Having problems with your GE Dishwashers ?

I have a GE PDwT 480R30SS dishwasher I tried it last night and the control lights won't turn off how do I turn them off


Answers :

Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a GE PDwT 480R30SS dishwasher I tried it last night and the control lights won't turn off how do I turn them off


... GE Dishwashers

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers

I have a Whirlpool Gold Model GU2700XTSBO its only 4 years old. About two weeks ago i noticed that the green lights were flashing and it would not run, I unpluged it for an hour and pluged it back in and the lights went away and it worked ok for the last two weeks. Last night I went to use it and there is no power at all to the washer, I checked the power source to the outlet and there is power there, so I dont know if there is a reset button or some control panel problem?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

I bought an IKEA Renlig DW60 dishwasher about 6 months - the controls are located on the inside top of the door. Ordinarily the dishwasher turns on and three red LEDs on the far right of the control panel light up. On occasion however only a single red LED indicating the temperature of the last wash I carried out will go on (it is always the 50 degree light as this is always the wash temperature I use). When this happens the dishwasher appears to be stuck and will not start when I shut th


Press and hold the cancel button for about 5 seconds. This resets the electronics and gets it going again ... Dishwashers

My kitchenaid dishwasher model # kuds02frss2 stopped working after I ran a cycle of dishes last night. When I looked at it this morning 3 lights were flashing: normal, china and cancel. When I turn off the breaker and turn it back on the same lights resume flashing. Any ideas on what this could be?


... Dishwashers

I have a GE dishwasher with front control panel and at first the wash and dry lights stayed on and it was beeping every 30 sec. when I turned the breaker off for the required 30 sec. the lights started flashing and it is still beeping. The control panel seems to be frozen as it is not working and wont do anything.. everything was working fine before this. I bought it at Home Depot on 3/14/07 and had it installed by a licened electricion. Help


Call ge @ 800-386-1215 for service ... Dishwashers

I have a Triton dishwasher. Last cycle, it completed washing then started drying and started beeping and the drying light is flashing. When I finally opened the latch, the beeping stopped, but the drying light is still flashing. The dishes were clean and warm - they air dried the rest of the way. I have not been able to get the drying light to go off. I have turned the breaker off over night, and flipped back on. The dishwasher goes back to flashing washing, and then clicks to drying and th


Hi,\015\012Make sure the salt level is ok - add 1Kg of salt if you have not done it in a while, and check rinse-aid level if apliccable.\015\012\015\012If this does nothing, then remove the lower kick panel for access to a data shee ... GE Dishwashers

Hi, I have an ADP8540. I turned it on last night but this morning the light was flashing and nothing was washed. I tried it again and it washed but everything came out all soapy and once again the light was flahing. Is this a problem I can fix myself?


... Whirlpool ADP 8900 Dishwasher

My GE Profile dishwasher (model PDW9880L00SS) has an electrical problem. Last night, the dishwasher was beeping and the control panel lights were bouncing around as if someone was pushing the buttons. I managed to get it to run a cycle, and now the control panel is completely dark.


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Last night I turn on my dishwasher adl 945. It started to work but after few minutes i noticed that the dishwasher stoped and it looks like in the middle of program. Now the dishwasher wont even to turn on. Do you perhaps know what is wrong? .


... Dishwashers

Have a 4 year old Kenmore Dishwasher Model # 74382. No problems at all until last week I went to start it and it would not turn on. Lights on the control panel were on with exception to the start light. I opened and shut the door to make sure it clicked and pressed the start button again and nothing. I tapped around the panel with the side of my fist and pressed it again and it began working. Well today different story I went to start it and it did the same thing. I tapped all over front of the


The problem is more likely the door switch is failing or out of adjustment/loose. You will need to remove the door panel. This is easy to do. There is a video at ... Kenmore 24 in. 74382 / 74384 / 74389 Built-in Dishwasher

My Ge profile Triton Dishwasher wont start when I lock it just keeps beeping and the" normal "light flashes there was something stuck in the turnstile and it stopped and beeped all night when I took it out it was left this way I have turned the power off and on and I still cant reset it any ideas it just wont reset


... GE Dishwashers

Dishwasher won't start and it is plugged to working outlet. Control panel lights do light up. When I turn the setting dial to start, nothing happens. It looks like the last cycle never finished as there is water on the bottom. Any thoughts what might be wrong?


... Whirlpool DU912 Dishwasher

I have pldb998ac frigidaire dishwasher. The rinse light stays on, and it won't start. Last night it was pretty loud while running the dishwasher, smelled a bit like plastic, and today only the rinse light. The heating element seems to turn on as well when the door is closed. Help - any ideas?


... Frigidaire PLDB998A Built-in Dishwasher

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

Maytag dishwasher mde8600aww I just replaced dishwasher handle and switch assembly and turned power on at breaker and lights blink independantly like its in diagnostic mode. customer said it started doing this last night? I have no tech sheet or manual 4 this. Help


Hi\015\012\015\012\015\012Thanks for using FixYa. The model no# mde8600aww for your Maytag seems to be a model no# for a Dryer instead of a Dishwasher. However, from what you have described it seems it is the control pa ... Dishwashers

I have an Asko 3251 that is about 4 years old. It has been great up until 2 nights ago when it just keeps running when is has completely cycled. You can open the door and it keeps running. You can push the shut off button and the lights on the controls go out but something keeps running. The only way I can shut it off is by shutting off the circuit breaker. The next morning I can turn the breaker back on and it will be off. Does anyone have an idea what is causing this?


... Asko 24 in. D3250 Built-in Dishwasher

Frigidaire Dishwasher model # FDB520RHB2 Stopped prematurely last night while on light cycle, now will not respond at all. Noticed water at bottom of tub; tried draining manually through drain tube, removed lower arm, glass trap, and filter, and water remains; tried electronic reset by switching off breaker for several minutes; all to no avail. Electronic controls (cycle/option select) will not respond at all.


This is not a uncommon problem and it sometime's is the pc control panel but i find that it is more often the interlock ( latch assembly .) i would change // there has been a improvment and i belive this will solv ... Dishwashers

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

Bosch exxcel Last night when i turned on my dishwasher it tripped the fuses in the house. I have changed the fuse in the plug, but it continues to do it. The lights on the display flash up once and then the fuse box trips again. Not sure what else to check. Can any one give any suggestions?


The likely cause of this is a failed heater element which would cause the fuse to blow. You will need to get the heater element checked out and replaced if necessary. A visual inspection of the element may reveal the problem jf not an electrical test ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Hotpoint FDL570, one month old, making a grinding/humming noise that cycles every few seconds on wash cycle. All the lights flashed on and off last night, instruction book said to turn off and on again but still making noise, any ideas before I call the retailer ? Thx


... Hotpoint Dishwashers

I set my dishwasher to wash last night (delay 2 hrs.) and I checked it this morning and it never washed. Yesterday, I had to turn off the dishwasher at the breaker box because it wouldn't reset. Now, the normal wash and heated dry lights are on, but it won't start. Also, it usually beeps when I close the dishwasher door, and now it won't even do that. We bought the dishwasher about a week ago. It a GE Profile dishwasher. Thanks, Chris


\015\012\015\012\015\012First off all try to close the door tightly with your hand till you hear a beep.dont force very much.\015\012as you mentioned that unit normally gives a beep when door is closed.but not it is not giving that beep w ... GE Dishwashers

Amana Dishwasher Model #ADB1500AWB3 (Purchased 7/2009) worked fine on Friday, and last night would not turn on, no green lights at all. We check circuit breaker, and electrical outlet but they were working fine. Do you know what might be wrong?


... Dishwashers

Won't start The last time I used the dishwasher (built in), it smelled of burning. I turned it off and now although the lights on the control panel come on, the dishwasher itself won't run.


... Zanussi 23 in. ZDI6041 Built-in Dishwasher

My dishwasher wont run when i push the start / cancel button the washing light comes on and blinks ,but the dishwasher does not turn on . i put in a new control panel and it still does the same thing.


Check the water level switch/ pressure switch.Control panel may not have full control. There may be yet another board inside! ... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0976 seconds