Having problems with your GE 24 in. Profile PDW9880JSS Built-in Dishwasher ?

It won't turn on...the buttons won't even light up


Answers :

As srmiller82 suggested, it's possible your dishwasher was recalled. Here's a list of recalled dishwashers (with images) that you can check. Hope that helps!
Hi there is possibly a recall on this unit, if you give me full model and serial i can check for you to be certain, but if there is a recall you will want to turn the power off to this unit and call GE service for them to fix it and they can also fix your other problem, but its possibly related to the recall. Let me know.
\015\012
\015\012
\015\012Sean
Repair Help & Product Troubleshooting for GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher keeps blinking the "clean" light and will not start. I have tried turning off the breaker to reset the machine but it still wont start even after pushing all the buttons.


... Kenmore 24 in. 16049 Built-in Dishwasher

My Maytag dishwasher goes for long stretches when it won't turn on even though I push the proper buttons. The buttons won't light either. It turns on by itself after a couple of weeks of sitting idle. Some of the lights may blink on the start panel while the dishwasher doesn't work, but only on occasion will it fully operate. I have turned off the power and turned it back on, hoping to reset the computer part of the dishwasher. It didn't work.


The Control Touch Panels like to fail on may brands - especially Maytag. They are sensitive to humidity - and a lot have the vents out the front - right by the control panel.Please reply using "continue with this expert ... Maytag Dishwashers

Dishwasher wont turn on dwa73a Amana built in. I turned off circuit breaker and now there's blinking lights on the air temp and water temp. Never use these buttons. I can't get any button to work much less get it turned on.


Hi\015\012\015\012You will have to first check/test the door latch assembly,\015\012if that is fine and the door is closing properly then it means that the control\015\012board is bad and should be replaced. Hope this helps...please post ... Amana 24 in. DWA73A Built-in Dishwasher

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

REFRIGERATOR LG LFC25760SW WILL NOT TURN LIGHT OFF. AREA WHERE BULB IS OVERHEATED, MELTING PLASTIC SURROUNDING IT. HOW CAN I SOLVE THIS PROBLEM? THE DOOR EVEN WHEN HELD OPEN AND THE BUTTONS THAT TURN THE LIGHT OFF WERE PRESSED DIDN'T WORK, LIGHT STILL STAYS ON. WHAT CAN I DO?


Turn the unit off so the bulb can cool and just take it out. Sounds like there is a problem with the switch, as to the melted surround if it is part of the liner there aint nothing you can do, save patch it with fiberglass and resin. ... Dishwashers

GE GSD5320 seemed to finish all light wash cycles. Then it began to beep, with the NORMAL light blinking. I hit RESET, but none of the other buttons worked. I threw the circuit breaker for this appliance and waited an hour. I Turned the circuit breaker on but now I get the NORMAL light blinking, even when the door latch is not engaged. No buttons work.


... GE GSD5320DBB Dishwasher

Electrolux dishwasher all lights blinking and wont turn on push start button either all lights flash or normal light stays on  either case the dishwasher wont run a cycle


Remove the toe kick by loosening 2 screws. There is a panel there with little lights that correspond to specific problems. The light that is on will correspond to the problem that the dishwasher has detected. Correct the problem and you should be goo ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

Bosch diswasher Turn dishwasher on lights that are showing are heavy duty wash, sanitize and clean lights. Just beeps like a load is completed - tried reset by holding down start button, etc.. Not able to even change cycles - only button that works is the on/off button


... Bosch SHX3AR75UC Ascenta Series 24 In. Stainless Steel Bar Handle Built-In Dishwasher

ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


... Asko D3122XLSS Stainless Steel Dishwasher

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers

My Asko D1996 Dishwasher will not start. The control panel has 3 lights staying on - position #1, 6 and 7 and are unresponsive no matter what buttons are pushed - even after turning the power off at the breaker, the outlet and the on/off button.I've tried holding down the start button for several seconds to reset but this did not work. I have also cleared the drain, filters and removed any water and pushed and held the Start button to reset.


... Asko Dishwashers

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

Hotpoint BC145 Dishwasher not cleaning starts to kick in but then just sticks on the "R" light flashing and cannot reset even after turning off. Itbeeps when pressing the select button sound weaker and shorter than they used to and the light does not move from the "R". On a couple of times I have tried it has reset and then the dishwasher starts but after about 3 minutes there is a low beep(not the usual beep when a programme finishes) and the washer stops and the light is flashing on the "R" ag


... Hotpoint 18 in. BCI45 Slim-Line Built-in Dishwasher

[email protected] My problem: I have a GE Quietpower2 dishwasher. The normal wash and heated dry lights continiously blinks, the pump seems to be operating with no water present. I've tried turning the power off and using the reset button with no results. The lights blink even with the door open.


Hi,It sounds like the main control board has gone wacky....replace the control board.\012That is not that hard to fix and you can easily buy the partsyourself online...Here is a tip that will help you with the onli ... GE Dishwashers

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

My dishwasher Kenmore 665.13462k902 worked fine for a little over a year, now it wont even start. At first, the high temp button wouldnt light, then no lights until you pushed start...tonight, nothing works...any help?


... Kenmore Dishwashers

My dishwasher Kenmore 665.13462k902 worked fine for a little over a year, now it wont even start. At first, the high temp button wouldnt light, then no lights until you pushed start...tonight, nothing works...any help?


... Kenmore Dishwashers

Today when I went to turn on my dishwasher it made a few weird clicking sounds and then didn't start up. Now it seems "dead" and I can't even get any of the lights on the panel to light up no matter what button I push.


Hi well i see this type of thing quite frequently, IF as you say there are NO LED's Lit at all. Then perhaps the circuit breaker or Fuse has, tripped, blown? Please check this, while at the Breaker box, recycle the Breaker, remove replace any Fuse.\0 ... Dishwashers

I have a 5 year old kenmore 665 15689 dish washer that wont come on at all . No lights no nothing . Before it stopped working the lights on the desplay were not coming on but it seamed to be washing normaly . I checked the breaker and even turned the power off for 5 min.


Theres a fuse in the back of the panel. ... Kenmore 24 in. 15689 Built-in Dishwasher

Installed a new control panel on my PLD4375RFC0 dishwasher and when power was turned on the PF light flashed then went off when the door opened. However, the screen remains blank even when pressing buttons to apply a setting. Have cut power and turned back on several times with same results.


... Frigidaire PLD4375RFC Dishwasher

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

We have a Beko DWD5410W dishwasher that has worked fine...until today - the 'wash' light is on but it is not wasing. I have pressed in the 'start' button and held for 5 seconds to reset and it then springs to life draining out or whatever that noise is, and then if I turn the dial to a setting (even the cold prewash) and press 'start' again it starts whirring away, then after about 10 seconds just stops, with the 'wash' light staying on. Not blocked, I have checked - this likely to be a frozen p


... Dishwashers

Inlet/drain light on. i know it drains OK because if i pour water into bottom and close door and turn on i can hear it draining water out. it wont fill. i have cleaned everything and taken base off and cleaned and checked float and all ok. i have tried every combination of holding buttons down and trying to reset but machine just makes low humming noise and after about 5 seconds the red light comes on again.


... Miele 24 in. G646SC Plus Free-Standing Dishwasher

WHIRLPOOL ADP 8540 dishwasher has blinking light on all the time (blinking in cycles of 4). When you turn it on (by holding the button down for around 4 seconds) it wont complete the cycle and you need to keep restarting it. can anyone let us know what the problem may be. Thank you TD


WHIRLPOOL ADP 8540 dishwasher has blinking light on all the time (blinking in cycles of 4). When you turn it on (by holding the button down for around 4 seconds) it wont complete the cycle and you need to keep restarting it. can anyone let us k ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0942 seconds