Having problems with your GE 24 in. GSD2220Z Built-in Dishwasher ?

GE dishwasher my dishwasher comes on then goes off by itself before it finishes it cycle.


Answers :

Ok, this will occur if the dishwasher timer control module become unstable overtime. this will require the replacement of the affected timer control or control board asap.
Repair Help & Product Troubleshooting for GE 24 in. GSD2220Z Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Bosch dishwasher model SHE4AP02UC/06, serial number FD901102579 that has been used twice since installation. When I select the Regular Wash cycle, the Regular Wash LED and the Active LED come on. The machine washes the dishes and then when it stops making noise. At that point the Active LED goes off and the Clean LED comes on with the Regular Wash LED. These LED's do not go off. There is no signal saying that the dishwasher is finished. Is this the way it is supposed to be operating or


Ya id say until u open the door after it has washed ... Bosch Dishwashers

I have a Fisher & Paykel 913T soft touch dishwasher. On all types of washes when the wash cycle starts there is no 230 volts on the element & after 5 minutes the wash cycle finishes & then goes onto to the next cycle. None of the wash or rinse cycles heat the water but on the dry cycle their is 230 volts onto the element & dries the dishes OK. Is my problem the power supply PCB or could it be the Controller PCB? Does the 230 volts to the element on dry cycle come from the same cicuit on the po


Have you considered the possibility the water temperature sensor may be faulty.\015\012\015\012If the controller is getting false water temp reading then it may never turn the heater on.\015\012\015\012Generally with FP dishwa ... Dishwashers

Our dishwasher goes through the cycle and finishes fine without water in the bottom. Then within a couple hours, water comes up and sits at the bottom of the dishwasher. Handyman could not figure out why. No clog in place.


Hello Sandra, Welcome to Fixya ! You've come to the right place. The problem you're experiencing sounds like (unfortunately) a common one. The water inlet valve has been an issue with B/S/H built ( this includes bosch, thermador, seimens & gaggenau ) ... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

GE dishwasher my dishwasher comes on then goes off by itself before it finishes it cycle.


Ok, this will occur if the dishwasher timer control module become unstable overtime. this will require the replacement of the affected timer control or control board asap. ... GE 24 in. GSD2220Z Built-in Dishwasher

My dishwasher goes through its cycles but the dishes come out all gritty and often not clean. The glass ware becoems quite cloudy and again gritty. Someitmes the Finish powder is not all used up


Hi there,\012Well first of all you can check out the water-inlet valve -most cleaning problems are caused by the dishwasher not getting enough wash water, so the water-inlet valve is often the cause. This valve is usually at the bottom le ... Haier Dishwashers

The dishwasher is in the middle of the cycle air dry indicator goes out lock indicator goes air dry goes out. Then dishwasher hesitates lock light goes out air dry indicator comes on. This is repeated throughout the cycle


... Kenmore 15634 Built-in Dishwasher

We have a Blomberg dishwasher. We came to a finished cycle to find water in the bottom. We have removed the water by hand, cleaned the filter and the hose. The lights come on, but it doesn't respond when trying to run a cycle. It will do it's ''finished cycle beep sequence'' at the end of the cycle that it didn't actually run. We have reset it by holding down the start button. Turned it off and on, etc.


I am curious what the repair guy found. We have the same problem. ... Dishwashers

Westoint Dishwasher I have looked in the manual under troubleshooting tips, but didn't find anything on the problem. The dishwasher goes into cycle,but during the wash cycle it stops,makes alarm and the wash and rinse ligts come on. And now I can't even find the product on this site.Westpoint Dishwasher WQP12-9240. Thankyou My dishwasher is stopping at stage 2 of the programme after beeping once. Quite often the detergent flap doesn't open. Am at my wits end and threatening to leave home!!!! Th


Hi again,\015\012\015\012That should be OK. Just get in touch with your sales rep or his boss. Somebody there will be able to look up the record of the purchase. If they ask for model & serial numbers, you have them. You will find ... Dishwashers

There is a pool at the bootom of my dishwasher when the wash cycle is completed. When doing "Rinse Only", I could hear something come on immediately following the rinse but nothing seemed to happen. I pulled the Dishwasher out and the drain tube is set up so that it immediately goes upward a few feet before it eventualy goes back down to the drain. I noticed that there is water in the tube right next to the Dishwasher before it makes that climb. I'm wondering what all this means...


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012 ... GE GLD5800L Dishwasher

I have a Kenmore model 665. It is having an intermittent problem. It goes through the fill cycle, and then stops. Timer does not progress either. Then, at some random moment, it will come back on and finish the entire cycle. This could even be a day or two later. Sometimes it seems a nearby thump will set it off, other times no one is anywhere near it when it comes back on. This happened for a month or so off and on 6 months ago, and then it worked fine for 6 months. Now it's back to it.


Its possible its a door switch thats causing this or the main wire is loose..be careful as you do have 115 volts. i'd turn off power and check where power comes into d/.w and make sure the wire nuts are tight.. the next step is a little more difficul ... Dishwashers

Incomplete cycle My Miele dishwasher (3 to 4 years old) finishes, leaving the dishes dirty and wet. It seems that it may only be running through part of the cycle - I'm not sure but from the time I set it going to the time it switches off, it seems shorter than usual. The dishwasher is not emptying as it has a pool of water in the bottom. I have tried various settings and have the same problem. the inlet/drain light DOES NOT come on. I have soaked up all the residue on the bottom and cleaned out


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

I have an LG dishwasher Model LD-O5AW2 Benchtop. IT has been going perfectly until now. I push the button in and then the start button, when the wash cycle has finnished it wont empty until I push the stop button off and then on again. Then it empties and goes to rinse but wont come out of the rinse cycle, just keeps rinsing, until I turn it off and on again.Up until now its been a great little dishwasher. JOAN


... LG Dishwashers

Smelly Dishwasher Hi I have a Baumatic bad6002 dishwasher. The smell that comes out of it is putrid and has been from day one. We rinse everything before it goes in, I have used dishwasher cleaners and hung smelly things in there to prevent the smell but it still stinks. I do not use cheap cleaners only finish or morning fresh. It gets turned on approx every 2-3 days and the dishes actually go mouldy before it gets turned on. I have had several dishwashers and this is by far the the most disgust


... Baumatic Dishwashers

Hotpoint, intergrated dishwasher BF12/47916/7 has stopped working, There is nothing happening at all. it has done half a cycle the only thing that happens is when you put the cycle on the dot before cycle no: 2 the power light comes on orange, this usually goes red when the cycle is on. I have changed the fuse & there is no difference. Help!


... Hotpoint 23 in. BF41 Built-in Dishwasher

I just installed a new Kitchenaid dishwasher (Model KUDE60FVSS3). After filling with soap, closing the door and starting the machine, it fills with water, waits a couple of minutes and then I can hear low humming noices coming from down below. After opening the door it appears that neither spray arm has turned as if to wash. This dishwasher was purchased new a few years ago and kept in storage as our basement was being finished. This dishwasher has never completed one cycle. Any and all inf


If you have a garbage disposal, there is a plug in the dishwasher that has to be removed for the washer to drain. ... KitchenAid KUDE60FVSS 24 in Builtin Dishwasher

My Frigidaire dishwasher keeps showing the Er uo codo on the display. It used to would finish a load even though it would stop for a while when the error message came up, but now it will not run at all when the error message comes up. I read on this site that the Er uo has to do with the vent. I pulled the dishwasher out and removed the vent. I turned the dishwasher on and the vent opened and closed about three times when the cycle started, then it stopped and the error message came up. Is


Hi. This code is in reference to the vent assembly. This may also be a control fault, as well. To isolate the culprit, you will need to make sure that the vent assembly is not blocked. If it is blocked, it must be replaced. Restricted air flow will c ... Dishwashers

Cycles improperly My dishwasher does not cycle properly. It races through the cycles, even when set to pots & pans, in about ten minutes. At first I thought it not filling properly, checked the fill switch, it's fine and water does come in. Then when it's finished it does not always drain completely. I have checked everything on the drain end as well. It seems to have a mind of it's own. I replaced the $145 computer control with no luck. It actually sped up from the original 16 minute ful


Hi there,\015\012\015\012please let me know the make and full model # off your d/w.\015\012\015\012thanks ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

During power scrub cycle which is the one we use most of the time the dishwasher stays at one minute fot a long time. the dishes come out clean and it finally does finish cycle just dont know why it takes so long on last minute of cycle for so long


It's just heating the water more ... Bosch 24 in. SHU43 Built-in Dishwasher

Last month i was washing dishes in the dishwasher and if i remember correctly i opened the door to get a knife out of the dry cycle. i remembered shuting the door back and that is about it. this is my daughters dishwasher by the way. i left her house not noticing that the dishwasher ever finished. a week later she asked me if i had a problem with it. i told her no. when she goes to push the start button nothing happens. it doesn't restart its self. we have turned the breaker off and on


Hi.Depending on the model you may need to reset the dishwasher. Most Kenmore and Whirlpool built dishwashers for example need to press a reset button sequence to operate again after a problem has occurred. In that case you usually get lig ... Dishwashers

My dishwasher starts no matter what cycle on a 2 hr hold, it doesn't hold it goes ahead with the wash cycle. And it won't shut off when the cycle is finished. Sometimes it starts like it's supposed to but most of the time it just has a mind of it's own.


... Bosch SHU5307UC Built-in Dishwasher

My 2 year old frigidaire dishwasher is not filling up with water, goes through cycle but no water is coming out, valve is open all the way?


If the\012water flows then the flow should be good, if not the inlet valve is bad or there\012is dirt in the filter. Also check the flow at the inlet of the water line. What\012is most important for the motor to start functioning is that the ... Dishwashers

My Miele Diamante G 2150 SCU is not completing a wash cycle. It starts and water goes into the dishwasher but it doesn't finish the cycle and the soap is still in the container.


... Dishwashers

Won't drain dishwasher goes through all cycles like normal but when it's finished there is still water in bottom, tried to cancel cycle but water stays. I cleaned all the water out and try it again same thing happened. I cleaned the filter so i don't know what else to do!


Make sure the garbage disposal is clear so the water can exit. After that, you may have something caught in the drain hose or check valve. It would require removing the bottom kick plate to gain access to check. ... Kenmore 24 in. 15689 Built-in Dishwasher

My GSX4756 dishwasher seemed to stop mid cycle and the start light is flashing. I have pressed the start button until the light goes out but as soon as I close the door it starts again on the rinse cycle but beeps like it has finished


Did you check to see if anything has fallen down into the drain area. Occasionally a butter knife will fall to the bottom of mine where the drain area is, there's an aparature that spins, and stops the machine midcycle. ... Bauknecht Dishwashers

On my Kenmore Ultra Wash Dishwasher model 665 the Normal Wash light is blinking even though the previous cycle finished successfully. Also I can't start the dishwasher -- it doesn't respond to any of the buttons. I have powered it off and on and the Normal Wash light comes back on within 5 seconds of restoring power.


Http://appliancejunk.com/forums/index.php?topic=2933.0\015\012\015\012\015\012\015\012Hi. please find above your service and repair manual, bel ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2061 seconds