Having problems with your GE Dishwashers ?

Ge dishwasher diverter valve leak - GE Dishwashers


Answers :

Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ge dishwasher diverter valve leak - GE Dishwashers


... GE Dishwashers

It appears that the Inlet Valve is leaking on my Kenmore dishwasher. By replacing the inlet valve do I also need to undo the connection at the bottom with the teflon tape - or can I just undo the screws at the bottom of the plate and leave that connection alone? The dishwasher is 4 years old, could something be causing the valve leaking other than the valve being bad? Thanks! :))


Probably just hard water causing the solenoid to stay slightly open. \015\012Shut off water \015\012Remove 1/4 hose\015\012Remove wire harness/plug\015\012Remove other side hose should be a clamp.\015\012Unscrew mounting bracket and replace in the sa ... Dishwashers

This a message for phil. The aquastop valve was not under the dishwasher. On my model, it was fitted directly onto the water inlet pipe. I replaced the valve as you suggested. After removing the old valve you could see through the clear plastic housing that water was leaking inside the valve. Anyway replaced valve but had to split wires and reconnect with connections supplied with the valve and according to instructions. Water leak has now stopped but when 'on' button is depresse


Please provide dishwasher make and model. Looks like you are retrofitting the valve to your dishwasher which may not be getting the correct supply voltage from the dishwasher control. Will need to understand part no. of the replacement valve you ha ... Dishwashers

Have a Kenmore Elite Dishwasher (66513123K701). Was not cleaning dishes very well so we ran diagnostics on it and found a problem with the diverter motor (W10155344) so we replaced it. Now, the dishwasher is leaking from the diverter. There was a o-ring from the original diverter that we had to keep since the new motor did not come with it. Wondering if we should get a new o-ring/seal, but I cannot find mention of such a part anywhere. Is there a certain way to seat the o-ring? Is it ok to


I have experienced the same diverter motor leaking problems. I have the whirlpool gold with the diverter motor (w10155344). I bought the unit new 4 years ago. The fix is remove the the two screws that hold the diverter motor and pull the motor. ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?


You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

No Power I have a bosch shx33 dishwasher. I just replaced the water valve because of a leak and now I can't start the dishwasher. It's like there is no power to the unit. I know there is power because I get a shock if I touch the two wires that are connected to the water valve. Is there another trip switch or something somewhere?


First let me say that using parts of your body to test for mains electriciy is a VERY VERY bad idea. You are lucky you are not dead. Please do not touch live parts again, get a multimeter or a mains tester.\015\012\015\012If there is mains across the ... Bosch 24 in. SHX33A02 / SHX33A06 Free-standing Dishwasher

We are having a small leak near the front valve or hose connection in our Kenmore dishwashers. This tends to happen when we are out of town and have turned the household water off. The dishwashers also has water in the bottom when we return. We have tried to set up the situation to make it leak in order to find it, but have not been successful. Have there been similar complants?


... Kenmore 16762 Dishwasher

We have a bosch dishwasher model shx43c and water is dripping on the floor from the area of the supply line, taking the supply line fitting out and re taping it and re tightening it has not helped, could the valve be leaking back this way, instead of the more common leaking into the dishwasher itself?


If the supply line is leaking it could be a 3/8 supply line maybe the rubber washer built in the line is shot try replacing the supply line.they are about 15.00 at home depot.do not over tighten the new line you could damage it.some times people cros ... Bosch SHU9925UC Built-in Dishwasher

I have a Maytag mod # mdb7601aws and it seems to be leaking from the fill reservoir on the outside of the dishwasher tub where the hose from the valve goes into the dishwasher. as it fills the water and steam escape from the top of this resevoir and leak down on to the floor. Can you you suggest any fixes for this, is there supposed to be some kind of a lid for this?


... Maytag 24 in. MDB7601AWS Stainless Steel Built-in Dishwasher

The dishwasher is leaking from the inside front left corner. it ahs two small covers over this valve. underneath it has two electrical wires. when you turn it on, it leaks from that valve to the floor.


HI. this is a inlet assembly issue. The water inlet valve can be identified by the water hoses connected to it. One hose will lead from the valve to the pump/motor assembly in the center of the dishwasher. Check that the hoses are securely connected ... Dishwashers

I have a SMEG DWF614 SS dishwasher. I continue to get an E8 error message. The diverter valve motor turns freely & the motor turns freely when they are seperated. However, when they are assembled, the motor turns the valve & continues to try turning the valve when the valve is on its stop position. Is the motor & valve faulty or is it the control. If you can answer, what part number would I require. Regards Leighton Davies


... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

Water leaks from underneath the unit. Water only leaks when the pump cuts on (pressurizes). It leaks down on to the hose connecting to the water inlet valve on the right hand side of the unit when looking at the door of the unit. When the unit is full of water and the motor / pump is not running the unit does not leak. This unit is a Maytag jetclean dishwasher Model DWU9200BAB about 12 years old


Please change the 'o'rings of drain line and the inlet and also check the drain hose and the inlet if there are any holes in it ... Dishwashers

Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst


... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher

Bosch dishwasher shx45m leaking at the water inlet valve


... Bosch Dishwashers

Diverter valve leaks


I have experienced the same diverter motor leaking problems. I have the whirlpool gold with the diverter motor (w10155344). I bought the unit new 4 years ago. The fix is remove the the two screws that hold the diverter motor and pull the motor. ... Whirlpool Dishwashers

Kitchenaid KUDP01FLBL3 dishwasher water fill valve leaks


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

With the assistance of someone from this forum, I can see that my dishwasher is slowly leaking water from the opening on the left side of the dishwasher area. There appears to be a problem with the dishwasher fill valve, and I'd like to know if it is something that I can replace/fix on my own. Thanks, Nick


Yes it should be possible to replace the fill valve but I will need the make and model number of your dishwasher to provide you further suggestions. ... Dishwashers

Smeg DWF612WH dishwasher has developed a leak. Water comes out of the rectangular hole on the side of the water softner used to mount what looks like a level or pressure switch. A few seconds after the fill valve opens water leaks out, not a lot just a small trickle. After the washer has filled and goes ito its cycle, it does not leak again. Over the past weeks the problem has got progressively worse.


... Smeg 24 in. DWF612WH Free-standing Dishwasher

Dishwasher is leaking , maybe at the valve


HI. this is a inlet assembly issue. The water inlet valve can be identified by the water hoses connected to it. One hose will lead from the valve to the pump/motor assembly in the center of the dishwasher. Check that the hoses are securely connected ... Estate 24 in. TUD4700KQ / TUD4700KB Built-in Dishwasher

Air gap valve leak for dishwasher


Remove the entire drain hose from the air gap and be sure it is clear, also the dishwasher drain should be going to your disposal, if you chose to use the air gap it should be connected from d/w to air gap then to disposal, todays dishwashers dont ne ... Dishwashers

Dishwasher inlet valve leaking. Can they be


Yes it can be fixed but usually you can find the part at first source for a lil cheaper. ... Whirlpool 24 in. ADG7952 Built-in Dishwasher

Hello, my Bosch Classixx dishwasher SGS43E42EU/21 has me stumped. It starts by taking in water but when "filled" pumps out for a couple of seconds then refills for say 10 seconds more before another 2 or 3 seconds of pumping out. This cycle continues for ages without starting to wash. I've tried various things: - checked the Auto Stop valve isn't being activated by leakage (removing the polystyrene float and bottom tray makes no difference - there's no leak) - the valve seems to operate it


Hello Dave,\015\012\015\012Sounds like an overfill problem - the symptoms are consistent with a failed pressure switch. Water enters the dishwasher through a chamber which has a float arm connected to a small microswitch -this is the pres ... Bosch Dishwashers

Water flow I have had my dishwasher off for over a year because of a leaking shutoff valve(nobody wanted to fix it) .My son finally fixed it, and i ran a clean cycle before washing actual dishes. Everythign worked fine until I realized it was leaking all over the floor. I looked in and the water was not stopping coming in after it finished.


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012chkq356 ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Water is leaking out of my 7 year old Kenmore built-in dishwasher at bottom right by what I think is the solenoid valve (2 wires going into white plastic fixture then into dishwasher)...how do I fix this?


Hi,\012That is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy ... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

I just bought a Whirlpool quiet partner II and it's leaking. It appears to be coming from a dome shaped thing at the front of the basin. It only leaks when the dishwasher stops and there is water in the basin. It appears to be a valve of some sort but i can't tell. Nothing in the manual even mentions what this thing is. Any ideas?


I think what your looking at is the fill switch float there should be a switch located under it on the bottom of the tub it might have came loses or not hitting it properly ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1435 seconds