Having problems with your GE Dishwashers ?

The dishwasher did not finish last rinse cycle. I have no power, no lights light up. I reset the breaker. Is their another reset button on the Dishwasher itself. I have a Quiet3 Power GE Dishwahser.


Answers :

Hi,

I am sorry to hear regarding the trouble.

The best way to reset - Disconnect the power supply for few minutes, say 15 minutes and then turn it on.If the problem persists, this would confirm an internal failure.

As there are no lights and no beeps - this would only mean that the control board is gone.On most of the models, there is a fuse on the control board that could cause this problem. Unfortunately, board level repair is never an option with control boards. You need to replace the control board. Be advised that there could be few other causes such as wiring or power issue's that you need to eliminate.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Hi
\015\012\015\012

You can try to press and hold the AIR DRY/RINSE ONLY button\015\012for 15 seconds. If this won't work then check the drain hose and the drain pump\015\012filter for any clogs, try to clean it so that the water drains completely. Also\015\012check if you hear a hum like sound from the bottom of the unit, it can be that\015\012the motor is bad. However, if the motor and pump is fine then it is the control\015\012board that is bad and should be replaced. Hope this helps...please post back\015\012for further assistance.
\015\012\015\012

Daniel

Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The dishwasher did not finish last rinse cycle. I have no power, no lights light up. I reset the breaker. Is their another reset button on the Dishwasher itself. I have a Quiet3 Power GE Dishwahser.


Hi,I am sorry to hear regarding the trouble.The best way to reset - Disconnect the power supply for few minutes, say 15 minutes and then turn it on.If the problem persists, this would confirm an internal failure.As ... GE Dishwashers

I have a Bosch SMU2046Uc/14 about 15 years old. Sometimes it works, sometimes not, for the last couple of months. Now it has stopped working completely as if no power. Checked the breaker. Another problem - one of our kids just today jammed the door lock on it and we cannot get the door to latch at all. Can you help with any one of these problems? How do you fix or reset the door latch??? What else can we check to troubleshoot the dishwasher? Thanks!


... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Model DU948 Whirlpool dishwasher stuck, won't start, has power and water. Tried pressing cancel but another button and that one blink constantly and nothing happens. we've reset the circuit breaker.


... Whirlpool DU1055XTSQ Built-in Dishwasher

Elba dishwasher (turn dial model) under 2 years old, this will be the 3rd time this has occured. You turn dial to preferred setting and press power it pumps out continuely and wont move to next stage, i have tryed reseting but to no avail please help, I will not be buying another F&P product again.


Your unit has had a "brain aneurysm" IE: Your Microprocessor has failed...Either a fix or a new one? ... Dishwashers

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

Dishwasher Normally, after the dishwasher cleans the load, it displays green light next to clean. Once the door is opened, the light goes off an dishwasher is ready for next load. But from few days, after opening the dishwasher door, the clean light does not go off, it remains lit. Dishwasher doe snot reset for next cycle. So, I have to go in the basement and trip the main power to dishwasher. That resets the dishwasher. This needs to be done before each cycle. Not sure how to resolve the issue.


Make sure that you do not open the door during the wash cycle. Wait until all the cycles \015\012are complete before opening the door. Especially don't open the door \015\012during the drying cycle. ... Dishwashers

My 3-yr old GE Profile dishwasher lost power soon after initiating wash cycle. Checked braker switch...fine. Checked outlet power...fine. Dishwasher power mysteriously came back on approximately 12 hours later. Initiated another wash cycle and lost power again after a few minutes. Water remains in bottom of tub. What's wrong????


First thing i would check is the actual wiring behind the toes kick\015\012you will seea wire box, shut the breaker off, open up the box and double check all your connections there,\015\012 the next step would be to check the voltage ac ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Maytag Dishwasher I need the reset sequence for my dishwasher. The power comany had turned off the electric to the house to make chages elsewhere in my house. When the electric was turned back on all appliance came back on except the dishwasher. The dishwasher has a front panel touch pad and three of the panel lights are flashing. I know there has to be a sequence to reset the machine. I also need the peace and quiet in the house since I am the husband and am suppose to know it al


We have a model mdvtt53aww1 and you can push three buttons and will light up the hi temp wash, heated dry and sanitize is there a code make it start ... Dishwashers

No power. Dishwasher will not come on. I checked power to power switch. It has power to switch. Is there a fuse in dishwasher, or a reset anywhere. It is a Whilrpool model.


Yeah, there is a fuse just enderneith the panel on the control board itself. It's white in color, and snaps on and off of the board. Very easy to replace. I bet that's your problem. Good luck :) ... Dishwashers

No Power I have a bosch shx33 dishwasher. I just replaced the water valve because of a leak and now I can't start the dishwasher. It's like there is no power to the unit. I know there is power because I get a shock if I touch the two wires that are connected to the water valve. Is there another trip switch or something somewhere?


First let me say that using parts of your body to test for mains electriciy is a VERY VERY bad idea. You are lucky you are not dead. Please do not touch live parts again, get a multimeter or a mains tester.\015\012\015\012If there is mains across the ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

Kenmore dishwasher My dishwasher stopped in the rinse cycle and no longer appears to be getting power, although the breaker works and the plug it is connected to is still receiving power. Is there a reset button for the motor, or some other idea to try and fix this? Thank you for your assistance. Mark


Mark, you probabley blew the thermal fuse located on the main board. Easy fix. Part number 8269213. You can ohm it out to be sure. You have to remove the inner panel to get at the control board. The fuse sits on the top side and clips on. Two wires ... Kenmore 24 in. 16293 Built-in Dishwasher

Hi, Had a power cut at my home and my Caple Di455DL Dishwasher was mid cycle on a glasswash program at the time, since power has been regained it will not restart or reset itself, it just lets a pulse of four beeps go once the door is shut and makes a sounds like its trying to pump out water? tried turning off at mains etc but cant get it to reset!


... Dishwashers

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

No Power My Whirlpool Dishwasher DU900PWKQO was working yesterday and now does not have power to it. Is there a reset button to press or can a dishwasher just stop working?


You probably have a bad door switch assm, there is no reset on this unit, if you have a bad door switch the unit thinks the door is open so it won't start. ... Whirlpool 24 in. DU900PCD Built-in Dishwasher

ASKO 1555 dishwasher won't run. The anti flood device motor won't stop running but we've removed all the water. All the lights on the front panel blink in unison and when we hold down the start/cancel button on the front, nothing resets. We can't run our dishwasher. We've tried disconnecting power and resetting the circuit breaker but the churning motor won't stop.


Hello,Welcome to FixYa.Based on your description " The anti flood device motor won\\'t stop running but we\\'ve removed all the water " It is likely nothing very serious. ... Asko 24 in. 1805 Built-in Dishwasher

Towards end of dishwashing cycle error code comes up and consitently beeps, can not turn off by machine buttons or reset. We have to reset by power plug. Water is left in bottom of macine, dishwashing powder is left on most things. Rinse button then works, it then drains the machine no problem. So I dont think it is the pump.


No response ... Dishwashers

Where is the reset button on a ge dishwasher ? GE dishwasher won't start up no power is getting to the machine..checked breaker and plug in all ok is there a reset button located anywhere ?


... GE 24 in. GSD2000Z Built-in Dishwasher

I have a Maytag Dishwasher. I believe the model no. is MDBH968AWQ3. We have had it installed for about a year and have had problems with it. We have had to have a latch replaced. Now the power went off the other night and it just flashes start/resume. We can't get it to reset. We have turned the power (breaker) off to it, thinking that it would reset, but it has not. Can you help?


... Maytag Dishwashers

The dishwasher quit during a cycle. I can't get it to start. I have power to all portions of the dishwasher. Do you think the motor stopped due to overload? Is there a way I can reset the motor? If so where is the reset button?


If the Dishwasher cycle does not complete \015\012\015\012Test the ... GE Nautilus 24" Built-in Dishwasher

Looks like program in electronic dishwasher has locked into a cycle. the machine will not drain even after resetting it. Also it will not restart any program or cycle after resetting and recycling power. The machine is a classic electronic bosch dishwasher It has worked perfectly for three months


Im a old bosch tech . the problem is the module or the drain pump is stuck. if this helps please give me a 4 thumbs up post thanks. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Haus dishwasher need to reset it...no power apart from power light on water at the bottom of dishwasher


... Dishwashers

Whirlpool dishwasher This dishwasher quit in the middle of a wash cycle,we had to empty it and wash by hand. I thought that maybe the breaker to the dishwasher popped but when checked it had not .I then noticed that there are no lights on the electronic key board .Even when not in use there should be one red LED that is lit. It almost seems as if there is no power to the dishwasher. Is there some type of backup safety switch or breaker on the dishwasher itself that I could reset?


Fuse on control board. ... Dishwashers

No power My dishwasher Model DMR77 quit working yesterday during a wash cycle. No power ie, no display light or tones. I am getting power to the unit, checked with a volt meter. I am thinking Power supply, or is there a reset on the unit.


Hi,\015\012 The main PSU is part of the control board. You may be lucky to find an aged fuse to replace, but it's more likely a power transistor that's fried.\015\012\015\012Unplug and remove the control board to see which bit's toa ... Samsung DMR77LHS Tall Tub Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2321 seconds