Having problems with your GE Dishwashers ?

Good evening, under the cycle selection buttons on our GE Profile Triton Triclean Model number : GSD5130D02WW , we are not able to select any of the cycles. The dishwasher activates on the rinse cylce only then stops. Please review and advise. J.P.


Answers :

The fact that it does work (briefly) on one of the cycles but not on any others, points pretty strongly toward the control board. It's a pretty expensive part, so before you buy it you need to open up the door panel, and make sure that it hasn't come loose from the pieces inside, which would prevent it from making contact with the buttons on the front.

Of course make sure that the breaker to the unit is off, or unplug it, if possible.


Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Good evening, under the cycle selection buttons on our GE Profile Triton Triclean Model number : GSD5130D02WW , we are not able to select any of the cycles. The dishwasher activates on the rinse cylce only then stops. Please review and advise. J.P.


The fact that it does work (briefly) on one of the cycles but not on any others, points pretty strongly toward the control board. It's a pretty expensive part, so before you buy it you need to open up the door panel, and make sure that it hasn't come ... GE Dishwashers

Hi, I have a Siemens SE24A230GB/17 dishwasher and it is not completing the wash cycle (any selected). It appears to be stuck on the 'wash' part of the program. I have done the reset actions as advised in the User Manual and tried another program, without success. I have found that the possible causes could be the timer or thermostat. The estimated time remaining display counts down, but the program does not complete the wash and move onto rinse and dry. Any help or advice you can provide would


... Siemens Dishwashers

KUDU03STSS2 The dishwasher won't start and you cannot select a cycle. Hiting cancel twice will turn a small steady light on in the time window were the spining light normally is before a cycle starts, at which time closing the door will drain the dishwasher. Tried using the reset combos: hot wash, heat dry, hot wash, heat dry - all lights came on but nothing reset. Also tried same sequence doubling the heat dry. Unpluged for ten minutes, still nothing. Can select rinse, but unit does not start,


... KitchenAid Dishwashers

KENMORE MODEL # 363.16222100 Hello - my dishwasher (model# above) is currently filled with H20 and will not drain/work. When the knob to select the dishwasher cycle to begin is turned, it just 'clicks' and does not engage the washing cycle. When I tried to just let it run the cycle as is to 'restart', it had an electrical odor to it., Currently the knob is at the 'Rinse & Hold-(Heated Dry Off)' part of the cycle and all dishes have been removed. I would appreciate any assistance available. Thank


Either the motor is locked up or the control failed. You will need a service visit. If it is over 10 years old, I would buy new. ... Dishwashers

My dishwasher is only one and half year old. all of a sudden the dishes seem not be rinsed properly. As if a small coat of thick unrinsed film further stick on thedishes and glasses after the drying cycle I then have to proceed to scrub each dish ,fork, knife and glass... I cleaned the dishwasher with a special product t to clean the empty dishwasher, and the drying rinse agent is on full . Please advise


Try running a cycle with bleach on an empty dishwasher water might be too soft ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My Maytag NDB9601 will not start any cycle. You can select the cycle and the display will show the time, but the start and delay buttons, located on the front, not the top with the cycle buttons, will not activate. This leads to the dishwasher not working at all. It worked in the morning, but not in the evening. Dishwasher is 1 year old.


Sounds like a possible door switch problem. \015\012\015\012If you take that area of the door apart, check the ribbon cable for keypad. You can clean the connector with a pencil eraser. ... Dishwashers

Bosch Dishwasher My 8 year old Bosch is not draining. It will not go past 1 minute on the rinse cycle, and 13 minutes on the regular cycle. For the past few weeks I have noticed a lot of bubbles in the bottom of the dishwasher after it is done, but it was draining. Now it's full of water and will not go past the 1 minute mark. I need to fix this, I can fix this, I just need some expert advise on how to do this myself. Thanks!


What is the model #?... there are 2 buttons when pushed together it will drain the water out..try the button to the left next to power scrub... and economy...hold the 2 buttons for 3 sec. you will hear you drain pump running.. if you don't hear any ... Bosch 24 in. SHU43 Built-in Dishwasher

Bosch dishwasher SHE44C02UC, serial # 13693156: Does not cycle. I turn off and drain by pressing "Regular Wash" and "Rinse and Hold" together (need several of these to completely drain), then rinse by starting cycle and repeating above sequence. Slight burning smell also - motor? Is there a way to initialize the sequence, and if there is, is it advisable, given the slight smell? Robert Langridge


Hi\015\012\015\012First, try to hear a hum like sound from the motor however, the burning smell indicates that the motor is unable to work. You can also check that the motor is work ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

How to change the motor on kudd01dsss0 - KitchenAid KUDD01DSSS Architect Series Double Drawer Dishwasher, Less than 24 in, 5 Cycle Selections with 3 Cycle Options, Sani Rinse Option, Whisper Quiet Ultima Sound Insulation System, Sure-Hold Light Item Clips, Rinse-Aid Dispenser, Electronic Controls with


... KitchenAid KUDD01DSSS Architect Series Double Drawer Dishwasher, Less than 24 in, 5 Cycle Selections with 3 Cycle Options, Sani Rinse Option, Whisper Quiet Ultima Sound Insulation System, Sure-Hold Light Item Clips, Rinse-Aid Dispenser, Electronic Control

I have a Bosch SHE44C02UC/46 that will finish all of the cycle but leaves a couple inches of water in the bottom. If I pull out the dishwasher and manually active the drain pump float it will drain the remaining water out of the dishwasher. I heard about a cold solder joint on the main controller board but I am not sure if this could be the issue. Please advise wat advise you can. Thanks.


... Dishwashers

The dishwasher is flashing error 20. The wash cycle begins to work but after a few minutes the wash cycle will stop and the light flashes on the program selected. We have tried turning the dishwasher off from the switch to no avail. Please advise us on what we can do to fix this.


... AEG 24 in. Favorit 3A Free-standing Dishwasher

My Whirlpool ADG957/3M dishwasher refuses to continue cycle,start button is flashing continuosly with beeping noise,also unable to select different cycle,stuck on rinse after selecting 65 degree wash.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. This issue can be either due to a faulty door latch or\015\012door lock switch which is not engaging its ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a Bosch dishwasher model SHE4AP02UC/06, serial number FD901102579 that has been used twice since installation. When I select the Regular Wash cycle, the Regular Wash LED and the Active LED come on. The machine washes the dishes and then when it stops making noise. At that point the Active LED goes off and the Clean LED comes on with the Regular Wash LED. These LED's do not go off. There is no signal saying that the dishwasher is finished. Is this the way it is supposed to be operating or


Ya id say until u open the door after it has washed ... Bosch Dishwashers

ASKO 1885 Built-in Dishwasher: The water sump fills normally, but the wash cycle does not start. Althought the timer seems to work, the wash cycle motor won't start up in any wash or rinse selection. The spray arms do not spin - no water is being pumped. At the end of the wash cycle time, the water will empty out of the sump. Thank you. TB


Hi, Welcome to FixYa. Based on your description and provided the dishwasher is indeed 1) an Asko 1885 and 2) filling ... Asko 24 in. 1885 Built-in Dishwasher

LG Dishwasher (LDF6920ST) control panel is not working on any other cycle but the delicate cycle. Following power up only one button will light up/can be selected. It started with the normal cycle button going out then the power scrub went out along with the upper rank and rinse only.


... LG Dishwashers

My Kenmore built-in dishwasher is running its cycles normally, but no water is coming into the machine so it runs the cycles dry (even a rinse cycle). Can you advise? If a part is needed, is it an expensive one? Thank you!!


Sound like the inlet water valve is to blame here - or else the main controller board relay is not telling it to open. Further testing will be necessary to determine which is the cause.If it is the board - you are better off getting a new ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

My Frigidaire Model FDB2810LDC1 dishwasher will not stop running. Seems to complete a normal cycle and different cycles can be selected with normal time countdown but at end only rinse agent low light remains lit and sounds as if pump is still running. If opened, water appears to be streaming from rotator arms. Have cycled power but symptoms remain.


... Frigidaire Dishwashers

Non-starting unit The dishwasher will not start, reacting as if the door is not closed. The right side of the control panel (air dry, sani rinse, hi-temp scrub) allow selection i.e. the indicator light comes on. However, none of the cycle selection buttons on the left will engage.


... Kenmore 24 in. 16934 Built-in Dishwasher

The dishwasher gets stuck in rinse/ dry mode . It should complete full cycle in about an hour, but it washes and then does not rinse/ dry and go to OFF. Please advise


Not a expert but id guess with my electrical knolage that a part needs replaceing proberbly obvious but without having a wireing diagram of that exact make and model sorry but thats all i can say my advice get a pro to look at it weigh up b ... Dishwashers

We have a Westinghouse Alu design dishwasher we inherited with our house. We think it's about 8 years old. Whatever wash cycle you select the machine always reverts to just the rinse cycle. We won


... Dishwashers

Dishwasher model 665 serial 16932, only cycles available on the keypad are "quick rinse" and "time saver". Other selections cannot be selected, won't light up or work.


Your dishwasher model could be 665.16932. Please confirm if the front panel looks like the model shown in ... Kenmore Dishwashers

Bosch Shu43C02UC dishwasher fills with water but the washing won't start. As the filling nears complete, a double clicking noise occurs to start the washing motor but nothing happens. The time continues to countdown but the machine is silent. When I open and close the door, the click click noise is heard but the machine is silent. I can cancel the cycle and drain the water but none of the washing or rinse cycles will activate but the timer works. The soap door even opens if the timer is left to


Have you checked the inlet water temperature is at the correct level for the dishwasher.\015\012\015\012Please provide the full model no. of your dishwasher -- Shu43C02UC /??\015\012\015\012I think the problem is linked to th ... Bosch 24 in. SHU43 Built-in Dishwasher

Model d2pdwi 854234715810 dishwasher trips house fuse part way through wash cycle. Rinse cycle works ok and water is comming in and can be pumped out. You can hear it clicking like its trying to activate something 1-2 time and then trips fuse.


... Whirlpool Dishwashers

Westinghouse Silhouette 906 dishwasher cuts out after pre-wash, sometimes goes through cycle to rinse, then cuts out. Obtained service from sole dishwasher technician in Ballarat - he was very discourteous, claimed to have corrected fault, charged $125.00. Fault not fixed - that was many months ago but don't want him back. Please advise


... Dishwashers

FDW40 My dishwasher has just stopped working mid cycle. The rinse and prewash lights are both flashing and the water will not drain away. I tried to empty the existing water out........put it onto a new cycle.......the water came in but again wouldnt empty.... Please advise


This is a blocked pump,Strip down pump and remove blockage. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2495 seconds