Having problems with your GE Dishwashers ?

My GE Potscruber dish washer is leaking water underneath in the middle. Water is dripping from around the metal sim running across the middle of the dish washer. What should I do next and is it fixable?


Answers :

You will have to get a flashlight and a phillips head screwdriver. Remove the lower front panel of the dishwasher and carefully check the drain hose for a leak. You may end up replacing the hose that runs from the base of the dishwasher into the garbage disposal or sink trap. J.
Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My GE Potscruber dish washer is leaking water underneath in the middle. Water is dripping from around the metal sim running across the middle of the dish washer. What should I do next and is it fixable?


You will have to get a flashlight and a phillips head screwdriver. Remove the lower front panel of the dishwasher and carefully check the drain hose for a leak. You may end up replacing the hose that runs from the base of the dishwasher into the ga ... GE Dishwashers

Kudm01fkss0 not running, initially the green light next to rinse flashes in the middle of the cycle. I clicked on cancel to drain. I ran the test cycle and the light next to normal was lit when done but it still will not run a cycle.


... KitchenAid Dishwashers

Whirlpool Dishwasher GU2548XTP- Dishes still dirty after it has run, especially the top rack. 5 (?) yrs old. Runs and grinds intermittently, no water seen under unit. Sometimes I add more water when it grinds, then it runs very quiet. Sometimes it doesn't seem to fill enough. Water supply good, inlet screen inspected not clogged. Not a lot of pressure shooting the water around the inside of the unit, as the detergent that bleeds through the slotted half of the detergent flip door isn't r


The inlet valve is OK, therefore the control board was not the problem. The impeller pump is noisy and inefficient, and must be replaced.Here is the part: ... Dishwashers

Leaking from under dishwasher. Has run great since 1996. Under counter model in manufactured home. Chnaged to drop in pellet dishwasher detergent and it ran great. There is no water inside the dishwasher circular drain. We never use the heating coil to dry the dishes. We have turned off the water supply line under the sink to the dishwasher. Cool clear water is running out from under the bottom right corner. The hot water heater is right next to it and everything is dry and warm under it which i


Hi,Depending on the model you have this could be a couple of things. The most likely suspect is the water inlet valve. What I would recommend to do is take the bottom toe panel off, typically there are either 2 or 4 screws holding this pa ... Dishwashers

I have a triton xl model @ gsd6200g00bb serial #va790400b. The dishes on the top rack are not getting clean. I have removed the top, and middle, and bottom arms cleaned calcium out of them. Removed the screen below the lower arm cleaned. The top and middle arms are still not spinning during wash cycles. Where do I go next?


Apart from the spray arms themselves there could be other reasons why the water is not getting up to the middle and top arms.\015\012\015\012The distribution circuit from the wash pump that feeds the arms could be blocked or the wash pump ... Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

We have a hobart sr24h dishwasher which is leaking around the lower portion of the door. Should there be a gasket that runs around the inside tracking of the door or machine and not just across the top?


Hobartcorp.com under service tab click parts then smart parts system tab ... Hobart SR24-H Built-in Dishwasher

Kude70FXSS3 after cycle completes blower continues to run. DW will not restart for next load. DW will not stop running if door is opened to add a dish


... Dishwashers

Dishwasher Dilema Hi, Can someone help me solve this problem. Last time I had a problem with my dishwashers I was pretty successful in solving it on this site. I was running a reg wash on the top drawer of my Fisher&Paykel when I suddendly had to stop it in the middle of a wash to add more dishes (something I do all the time) suddenly both screens started beeping with an F1 along with a wrench. It sounds like both motors top and bottom are running full blast. I tried shutting the power for a few


You need to remove the bottom drawer and dry out the water with towels and a hair dryer when this is done it should operate normally. most likely when you pulled out the drawer the water sloshed back and out of the drawer making the dishdrawer think ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

My kitchenaid KUDI01DL dishwasher began making a lot of noise while running, then subsequently decided not to circulate the water around to wash the dishes. It sounds like the motor is running (maybe) but there is no washing action going on. The machine will fill, drain and heat the water but nothing else. Is it likely that the pump/motor assembly has ceased to function properly? thanks...


The problem is very likely in the chopper and/or somewhat possible in the impeller. The chopper is replaceable from the front. Disassemble the pump, the chopper will be on its left side under a cover. That cover is kinda tricky to remove (remove all ... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

I have a whirlpool dishwasher Quiet partner 2. I am using cascade detergent, my dishes coming out spotty. I have tried running with a very light load and the same thing happens. I notice that there is a white film around where the water comes out during a wash. I am running a normal cycle with heated dry.


Your problem is hard water. the minerals dry on your glassware causing a white film or residue. go to www.dishwasherfilter.com. they have an awesome product designed for yo ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a KitchenAid Sculptura dishwasher and it have been leaving food particles on the dishes. I started to take it apart, removing the bottom spray arm. I can see a lot of old food underneath. I'm having a hard time removing the next piece. There is a 1" rubber nut with a screw in the middle. Is this the next step for removal?


Hi\015\012\015\012Thanks for using FixYa. Please post back with the model no of your Kitchen Aid Sculptura Dishwasher so that I can further assist you.\015\012\015\012\015\012Thanks\015\012Ryle ... Dishwashers

Our dishwasher was cleaning just great...then the next washing...no clean dishes. We thought we forgot to run it, so reran, and the same thing...dirty dishes. Any ideas?


Hi If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liqu ... Amana Dishwasher Accessories

DD602 model. while running upper washer appears that the seal/gasket around the whole upper is not working as water makes it out of basin and on to the middle shelf, then drips on floor. is there a way to test/double-check that the gasket is filling with air? any other ideas.? bottom basin works fine.


I had a air leak so that it would fail to keep a seal.To find out what was going in a made up a hose, which I could put in line and fitted in a pressure gauge.  It showed that the pump was pumping, but the exhaust valve had a small leak. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Portable Dishwasher I have a older model portable dishwasher. It works great and until it goes out I would like to keep it. I am wondering how or what I will need to make the dishwasher a non-portable. I get so tired of moving it across the kitchen floor. Is there anyway I can hook something up to my lines underneath the sink so it will stay where it is? it is only about 10 ft away from my sink but that it alot of moving around when it is full of dishes. Please help. [email protected]


I sent you and email with some instructions, Look to hear from you soon!! ... Kenmore 17252 Free-standing Dishwasher

After 3 years it just started making a loud noise, I am no expert but it sounds like a fan in a motor. I have only heard it today, but I am betting it will still happen next load too. I didn't change any of the settings, have been running the same way forever. When I did hear this noise I started pushing buttons to see if I could get it to stop, no good, no change. The cycle has completed and everything looks ok, waiting on the dishes to dry. Drainage has never been a problem for me either.


I would say this is a build up of lime.try changing your tablets and checking your salt levels.there is no fan .try what i say and see what happens.have you found a glass broken it could be as simple as that but i dont think its serious.adrian,,,, ... GE Nautilus 24" Built-in Dishwasher

Top wash arm does NOT spin, but is not blocked or hard to move by hand. Does this run off water pressure? Whatshould Itry next. I have already removed the filters and cleraned around the pump. The bottom wash arm works great.


Remove the dishwasher from the cabinet and look at the hose going up to the top. Make sure it isn't clogged and that there is nothing in the port where it comes out of the pump. The top arm is powered by water pressure from the pump. ... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

Dishes not coming clean, film ring on glasses and dried grime on the utinsels. Have run through twice with vinegar, not sure what to try next. Checked basket/drain and it was not blocked just has a small ammount of warm water after cycle. I use very little cascade soap and keep rinse agent ciup filled. Inside has a whiteish film.


It is definately hard water causing your problems. go to www.diswhasherfilter.com. this product will solve your problem. guaranteed or your money back ... Bosch Dishwashers

Dishes are not slick after the cycle, clouded. Black, gummy plaque line around what appears to be a drain.Need to find the drain and clean it. What sort of cleaning product might be run through a cycle. We don't have a manual, but the Model number is MDB4100AWW


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Maytag 24 in. MDB4100 Built-in Dishwasher

I have a Jade RJDW2470A dishwasher which was re-branded Jade. (It is a Maytag product.) It get's stuck between cycles and will run forever unless I manually advance the dial to the next cycle. It seems to get stuck around the "rinse" cycle and the soap door does not open until after I advance it past that cycle.


... Jade RJDW2470A Free-standing Dishwasher

Dishwasher is 2 years old. Top shelf dishes not getting clean even on on heavy duty and sani rinse cycle. All arms move freely,tried the 2 cups white vinegar in an open container and run cycle. I thought that helped but a few days later we are back to the same thing. No debris around drains. Tried loading differently. I have called for a repair person,but is there anything else I could check on my own?


Sometimes the holes in the arms get blocked up,sweetcorn,rice etc, this then stops the arm spinning and water being sprayed onto plates etc, unscrew it and run water through the centre hole and see what happens. ... KitchenAid Dishwashers

Kenmore Ultra Wash Quiet Guard - will not drain at end of cycle. After cycle is complete, water (not clean) sits at the bottom of the washer but I still unload the dishes and then turn the cycle dial around again - going past all the water heating and filling and washing - and land on the drain cycle, it will drain. Any ideas why it will not drain when I let a cycle run, but will drain once I cycle it through to the drain option?


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Leaking dishwasher My GE dishwasher leaks when running a load of dishes. The leak seems to be coming from about the middle of the tub about halfway back. I can't see exactly where it's coming from, but it appears to be dripping right behind the motor. Could it be a poor connection? I would appreciate any suggestions. Thanks, Bob Engle I do not seem to be able to find the model number


Probably a leak at the motor seal where it enters the tub. Best to remove the motor if you can and inspect the seal. ... Dishwashers

Bosch Diswasher Have Bocsh SMU 2046 UC diswasher. Aprox. 11 years old Has always worked well. Recwntly is not cleaning at 100% as before. Seems to run through cycle as normal and sort of cleans but leaves stains in coffee cups and flatware seems filmy, sometimes a little guk left on dishes, all uncharacteristic of past performance. Tried a thermometer during cycle and water temp is around 151 F during wash, 136 F at rince. and 154 F at dry time. Have checked arms for cloging and are free w


Remove the drain hose and check if you have any residual into it. After 11 years your appliance may need a thourought cleaning.Check also if the pump has enough pressure. ... Dishwashers

Frigidaire dishwasher PLD2855RFC rinse aid leaks around cap. How to fix? New cap? Is this a recurring problem? I have found rinse aid on door below cap (residue) plus have found rinse aid itself on dish below dispenser. I have to refill the rinse aid reservoir about every 7 or 8 wash loads. Also, the dishwasher is very noisy when running (should be quieter). Not very happy with this model ...


... Frigidaire PLD2855RFC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1513 seconds