Having problems with your GE 24 in. GSD2120C Built-in Dishwasher ?

Potscrubber dishwasher leaks water at the drain pump valve shaft opening at the metal plate holding the solonoid


Answers :

Repair Help & Product Troubleshooting for GE 24 in. GSD2120C Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Potscrubber dishwasher leaks water at the drain pump valve shaft opening at the metal plate holding the solonoid


... GE 24 in. GSD2120C Built-in Dishwasher

Smeg DWF612WH dishwasher has developed a leak. Water comes out of the rectangular hole on the side of the water softner used to mount what looks like a level or pressure switch. A few seconds after the fill valve opens water leaks out, not a lot just a small trickle. After the washer has filled and goes ito its cycle, it does not leak again. Over the past weeks the problem has got progressively worse.


... Smeg 24 in. DWF612WH Free-standing Dishwasher

Dishwasher does not start it seems there's no water coming in the tub. I got a trouble shooting manual from ejunkie.com and tested the coil of the water valve which read 1000 Ohms, which means it's OK. Then I hot wired the coil while connected to the water line and the valve opened and I had water flowing [ in a bucket] I have tried to start the test program [hold power scrub plus and regular switch at same time then start button] and lights start flashing you hear drain pump come in then the un


... Bosch SHV4803 Dishwasher

My GSD900G-01 dishwasher leaks where the hot water is supposed to go into the tub. There's a plastic fitting that seems to be glued to the side of the tub and the hose from the inlet valve goes to the top of this fitting. There are no visible cracks or other damage but there is some rust inside the tub at the fitting. The fitting has two open gaps on it's side which is where the water is leaking out. It looks like the water is supposed to flow past these gaps (which I'm guessing are there to


Hi, I seen where this posted on premium. If you still need assistance, please let me know. I can help you through this.\015\012\015\012Vic ... Dishwashers

I have a Kenmore dishwasher 665.17799990. Not enough water was coming in so I thought that I'd check the screen inside the water inlet valve to see if it was clogged. It was. I cleaned it out,but mistakenly opened the wrong part of the valve looking for the screen and took apart the diaphram assembly. Bad mistake. Now I can't get it back together without it leaking like crazy. I can't remember how it was configured to start with. I put it together once,but it wouldn't shut. I can't afford to buy


... Dishwashers

Just installed dishwasher, I open water valve to check for leaks and water pour In dishwasher and pour out the bottom


... Avanti DW18 Built-in Dishwasher

G.E. (GSC3408K00WW) Hi ran dishwasher without water supply valve open, oops. Know it sprays water and after a minute and a half it kicks out the breaker in the apartment. I flipped it over and the motor shaft and pump shaft turn by hand. Any ideas what could be the problem other then operator error, LOL.


... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

After it cycles I open up dishwasher and the soap tray is open with soap leaking out and on dishes. How can I tell if this is a problem with float switch or water inlet valve because I think it's not getting any water? have maytag MDB3700AWE. also checked to make sure nothing stuck in float.


Try this link it should help http://appliancehelponline.com/dishfloatwaterinletvideo.html ... Maytag 24 in. MDB4600A Built-in Dishwasher

With the assistance of someone from this forum, I can see that my dishwasher is slowly leaking water from the opening on the left side of the dishwasher area. There appears to be a problem with the dishwasher fill valve, and I'd like to know if it is something that I can replace/fix on my own. Thanks, Nick


Yes it should be possible to replace the fill valve but I will need the make and model number of your dishwasher to provide you further suggestions. ... Dishwashers

Hi I have a Neff built in dishwasher s5453X1GB/70 about 4 years old. Never had a problem before. Came downstairs last night to find the kitchen floor flooded. Water also still in machine. But must have been near end of cycle as plates all clean. I have read other links and opened pump compartment in centre of machine and syringed out all water and cleaned fan. When i switch on machine it is still making odd humming noise (emptying cycle?) I have read about anti -flood valve etc. Any more tip


... Dishwashers

I have a GE dishwasher (GSD4020Y70BB) new in 1996. I replaced the whole motor assembly in 2007, seal was leaking. My dishes are not getting clean now, dried food left on plates, coffee stains in cups not being cleaned. I removed main spray arm, found nothing, turned washer on and plenty of water gushing out. I took the cover off sump all clean. I removed the filter screen in the back, there appears to be a valve with some soft rubber around it. Water gushes out of this, does stop during the cyc


Have you checked the drain pump impeller and drain hose? I am curious if there is a back siphon from the drain hose or the waste outlet at the garbage disposal might be blocked or plugged with food debris.\015\012I wou ... Dishwashers

I have a Bosch dishwasher and the upper arm that spins and dispenses water has come off. There is a bracket on the back wall with 2 protruding pieces and an open whole in the middle which seems like the water comes out of it. There are 2 metal "clips" on the side of this braket which seems like the plate part of the spining arm should be able to attach to it.. I cannot figure out how..Any helo would be apprecated..


On Bosh dishwasher you just slide the upper arm vertically until it snaps in place. The arm attachment will snap automatically into the clips, onto upper dishrack, unless the upper arm is damaged ... Dishwashers

Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.


If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers

This a message for phil. The aquastop valve was not under the dishwasher. On my model, it was fitted directly onto the water inlet pipe. I replaced the valve as you suggested. After removing the old valve you could see through the clear plastic housing that water was leaking inside the valve. Anyway replaced valve but had to split wires and reconnect with connections supplied with the valve and according to instructions. Water leak has now stopped but when 'on' button is depresse


Please provide dishwasher make and model. Looks like you are retrofitting the valve to your dishwasher which may not be getting the correct supply voltage from the dishwasher control. Will need to understand part no. of the replacement valve you ha ... Dishwashers

Leaky Dishwasher I recently moved into a new house that has a brand new Magic Chef dishwasher. We haven't even had a chance to use it, but last night discovered water leaking from the bottom onto the floor. When I opened the door, there was about 3-4 inches of water inside. I baled as much of the (slimey) water out as I could, and that stopped the leak. Now afraid to run the dishwasher for fear that it might leak even worse. E71195 Type 777-0


... Magic Chef 24 in. DC4000 Free-standing Dishwasher

Miele 646 sc plus inlet tank solonoid valve on water tank leaking. We moved the machine from one room to another and now this valve is squirting out water. We replaced both door seals thinking that was the problem, then started the machine with a side pannel removed, and saw the jet of water coming from the solonoid valve on the water inlet tank. Any ideas.


... Miele Dishwashers

Dishwasher is leaking in front on the floor during the final rinse cycle. we opened the kick plate but did not find any water farther back. We also checked around the seal of the door . did not find any leakage.


Try a different detergent like cascade.. ... Dishwashers

We have a frigidare model PLD4375RFC3 dishwasher that won't turn on! I select the cycle and press on and it just shows me the time for 15 or 20 seconds and then turns off. I opened the bottom and everything looks ok, there are no leaks and all wire connections are in place. Latley the motor has been squeeling a bit and the dishes have not been clean so obviosley something has taken a dump! I just need to know were to start, is it the water valve or circulation pump and how do I test them?


... Frigidaire PLD4375RFC Dishwasher

Samsung dmt800 dishwasher error code 4e. Water valve is open, pressure and temp correct, flex water hose not kinked, water inlet valve is free of debris. next steps? replace water inlet valve?


... Samsung DMT800RHW Built In Dishwashers

Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?


You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

It appears that the Inlet Valve is leaking on my Kenmore dishwasher. By replacing the inlet valve do I also need to undo the connection at the bottom with the teflon tape - or can I just undo the screws at the bottom of the plate and leave that connection alone? The dishwasher is 4 years old, could something be causing the valve leaking other than the valve being bad? Thanks! :))


Probably just hard water causing the solenoid to stay slightly open. \015\012Shut off water \015\012Remove 1/4 hose\015\012Remove wire harness/plug\015\012Remove other side hose should be a clamp.\015\012Unscrew mounting bracket and replace in the sa ... Dishwashers

Item: Whirlpool Ultra Dishwasher Age: 3 yrs Problem: Not enough water to effectively wash the dishes. State: When the dishwasher is started, the fill valve opens as normal. Only about 1/2 the amount of water is let in when the pump turns on and the washing cycle begins. Opening the door shows that the water level does not reach the bottom of the float. When I close the door, the wash cycle begins again but stops after a few seconds. This is when the water begins to fill again. This time, the wat


Larry,The float is generally for overflow conditions and will interrupt power to the fill valve solenoid. If you are not filling completely in the time allowed by the timer, it is most likely a flow restriction in the water ... Whirlpool GU2400XTP Built-in Dishwasher

Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst


... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher

Dishwasher continually beeping midcycle. Open washer - dishes wet, water in bottom of dishwasher and water faucet sign illuminated. Can anyone advise what's going on? Just checked the water valve to make sure it was open. Thanks.


... Thermador DWHD630GPR Builtin Dishwasher

Water leak My model is a GU2400XTPB1 The tub of diswasher has small hole where a screw is mounted on bottom of dishwasher. Leak is severe during cycle. I have tried epoxy but it will only hold up for a few washes. Will anyhing seal the leak and hold up? The dishwasher is only 2 years old..


Mine also started leaking. Element also too hot. Mine has a 20 year warrenty on the tub (which I was NOT aware of) Repairman came today and the whole tub unit and element will be fixed for free! Look in your whirlpool instruction book to see if your ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2797 seconds