Having problems with your GE 24 in. Profile PDW9880JSS Built-in Dishwasher ?

Where is the water control valve? and what am I

\015 GE Profile dishwasher is running & heating but without water. I checked the water tube and there's no blockage. Yesterday I was advised to check the water control valve. Where is the water control valve, and what am I looking for when I check it? Could I have a bad water pump?\015

Answers :

Yes, the water control valve is likely your problem. Where the external hose attach to the internal hoses, there is the water vales in between them. The hoses screws right into the water control valves. The valves are likely not opening. You can test power to the valves with a voltmeter. If there is power on the fill cycle but no water, then valves are bad.
You can view parts and diagrams at partselect . com
Repair Help & Product Troubleshooting for GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch SHU43C Dishwasher. Where to get parts - quick? Needs a new control-board / circuit board. All valves, switches, heater appear to work. Won't run open the water inlet valve. Won't run the self-check program. Has a burnt connection on the control 'mother-board'.


1-800-944-2904 That is Bosch Company. They will send out-- next day. ... Bosch 24 in. SHU43 Built-in Dishwasher

FDW70 dishwasher, starts to fill with water, shows pre wash on control panel, then pumps out within about 2-3 minutes, but has vertualy no water in it. Puts up code A10 on control panel, can still hear the pump going even when l open the door. Have replaced a burnt out heater tube with a new genuine unit, also have removed & checked fill valve & this works fine.


Hi,Try this few steps;Turn off the water supply to the dishwasher and remove the hose, turn\015\012on the machine for a couple of minutes in a fill position then turn off\015\012the machine, reconnect the hose, turn the ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Where is the water control valve? and what am I


Yes, the water control valve is likely your problem. Where the external hose attach to the internal hoses, there is the water vales in between them. The hoses screws right into the water control valves. The valves are likely not opening. You can test ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Maytag HDB8600AWW Dishwasher had been making noise (thought might be water valve, like previous DW), eventually stopped draining water, water now in bottom, I've let sit for couple weeks, looked inside, water was gone, I tried running again, it filled with water, but heard humming control panel noises for first time, then shuts itself off. Also, my handle needs replaced. Please let me know as soon as possible. Thanks in advance. David Weaver


Hi David\015\012\015\012The hum and all the noise that you have mentioned in your post states that the issue is with the pump and motor assembly. Please check the drain hose and try to clean the drain pump filter for any clogs, obstructions. Af ... Dishwashers

I changed my water control valve, thinking my dishwasher was not getting water, however, if I put water in the basin, dishwasher pumps the water out, however, it sounds like the dishwasher stays stuck in the drain mode, pump just continues to run?


Hi,\015\012\015\012There is a simple explanation for this - water is leaking into the bottom of your dishwasher under the washing compartment. This has caused the float to rise and trip the switch which activates the Aqua-Stop / anti-floo ... Bosch SHU9915UC Dishwasher

My Bosch SHY56A02 dishwasher won't fill....When cycle is started, it seems to pump water out but none in. Water feed is good....Added water manually and it pumps out immediately. Also, unit continues to run with door open...door switch is not jumpered. Could it be the fill valve? More likely the control module? Thanks for your help!


Hi,\015\012\015\012As water is filling in your dishwasher a float rises along with it. When the float reaches a predetermined level it shuts off the flow of water by activating a switch thereby preventing a leak. Sometimes the float can g ... Bosch Dishwashers

Hello, I would appreciate if you have any suggestions regarding my GE dishwasher. It turns on and seems to want to work but the rinse cycle does not produce any water, it makes noises like the water is coming out and rinsing but when I open the dishwasher the dishes are not wet. I've checked the water valve, turned the control panel off and on, I'm wondering if it is just clogged, any suggestions? Thank you.


Hi,\012Here is a tip that will help you to find out why water will not come into thedishwasher... Dishwasher Trouble No Water entering Dishwasher ... Dishwashers

Hello, I had a problem with my Bosch dishwasher not washing properly. I have fixed burnt out wires, replaced the water inlet valve, AND tested with a new control module. Nothing is helping. When I start the cycle, it completes the initial drain and water does flow into the unit for about a minute, maybe a minute and a half. I can hear the clicking of cycle changes but it is not washing. Eventually it will drain the inch or so of water in the bottom, but it never washes. Any help???


Hi,\015\012\015\012Welcome to Fixya.\015\012\015\012Can you hear the wash motor humming ? I`ve got a "pdf" I can send you regarding this if you want to contact me at ... Bosch SHU9925UC Built-in Dishwasher

Water pump runs all the time (for hours on end, cycle will not complete, dishwasher does not wash at all, I have good water supply coming to the water control valve, all lights and buttons on it work ok.


The timer is bad. change it, do you have HOT watter?\015\012How hot is it\015\012Vitally ... Dishwashers

Hotpoint HDA3400g dishwasher is not running. I have checked to make sure it has power. Took the washer apart, checked that it had power through the door switch to the timer control, all is well. Still not running or getting water into the dishwasher. Any ideas besides replacing the water inlet valve? Will this dishwasher cycle through if it does not have water?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check for the following if your dishwasher\015\012is not working-- ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

How do I replace water inlet control valve on a Miele G851 SCI


There is a box on the end of your inlet hose that contains two solenoids. that is called your water proof system hose. when you try to start a cycle, that box should vibrate as the solenoids get power and try to let the water in. if it vibrate ... Miele Dishwashers

I'm not getting any water into the dishwasher, not on wash or rinse. The float float is working feely and I can hear it click when manually pushed. I don't seem to be getting any power to the valve that controls the water.


Hi pull the wires off the inlet valve under the dishwasher. Then set the dishwasher for a cycle and test the wires with a volt meter while the unit is supposed to be filling. If you are getting 120v the valve is either blocked or bad, you will have t ... GE Dishwashers

Dw861uqp Water is continually pumped from pan. Is there a solonoid controlled valve that diverts the water to the spray tower during the wash and rinse cycles?


... Jenn-Air Dishwashers

I have an Asko 1585 dishwasher. It drops the inlet valve on step (step 12), and the recirculation pump (next step) tries to pump with no water. Later at about step 47, the inlet valve begins to work again and the dishwasher finishes the cycle without a problem. I have had the board checked, and all of the power supply and transfer circuits are good. That leaves the processor. Is there any combination of buttons to press which can completely reset the controller board?


... Asko 24 in. 1585 Built-in Dishwasher

Water wont drain from the bottom, removed hose and not stopped up. float switch is working but dont know how to test the discharge valve that controls where the water goes, either out drain or back into sprayers


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Beatstherest again Thank you for helping me with question on dishwasher install...Water seems to be ok. Electrical connections seem ok. What is the electrical part on the valve that you mentioned? Does this control the water flow?


Well if the wire connection/leads arent fully connected to the valve its possible the valve would not energize. (2 wires leading to the valve in which oyou hooke up water supply) perhaps came loose in shipping/delivery ... Tappan 18 in. MDR251RE Built-in Dishwasher

Dishwasher model en50242 after cleaning both filters and turning on the valve etc no water is going into machine. The control panel shows 2 lights one above the tap sign the other above the programe light. The pump runs for a few seconds then stops and nothing further happens. We are in a high water calcium area.


... Siemens Dishwashers

KitchenAid KUDL03IVWHO Machine seems to stop after the initial water fill. There is power to the machine, the door latch circuity is working, all the buttons on the control pad light up. After selecting any of the wash cycles and pressing start, the washing light illuminates and the machine fills normally to the point where the fill valve stops the inflow of water. At this point the machine stalls, it does not start the cleaning process. I can press cancel and the machine drains normally. I e


Hi,\015\012\015\012You have got to the correct resolution. This is a circuit or most commonly called the board problem. Please find the bellow mentioned link which will help you to get one compatible for your washer.\015\012\0 ... Dishwashers

Dishwasher makes grinding noise during wash cycle (after pre-wash). noise persists for 15-20 minutes. It seems as though the inlet valve doesn't open during this phase of the cycle. adding water to the dishwasher manually eliminates the noise and water circulates through the wash arms. I'm trying to determine if this is a controller issue or a valve/pump issue.


Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\01 ... KitchenAid Dishwashers

I HAVE A MODEL GE PROFILE PDW9980L00SS I NEED SOME HELP INLET CONTROL VALVE WHAT IS THE HISTROY ON THIS PART I GET WATER TO IT BUT NOT IN THE DISHWASHER.I CAN FEEL IT TRYING TO WORK BUT NO WATER.


You may need to replace the inlet valve, the part number is WD15x10004. ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Not getting any water during wash or rinse cycle would this be a problem with the timer or water control valve


The water-inlet valve lets water enter the machine. First Check to see if the valve is getting water. Make sure it’s not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if yo ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Bosch Dishwasher SGS45E02GB/45 partially fills then empties repeatedly. Have replaced flow rate meter; still the same. Water matrix; pressure chamber and hoses clear, not blocked; float valves operating. Control module has no sign of burnt joints. LED does not countdown; water level inside machine does not reach correct level. Any suggestions?


... Bosch Dishwashers

My kenmore dishwasher model 363.16222100 isn't getting enough water. I checked the flow control valve and it seems to be working. what else could it be?


... Dishwashers

What is the part number for the small hose coming out of the water control valve.


... EuroTech 24 in. EDW154E Built-in Dishwasher

Ok i need help i have a Hobart C44A and it is not rinsing at all could this be the final rinse solonoid valve all the machine does is alarm out cause of no rinse. I checked in side to make sure that it isnt our controler and there is no rinse water coming out of the jets. I know that the actuator is working properly to tell it when to rinse or do i have a bigger problem


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0846 seconds