Having problems with your GE 25 in. Nautilus GSC3400J Free-standing Dishwasher ?

Dishwasher knob is stuck

\015 My 15 month-old daughter discovered the dishwasher and turned the knob a few times over the past few days. Last night we ran the dishwasher. It washed everything, but the knob is now stuck in the drying section and won't turn either way. We have a GE Nautilis dishwasher that is approx. 3 years old. Any suggestions?\015

Answers :

Sometime's something sticky may have gotten behind the timer knob you may have to disassemble the control pannel and clean behind the knob.
Sometime's something sticky may have gotten behind the timer knob you may have to disassemble the control pannel and clean behind the knob.
Repair Help & Product Troubleshooting for GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Asko D1706 Dishwasher will no longer respond to control knob, turning knob clockwise has no effect on cycle nor will this turn dishwasher off! Dishwasher appears to be stuck in some part of cycle but will no longer wash dishes, door must be left open or will not turn off!


I also had this problem.\015\012Support person couldn't tell me if the pump was supposed to run even when setting the control knob to 'off' (bar before (1)).\015\012After draining the pan, the control knob functioned normally. So apparently any power ... Asko D1706 Built-in Dishwasher

Dishwasher knob is stuck


Sometime's something sticky may have gotten behind the timer knob you may have to disassemble the control pannel and clean behind the knob. ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

DISHWASHER PROBLEM HI, Last night I ran the dishwasher down in our kitchen down stairs. Four hour later I heard a humming sound coming from down there. I noticed the dishwasher went through the cycle perfectly , except on the hot drying cycle the timer knob was stuck and won't budge. I cannot move it either way. So I just unlatched it. Want do you think happened?


Do you see any error message on the display? ... GE Nautilus 24" Built-in Dishwasher

Kenmore Dishwasher 587.15163401 knob stuck mid-cycle


See if it is stuck on a water heat cycle. if the heater circuit or the thermostat is not working properly it will continue to run looking for a rise in temperature. If these are in working order the timer it self could be sticking and not advancing. ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Fridgidaire/Electrolux dishwasher stuck knob


It definately sounds as though the motor in the timer assembly is dying, or the gears in the assembly are wearing down to the point that the gears can't turn the way they're supposed to. Replace the timer. ... Frigidaire Dishwashers

Dishwasher get stuck and will not advance on its own. It does rinse and drain if I manually advance the control knob.


Without a model number I can't direct you to the exact replacment part you need. However, it would appear, based on what you've described, that the timer motor is faulty and should be replaced.\015\012\015\012Since you can manually advanc ... Bosch Dishwashers

My dishwasher gets stuck on Hot Start option. It runs fine otherwise, but every time I use the hot start option, it just keeps running and won't automatically run through the entire cycle. I manually have to come back and turn the knob.


... GE Dishwashers

Dishwasher gets stuck at various places while running. Have to move the knob ahead by hand


The timer switch micro- motor to be checked. Contact service provider. ... Bosch SHU4006 Dishwasher

Maytag DWU6402AAB dishwasher hums but motor does not run. I've taken the inside apart down to the disk-shaped impeller. It turns freely so the pump and motor are not stuck. When control knob is turned motor hums at the places where it normally should run. The water valve & heating coil seem to be operationg normally. i assume the next step is to test the motor &/or motor relay. Is this correct and how do I do that?


... Dishwashers

My dishwasher has power but does not turn on to any cycle when the control knob is in that position. It was adding water and starting to wash, but not going through the whole cycle and not rinsing and drying. Now it has water stuck in it. I hear sounds underneath like it's trying to go to the next cycle (a clicking noise), but then it doesn't. I put a new timer in it, but it was doing the same thing before that.


Hi just check out the following solutions that i provide u right now.. it will be a perfect fix for ur problem..\015\012\015\012\015\012\015\012\015\012\015\012first of all make this check\015\012 \015\012Door switch\015\012\015\012\015\ ... Dishwashers

My GE dishwasher's door is stuck shut ~ I'm assuming a broken latch. I was told to fix the latch, the dishwasher has to be taken out from under the counter top (in order to get the door open). My problem is: with the dishwasher door stuck shut, it's impossible to unscrew the dishwasher from the countertop... Any helpful hints? Pleeeeeeeease (all of my silverware is stuck INSIDE the locked dishwasher - LOL!)


Well I'll try to help you get this opened. I don't know how much space you have at the top side edge of the dishwasher. You need a long stiff rod like a metal clothes hanger straightened so it can reach from the side to a little past the dishwasher m ... GE Profile PDW9880NSS Stainless Steel Dishwasher

I have a Zanussi dishwasher model IT 5614. When I turn the dishwasher on, the indicator light is already stuck at "BIO 50" and won't move, and the dishwasher won't start when the door is closed. This just happened today. The indicator light for dishwasher salt was also on, so I added dishwasher salt and that light went off, but the machine is still stuck. The instruction book says that when this happens, technical assistance is needed. What exactly is the problem, and is it anything I can


It has been suggested to switch the machine on/off a couple of times and the flashing light will not reappear. Until this light goes off the dishwasher will not start. All the filters should be cleaned free of any leftover food particles. What i mean ... Dishwashers

I have a SHU3032UC BOSH Dishwasher for a couple of years now. Always worked as expected. Latetly, the dishwasher never stops. It looks stuck on an "unknown cycle"... The cycle dial stays at the "bottom" cycle (there's nothing written). If I turn it 1-2 "clicks", the dishwasher continues its work and ultimatly finishes with very good cleaning results. Once, I open the dishwasher when it was stuck in the "bottom" position, and there was hot watter at the bottom. Here's what I've tried so


Hello, welcome to FixYa.\015\012\015\012Based on you description of the timer not advancing I suspect the thermostat isn't satisfied when heating the water.\015\012\015\012The SHU 30** unit`s with a mechanical timer have very few if any, issues with ... Dishwashers

Dishwasher GSD2030F03WWSA735136B Model Series number;Piece fell off inside front panel, making it impossible to turn on dishwasher at all..so I took off front panel screws, opened dishwasher and saw white plastic piece but can't find where it goes but it must have something to do with turning the knob to start dishwasher because the knob won't turn now..so it must attach inside somehow but I can't figure out where it goes...help!!


I think you need to get a new knob, write down the model number and make and take the pieces to your local domestic appliance supplier, there might be something similar in stock. Now I do mean the kind of small supplier that understands this kind of ... Dishwashers

Westinghouse undercounter dishwasher. after shutting door with latch, comes on when dial knob turned to selected wash. was taken out to redo floor underneath. after being placed back in position, did at least 2 loads fine. now after dial knob gets to selected wash, dishwasher light comes on and i can hear the motor try but then starts clicking. there is also water at the bottom inside the dishwasher


This seems to be a drainage problem, obviously. There may be some food debris in the drain tube where it connects to the drain pipe. It would be easy to detach and do a visual check, and see if you can clear the clog. Also, try to s ... Dishwashers

We have just moved into this unit fitted with a MIDEA WQP12 - 9011B dishwasher with NO MANUAL. What can we do ? We have been using the dishwasher by turning the operating KNOB to a position and pushing in the POWER KNOB. The machine then goes through a cycle of 80 to 100 minutes but without an USER OPERATING MANUAL, we have no idea of whether the dishwasher is being operated correctly.


... Dishwashers

I have a bosch dishwasher SHE43C06UC22 (non-LED version). It's stuck in the drain cycle and continues to run even when opening the door (it should stop, but it doesn't). As a test, I poured a large glass of water in the bottom of the dishwasher and it drained it into the sink as it should, but it continues to run in the drain mode with no water in it. I've heard I either have a float stuck or an emergency drain switch or leak somewhere causing the dishwasher to continue in the drain mode. Ho


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012This can be caused by either faulty door switch or indeed the float you mentioned.\015\012\015\012This is where to look for the switch and test it ... Dishwashers

Siemens lady dishwasher is getting stuck on


I removed the dishwasher and put fill hose on mains pressure. (30 to 45psi or 2 to 3 bar). Working ok now. May be issue with water pressure switch ? ... Siemens 24 in. SL84A305UC Built-in Dishwasher

Kenmore dishwasher dial stuck during cycle


... Kenmore Dishwashers

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

Hi! My dishwasher's programm selector knob is broken , the dishwasher is working but I dont find enywhere a knob. Tryed on ebay and shops no luck. Can you help me?


Hi.Depending\015\012 on the model number you can find wiring parts for most models on \015\012the web sites listed at the link below. Try Partselect and \015\012Appliancepartpros : ... Dishwashers

Dishwasher is making a loud grinding noise when it's started. Doesn't matter the cycle choice; the cycle starts as normal then once started up starts making a sort of grinding noise as the water is pulsing, like something is stuck or blocking the "push" of water. I couldn't see anything stuck in the bottom - any thoughts before I call a repair person? I've never owned a dishwasher before - maybe there's a basic drain/blockage thing I should check out first? And, any recommendations for repair


... Maytag 24 in. MDBH970AW Built-in Dishwasher

I have an Equator Mini Maid PLS602S dishwasher. It works fine, but the upper spray arm fell off and the clip and knob holding it in place are missing. Equator said they no longer make this model and don't have the parts. Can you tell me where to get the clip and knob to hold the upper spray arm in place. I know there is a little white clip - I actually had it but lost it, because when I tried to hold the arm in place with that, the next time I ran the dishwasher the arm fell off again. I


There are no parts sources that i can find for this dishwasher, but my suggestion to u is this, locate an appliance repair shop in the local area that has dishwasher parts, bring the portable unit down to the shop and see if they can mat ... Equator Dishwashers

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

My dishwasher's lid is stuck down and won't retract. I have a Fisher and Paykel DD605 dishwasher, and I think I must have placed some dishes in there that were too big for it and the lid got stuck. It's now showing an F7 error and refuses to do anything other than beep at me. I've tried turning the power off and back on, but it persists with the error. Is there a way to get it to reset and retract the lid? I've read that in situations like this, when people get repair technicians to com


The error code f7 stating that "the communication time out error"this are all the reason for the error1.the motor control micro has crashed and is not responding to communication request.2.the hardware communication link from ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1148 seconds