Having problems with your GE 25 in. Nautilus GSC3400J Free-standing Dishwasher ?

I have a portable dishwasher that hums when it is started but no water seems to be making it in to the dishwasher.


Answers :

Fill valve is bad need a new valve
Repair Help & Product Troubleshooting for GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher was making a loud hum. I turned it off and started it this morning. Seemed to be working fine, but after about 5 minutes it started making the same loud hum. The first time it seemed to be between cycles with no water, this time there water moving as normal except for the loud hum.


... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

I have a portable dishwasher that hums when it is started but no water seems to be making it in to the dishwasher.


Fill valve is bad need a new valve ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

I have the Kitchen aid KUDS01DL dishwasher. It was working fine until last week. When starting a cycle, the washer fills with water. Once filled, the motor makes a humming noise and does not circulate the water. I end up stopping the cycle and the discharge pump empties the water. I took apart and cleaned the basin this morning. I did find some random garbage but it did not seem blocked. Do you have any ideas?


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

Our dishwasher seems to have stopped working over night. The power button comes on and the unit beeps to acknowledge start, but then there is only a very light hum & the unit does not start. No water comes through the unit and it just hangs at the light hum. We have not turned off any water but just checking if there is a simple solution? Adam Hdw100sst


Suspect pump.on start the pump will activate to remove condense water from drying the last load.if the pump does not start then the next step of adding water to start wash cycle will not happen.ensure pump is not blocked ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

Baumatic (BKD62SS or BKD62W .3) Dishwasher will not do a normal load but will run in a strange start up mode I found. When I press the power button, select a cycle, then press start the dishwasher will no longer do anything. 5 seconds after pressing start it will make a light hum noise, a little like heating water. After about a minute the dishwasher won't have done anything. It will then beep 30 times with the third led on the set of four (don't know what it means) will flash a lot. The beeps t


... Dishwashers

We have a GE GSD4000J00WW dishwasher, 2 yrs old. Suddenly seems to fill with water, but no motor engages when you start the cycle. When you turn the knob, it makes a clunking sound, but all that happens is water fills. Also, how do I get the water out of the bottom of the dishwasher now? Thanks!


... GE Dishwashers

I have an electrolux slimline dishwasher model number esl 4115.On every cycle it starts with pumping out any excess water but will go no further.I have tried putting water in and all it does is pump out the water and continues with a humming noise.once opened the humming noise continues and the programme light continues to flash.there is another simble which is -] but with an arrow rather then a line that flashes 3 times.It seems to be stuck on empty.In the handbook it states that the anti-flood


... Electrolux 18 in. ESL4114 Slim-Line Built-in Dishwasher

I have a Defy Dishwasher DW-12. I push the start button and it makes a sound as if to start and no water comes in - it just hums and the water is on. It has been working fine. - but last night i was woken up with it still buzzing after 5 hours! and nothing happening


... Dishwashers

Frigidaire FDB1502RGC0 dishwasher set for normal wash and heat dry option, both leds are on. dishwasher cycles through wash, but never makes it to dry cycle. After wash, the leds for OPTIONS high temp wash and dry cycle start blinking and do not stop blinking until I hit cancel - which cancels everything. Open unit and water sitting in bottom. Is it a bad operator panel? Water pump did seem to be working during wash cycle. NEED HELP.


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

ETNA ENF 18500A/5 type: 3.E1.181213221110 36 VLENNL 5 Dishwasher lights are on, and set for running, but the dishwasher does not do anything. Sometimes it makes a slight hum when closing the door, but most of the time, nothing. It stopped running after standard dish washing liquid was put into the machine by mistake. At that time, the machine started and ran through part of the cycle, but did not complete, and did not drain the water. Since then it has not started again. I have remo


... Dishwashers

MY ADL 348 dishwasher seems to start briefly, a small bit of water comes in and then its make a washing noise, and then stops and bleeps a few times. When I press the on button it does the same over again. Iam waiting on IGNIS to come out since NOv2010. We have checked the filter where water goes out and doesnt seem to be clogged


\012Hi,\012The dishwasher is not filling with water...Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Trouble ... Whirlpool ADL934 Built-in Dishwasher

I just bought a used LG LDS 5811ST stainless steel built in dishwasher. The previous owner said he bought it 4 years ago. It's in great shape but doesn't work. It powers up but the water is not pumping into the dishwasher. The previous owner said that he thought it was the pump. He said he took it apart once and cleaned a bunch of crud out of some hoses and it worked for a while then started making funny noise and stopped. When i got it home i powered it up and connected water hose. It seems to


Rom the Service Manual:"1E INLET ERROR Not reached to the normal water level in spite of 10 min. water supply.The Hall sensor is OK?Check the frequency of Inlet Water by the Test Mode." ... Dishwashers

I have an asko D3450 dishwasher. Washer makes buzzing/humming noise at start of cycle and then randomly through cycle. I checked the sump and pump appears to be clean and impeller spins freely. The cycle seems to work ok. Water is pumping out ok. If you open the door to stop the cycle, the buzzing will continue for a few minutes then stop. If the cycle is restart, the buzzing starts again. The vibrations seem to originate from under the lower spin arm.


If the sound is a bussing - it is the capacitor mounted to the pump. It is failing.Shown here (big white cylinder on right of pic).. ... Asko 24 in. D3450 Dishwasher

My Miele Platnum dishwasher is not working. It is flashing "intake/drain" When it begins instead of the normal hearing of water moving around you just hear a humming. My husband and father took out all the filters/baskets etc and made sure everything was cleaned out. They checked the hoses. After that it seemed like it was going to work because it started to cycle normally but now it is flashing again and this time there was water standing in the bottom of the dishwasher. Any thoughts?


Most common faults with dishwashers is a drain fault. Check for any kinked hoses and check the drain spigot under the sink where the drain hose connects into the u bend. Usually this is where food gets trapped due to the spigot not being drille ... Miele 23 in. Novotronic G841 Built-In Dishwasher

Hello, my Bosch Classixx dishwasher SGS43E42EU/21 has me stumped. It starts by taking in water but when "filled" pumps out for a couple of seconds then refills for say 10 seconds more before another 2 or 3 seconds of pumping out. This cycle continues for ages without starting to wash. I've tried various things: - checked the Auto Stop valve isn't being activated by leakage (removing the polystyrene float and bottom tray makes no difference - there's no leak) - the valve seems to operate it


Hello Dave,\015\012\015\012Sounds like an overfill problem - the symptoms are consistent with a failed pressure switch. Water enters the dishwasher through a chamber which has a float arm connected to a small microswitch -this is the pres ... Bosch Dishwashers

Bauknecht gsx7551 dishwasher was blocked, took pipes out, blockage seemed to have gone, successfully did a rinse cycle, tried to start a wash and makes noises but no water going into machine, then machine constantly beeps + cycle will not start


... Bauknecht 24 in. GSX7551 Built-in Dishwasher

Hi, I have a ge dishwasher, model number VSD2304J00WW and it does not run properly. When I turn it on, it will hum and then start to make a clicking noise. Then there will be a bad smell, and a little smoke. Also the water does not drain. I've had water in the bottom of it for a few weeks now. The cycle never finishes either.


... GE Dishwashers

Meile G 1534 new dishwasher was installed by plumber on friday, it completed its first cycle fine , however when the next cycle started it makes a horrible dry grinding sound from the cabinet/ door and does not seem to be pumping water. i use tank water


Wondering if you called the plumber who installed it. \015\012\015\012Check if the water tank is not empty or tap is closed. It could be the inlet valve of dishwasher trying to open up or the detergent dispenser door solenoid.\015\0 ... Dishwashers

Dishwasher is making a loud grinding noise when it's started. Doesn't matter the cycle choice; the cycle starts as normal then once started up starts making a sort of grinding noise as the water is pulsing, like something is stuck or blocking the "push" of water. I couldn't see anything stuck in the bottom - any thoughts before I call a repair person? I've never owned a dishwasher before - maybe there's a basic drain/blockage thing I should check out first? And, any recommendations for repair


... Maytag 24 in. MDBH970AW Built-in Dishwasher

GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but


... GE 24 in. Profile PDW7300G Built-in Dishwasher

Our Whirlpool KUDP01ILBS2 dishwasher isn't working like it used to. Dishes seem to be getting partially clean, they aren't getting dry at all and it seems they may be being rinsed/washed with dirty water. There is plenty of water in the machine when I interupt the cleaning cycle. I always run the hot water in the sink before I start the dishwasher so the first water into the dishwasher is as hot as possible. Also the sani-rinse light is flashing when the cycle "completes".


Heat that is retained in the dishes is largely responsible for drying\015\012in this dishwasher. Since plastics do not retain heat very well, they\015\012will not dry as well as glasses, ceramics or metal dishes. Rinse aid\015\012must be used so that ... Dishwashers

Portable Dishwasher Hello, We just got a used Haier portable dishwasher, model HDP18PA and while the hose connnects fine to the sink, the water isn't going into the dishwasher and is coming out of the connection. Does that make sense? It looks like, if it operates properly, the water should be sucked into the dishwasher but the connector isn't pulling the water in. Help! Thank you! Tara


You have to have a good seal. Get a hose washer from your local hardware store and replace both of them on the hose if they are like a garden hose. If you still don't get any water to the unit, post again and I'll step you through it. ... Dishwashers

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1865 seconds