Having problems with your GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher ?

Dishwasher with one inch of water in bottom when complete

\015 I have a three year old ge adora dishwasher and when the cycle is complete it still has one inch of water in bottom\015

Answers :

Undo the drain hose from your drain and put it in a 5 gallon bucket and see how it drains your sink drain maybe stopped up or if it drains into a disposal it may be stopped up
Repair Help & Product Troubleshooting for GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher with one inch of water in bottom when complete


Undo the drain hose from your drain and put it in a 5 gallon bucket and see how it drains your sink drain maybe stopped up or if it drains into a disposal it may be stopped up ... GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher

Our Hotpoint Dishwasher Model HDA200X-73BA has two little white plastic pipe stubs poking out of the bottom of the dishwasher. During one of the cycles--(I don't think it is the drain cycle)-- some water is being released from one of these pipe stubs and then it stops and the other one runs some water. They each only run for a few seconds, but the water is just running on the floor. These little pipe stubs are about one half inch in diameter and project out of the bottom of the dishwasher about


Hello. go to the sears direct website, click on the blue link below, and enter your model number. ou can then access an excellent parts diagram which will show these stubs and what may be missing from them. Joe\015\012\015\012 ... Hotpoint Dishwashers

How do I find and fix the problem of one and one half inches of water left in the bottom is the dishwasher when the cycles are completed?


Hi,\015\012\015\012Firstly, check to make sure the waste outlet from the dishwasher isn't blocked. Remove, the drain hose where it attaches to your sink and check both the hose and the sink inlet connection. If these are clear, make sure ... GE GSD5130 Dishwasher

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have a kitchenaid Model KUDW03CTBL2 dishwasher. It is pumping water, but the top sprayer and the one under the top rack just have a little water coming out. Not enough to make them spin. We also noticed the water in the bottom when opened is not as much and it is cool not hot. The dishes on the top rack will not clean, and the bottom is not completely clean. We have checked water pressure and water tempurature through the house, All is operating fine. This dishwasher is only 1 year and 10month


... KitchenAid Dishwashers

My hot point dishwasher is not draining,after all cylces are complete there's always 2 or 3 inches of water on the bottom of the washer, what is causing this? I have a Hotpoint dishwasher 24" built in. The switch won't come on just hums. When I oprn the door ther is 2" of water on the bottom? Any solutions . Where is the reset button on serial number hda430vww, hda400vba> Thank you!


... Dishwashers

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

Once my dishwasher completed the cycle there is no water but after two or three days the bottom of the dishwasher fills with the dirty water. what could be the reason? I have garbage disposal and one pipe from the dishwasher connect to garbage disposal.


You must have your dishwasher connected directly to the garbage disposal and not through an air gap. What is happening is when you disposal fills with water it is siphoning through the drain hose back to the dishwasher. If you sink has a spare hole o ... Frigidaire 24 in. FDBB944C Built-in Dishwasher

Subject is Bosch dishwasher SHU6800. There is a soap residue left on dishes. Residue is not visible. Using two glasses taken from a recently completed wash cycle I rinsed one under tap water and then filled glass with tap water. The second was just filled with tap water. There is noticeable soap bubbling and foam in the second glass. Starting the 10 min rinse/hold cycle following completion of a full 60 min wash cycle results in considerble soap foam in the bottom of the tub. Have tried thr


WHAT IS WRONG WITH YOUR DISHWASHER? \015\012\015\012\015\012\015\012 \015\012For a detailed Dishwasher ill ... Dishwashers

The water doesn't completely drain out. The dishwasher completes the cycle but there's an inch of water at the bottom.


The drain pump motor is in line with the outlet pipe. First check if the outlet pipe is not blocked or obstructed. The motor can be tested by removing the 2 electrical push on connectors and connecting mains supply to the 2 terminals. If the motor sp ... Dishwashers

Water does not completely drain? Garbage disposal is functioning properly and hose from Kitchen Aid dishwasher to Garbage disposal is good. I ran the dishwasher a couple of times start to finish for rinse cycle and approximately 1/2 inch of standing water on the bottom. Any ideas? Please help. Thank you.


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

When the dishwasher completes washing the dishes are clean and dry but the water doesn't completely drain. There is about 1 inch of water at the bottom.


TYPICALLY A D/W WILL RETAIN A SMALL AMOUNT OF WATER IN THE SUMP OF THE MACHINE IF YOUR DISHES ARE CLEAN AND DRY I WOULD NOT WORRY IF YOU HAVE DIRTY STANDING WATER IN THE SUMP FIRST OFF GO TO WHERE IT DRAINS UNDER THE SINK GET A 5 GALLON PAIL AND UN H ... Dishwashers

I have a GE Quiet Power 3 dishwasher and water is not draining completely after the wash cycle completes. There is about an inch of risidual water in the bottom of the washer after the wash cycle is done.


... General Electric Adora GHDA670N Built-in Dishwasher

Dishwasher drain is hooked to a food disposer and until recently the unit worked fine. Last week following a cycle a couple of inches of water did not drain out. All food is removed from dishes, silverware, etc. prior to loading and the food trap in the bottom is completely clear. I ran the unit empty through a Lightwash cycle and afterwards the water level (that which didn't drain out) looked to be the same as before. The dishwasher is run 2-3 times weekly whereas the food disposal is


Hi, The I don't think the problem is with the loop and the 32" above the floor.If the dish washer was removed from one house to another, did *********** ever have a dish washer in the house before that he replaced this one with? The reason I am aski ... Dishwashers

My Bosh SHX33MO5UC built in dishwasher does not empty. There is about one and a half inches of water left in the dishwasher at the end of the cycle. The water does not seep in after the cycle ends but just does not completely empty


Hi,\015\012\015\012\015\012The drain hose can cause the dishwasher to fail to drain properly. The recirculation hose can be responsible for problems with poor rinsing of dishes.To access the drain hose remove the lower panel located benea ... Bosch 24 in. SHU43 Built-in Dishwasher

The dishwasher does not pump all of the water out. There is an inch or two left in the bottom of the dishwasher after the cycle has completely run. The control panel has been recently replaced on this dishwasher and it did not correct the problem. Help?


You likely have a dirty or faulty water level sensor in the machine that needs to be cleaned or replaced. ... Dishwashers

Hello, I had a problem with my Bosch dishwasher not washing properly. I have fixed burnt out wires, replaced the water inlet valve, AND tested with a new control module. Nothing is helping. When I start the cycle, it completes the initial drain and water does flow into the unit for about a minute, maybe a minute and a half. I can hear the clicking of cycle changes but it is not washing. Eventually it will drain the inch or so of water in the bottom, but it never washes. Any help???


Hi,\015\012\015\012Welcome to Fixya.\015\012\015\012Can you hear the wash motor humming ? I`ve got a "pdf" I can send you regarding this if you want to contact me at ... Bosch SHU9925UC Built-in Dishwasher

WATER DOES NOT COMPLETELY DRAIN FROM DISHWASHER. TOOK APART DRIN VALVE OTHER NIGHT AND PUT BACK TOGETHER AND IT STARTED WORKING FOR ABOUT 5 LOADS. NOW THERE IS ABOUT 1/2 INCH WATER STANDING IN BOTTOM THAT IS NOT NORMALLY THERE AT THE END OF THE CYCLES.


It is likely that the water pump is feeling its age. Replace the pump. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

I just installed a new Kenmore Elite dishwasher but the water does not completely drain out after the cycle is done!!!! There is about 1/2 inch of water remaining in the bottom.


It is supposed to be in the bottom.it keeps the seal wet if the seal dries out you will develop a leak around the motor ... Kenmore Dishwashers

KUDIO1IL8L6 Kithenaide dishwasher. Water remains in bottom of dishwasher about 1 inch deep afeter all cycles are complete. I have checked to see if it drains and it does twice although it seems slow to me. Do you know what is causing this?


You have a restriction in the return of the unit. This also leads to sanitation issues. Pull the bottom basket, remove the lower arm and using a screw driver, remove the return cover. Clean out any obstruction and reassemble. If you are still hav ... KitchenAid Dishwashers

Whirlpool DU915pwk80 not draining after cycle complete. I can run the cycle...and it doesn't overflow but it doesn't drain when its complete, i still have a couple inches of water in the bottom of the dishwasher after the cycle.


First thing that i would check is your drain line at disposer or sink.under sink. check to make sure its not clogged up. both the hose and were the hose hooks uo to look inside and see if blocked if so clean out with a flat blade srewdriver and test ... Dishwashers

Water is not draining completely from the dishwasher. About 1-2 inches remain in the bottom. Seems to drain most of the water during the wash cycle, but a bit remains. Thoughts on how to fix this?


Either the check valve on the end of the drain hose that connects to the drainpump motor is closed shut or sometin is clogged inside the drain hose..... also maybe you pump motor assmbly is faulty... u prob need wet/dryshop vac and drain it out from ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

Drainage problem My dishwasher drains on every cycle except for the last rinse cycle, so I know it isn't clogged. I always have about an inch of water in the bottom of the dishwasher when it completes the last cycle.


My hotpoint dishwasher hda487a-01 is not pumping out the water ... Hotpoint 24 in. HDA3740G Built-in Dishwasher

I own a KUDS01FLSS3 KitchenAid dishwasher. The lights on the control panel do not come on and a cycle can not be started. There is about an inch of water in the bottom of the dishwasher basin and it looks like the previous cycle did not complete. I have checked the wall outlet that the washer is plugged into and the washer is receiving power from the wall. And ideas? My next thought was to take the door off and check the power supply running to the door panel and control panel.


Servtek06 writes:\015\012check connections @ control board/module. May be Control Board/Module. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2311 seconds