage. There is no unusual beeping but there is however a weird motor noise that just appeared. Dishwasher appears to run through the cycles but most of the time there is still traces of food left behind. It takes about 3-4 washes to clean the plates. Sometimes there is a lot of soap residue left around the release door which leads me to believe there might be a pump issue? ive ope


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Nasty dishwasher there is nasty wet grunge at the bottom of the door, around the place the heating unit in the bottom of the dishwasher. half the time the dishes are clean in the bottom of the dishwasher. half the heating element is melted..for some reason...what do i do. the dishwasher still works, if we make sure the dishes are clean before they go in. using more for a sanitation thing than a dishwasher. can ya'll help me?


Sounds like your heating element is broken and you should replace it to prevent a possible fire hazard. \015\012You can replace the element easily for not alot of cash. You'll need to pick up a new one at an appliance parts store, just bring them the ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

We used our LG diswasher to clean our grill grates, which was a bad idea, because now the unit will not clean the dishes. We cleared the washer arms of debris, but the unit still is leaving the dishes on both racks dirty and is leaving the liquid soap dispensed into the unit undissolved on the door of the unit. There are no kinks in the water inlet, and water is getting into the unit, but the dishes are not getting cleaned.


Hi\015\012\015\012\015\012Thanks for using FixYa. Please make sure the dishes are loaded properly or\015\012dishwasher is not overloaded. Also check that the dishwasher is filling\015\012properly. It will fill with water up to ... LG LDF6810ST Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0786 seconds