Having problems with your GE 24 in. GSD2220Z Built-in Dishwasher ?

Standing water washer not draining completly after wash is finished


Answers :

I would say you have a clogged drain hose. Check the hose for any blockage. Also may need to check under the dishwasher where the drain hose connects to the washer - this is where i've had blockage before. Make sure the power is off to the machine, as the wiring is around that area also.
Repair Help & Product Troubleshooting for GE 24 in. GSD2220Z Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Standing water washer not draining completly after wash is finished


I would say you have a clogged drain hose. Check the hose for any blockage. Also may need to check under the dishwasher where the drain hose connects to the washer - this is where i've had blockage before. Make sure the power is off to the machine ... GE 24 in. GSD2220Z Built-in Dishwasher

Just installed a FDB520RHS2 Frigidare dishwasher. Is it normal to have water standing in the bottom after washer is finished or should it be completely drained?


... Frigidaire Dishwashers

When the dishwasher is completed and finished, there is standing water in the bottom of the washer. We have to drain manually and the dishes are not rinsed and the smell is funky.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

Kenmore Ultra Wash Quiet Guard - will not drain at end of cycle. After cycle is complete, water (not clean) sits at the bottom of the washer but I still unload the dishes and then turn the cycle dial around again - going past all the water heating and filling and washing - and land on the drain cycle, it will drain. Any ideas why it will not drain when I let a cycle run, but will drain once I cycle it through to the drain option?


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Westinghouse Virtuoso 922 dishwasher. Wash cycle completes, but water does not drain out. If I let the cycle continue, after a delay the rinse cycle starts, but of course no clean water is pumped in so the dishes are "rinsed" in the dirty wash water. The wash cycle itself is successful with water pumping all around the washer if I open the door mid-cycle. I have removed and cleaned all filters which were correctly fitted so I am confident there is no foreign matter inside pump. When the water sh


... Dishwashers

I have a GE Quiet Power 3 dishwasher and water is not draining completely after the wash cycle completes. There is about an inch of risidual water in the bottom of the washer after the wash cycle is done.


... General Electric Adora GHDA670N Built-in Dishwasher

I have a Bosch dishwasher, stainless steel front- with buttons on the inside top( same as display, and the washing cycle won't start. Water seems to be running into the washer, as I can hear it, but the cycle never starts. Recently, I had clogged garbage disposer issue that has been resolved. The dish washer drains into the disposer, and I had free standing water left behind in the washer for 2days during this time.. Could this be the issue? Can you help me figure out this problem? Thanks!!


... Bosch 23 in. SHU 8805 Built-in Dishwasher

Kenmore elite dishwasher model 665.13153k701 At end of wash cycle, water does not drain completely. Intemediate drains during wash do drain completely. rinse and hold drains completely. watching water at end of wash thru disposal, water flow cuts off like valve closed. other drains taper off


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have just bought a cid60b10 dishwasher and it won't work! I completed the first wash putting water in the salt dispenser as instructed and when it had finished the wash there was still water in the bottom of the washer. Now when I turn the machine on all the buttons light up and then go off and I cannot select a function. Does anyone know how I can fix it without having to send for a technician?


... Dishwashers

Bosch dishwasher model SHV6803UC/12 - washing cycle finishes with substantial water in pan. Dishwasher turns on intermittently following cycle and drain small amount of water but never close to completely draining pan.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I`ll start by letting you know there are many things which can manifest in the manner you`re describing...or even how one interprets what you`re ... Bosch 24 in. SHX46A05 Stainless Steel Built-in Dishwasher

Yes I have a whirlpool DU1345XTVB1 dishwasher. Just got in July. After each wash cycle the dishes are not dry. I have been using Finish gelpacs w/jetdry & also have a off brand drying agent in reservior to help dry dishes. The water temperature is set pretty hot & washer is draining good. I have tried checking wash cycle a few minutes into 1st cycle to see if water is in filling & heating. Didn't know if maybe heating element going out or thermostat not working? Thank you for your time.


<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-language: EN" lang="EN">Hi,<br />Check your heating element.. </span><br />\015\012<span style="FONT-FAMILY: 'Trebuchet MS'; FONT-SIZE: 10pt; mso-ansi-lang ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

I have a kenmore Ultra Wash Dishwasher, Model 15825691. We were recently hit by lighting. Once hit, the dishwasher started up. Since then, all cycles work, however, at the end of any cycle, the dishwasher continues to run and fill the bottom of the washer up to about two inches and then cuts off, so when we open the washer, there is approx 2 inches of water inside no matter what. I have pressed the "Cancel/Drain" button, in which drains the water after two minutes, but when that is finished, the


There must be a problem wit the fill valve. Check which valve the water enters. Check first the wiring to the valve of the water inlet or where the water comes out to fill the washer. Check for physical evidence of damage on the solenoid (or contr ... Kenmore 24 in. 16539 Built-in Dishwasher

Washer goes through complete cycle but doesnt totally drain. there is about 1 inch of dirty water left in washer. this washer is over 1 year old, kenmore ultra wash


Make sure your Drain Pipe is properly fixed . any Blockage in the Drain Pipe Creates the above mentioned Problem ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

When starting a wash cycle it pumps out the remaining water as usual. It fills normally but does not pump/wash the dishes. It continues to heat and when first noticed it seemed to have gone through the complete cycle but didn't wash. The detergent door had opened and the soap pack dropped out but it never dissolved. The dishes were extremely hot too. Is the same pump used to both drain the washer and wash the dishes?


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Asko 24 in. 1805 Built-in Dishwasher

Whirlpool quiet wash plus dishwasher, (DU915QWDB1) not sure if the model number is correct. Basically my dishwasher will not drain completely (smells bad) and spills water during a wash. I don't know what it is, if there is something easy to adjust inside the washer? Or If there are general troubleshooting tips that I need to run through in order to diagnose the problem? Help!?


... Dishwashers

Have SHU43C and have had no problems with it. We usually run it on the Quick Wash cycle, but ran it on the Regular Wash cycle yesterday because the glasses seemed to be coming out spotty. After it ran, there were no lights on the display like there usually are. The washer had run and the dishes were clean, but it has not drained completely. There is still about an inch of water in the bottom, despite removing and checking both the Large Object Trap and Fine Filter (neither which were clogged


The drain pump needs to be replaced or cleared of obstruction. ... Bosch 24 in. SHU43 Built-in Dishwasher

When i turn on my kenmore 363.15222100 it starts putting water in instead of starting the washer when it finishes filling the water it heats the heating element and wont wash or drain.


... Dishwashers

After wash cycles are completed there is about 1/2 gallon of water remaining in the bottom of the washer. I checked the drain that exits into a disposal and that is clear. All around the bottom of the washer base is clean and I can find no obstruction. Nothing in the owners manual gives me a clue as what else to do. I don't want to start taking things apart unless I have to.


Hi and welcome to FixYa. I am Kelly. Most dishwashers are connected to the sink / garbage disposal via an Air Gap. The Air Gap gets debris inside it that blocks the drain passages. Check out this video on how to clean it: ... Maytag 24 in. MDBH950AW Built-in Dishwasher

Water does not completely drain? Garbage disposal is functioning properly and hose from Kitchen Aid dishwasher to Garbage disposal is good. I ran the dishwasher a couple of times start to finish for rinse cycle and approximately 1/2 inch of standing water on the bottom. Any ideas? Please help. Thank you.


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

The washer won't complete it's cycle. It just runs and runs. One time I got it to complete by turning it off, then switching to the Rinse and Hold cycle, but now nothing works. It doesn't drain the water, it appears to be stuck in the wash part of the cycle.


... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Frigidaire dishwasher model # fphd2491kfo has standing water in bottom after the wash cycle is complete


Hi Bill Walters - Generally speaking, the drain pump receives power directly from the main control board. If you have verified that the drain pump does not work then more than likely it is not getting power or the drain hose is restricted. If the ... Frigidaire Dishwashers

GE Triton XL - Water won't drain after wash cycle is complete


... Dishwashers

Hotpoint dishwasher machine go's through wash cycle, through to the end, after dry cycle ends there is always 2 inch's of water left in it that doesn't drain out' but some water is added when new cycle is started, then throughout wash cycle whenever water drains it never drains completely, always leaves 2 inches of water before adding more water to begin rinse cycle. what do I need to do?


... Dishwashers

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

Water has not drained completely away. Scummy residue left behind. Now machine won't respond to 'light wash' command. It's a free standing Ultraquiet 111. I don't know how to clean it. Help...please


Hi, well the ONLY reason that a machine will NOT drain away, is either the Pump, is faulty, there is a blockage in the outlet Pipe, or a blockage in the internal pipes. You will have to either DIY or call a professional.\015\012\015\012If you D ... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2043 seconds