Having problems with your GE 24 in. Profile PDW7800 Built-in Dishwasher ?

Electrical expert Replaced our dish detergent dispenser cup. Everything was fine with that. However, the display only lights up for two cycles and the start button is not functioning. We have re-done the two wiring harness pieces and shut the power off via circuit a couple of times now, but the problem remains. Any suggestions?


Answers :

Repair Help & Product Troubleshooting for GE 24 in. Profile PDW7800 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Electrical expert Replaced our dish detergent dispenser cup. Everything was fine with that. However, the display only lights up for two cycles and the start button is not functioning. We have re-done the two wiring harness pieces and shut the power off via circuit a couple of times now, but the problem remains. Any suggestions?


... GE 24 in. Profile PDW7800 Built-in Dishwasher

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

Diswasher circuit connect problem


... GE 24 in. Profile PDW7800 Built-in Dishwasher

Model mdb7601awb diswasher . Nothing works , no buttons torn on or work when pushed, no action. 1.Have checked power to unit and is ok 2.checked door switches (2) and both work properly. 3. no visual discoloration on circuit board. There is a blue dot on the wiring harness from control board to button panel.When evaluating with magnifing glass I believe this to be blue ink droplet and not any burnning of harness. Need a Guru.


I have had the board replaced 5 times and the entire dishwasher replaced once. It was necessary to go to the state attorney general to get Maytag to extend the warranty. Just called the service center for the sixth time, after this the warranty will ... Maytag 24 in. MDB7601AWS Stainless Steel Built-in Dishwasher

Dd603 no power to top drawer. circuit board in top drawer ckecks ok bottom board and top drawer wiring harnes were burnt. replaced both pieces. Still no power to top drawer. Need some help. Thanks


... Fisher and Paykel Dishwashers

I have a Kitchenaid Kudioflss2 dishwasher.The normal cycle light on the display will not go off. None of the other lights will go on. I've completely disconnected the key pad from the unit and have shut off the power. None of the buttons are stuck down. I tried alternating between two buttons normal ,cancel,normal, cancel etc. and a few other combo's.The manuel under the kick plate is missing.Should i just buy a new keypad(part that lights up) or could it be the interface(part where all the wire


... Dishwashers

Kitchenaid dishwasher kuds24sewh2. Have done reset with the sequence of buttons and have even tripped the circuit. Nothing has worked. Thye unit powers on and then shuts off.


Hi\015\012\015\012If the drain pump is clean and the water inlet valve is fine\015\012then the issue is with the control board that is bad and should be replaced. Hope\015\012this helps...please post back for further assistance.\015 ... KitchenAid 24 in. KUDI01FL - Multiple Color Built-in Dishwasher

Have an electrical circuit that has stopped working. Romex circa 1930. The breaker is fine. There are 4 ceiling lights and 3 outlets on the circuit. There is power through the hot wire leaving the breaker. Tried wiring to a different breaker to be sure. Still no power


If there is power leaving the box, you have a broken/damaged wire somewhere.If all the lights and outlets do not work - the problem is with the common (return) (white) or a broken/damaged wire before the first item in the circuit.If the b ... Dishwashers

I am installing a Kenmore dishwasher model 13743. I have direct wired the washer?s terminal box wires to the wall power via a BX wire and the washer doesn?t respond. None of the panel buttons are active. With a multimeter, I find that there is voltage on the wall wires and on the dishwasher end of the BX cable wires that hard wired to the wall current. Even though, when I connect the dishwasher?s terminal box wires to the BX wires as directed in the Installation Instructions (white to white,


Next step to check the door switch...the door must close and the switches on the door must close to send power to the control...let me know ... Dishwashers

My LDF6920ST power supply has 3 wires white black and green. Green is for earth but my wall power supply only has two wires red and white do I need the third to earth out?


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Bosch #SHE44C dishwasher does not fill. No power to the water solenoid, but power coming out of the control board and the emergency shut off float and switch is working. I need a manual with a wiring schematic and cycle sequence so I don't have to tear it completely apart to trace every wire. Thanks


... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Which of the two wires conecting power cord in dishwasher is the hot wire


... Kenmore Dishwashers

I have no power to the dishwasher. I tried the circuit breaker, flipped it. No lights on, nothing. It must have been running when the power might have gone off, may be the power surged or something and it wasn't able to finish running the cycle. I have taken out all my dishes and washed them by hand but I still have water standing in the bottom of the dishwasher. I am a mechanically challenged mom and my husband won't be getting home for two more weeks. The dishwasher is a WhirlPool Gold Quiet


First check and make sure that the units not on a switched receptacle(and is wired into this circuit(i know the dishwasher is "hard-wired",as in the unit doesn't have a plug on it,but it could have been wired into this switched circuit by mistake) un ... Whirlpool Dishwashers

The dish washer ran its full cycle but won't shut off. the little pump motor in the very bottom keeps cycling water in the bottom. it won't shut off when you open the door, it won't shut off when you push the power button and the front switches won't respond. the little light on the front of the dish washer is blinking and it has never done that befor normally the lites are always on solid.....


The drain stuck cycle ( I presume you mean drain pump running constantly ) are directly related with overfill scenarios for Asko dishwashers of this ... Asko D3122XL 24 in Builtin Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher would not work and clean light would blink seven times. Asked an expert and they said to hit saniwash and heated dry two times. This work for a couple of times but now the dishwasher acts like there is no electrical power goimg to it. I tested the power with a voltmeter and there is power going to the circuit board.


Normally this happens when the dishwasher electronic control does not detect a water temperature increase during the main wash cycle. The issue could be in the heater element, the thermostat or the wiring that is connected to those or on the electro ... Dishwashers

No Power I have a bosch shx33 dishwasher. I just replaced the water valve because of a leak and now I can't start the dishwasher. It's like there is no power to the unit. I know there is power because I get a shock if I touch the two wires that are connected to the water valve. Is there another trip switch or something somewhere?


First let me say that using parts of your body to test for mains electriciy is a VERY VERY bad idea. You are lucky you are not dead. Please do not touch live parts again, get a multimeter or a mains tester.\015\012\015\012If there is mains across the ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

No lights come on, circuit not tripped, power to machine wiring


... Maytag MDB7100AWB Dishwasher

My Frigidaire fghd2433kf1 starting flashing PF occasionally. I would open and close the door and it would go away. It became more frequent until two days ago when the dishwasher stopped mid cycle and flashed PF. When I opened and closed the door, everything went dead and the dishwasher no longer works. It acts like it has no power coming into it. I checked the breakers and the wires connecting the power into the dishwasher. No luck. I replaced the control panel, but not the control board. It did


... Frigidaire FGHD2433KF Builtin Dishwasher

My dish washer just stopped working, no power no lights no nothing. it is plugged in and the circuit breaker is not tripped the wires for to the plug are tight and i didnt find an loose wires, the gfc plug is not tripped either, any suggestions?


This machine has no power, and i would suspect a broken wire but you say the trip did not trip,have you got a voltage tester?if so set to x1k or until when you touch both points it workes.with the plug in hand put one point on the right plug ter and ... GE 24 in. GSD3630Z Built-in Dishwasher

LE on display panel. I have taken front panel off and all wiring has already been electrically taped together, so I don't think it is wiring. (This was done by a service rep when I had 1E problem) How do I tell if the impeller, rotor or blade is blocked? Or sump assembly or main power control board needs to be replaced?


Http://www.justanswer.com/questions/2bijk-i-have-a-lg-ldf6810st-dishwasher-with-an-error-that-the-serv ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Dishwasher was cutting out intermittently,totally dead no power then after 15mins or so,finally went bang this am,smoke etc,took insection cover off at bottom swit6ched on again to see spark dead short on unknown unit with four wire block connector attatched,two white to same connector and two purple,left disconnected and workin fine,hot water,inlet and outlet both working fine so what does that unit do?


... Bosch 18 in. SRS43E02 Slim-Line Built-in Dishwasher

My Whirlpool Quiet Partner IV has alternating flashing lights across the front panel where I make selections for the type of cycle. When these lights are flashing, the dishwasher will not operate. We have already replaced the circuit panel and the problem persists. We have shut off power at the circuit box several times with no success. Please help!


Here is the tech sheet\015\012http://www.servicematters.com/docs/w...%208530866.pdf\015\012\015\012Here is a manu ... Whirlpool Dishwashers

My dishwasher has no power . I had work done on the floor which caused vibrations. My water connection was leaking which I fixed but I found out that It has not power. Not sure if the vibration caused some wires to disconnect. What should I check before I pay $130 for a repair man to diagnose the problem.


Call the technician. Have him state on the bill that whoever did your floor caused the electrical malfunction ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Whirlpool Dishwasher No Power: GU1200XT dishwasher thermal fuse in power up circuit blew & was replaced about two months ago. It has blown again. Both times it was after wash was finished but water was left in tub. Would appreciate suggestions on what may be causing the hi temp condition and how to verify.


I have a similar problem with my whirpool diswashre GU2500XTPB1. I check thermal fuse (on the board. It is OK (continuty). Right door switch _ OK, Left door switch _ weaker a bit). It still not work) I do not know what to check? ... Whirlpool 24 in. GU1200XT Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1114 seconds