Having problems with your GE 24 in. GSD4020Z Built-in Dishwasher ?

Dishwasher started dirtying the dishes more after the cycle then when they were put in...we stopped using it. Now, every couple days/week...when I start smelling the nasty water, I run it, with bleach. After a few days, it fills back up with nasy water....any suggestions???


Answers :

You have a clog in your drain hose.let me know if i was helpful to you.
Repair Help & Product Troubleshooting for GE 24 in. GSD4020Z Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher started dirtying the dishes more after the cycle then when they were put in...we stopped using it. Now, every couple days/week...when I start smelling the nasty water, I run it, with bleach. After a few days, it fills back up with nasy water....any suggestions???


You have a clog in your drain hose.let me know if i was helpful to you. ... GE 24 in. GSD4020Z Built-in Dishwasher

I have a GE dishwasher model GLDL560N10SS. I noticed a burning smell coming from it the other day and then realized that although I can hear water running into the dishwasher when I start it, it never actually runs in the sense that the water is pushed through the various outlets to wash the dishes. I'm assuming that it is because the unit is dry and the heating element is still coming on that it is causing a burning smell. If I open the unit and reset it, it pumps the water back out into the si


The problem sounds like it is in the water inlet selonoid. Pull off the bottom panel and this is the part that the main water line hooks to there is a selonoid and it has a plugg inconnection to it unplugg it and check for power when the unit is supp ... Dishwashers

I have a NEFF dishwasher model SD11XT1F about 18 months old. It smells. I've tried all the book solutions but the smell returns after a couple of days. I can get rid of it by mopping out the small amount of residual waterin the sump, so I'm wondering if it's bacteria in the salt solution reservoir. I've run a programme pumping the waste into a washing up bowl. The water from the first two cycles appears greeny-yellow. Is that OK? Can I clean out the salt somehow and start again, or is it a d


HiThe smell usually comes when the unit is unable to drain water completely, you can run your dishwasher at its hottest temperature setting with 1 cup of vinegar inside the unit. After this take off the bottom front panel and clean it com ... Neff Dishwashers

Whirlpool DWF417W, Type 12155 A couple of weeks ago the machine failed to empty, leaving dirty water in the machine at the end of the cycle. Start a new program it emptied & all was then well. A couple of days ago we started a wash cycle as normal, shut the door, the pump normally runs for about 10 seconds then the cycle starts. However the pump just runs continuously?? After looking here there seemed to be a few links to the subject of water being in the base & the anti flood switch being ac


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

Asko diswasher Dishwasher will not get water. Lines all checked, water on. Pump runs even when in off. Problem started when there was a water clog in the sink next to the dishwasher, and the dishwasher backfilled with water. We used a shop vac to get the dirty water out. Next day tried to use dishwasher, runs, but no water and empying pump will not stop running. Ideas?


Check for water leaks or not draining/overfilling fault ... Asko D1776 Stainless Steel Built-in Dishwasher

Bad Smell I run my dishwasher at least every other day. I've noticed lately it smells....kind of like rotten eggs? Is there a filter that needs to be cleaned out? If so, where is it located and how can I do this? We have soft water running through the dishwasher and water doesn't sit in the bottom. Please help.


Start your dishwasher with no dishes in it.\015\012Let in run until it takes on water and start washing.\015\012Then open the door and pour in 8 oz of white vinegar and let it finish the cycle.\015\012If this does not correct the sm ... Kenmore 24 in. 15932 Built-in Dishwasher

GE Profile Dishwasher, GSD4920 won't stop running. Still spraying water. No lights on the display. Looks like it ran all day since I started it before work. I turned power off and back on, but it still starts running when I close the door. Water is in the bottom and looks pretty dirty. Any ideas? Thanks, Larry


... GE GSD3800G - Multiple Color Built-in Dishwasher

Dish washer does not drain after the cycle is complete. The last few months when the dishwasher is done their would be a small amount of water left in the bottom. It didnt create any problems but would smell after a few days. So we would just run the drain cycle and it would empty. Well i got home to and the wife said the it was really full. The water was dirty and when you run the drain cycle it didnt drain. She said the dishes were clean. So i cleaned the vent, and filled the sink with


Check drain hose and drain pump.End of drain hose must be in same level with machine.Try it. ... KitchenAid KUDR01TJ Dishwasher

Dishwasher fix water does not go through the spray,. the upper hand an lower hand are clean , the pump does operate to empty the dishwasher . I do smell like some burning smell when I turn the dishwaher on, the water start running for 1 minute or 2 than stop shortly and doesn t reach the arm then the dishwasher becomes hot inside . Thank you


Something has gotten passed the screen and is jamming your pump impeller pull lower spray arm pull screen and see if you can find what is jamming the impeller and remove it drain pump is separate ... Maytag MDB7100AWB Dishwasher

It starts running then stops - starts pumping in water then stops, etc. burning plastic smell near top... doesn't leak, gets power, but begins to fill, then stops - might start to drain (pump), but then that stops too...


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Asko D1996 Dishwasher - Tank fills with water but it "washing" cycle never starts. However, the heating element begins the work and with no water running over the heating element it smells like something is burning. I have tried changing the programs from Pots and Pans to regular wash but the same results. Nothing happens


... Asko D1776 Stainless Steel Built-in Dishwasher

I poured about half a cup of bleach on the bottom of my dishwasher to get rid of water stains after the last load I washed. Now when I try to start a cycle the dishwasher makes a noise as if its running but no water or washing action happens.


... Kenmore 15121 Built-in Dishwasher

Asko D1996 Dishwasher - Tank fills with water but the "washing" cycle never starts. However, the heating element begins the work and with no water running over the heating element it smells like something is burning.


... Asko D1776 Stainless Steel Built-in Dishwasher

Hi, I have a ge dishwasher, model number VSD2304J00WW and it does not run properly. When I turn it on, it will hum and then start to make a clicking noise. Then there will be a bad smell, and a little smoke. Also the water does not drain. I've had water in the bottom of it for a few weeks now. The cycle never finishes either.


... GE Dishwashers

Hi, I have a Bosch Dishwasher that sounds like it is working.... sounds like water is circulating in there, and yet, nothing is happening. I came home the other night and it was still running... had started it earlier in the day. I get the same sound when I start it. Help! Janine


Bosch dishwashers will run forever if it can't get the water to 150 degrees. it can't get it there because either the heating element is bad, or the solder joint on the control board that contols the heating element is bad. you can order a new board, ... Bosch 23 in. SHU3307UC Built-in Dishwasher

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

My dish washer isn't cleaning the dishes well. There are little particals inside of every cup and on dishes after it is done. I just emptied and and now I'm running it with bleach. But before I started it I looked at the drain hose under the sink. The drain hose had water in it. The drain hose is going uphill from the dishwasher to the sink so I don't know if this is normal to have some water in the drain hose when the washer completes since it's not would have to pump uphill to get to the garba


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

I have a Whirlpool Gold Quit Partner III, model GU1100XTLB1. When I run the normal cycle it functions well until near the end. At that time the unit stops and the pots&pans indicator light blinks. If I hold the cancel button in the unit drains then refills and the light starts to link again. I don't know how to reset this unit because I only have air dry. If I leave the power off for a day I can get the unit to reset. If not, it just fills back up with water and the pots&pans starts blinking aga


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Dish washer will not start. Program shows that there is power, but it will not start. Door is securely shut. the other day I took the trap apart and saw about 1C of standing water below the silver grate. I did this because the dishwasher was smelling bad, thought there might be food trapped there. any ideas?


Hi..If dish washer wont start check this\015\012\015\012Check for a blown fuse or tripped circuit breaker ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

Bosch dishwasher shu43c - no water is getting in. Starts and runs, but electrical smell is being emitted. Is this a valve issue, plugged water line or perhaps something more like the pump?


The problem is in my free guide. It is here. Odds are the drain line is plugged and it isn't letting in water because the old water isn't be ... Bosch 24 in. SHU43 Built-in Dishwasher

Good mroning after starting any program first the pump will run followed by water intake. After a while the machine stops and the light intake/drain starts blinking. Most of the time water will stay in the machine. After pressing the on/off bottom first switching the machine on again and starting a new program the machine pump start running emptying the water but than stops after a short water intake again. I opened the water stop but it seems to be ok. The filter inside the machine is cle


Good morning don't get shocked because ullu ki to abhi subah hi hui he ... Miele 24 in. G892SCU Plus Built-in Dishwasher

I have a Honda GC160 5 horsepower power washer with 2400 psi. When its cold it is easy to start but after it has been running for a while the only way to start it is to have the water shooting out of the wand. Once it is hot and running if i stop the stream of water (release the trigger on the wand) then the machine shuts off. It seems like the only way to keep it running is to constantly have water running through the wand. Please help


... Pressure Washers

I have been negligent in not cleaning out the filters and after the unit more or less stopped, I pulled the two filters finding them full of what looked like soap scum. I cleaned them best I could (but noticed the inner filter still had most of the small holes blocked) Started the unit and it cleaned alright for a couple of days. Last night after running a load all the water did not empty from the bottom of the tub? Any suggestion on what wrong? Bought the unit on 1/19/05. Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

My dishwasher recently started leaving a white, chalky residue on all the dishes. It wasn't gradual at all. One day everything was fine and all the dishes clean and the next they were covered in nasty residue. We've ruled out any issues with soap, rinse agents and hard water. A appliance repair guy came out and said the float was "tampered" with and said that he fixed it. He said that if the problem came back we need to order a new float assembly kit. My husband has looked at it several times an


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Whirlpool Dishwashers

My Kitchen Aid two drawer dishwasher started not draining all the water out, Then a few days later it would not stop running., both drawers. It only stopped when the circuit breaker was turned off. What is wrong? Does this dishwasher has a cancel button?


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1889 seconds