Having problems with your GE 24 in. Profile PDW9200J Built-in Dishwasher ?

I have a GE Dishwasher model PDW9200J and the "Start/Reset" button on the control panel is dead. The control panel is not locked and I tried rebooting by turning the power off for 30 seconds, but did not help.


Answers :

The Start/ reset button is part of the integrated keypad on your model and you will have to replace the whole strip.
\015\012
\015\012See item 719 in this diagram.
\015\012
\015\012Hope this helps. If this is different to your model then please post a comment so that I can find the correct part for your dishwasher.
Repair Help & Product Troubleshooting for GE 24 in. Profile PDW9200J Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you


Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers

I have a GE Dishwasher model PDW9200J and the "Start/Reset" button on the control panel is dead. The control panel is not locked and I tried rebooting by turning the power off for 30 seconds, but did not help.


The Start/ reset button is part of the integrated keypad on your model and you will have to replace the whole strip.\015\012\015\012See item 719 in ... GE 24 in. Profile PDW9200J Built-in Dishwasher

My GE Dishwasher, Model GSD6960N10SS, has no power. None of the lights on the control panel are lit. The circuit breaker is on and the wall control switch is also on. I turned off the power for 30 seconds and turned it back on, but there is still no power.


... GE Dishwashers

My serial #TH24050632 has an occational control board failure and requires a reset. That is my current problem. In the past I turned of the circuit breaker for thirty minutes, and then pressed sertain control buttons inseries or at the same time for ten to twenty seconds. I have misplaced the information I wrote down to correct my problem. Can you help me with the correct procedure to reset my control panel? Thank you.


Check if this works.\015\012\015\012Press normal wash and heated dry one after the other about 5 times.All lights on panel will light.Wait until all lights go out and it resets itself.It will go into a mode on it's own.Then press cancel a ... Dishwashers

Whirpool DU1055xtss3 will not turn on. the only lights on control panel that turn are ,the options.Hi temp wash,sani rinse,heated dry. Have reset power, no help


... Whirlpool DU1055XTS Built-in Dishwasher

My Asko D1996 Dishwasher will not start. The control panel has 3 lights staying on - position #1, 6 and 7 and are unresponsive no matter what buttons are pushed - even after turning the power off at the breaker, the outlet and the on/off button.I've tried holding down the start button for several seconds to reset but this did not work. I have also cleared the drain, filters and removed any water and pushed and held the Start button to reset.


... Asko Dishwashers

We have a Bosch dishwasher SHX46A06 UC/21. It continually runs. We couldn't find a diagnostic test for our model, but we did for another model. We held down the power scrub and regular wash cycles then turned it on and pressed them again. The delicate/econo light started blinking. Looking at some of the blogs, most often it seems to be the heater or the control panel - does this diagnostic test help to pinpoint what could be wrong? Also, where can we find a good manual for our model - we're havi


Here is a link to the service manual http://cgi.ebay.com/Bosch-Dishwasher-Service-Repair-Manual-/250480379703. \015\012 ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

The control panel on my dishwasher will not work. I have tried the unlock button and that was not the problem...I have turned off power to it for 2 minutes and that was of no help either...Can someone please let me know what is going on with my dishwasher....


Your touch pad control panel has gone bad. The part alone is about $150. not counting a house call and labor. If this machine is over three years old I recommend replacing it. A repair without a warranty is not cost effective. Joe ... Whirlpool DU930PWS Built-in Dishwasher

The contol lock LED is illuminated on the front panel of my Maytag dishwasher. (Neither my wife nor I pressed the control lock for 3 seconds!) We've tried to extinguish it by pressing it for 3 to 5 seconds, but it remains ON. We've turned off the breaker to the dishwasher overnight, but when we turn the breaker back On, the contol lock LED comes on. We simply can't unlock the control panel. We can tell that all of the other buttons work just fine because pressing any of them causes the 3 Sec LED


If by pressing the control lock button for 3 seconds does not solves the problem.then there are 3 possibilities due to which this problem may occur\015\0121)the door is not closing properly. the dishwasher door latch is either cracked internally or t ... Maytag Dishwashers

Our Bosch dishwasher #SHU9922UC (FD8007) will not turn on properly. Only its drain pump starts -- and keeps running -- when it's powered on and the door's closed. Pressing the two "drain cancel" buttons for more than 3 seconds doesn't help. Neither does cutting off power, then turning it back on in the hopes of resetting the machine's 'computer'. No water inflow occurs. Help?


I had a similar issue after I replaced a bad drain pump, seems the logic got hung up.. I poured in a pitcher of water, closed the door, it drained and was then ok - worth a try. If not, you may have a bad water level switch. ... Dishwashers

Bosch Integra 500 dishwasher turns on and starts wash cycle, turns off after 90 seconds and then there is no power on the button panel at all. The dishwasher is full of water. Now the unit will not turn on or off. There is power to the outlet the dishwasher is plugged into.


Your controlboard is no good. find out if its a recall unit go to thermador.com which is the company that owns bosch and they can tell you the price if you have to oreder it or if its free for part and you pay labor to install ... Bosch Integra® 500 SHX46A0 Dishwasher

My PDW8280J10SS GE Profile Dishwasher, will not power up. No LEDs on control panel. Checked the micro switches. They are fine. So it is the Control Module or the Control Panel. Thanks in advance for your help.


Hello &\015\012Welcome to FixYa\015\012\015\012You are right.....the\015\012problem is with the control module also known as electronic control board that\015\012needs replacement. Please get back to me if you have any ... Dishwashers

I have a GE dishwasher with front control panel and at first the wash and dry lights stayed on and it was beeping every 30 sec. when I turned the breaker off for the required 30 sec. the lights started flashing and it is still beeping. The control panel seems to be frozen as it is not working and wont do anything.. everything was working fine before this. I bought it at Home Depot on 3/14/07 and had it installed by a licened electricion. Help


Call ge @ 800-386-1215 for service ... Dishwashers

Greetings. I have a Fisher & Paykel dishdrawer - the top drawer appears to have lost power mid cycle and the lid has not retracted - no led display - no response from the buttons. The bottom drawer functions ok. I have tried turning the power off at the wall for 30 seconds and on again. I have tried swapping the top and bottom controllers and the bottom still works but the top does not, so the controllers must be ok Not sure where to find the model number sorry. Any suggestions?


Describethe inside of unit,any wear on it anywhere, the rack the dishes go on is it plastic coated? is it wore with rust comeing though on tips here and there? ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

Installed a new control panel on my PLD4375RFC0 dishwasher and when power was turned on the PF light flashed then went off when the door opened. However, the screen remains blank even when pressing buttons to apply a setting. Have cut power and turned back on several times with same results.


... Frigidaire PLD4375RFC Dishwasher

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

I have a whirlpool quiet partner i dishwasher (model DU1055XTSQ2) that has suddenly stopped working. Control panel has partial functionality. All of the buttons on the control panel have a green LED feedback light when depressed. None of them provide LED feedback anymore except the Hi-Temp Wash, Sani-Rinse, and Heated Dry buttons. So there is power to the dishwasher. Any ideas? Please help Scott


The control board has failed.CLICK HERE to see the parts breakdown. ... Whirlpool DU1055XTSQ Built-in Dishwasher

FDB834RFS0 FRIGIDEAIRE DISHWASHING M# FDB834RFS0 Precision Wash System.... All control panel blinking.... Main power turn of and repower then ONLY HI TEMP WASH and NO HEAT DRY LIGHT ON. How do I enter control panel mode to clear blinking lights? Could it be faulty element inside dishwasher? Any suggestions gladly appreciated. Tks .. AA


... Frigidaire Dishwashers

I have a Kenmore Elite Ultra Dishwasher and the cleaning light is flashing. I have tried pressing the start/resume button and closing the door within 3 seconds. I am not able to turn on my dishwasher. I have tried turning off the power for 20 minutes but when power was restored the green light continues to flash and the dishwasher will not work. This machine was installed in May 2008. Help!


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012buttons are non ... Dishwashers

I have a bosch dishwasher model classxx maxx freedom performance sgs43co2gb/35. the machine when turned on doesnt stop,so i checked the control panel and there was a black ring of soot,before i purchase a new control panel,what would cause this to happen? please help!!!


I think your model was part of the recall and the repair is free to fix call bosch and they will take of ity. they need to know the model asnd serial number to know if it is one of the recall ... Bosch Dishwashers

Whirlpool DU940 dishwasher. Opened the door and felt that the coil was warm but washer has not been turned on and control panel does not function. Removed power from washer and coil stopped heating but control panel still not working.


... Whirlpool GU2400XTP Built-in Dishwasher

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

I have a Maytag dishwasher MDBM601AWW. The control lock on the control pad will not unlock. I replaced the electronic control board and it worked for one wash. Control lock engaged again. I shut down the power and pressed the control lock for 3 seconds as directed by the owners manual. No luck. Please help Rich.


You have to power the unit back up and then holld the lock in for three seconds, if ths does not reset it then the console not the control bord needs to be replaced it comes with a new touch pad ... Dishwashers

No power I have no power.  I checked the plug and it had no power, so I reset the breaker.  Power returned to the control panel.  I selected normal wash.  It started up and 2 seconds later no power again.  Breaker flipped again.  What is the problem?


... Jenn-Air JDB7910 Dishwasher

I cannot unlock the controls on the panel - i just bought a house that has the whirlpool gold quiet partner dishwasher and when i press any button nothing happens but says controls locked - i unlock the controls and try to turn on the dishwasher and still happens and says controls locked again. can you help?


Try turning the circuit breaker off for 30 minutes. Then turn back on and see. If it keeps locking you may need new control console. Hope this helps. ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1330 seconds