Having problems with your GE Dishwashers ?

GE Profile Dishwasher with water in bottom, won't drain Water on the bottom of the unit


Answers :

Find the grille above the pump remove the grille and unclog the pump
Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I own a GE Profile GSD 4330 dishwasher. Recently it has been leaving some water in the bottom of the tub. This water accumulates over time until the entire bottom is filled. I have checked the air vent, garbage disposal unit and the filter in the bottom of the dishwasher (which was filthy). I cleaned the filter and everything else looks okay, but it is still leaving some water in the tub.


... Dishwashers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

GE Profile Dishwasher with water in bottom, won't drain Water on the bottom of the unit


Find the grille above the pump remove the grille and unclog the pump ... GE Dishwashers

Thermador dishwasher lights go on when door is open but go off when door is clossed the motor hums when door is closed but the unit will not operate there is water in the bottom but it wont drain


... Thermador DWHD43 Dishwasher

How do i remove the pump off my bosch dishwasher,as bottom 1 unit, any tips wont empty water cleaned all traps. is the a pump solenoid?


Inside the dw remove all filters and in the sump there is a cover over the impellor with 1 self tapping screw remove and there could be a object stopping pump. ... Bosch Dishwashers

I have a LG Dishwasher LD 14AW3 it fills and runs for about 30 min. It then appears that when it tries to rinse it cannot get water and flashes "1E". I disconnected the unit and when I moved it out of its position water was leaking from the bottom of the unit. after cleaning out the inside filter & the hard water filter I re-connected and found it worked. I ran a dishwasher cleaner through it at high temp. After a few loads the problem has come back. It is now located in MY garage waiting for me


Found a leaking component that was causing the foam float located and attached to the inlet valve to shut down the water inlet and the water inlet Solenoid was also sticking. I found out this simply by tapping it while it was trying to get water for ... LG Dishwashers

Dishlex Global 310 model. My dishwasher has water sitting on the bottom of it and it wont drain. I noticed it after I did a cycle of dirty dishes and the 'fast' light was flashing when I went to open it. Which shouldnt have been because it was on a normal wash. The water has been sitting at the bottom for 2 days now and still wont drain! I've taken out all the parts on the bottom which come out and cleaned them. Still no change however.


Just ran another cycle and it was fine ... Dishwashers

I have a Frigidaire dishwasher that is beginning to leak from the bottom. After taking off the lower front floor panel and looking under the unit, then pouring a bowl of water into the washer the water drips through unit onto the floor. What do you recommend? This is still an attractive dishwasher.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Dishwasher drain is hooked to a food disposer and until recently the unit worked fine. Last week following a cycle a couple of inches of water did not drain out. All food is removed from dishes, silverware, etc. prior to loading and the food trap in the bottom is completely clear. I ran the unit empty through a Lightwash cycle and afterwards the water level (that which didn't drain out) looked to be the same as before. The dishwasher is run 2-3 times weekly whereas the food disposal is


Hi, The I don't think the problem is with the loop and the 32" above the floor.If the dish washer was removed from one house to another, did *********** ever have a dish washer in the house before that he replaced this one with? The reason I am aski ... Dishwashers

After cleaning alot of crud out of the bottom, the dishwasher wont drain! I took all the parts out that I could and cleaned them with bleach water, put it all back together and ran a load of dishes.........Now there is orangish water standing in the bottom of the dishwasher!


Hi,\015\012\015\012\015\012You have blockage inside, in the drain line, or if it connects to the disposal side of the sink. I would first check at the disposal, if it does indeed connect there. Usually gunk from the disposal will cl ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Frigidare dishwasher model gld355rfb2 when you select a wash cycle unit begins prewash when it moves to wash unit quits and pf (power failure )is on display unit is full of water on bottom of unit so I reset the unit hit cancel button at which time unit pumps off water . I then tried again with same results as above.


... General Electric GDWT160RSS 24 in Builtin Dishwasher

Maytag Dishwasher I would like to know the proper water level after DW fills. Older Whirlpool units a quick guide was when water just covered heater. I have a new D/W and the water supply is difficult to access, there is a kink in the water line slowing the water flow. The D/W fills to bottom of heater, but because the unit is so quiet I can't determine if it is timing out or working properly. I intend to repair water line when counter work is done. Thanks for any help Gary


Newer Maytags should fill close or up to the heater not over. Sounds like your alright for now but I would get that water line fixed. ... Maytag 24 in. MDB8951AWS Stainless Steel Built-in Dishwasher

Once cycle is complete, water remains at the bottom of the dishwasher (inside the dishwasher - level of water remaining up to the element/heater). Dishwasher GE Profile Model PDW7712J00BB Ser. TF615328A My question: How to eliminate all the water once cycle is over? Thank you, Nicole


... GE Dishwashers

I have a General Electric Potscrubber dishwasher. When the cycle is finished, the water does not drain into the sink.I turned the unit upside down to look into the bottom. The motor turns freely. The instruction sheet I found in the bottom of the unit said to remove the filter screen and check the piston valve. I looked at what I thought was the piston valve, but I'm not sure how to check it. The line to the sink seems to be clear. The model of my unit is GSC3230Z03WW. The serial number is AZ627


... GE Dishwashers

Hello, I have a Frigidaire Dishwasher, model FDB750RCC1. It will not fully drain. There is water in the bottom of the unit after the cycle is complete. As it is not full of water or leaking out of the unit when I open the door I am suspecting it is the pump that has broken? (the water must be draining to the overflow point and then stopping as there is nothing pumping it) Any thoughts or ideas for me anyone? Am I on the right track?


... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

Water wont drain out of bottom of tub. The dishwasher works fine, it just wont drain the dirty water out. If I restart it to wash again, the dishes are washed in the dirty water.


Hi, A clog in the drain line or air gap (if there is one) is the usual reason that a dishwasher won't drain. Often the problem is at the point where the drain line attaches to the garbage disposer or househ ... GE Nautilus 24" Built-in Dishwasher

Seems my drain is plugged on my dishwasher it is the magic chef 4500b unit and i now have water all over my kitchen floor. i cant seem to find the product du4500b  so i entered the du2000 , either way there is water on my floor and about 4 inches of water in the bottom of the dishwasher


Ok there are several problems this can be caused from...1. there is usually a float device (I'm not sure about this model) that floats up and turns the water flow off when an appropriate amount of water is injected into the DW...sometimes these ... Magic Chef 24 in. DU2000 Built-in Dishwasher

I have a ge profile quietpower 7 dishwasher. its built in.cannot find manuel and cannot find the serial number anywhere on the dishwasher..i need either your help with serial number or help with why water will not go into the dishwasher. motor runs water decided it wont go in. one day worked perfect and next day stopped working.


Hi\015\012\015\012This is often caused due to the fill valve. You can ... GE Dishwashers

Water will not drain from bottom of GE Profile PDW7300 dishwasher. I checked the service mode feature by depressing the cookware and the heated dry keypad simultaneously for 3 seconds and did not hear any activity from the dishwasher when I activated the drain pump and when I activated the main pump. Other service mode features did activate when I checked them (i.e. activate water valve, open active vent, etc.).


... GE 24 in. Profile PDW7800 Built-in Dishwasher

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

Frigidaire FDB1502RGC0 dishwasher set for normal wash and heat dry option, both leds are on. dishwasher cycles through wash, but never makes it to dry cycle. After wash, the leds for OPTIONS high temp wash and dry cycle start blinking and do not stop blinking until I hit cancel - which cancels everything. Open unit and water sitting in bottom. Is it a bad operator panel? Water pump did seem to be working during wash cycle. NEED HELP.


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

Top arm does not turn in most of gibson amana an frigidaire this is done by ball in bottom of pump .it is clean.spray arm are clean .bottom arm move all the time.timer works it hesitates every so often and so ball will move an water should go up to upper arm but doesnt.common problem on these units but dont know how to cure?change ball.didnt work..on one unit changed pump cure problem for 4 months then returned....also does anyone know were u can buy the plastic they used to sell for dishwashers


Can yo give me the make and model number sol I can look at the service manual for you? ... Dishwashers

GE Profile Dishwasher with water in bottom, won't drain Cloudy water remains in bottom of washer and won't drain.


Hi and welcome to FixYa,Your described problem almost always indicate a faulty drainage system. Unless there are defective components, cleaning (although messy) would be corrective. Normally, there would be a filter/screen that cou ... GE 24 in. Profile PDW7800 Built-in Dishwasher

E1 fault code Dishwasher runs for about 5 minutes. Water fills up at bottom of unit and then machine seems to pause then fault code E1 appears then water is pumped out from bottom of machine. There are no leaking pipes and drain is installed correctly. I installed a new wash pump and fault still appears.


Hi,\015\012I think both the heater and thermostat / trip switches need to be checked.\015\012If water is going in and out ok, then it seems to be waiting to heat the water. It sees a fault - so just clears out.\015\012Heating elemen ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2441 seconds