Having problems with your GE 24 in. Profile PDW9880JSS Built-in Dishwasher ?

GE Monogram My pump keeps running and will only stop if I unplug the unit. The pump stays on even if the door is open and the control panel does not react and no lights.


Answers :

The control module is damaged and, you will need to replace this device asap. the pump will burn out soon if the control module isn't replaced.

The control module will run you about $109.00
Repair Help & Product Troubleshooting for GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

GE Monogram My pump keeps running and will only stop if I unplug the unit. The pump stays on even if the door is open and the control panel does not react and no lights.


The control module is damaged and, you will need to replace this device asap. the pump will burn out soon if the control module isn't replaced.The control module will run you about $109.00 ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

KitchenAid KUDC25CH Dishwasher Just installed a new control board, last week after some lengthy emails we decided it was probably the control board , control board in now in, as far as I know the dishwasher cycles thru all three of the small lite rinse buttons ad it may have finished completely, there wasno water in the bottom of the washer so all was pumped out and the dishs were dry......the large rinse button on the panel is blinking. I open and close the door but the light contiues to blink


The system does not allow me to view what other consultants have suggested to you about the problem with your dishwasher.\015\012\015\012Before you try anything else, get a Finish dishwasher cleaner kit from the supermarket and run the di ... Dishwashers

Maytag dishwasher lights but wont run, I can select a cycle then press start and nothing. also the control panel lights stay on when the door is opened


... Maytag MDBH955AWS Stainless Steel 24 in. Built-in Dishwasher

I have a Whirlpool Gold Quietwash Plus (part # 9744480), due to a number of opening and closings of the door, the lights on the front panel now just blink. How can I reset the control panel.. I have tried power scour>air dry>power scour>air dry and only end up with both blinking instead of going into control diagnostics by pushing pots&pans. The unit will attempt to start then just go to blinking lights.. Thanks


I would cut the power to it for awile 5mi and try it that may do it ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My ASKO 1805 Dishwasher started to smell weird and white smoke came from it. I turned it off, but after I turned it on again it just keeps pumping water in and out, I can't get in contact with it (None of the indicator lights are working and it is not reacting to any commands) In addition the safety feauture that is supposed to stop all operation the moment the door is opened is no longer working. (i.e. even with the door open it is still pumping water) Does it sound like an expensive repair? (


Hello,\015\012\015\012Welcome to FixYa. Based on your description ( specifically the white smoke and smell ) I would suspect the control board is faulty. \015\012\015\012If the unit does not stop when the door is open can be r ... Asko 24 in. 1805 Built-in Dishwasher

I have a mdd8000aws dishwasher. After a power outage (2 days) the power came back on, and the bottom drawer no longer works. It still make the chiming noise when the drawer is opened, but the control panel is not fully lit up and the washer will not start in any mode. The lights seem to flicker for a short moment and then they all stay very lightly lit up. Is this just a bad control panel or is there some other circuit that needs replaced? BTW, the top drawer works perfectly.


... Maytag MDD8000AWS Builtin Dishwasher

FDW70 dishwasher, starts to fill with water, shows pre wash on control panel, then pumps out within about 2-3 minutes, but has vertualy no water in it. Puts up code A10 on control panel, can still hear the pump going even when l open the door. Have replaced a burnt out heater tube with a new genuine unit, also have removed & checked fill valve & this works fine.


Hi,Try this few steps;Turn off the water supply to the dishwasher and remove the hose, turn\015\012on the machine for a couple of minutes in a fill position then turn off\015\012the machine, reconnect the hose, turn the ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Maytag quiet series 300, model # MDBTT60AWW. The front control panel have some green lights on but the start/cancel button won't work. The dishwasher will work for 5 days and quit for 2-3 days then work again. I tried to reset the main electrical panel hoping the dishwasher will reset too but it didn't work. I opened the panel on the front door to see if water is getting into the electronic panel but it is dry. I'm wondering if it is the front control panel itself is the problem. I want


... Maytag Dishwashers

Have a GE Quiet Power 3 Dishwasher. Went to reun it and when I closed the door no lights came on to pick a wash cycle. Nothing like it lost power. No buttons work, nothing. Opened door and removed inside door panel. Have power at door latch switch. Actually have power at all 4 connections and doesn't change when engaging switch as if door was closed. Switch does click but no power at front control panel. Whats up. I have my own Handyman/Home Remodeling business and I'm very good at fixing things


If your dishwasher is not running check the following \015\012\015\012You have already taken care of the 1st item.Power Supply The main power supply is the first thing to check. Also remove the toe ki ... Dishwashers

Control panel buttons don't work. Seem to be stuck in the "Lock On" mode. Can't turn off, and dishwasher won't run. When you open the door all lights go off, but as soon as you relatch the door, the "Lock On" light comes on, although sometimes it can be another light. In any case, it won't run.


... Kenmore Dishwashers

Dishwasher front panel lights are all blinking in unison. Pump has removed all water from bottom including sump. Pump and lights will not shut off or reset with dishwasher door closed or OPEN. I have shut the circuit breaker off to keep from burning up the pump. Problem continues if I reset circuit breaker.


It would help to know what the make and model of the dishwasher is.\015\012\015\012Most likely the flood switch at the base has been activated. ... Dishwashers

My Frigidaire 4000 Dishwasher panel board is lighting up with almost all lights on/flashing. When the door is closed the pump engages and ther is no water in the machine. If we put water in it drains successfully. The following is flashing on the control panel: washing, drying ER, clean and s. Up top lighted up is china crystal and rinse only. What is going on?


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a fridgidaire dishwasher model # FDB 1450chc2 andon the control panel the red lights are flashing and washer wont start ?? when I open the door the lights go out but when I close the door and push start the washing lights start to blink but doesnt start to work ?? Need help thanks bc.is@shaw.ca Brian


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Came home and dishwasher was stil running from the morning. Opened the door and all the lights on the control panel were lit up and unresponsive. cut power to unit for 1 min and now the controls don;t light or respond to anything . They are not locked and there is power to the unit any ideas ?


Hi\015\012\015\012\015\012Thanks for using FixYa. From what you have described it seems that the control panel has gone bad and needs to be replaced however, if you want more information then please do revert with the manufac ... Dishwashers

Have a 4 year old Kenmore Dishwasher Model # 74382. No problems at all until last week I went to start it and it would not turn on. Lights on the control panel were on with exception to the start light. I opened and shut the door to make sure it clicked and pressed the start button again and nothing. I tapped around the panel with the side of my fist and pressed it again and it began working. Well today different story I went to start it and it did the same thing. I tapped all over front of the


The problem is more likely the door switch is failing or out of adjustment/loose. You will need to remove the door panel. This is easy to do. There is a video at ... Kenmore 24 in. 74382 / 74384 / 74389 Built-in Dishwasher

Dishwasher works but control panel only lights up when door is open. if i close the door all lights go off but dishwasher starts to wash


... Frigidaire Dishwashers

Maytag MDBH985AWS...control panel button to turn on the washer does not work...wash cycle and delay lights will light when pushed but washer will not come on. Have tried pushing normal wash and heated dry in sequence, flipped circuit breaker, open and close door, pushed buttons while door is closed


... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

The control panel on my Maytag MDBH970AW is unresponsive, and the latch is stuck in the "open" position (the plastic piece stays pushed in to the handle and won't come down). I've checked that the unit is getting power from the house. Last time I had this exact problem (when it was under warranty), they had to replace the control panel, the latch, and it seemed like most of the door. What should I do?


... Maytag 24 in. MDBH970AWS Built-in Dishwasher

Maytag dishwasher MDB6650AWB. Stopped working/no lights on panel after wife opened and closed door to add to wash during wash cycle. Replacec door mechanism. No change. Control panel?


... Maytag 24 in. MDB6657 Built-in Dishwasher

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps. ... Kenmore Dishwashers

After unit runs for a minute it stops ,open door and all lights are flashing.took bottom panel off and light forwash pump on,green but not flashing, took screen off didn't see anything.


It is possible the wash pump is faulty and is preventing the water from circulating leading to error condition.\015\012\015\012Refer ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you


Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers

My frigidaire dishwasher FDB1502RGC4 will not run a cycle. it will fill and drain the water but will not run a wash cycle. all the lights on the control panel lightup when they should. so i dont think it is a fuse. and there is not much i can see after i opened the front door, the control module and the console assembly. could it be one of these.


Having the same problem with mine, just replaced the discharge pump last week because it went out, worked a couple days now this. still have not figured out the problem ... Frigidaire FDB1502RGC Built-in Dishwasher

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays


... Siemens Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1201 seconds