Having problems with your GE 24 in. Profile PDW9880JSS Built-in Dishwasher ?

PDWT180R10SS how do I remove the screen to clean it?


Answers :

Repair Help & Product Troubleshooting for GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

PDWT180R10SS how do I remove the screen to clean it?


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

I have a whirlpool GU2700XTSQ1 dishwasher. I have the typical top rack not cleaning problem. I have removed the rear washer tube that leads to the top sprayer, no clogs. Upper arm is clear, lower arm is clear. I also removed the lower cover, checked the chopper screen and inlet, no clogs. There is a screen inside that I cannot get to. It appears to have some sort of paper or cloth sticking through the screen with a 50% block. Perhaps a sticker or label from a dish. I see this screen when looking


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

How do you remove the screen bolt from a Maytag MDB4261AW dishwasher? I got the arm off, removed the torx bolds, and can't figure out how to remove the middle bolt to remove the screen and clean out the drain.


... Maytag MDB4621AW Built-in Dishwasher

Bosch dishwasher Over the weekend my drains backed up into the dishwasher. After cleaning the drains I ran the dishwasher 3 times. Under the screen there is still about an inch of water. I never noticed this before because I never removed the screen before. Can you tell me if this is normal or is there a problem with the dishwasher. The water in the little area below the screen is clean.


Its normal. its there to keep moisture around the rubber seals so they dont dry out. ... Dishwashers

I have a GE dishwasher (GSD4020Y70BB) new in 1996. I replaced the whole motor assembly in 2007, seal was leaking. My dishes are not getting clean now, dried food left on plates, coffee stains in cups not being cleaned. I removed main spray arm, found nothing, turned washer on and plenty of water gushing out. I took the cover off sump all clean. I removed the filter screen in the back, there appears to be a valve with some soft rubber around it. Water gushes out of this, does stop during the cyc


Have you checked the drain pump impeller and drain hose? I am curious if there is a back siphon from the drain hose or the waste outlet at the garbage disposal might be blocked or plugged with food debris.\015\012I wou ... Dishwashers

I have a triton xl model @ gsd6200g00bb serial #va790400b. The dishes on the top rack are not getting clean. I have removed the top, and middle, and bottom arms cleaned calcium out of them. Removed the screen below the lower arm cleaned. The top and middle arms are still not spinning during wash cycles. Where do I go next?


Apart from the spray arms themselves there could be other reasons why the water is not getting up to the middle and top arms.\015\012\015\012The distribution circuit from the wash pump that feeds the arms could be blocked or the wash pump ... Dishwashers

My dishwasher runs but does not have enough pressure to clean the dishes or turn the spray arms. Arms spin freely. I have removed and cleaned the screens in the bottom of the dishwasher. I also have removed the large pump and checked it for damage..no problems found. Model SHU43CO5UC / 17


Hi.Below a list of things to check.Check the water inlet at the back, ensure that the hose is not clogged or kinked, and that there is sufficient pressure.Ensure that the machine is not underfilling. Test the water ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix works for about 2 months, then another cleaning is required, even though we h


... Kenmore Dishwashers

GLD4050 DW won't pump out at any time during wash cycle. Removed lower arm, screen, etc. and washed and cleaned out everything. Removed drain hose and cleaned it out. Reinstalled and ran again. At no time during he cycle does the water pump out. HOWEVER, if I put my hand on the drain pump I can feel and hear the pump running as usual at the right times in the cycle. What else could be preventing the pump out? Thanks!


You could have a plugged pump itself or broken propellers as long as drain and screen are clean which looks like you already took care of that. ... Frigidaire GLD4050RHS Builtin Dishwasher

How do I remove the screen to clean out debris below it ?


The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the ... Kenmore (15132) Built-in Dishwasher

My dishwasher Model #FD81100RHM2 removing screen to clean underneath


... Frigidaire Dishwashers

I have a GLD 4456R00CS dishwasher that is maybe 6 months old. It seems to cycle properly, but has never really cleaned the dishes. This is the worst dishwasher we've ever had (over 25 years) and I'm ready to take it to the street. I've cleaned the screen (was already clean), checked the spray bars for clogs (removed, sprayed water through it, and replaced), and looked for any other obvious problem.


Sorry you have had so much problems with this dishwasher. Before you "take it to the street" please check one more thing. I have had so many people say similar problems. \012\012\012\012Check that you are usin ... GE GLD4456RCS Builtin Dishwasher

We have an E39927 dishwasher that dumped a lot of water on the floor--seems to me from the last time this happened there is a filter or clean-out section that needs cleaning. I assume it is the round rotating device on the front right floor of dishwasher. Can't locate my manual. Is that the correct place to clean and if so, how do I remove the top to access the screen? thanks, Gail


... Jenn-Air Dishwashers

I have a kenmore dishwasher, model 587-1625. Noticing that are dishes didn't seem to be getting very clean. I removed the drain screen and cleaned, noticing a lot of hard water deposit. yet, it still drain. Now after cleaning it doesn't drain now what?


Check for a plugged air gap (on top of the sink) ... Kenmore Dishwashers

Drain screen removal and cleaning on Triton XL GSD6900J


... GE 24 in. GSD6900J Built-in Dishwasher

Removed the bottom filter of a GE Quietpower 3. Cleaned the screen and replaced the unit, now the machine does not drain. I assume the screen and the part under it can go in one way.


Hello, luckyI\012 was trying to help you out here. I am not sure if this well help you? \012But here is a link to about everything you want to know about your \012dishwasher, from repair to trouble shooting on most common dish ... Maytag Dishwasher

Dishwasher rotating arm and middle spout do not work since I removed screen at bootm to remove gunk. Easy to get off, but I must have put them back together incorrectly, please help. Dishes not getting clean.


There is a very good chance the rotating arm and spout have become clogged also. Remove the 2 components and clean out the holes to clear blockage. ... Dishwashers

I have a Kenmore Elite Dishwasher about 7... Problem with the Kenmore Dishwashers I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix wo


Check the inlet hoses; if the catch screens have sediment build up, that will reduce the pressure of the rinse water. Also, look for missing plugs on the rinse arms... ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

Kenmore 17362 dishwasher was making a bad noise and now the motor seems to be locked up. I might have already un-jammed the motor by removing the cover on the bottom (inside), and turning the knife impeller on the outside of the screen, but I can see lint type material in the hole on the other side of the impeller. Hard to explain, but it is in the hole in the center of the unit and there is a screen like the knife impeller has behind it. I could clean this lint if I could get the door off. How


... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

I have an shx65905uc bosch dishwasher that runs and works except for that there is not enough water pressure to rotate the top wand or operate the top sprinkler. The bottom wand does have water and turn and does the top but it is not enough to turn it. If i remove the bottom wand and plug it off then the top will work properly. I have cleaned all screens and removed the plate to access the pump and all seems fine. Any Thoughts


... Bosch SHX65P05UC Dishwasher

Not cleaning There seems to be a lack of water pressure although the pump seems to work properly. I ahve cleaned the screens. Whem i remove the sprayer arm etc, there seems to plenty of water pressure.


Check spray arm jet holes. Clean the clogging with blower or soft bristles. ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

Hi, I have a Miele dishwasher G2150 that after 7-10 minutes on any cycle the rinse, dry, and end lights flash amber. I called the 800 number and they walked me through the diagnostic sequence and they said it was an error code 12 something to do with water restriction. I removed and checked the bottom "L" filter(clean), the wheel (moves freely, not dirty), and the grey in line filter screen on the intake hose,( clean also). I can feel the water coming through the intake hose, water comes in thro


... Miele G2150SC Dishwasher

My Maytag MDB7130AWB dishwasher is leaving detergent residue on the dishes. I removed the lower spray arm and filter screen. The screen was very clean with no mineral build-up. What could the problem be?


This is going to be more of a problem as the dishwasher detergent manufacturers are removing phosphates from dishwasher detergents. You can buy phosphates (or STTP) from various sources on the internet. It's called Sodium Tripolyphosphate. It's about ... Maytag Dishwashers

My KichenAid KUDS011 has functioned well until this morning. When I push any of the buttons on the keypad, nothing happens. I noticed there is still water in the bottom of the dishwasher from the last dish washing. Also, I've heard there is a screen or similar part in the bottom of the dishwasher that needs to be cleaned occasionally. I haven't figured out how to remove the bottom center of the dishwasher to access this for cleaning.


If the drain or screen are clogged, the machine may no operate.Unscrew the the 2 long screws on bottom, remove the basket, there may be a flapper under the basket, For pics, see here: http://www.contractorssolutions.com/dishwashers. ... Dishwashers

I want to take off the bottom screen to clean debris. I have taken screws out, how do I remove the screen?


You may to remove more screws from around the complete bottom part of your dishwasher. Have you tried to add Dishwasher Magic to clean the grit and grime out first? Or perhaps if you can't find Dishwasher Magic, we started using Tang Orange Juice pow ... Kenmore 24 in. 16032 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0610 seconds