Having problems with your GE Dishwashers ?

Water standing in the botttom of dishwasher. not draining


Answers :

Outlet drain may be plugged. Pump may be clogged or defective.
Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our kitchen drain clogged recently and water drained back into our VUD141 dishwasher. A plumber cleared the drain, and turned on the DW - which pumped out the standing water. But now, we have no water flowing into the dishwasher. The drain pumps, the heater works, but there's no water supply. The plumber who cleared the drain said he didn't DO dishwashers, and I cannot locate the owner's manual since we prepared for a move.


Hi\015\012\015\012 \015\012\015\012When the dishwasher won't fill and the water supply is on,\015\012then the issue is with the water inlet valve which is either clogged or\015\012blocked, you can try to clean it. If this wont so ... Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU


... Whirlpool DU1055XTS Built-in Dishwasher

Water standing in the botttom of dishwasher. not draining


Outlet drain may be plugged. Pump may be clogged or defective. ... GE Dishwashers

Bad smell This is more of a general question. When I run the dishwasher there is a bad smell as it fills with water. It comes out of the sink/garbage disposal. I have cleaned out the line that comes from the garbage disposal to the drain and that doesn't stop the smell. Is there a line that needs to be cleaned from the dishwasher to the sink or how can I fix this issue? My dishwasher, at the drain, has water standing and it smells. I think it is there from condensation as the dishwasher, unknow


Smell is not the fault of the dishwasher but your waste disposal unit - they stink!it may be awkward, but arrange your drain so that there is a water barrier. better still. install a standpipe for the drain, again with a water barrier ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Leaking dishwasher There is standing water in the dishwasher when it's not being used. Recently we had a garbage disposal installed and was wondering whether this may cause the water from the sink to settle in the dishwasher. Also, the water rises and leaks on the floor. We have to run a wash cycle to drain and dry out the dishwasher. What do you think the problem is?


It sound like while the assembly of the garbage disposal, you placed the end of the drain line pipe in a lower position than it was before.\015\012Good luck! ... Kenmore 15129 Built-in Dishwasher

Whirlpool Quiet Wash Plus dishwasher Model DU920PFGZ3. Worked fine until I replaced the insinkerator and forgot to punch the drain plug leaving water standing on the bottom of the machine. I punched the drain opening, and pushed the cancel/drain cycle button. It drained fine but since no water comes from the spray arms. I have removed the arm all the way down..NOTHING!! Some research indicated it could be the water inlet valve. When the buttons are pushed, it cycles but no spray or water.


... Dishwashers

My Kenmore Elite dishwasher did not drain the water out of the bottom after the dishes were washed last night. Could I possibly have pushed a wrong button to keep it from draining, or do I have a problem? All the dishes were clean. Should I run it through another wash cycle? I've got water standing in the bottom of my dishwasher.


Yes , If the program controller has hung it would have skipped the drain cycle. So try to redo the cycle and see if the drain works, is not check the program controller and the drain valve/pump.- if there is food particles that have clogged and block ... Kenmore Dishwashers

I just installed my kitchen aid dishwasher model kudco03fvss and it won't drain. There is standing water in the bottom of the dishwasher. It is a brand new appliance. There is no water going through the drain hose that I can tell. Is the pump faulty?


Hi, my name is Audrey. I am a KitchenAid employee and thought the following link might help address the draining issue you're having with your dishwasher:\015\012 \015\012 ... KitchenAid KUDC03FVSS 23 in Builtin Dishwasher

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

Dishwasher won't drain. Pushed the drain button and water stil is at bottom of tub. Sink is not clogged, drain hose is not clogged and can't see what is in bottom of tub due to standing water? What are suggestions for repair?


... Kenmore 15639 Built-in Dishwasher

Standing Water After running our dishwasher we have standing water in the bottom, it won't completely drain out. Thanks, ---Joe


Are you leaving it long enough to finish it's programme or are you opening it when the drying light is on as some dishwashers leave a bit of water in the bottom to help with the drying programme ... Dishwashers

Our GE Dishwasher model GLD4500N00BB will only drain a small amount of water out of the dishwasher. there is water left standing after a wash. what is going on?


Look for restricted drain system. Screens and ports get plugged, also verify the drain hose is NOT kinked at all. Hot water draining relaxes hose and can cause restriction. ... Dishwashers

Standing water at drain in dishwasher after using.  Is this normal or should the water drain completely.


Most dishwashers leave a small amount of water in the bottom to keep the seals lubricated. If it is only a small amount of water it should be normal. ... Dishwashers

I have a JennAir dishwasher (E71195), and all the water does not drain out. The sink is not backing up, but there is water standing in the bottom of the dishwasher.


... Dishwashers

My dishwasher is not draining water - there is standing water at the bottom of the bin (I used a cup to get out as much as I could before I shot the video). The back part that looks like a drain is no


Pull the bottom sprayer out. There should be two clips on either end of it that allow it to come out. Then remove the screen from the bottom of the dishwasher floor. This can be tricking and may take some effort to get out. I'm betting the drain in t ... Dishwashers

Water does not completely drain? Garbage disposal is functioning properly and hose from Kitchen Aid dishwasher to Garbage disposal is good. I ran the dishwasher a couple of times start to finish for rinse cycle and approximately 1/2 inch of standing water on the bottom. Any ideas? Please help. Thank you.


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

After cleaning alot of crud out of the bottom, the dishwasher wont drain! I took all the parts out that I could and cleaned them with bleach water, put it all back together and ran a load of dishes.........Now there is orangish water standing in the bottom of the dishwasher!


Hi,\015\012\015\012\015\012You have blockage inside, in the drain line, or if it connects to the disposal side of the sink. I would first check at the disposal, if it does indeed connect there. Usually gunk from the disposal will cl ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My GE Profile Performance dishwasher (GSD 4910) doesn't drain. I hear the pump working, and water draining into the sink (not a disposal) as it should, but water is left standing in the tub about as high as the heating element. I have taken it apart and removed a few small items stuck in the system in various places, but that didn't affect anything. I have read here and there about the piston and nut assembly, but I don't think my model has that -- or maybe it does? Can you affer a


... GE 24 in. GSD4910X Built-in Dishwasher

All of a sudden, my Kenmore dishwasher (Model 363.1411691) will not cycle. When I lock it shut and try to set it to wash, all I hear is a click--no motor running, no water sounds. As I advance the timer knob, I just get clicks where each cycle should begin. There is standing water in the bottom of the dishwasher which does not drain out. Any advice would be much appreciated, for sure.


Hi.The clicks are simply the relays in the timer board that try switching on. The control module is likely working.The cycle does not start because of a different problem.If no light is coming on, then ensure that wall socket ... Dishwashers

When the cycle was done I had water standing in the bottom of the dishwasher. I checked the drain line and it is not clogged or crimped anywhere. I pushed the button to drain it out and it is still in the bottom of the dishwasher.


Can you here the drain pump coming on there may be a small piece of glass or something in the pump not allowing to flow out of the dishwasher ... Dishwashers

Wont drain? My dishwasher will not drain. I ran a load and now there is standing water in the bottom of the dishwasher. I had problems with my disposal earlier and think maybe it progressed down the pipe.


If you have an air gap on the sink from the dishwasher and water is leaking out here into the sink instead of the drain it is probably plugged from there to the disposer or "P" trap in the drain line,also check the sump screen and down in there for f ... Bosch 24 in. SHU43 Built-in Dishwasher

Our dishwasher isn't draining completely. After a load there is standing water in the bottom of the dishwasher. I checked and the drain hose isn't blocked. What else can I do to fix it?


Hi,\015\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Water will not drain ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

Dishwasher not emptying at the end of its cycle. If water siphoned out will work temporarily then fails again, with water remaining standing inside machine. Check water indicator light is on, goes off when water siphoned off, then comes on again when machine again fails to drain


Not sure of your light indicator; check the manual. But fyi there should be a little water left in, so the rubber seal doesn't dry out. More than that, and could be clogged drain or bad solenoid, which tells it to open and drain. See: http://www.part ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

We heard our bosch dishwasher just running last night but not circulating any water. I took out the drain screen and there was some dirty standing water so I used my shop vac to remove. It is still just running and no water is flowing. I was told it is the flood shut off? Please advise ASAP. Thanks


Hi\015\012\015\012The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The wa ... Bosch 24 in. SHX46A05UC Built-In Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1512 seconds