Having problems with your GE 24 in. GSD4000J Built-in Dishwasher ?

The dishwasher will not come on. I have checked the plug in and the circuit breaker. They are o.k. The lock handel is alittle loose feeling i tighten it as much as possible this did not help.


Answers :

Repair Help & Product Troubleshooting for GE 24 in. GSD4000J Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The dishwasher will not come on. I have checked the plug in and the circuit breaker. They are o.k. The lock handel is alittle loose feeling i tighten it as much as possible this did not help.


... GE 24 in. GSD4000J Built-in Dishwasher

Just replaced the white plastic in-setting of the top sprayer that was broke and while i tightened the "nut/screw" that keeps the spray arm up there it almost feels like it is too tight to turn freely. Should I oil it with something or is there some other reason that it is not as loose as i think it should be to turn (which it's not during the cycle)? thanks for any help.


... Champion 24 in. UH-150B Built-in Dishwasher

Mdb7759 Control panel stopped working, replaced it and got two cycles out of it and it stopped working again. I feel that this machine is a real lemon and should be recalled. Any possible solutions? I've tried the heated dry/ high temp wash reset but I does not work. Help


... Maytag 24 in. MDBH950AWS Built-in Dishwasher

My Kitchenaid ModelKUDI01TJBL0 only leaks at initial start up. Just after the water fills, the first few seconds of the wash cycle. It pours out the front door for a couple seconds than no more for the rest of the wash. It is level, no cracked arms, or loose pumps.Splash guard is in place. The float seems to be working, not too much water in the bottom. I am stumped. Although I do feel that it has something to do with the level of the water being too high, when the arm starts turning, it makes a


Is the unit level or leaning back if leaning back it is morelikey filling too much if level make sure the float moves up/down easy if not clean ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Dishwasher problem Our Asko 1353 dishwasher stops halfway through its's wash cycle. I suspected the thermostat, as it seemed loose in it's holder and not tight against the tub. After I tightened the holder the problem is still the same. Also, the on/off switch (pressure switch?) does not stay in the on position and when I looked it over I found one of the crimp on terminals had melted. Short circuit? Too much resistance from bad thermostat? How do I check the thermostat before I order a new one?


I think your switch may just be bad,but to check the t-stat remove both wires and use a multimeter,set the meter to ohms and connect the two leads to the terminals on the t-stat.with the t-stat to off you should read an (ol) open condition,when you t ... Dishwashers

There is a pool of water at the bottom of the dishwasher that wont drain out. nothing seams to be clogged. This happens in every cycle. If I drain the water manually as much as possible at the end of a cycle it will be there again after the next one. Thank you for your help.


... Viking Dishwashers

We have a Whirlpool Dishwasher Model ADP 5550 Condenser( made in germany) which we purchased in Australia. We have relocated to India and shipped it here. After connecting it and doing the necessary plumbing arrangements, the dihwasher is functioning but it does not complete the entire cycle. It only rinses and washes. it does not do the second rinsing and drying cycle. Is it possible to get an electrical diagram of this model as the consultant here feels that it may be an electrical loose conne


... Dishwashers

Please advise how I can safely remove the water and energy rating labels from from my Dishlex DX103 dishwasher,without damage to the paint surface. The labels are stuck firmly and can not possibly be peeled off.I would very much appreciate your help. Thank you, Heather Jenkinson


Hello Heather,\015\012Most labels can be removed with isopropal alcohol without affecting the painted surface.. Try a small amount on a clean cloth to verify that it doesn't 'cut' the paint.. ..but that should work for you.. ... Electrolux Dishwashers

How do I tighten the loose door handle on my Bosch SHX46A05UC/14 dishwasher?


... Bosch Dishwashers

My frididaire dishwasher is leaking at the heating element/burner (red wire). I have tried to tighten the connection from under the dishwasher but it continues to leak (very slowly). The clasp used to tighten the element does not hold it's tightness and will become too loose if tightened all the way. What do I do?


Replace the heater element. ... Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

Bosch dishwasher model SHV66A. New in 2004. Has worked well since then, but for last couple weeks something's up. Dishes aren't clean. Residue remains on everything. Food looks caked on & dried to plates. Silverware a little better but not much. Tried running a couple cycles with vinegar, no help. Took out strainers, etc. on bottom of washer & cleaned out; no help. Just ran a cycle now - - opened midway and it appeared the arms were both spinning. Also, water seemed warm (maybe not super


Hi\015\012\015\012If you are observing that the dishes are\015\012not clean, then you'll need to follow certain steps to be sure where exactly\015\012the issue. First thing to check for is\015\012the deter ... Bosch Dishwashers

Dishwasher flood I have a whirlpool "Queit Partner I" type dishwasher. When I used it for the first time it flooded my kitchen floor. I had to stop in the middle of everything. What do I do from here. Not sure if I put in the correct detergent or if I put too much in. Never had one of these things before. I was always the dishwasher...help...I can be reached at [email protected] Thanks for your help.


... Dishwashers

My dishwasher is a swan sdw7030w, water is going in and out the machine but no water is getting through to man part wher dishes are, am putting it on and it's jumping from my choosen cycle to economy while beeping, the salt light and starish looking 1 are both on as well, can anyone help me? It was working fine n old house, could it possibly be my water pressure as I can't think of anything else as a woman. Please help me.


... Dishwashers

Bottom rotating spray arm is loose and strikes the inside of the door. How to remove and tighten or how to tighten?


The diagram at this site shows how the lower arm spray fits together with the wash pump assembly. The ... GE Tritonr XL GSD6260JCC Dishwasher

My dishes seems to have white residue left on then i can feel it on the dishes mostly the top rack i can feel little tiny reside bumps on the glasses like maybe it didn't rinse well so I have run the dishwasher trough with no soap or anything on hi temp rinse and the white residue is still there. can you help?


Hi,Check your heating element.. Dishwasher ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My whirlpool motor does not sound like it kicks on when started. The dishes are not getting cleaned...and water remains in the bottom. When I hit drain, it will drain. I also recently noticed that I am having to use my garbage disposal much more often and do not even put much food down it. Could it all be related? PLEASE HELP!!!


Yes it's most likely related. Your dishwasher dumps all the debris it washes off the dishes into the garbage disposal. I'm not a dishwasher distributor so I can't tell by the model number just what dishwasher you have.\015\012 Most people dump ... Whirlpool GU2400XTP Built-in Dishwasher

My whirlpool gold dishwasher leaves a thick white residue on the dishes. You can actually draw in the residue with your finger. I have cut back on soap, tried different soap, and run vinegar thru it. Nothing helps. My old dishwasher ran fine. Is it because the new one doesn't use as much water? HELP!


Www.dishwasherfilter.com will solve this problem guaranteed. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My 450 pro Viking dishwasher (only a couple of months in use!)has both lights of normal wash and light china on, as well as the power light on. I cannot cancel program or start. It goes nowhere. Can someone please help me? I have 5 young kids at home and this is my idea of a nightmare! HELP!!!! Thank you VERY much Alma


\015\012Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hums" again and will do nothing. ... Viking Dishwashers

I've had a Miele G 851 SC Plus Novotronic dishwasher for about 7 years. In the past few months it is not cleaning well . . . streaking of glassware and some heavy stripping of finish on flatware. Feel like something needs to be cleaned out or a rinse aid needs to be added or . . . ??? We've cleaned out the bottom basket but didn't seem to help. Can you help?


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

The cabinet handle that is on the wood cabinet door cover is loose, I need to remove the cabinet door, tighten the knob and replace the door


... Miele G2183SCSF Builtin Dishwasher

Possible loose seal


Dear friend,\015\012ngfam at you service! happy to assist!Call service and have them change the door sensor!This is an electronic part!We sell appliances for 65 years and I recommend this nation wide Fa ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Dishes come out feeling gritty. Using Finish doesn't help


If you open the door immediately after the dishes are washed, and before the "dry" cycle, is the water hot enough to have "steam" coming out of the machine? You should be able to feel the heat. If not, perhaps the water is not getting hot eno ... LG Dishwashers

Having trouble with dishwasher- I feel like dishes are not getting clean- will replacing circuit board on dishwasher help dishing become cleaner?


You may need to clean out the filters that keep food from being pumped up to spray out of the sprayers. This will depend on your make and model as to how to do this. Clogged filters will reduce the amount of water being sprayed. Try opening the do ... Maytag Dishwashers

Danby portable dishwasher ddw1899wp starts taking in water and then stops working with pre-rinse light blinking. Please help me on this issue. Any answer would be much appreciated.


If the water level sensor does not electrically shut off when the level needed is reached, the pre-rinse cycle will error out thinking that the level has not been reached. That sensor is a float device and probably needs to be replaced... ... Danby DDW1899WP Portable Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0578 seconds