Having problems with your GE Dishwashers ?
MANUAL FOR GE GSH 5530 220 V ONLY - GE Dishwashers
Repair Help & Product Troubleshooting for GE Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have a Hotpoint Dishwasher model no BFV620,hope anyone can help,the problem is 1(listed as pre wash) and 2(listed as wash) flashes rapidly when system starts to drain ,and the system does not drain completly ,still dirty water in bottom of the dishwasher,checked instruction manual and this lists any other forms of lights flashing but not the 2 mentioned,any advice would be greatly appreciated
... Hotpoint 23 in. BFV62 Built-in Dishwasher
2 brand new Kenmore elite dishwashers - All hookups checked and correct. Start buttons blink - cycles will not start. 1 washer ran for about 10 seconds - then the light started blinking. Troubleshooting in manual says light will blink if the door is not closed. They seem pretty closed. Dishwashers leveled and plumb. Tried it mounted, and unmounted. No Luck. Thanks
These dishwashers have a safety feature. The door has to be closed within 3 seconds of pushing the start button. If the cycle is interrupted at all by opening the door or pushing something while started you will have to push the start button to resum ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
Samsung DMR57 dishwasher - Food grit and grime is now being left on the dishes in the lower rack, especially where they touch, after washing. The unit is 1 1/2 years old. The problem seems to be increasing over the past few months. I've tried all the manual's recommended procedures, to no avail. It would appear that either the water is not splashing up enough OR the grit is not being flushed out sufficiently. The manual states (inside front page) that "This product keeps food waste internal
Make sure that your unit is draining completely, if not then the sump needs to be serviced and cleaned out professionally. Make sure all your wash arms are clear, pull them off and check for stuck toothpicks, food debris etc. Next make sure that they ... Samsung DMR57LFS Stainless Steel Builtin Dishwasher
Our LG 6810 dishwasher has stopped cleaning. After the cycle the dishes are wet and covered in greasy clumps. We ran the test cycle and got the following: 3H/U3 11 22 33 44 55 66 04-2 32 33 0 (inlet valve) 35 36 37 38 23 (Thermistor) 3A 3A (beeped twice and showed 3A) 3A (beeped twice and showed 3A) Any advice you could give me would be appreciated. I have the service manual but have never done any type of dishwasher repair. I'd like to not have to replace this dis
1.) Take racks out of unit.2.) put both of the spray arms in the 12 o'clock position3.) Run the washer,once the washer has started wash cycle,open the door and ensure the spray arms have moved off of the 12 o'clock position. Write down re ... LG LDF6810 Built-in Dishwasher
Miele dishwasher optima G 2420. during instalation and test for water hardness display shows 'P' then '1' then '0'. is this a water hardness of '1' or of '10'
... Miele Optima G2470SCSF Dishwasher
I have a maytag quiet series 300. When it is done with any of the cycles in leaves about 1-2 inches of water in the bottom of the dishwasher. I can manually hit the start button twice and it will go through a 2 minute cycle and pump out the water. I have cleaned the filter inside the dishwasher where it drains and have checked the hose to the disposal and it pumps out fine. It just doen't pump itself at the end of the cycle. HELP!
Here it is - Maytag Quiet Series 300 Manual ... Maytag Dishwashers
Bosch she44c dishwasher. Dishwasher times down to 1 min and continues to run until until manually turned off. After further investigation the spray arm do not rotate during cycle. We have also noticed a decline in how clean the dishes are
Hello, Welcome to Fixya.. On bosch dishwashers the "1" is actually an error code and not coincidentally the reason it runs forever ( likely doesn't dry or clean well either right ? ). Here`s the most likely reason why it has detected the error... Eve ... Dishwashers
Model No: SE6 TIE 1 GB/17 Tecnik integrated dishwasher The dishwasher started to make a strange noise. I scooped the excess water out of the bottom and reset the machine but when switched on again it just pumps water into the bottom of the macine. I have removed and cleaned filters as per the manual troubleshooting section! Thanks for any assistance
... Tecnik Dishwashers
Err 1 on Whirlpool Dishwasher ADP6000Wh, have manual says "Longer inlet time" checked the faucets but all seem to be connected properly. wash cycle stops approx 1 minute in.
... Whirlpool Dishwashers
My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat
Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers
When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid
What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher
I lost the manual for my dishwasher. I have two questions: (1) How does Light Wash differ in its cycle from Normal Wash? It seems it should be (but isn't) shorter. (2) When using the Light Wash cycle, should I put soap only in 1 of the cups for dispensing (leaving the pre-wash cup empty)?
\015\012We need the Model Number off the inside of the door to get you the manual please post this first so we can Help you Thanks ... Dishwashers
Electrolux built in ESL4115 Dishwaser:- Starts the programe briefly but stops with two intermittent audible signals when you open the door the cycle has not really started and there is water at the bottom of the dishwasher(when u refer to manual says the sink spigot is blocked or water drain hose has not been correctly laid or is bent). I have had this for just over 1 year working ok up to this point, tried to see if there is a blockage, taken pipes out doesn't appear to be any blockage also th
... Electrolux Dishwashers
NEFF S4340X0GB Dishwasher frequently stops with sump full of dirty water. Detergent dispenser has not opened. After manual draining machine is ok for 1 or 2 washes. Interior is clean. Problem occurs on all programmes. What is the problem?
Dirty dishes The dishwasher in the house I moved into is a very basic model of approximately 1-2 yrs. old. In every load that I wash there are some dishes that are not cleaned properly. I do not have access to a users manual and was wondering if I need to set the water temperature? Can anyone help?
You need to take the spray arm off of the bottom and get down to the filter: there's probably food trapped in the filter somewhere, not able to drain out and it keeps recycling onto the dishes at each cycle. Good luck! ... Sears 24 in. 14181 Built-in Dishwasher
How do you reset a GE quietpower 1 dishwasher, it will only let me run it in Rinse cycle, no wash cycle, no heayed dry. I need a manual to learn how to operate the control panel!
... GE Dishwashers
Some 1 gave my daughter a slimline zanussi dishwasher not sure what model it is but looks quite old. need a manual as the program numbers have faded and cant see them regards chris oh and its a aqua save if this helps at all thanx.
Hello,\015\012If the model is correct then even without a manual the control set up is as follows.\015\012From Lhs you will see on/off/ button next are the 2 lights top one is on/off and the bottom is for salt low light.The next button to ... Zanussi 18 in. ZDT5052 Slim-Line Built-in Dishwasher
I'm having trouble starting my ge profile dishwasher; the machine locks but then when I push the start button one of three things happen: 1) I get error C3 and I do not have a user manual) 2) nothing happens 3 I get the screen indicating that the machineis a sensing soil level, washing' but in fact nothing happens - I do not hear the motor starting and no water runs, thank you!
... GE 24 in. Profile PDW7800 Built-in Dishwasher
My Bosch integrated dishwasher(model SGV56A03 GB/12) runs through the cycle but doesn't stop at the end of the cycle. It continues to heat water and it sounds like the motor is running even though the time indicator shows 0 minutes. I have to manually switch it off. Any ideas before I call out an engineer. I have checked all the filters etc included in the troubleshooter info anf there are no blockages.
... Bosch Dishwashers
Preventive maintenance? I have a kenmore elite dishwasher 665.13113100 for 1 1/2 yrs - It's working just fine. Should I be cleaning the filters yearly or doing some type of preventive maintenance? I don't find that info in my manuals.
You should buy some c.l.r. (calcium,lime,rust) remover.It's packaged in a grey bottle at any supermarket,drug store,ect.Pour a cup in and run a cycle once a month.This will prevent any lime build up from scaling the dishwasher due to hard water. ... Dishwashers
I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.
Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers
Kenmore elite dishwasher, less than 1 yr old. Wont drain. I have pressed ''Drain'' on the keypad, motor/pump runs but no drainage. If blocked, where? Can I clear it without having to dismantle and remove from under the counter. I have no manual to reference. Thanks.
Could be blocked in the bottom of dishwash, you may have to remove blockage. or take lose the hose under the sink enter the garbage dis. ... Dishwashers
Cookworks wqp8-9239 slimline dishwasher. Start the cycle on setting 1-4 and half to three quarters of the way through it stops and starts beeping with the first 3 buttons of the control panel flashing. The manual says when lights begin to glimmer the machine is out of order? can i ficks this without sending for repair man?
Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. It's been in for about 5 years and have had no problems with it. Can't find instruction manual.
THERMADOR DISHWASHER MODEL # DW44ZW 1. NEED MANUAL; 2. LIGHTS GO ON WHEN THE DOOR IS OPEN; 3. NO LIGHTS ON WHEN DOOR IS CLOSED, BUT MOTOR HUMS, BUT DOESN'T DRAIN.
HiThanks for using FixYa. Please click on this link for manual of Thermador DW44ZW Dishwasher. T ... Dishwashers