Having problems with your GE Dishwashers ?

Purchased ge dishwasher model ghda674n00bg and discovered after installation that I removed the rubber check valve from the discharge line in error. Is it mandatory that this check valve be installed? Naturally I would prefer not to remove and reinstall unit. Thanks for your help Regards, John


Answers :

Repair Help & Product Troubleshooting for GE Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Purchased ge dishwasher model ghda674n00bg and discovered after installation that I removed the rubber check valve from the discharge line in error. Is it mandatory that this check valve be installed? Naturally I would prefer not to remove and reinstall unit. Thanks for your help Regards, John


... GE Dishwashers

I bought this dishwasher 5 years ago and was kept in the box until last month. I installed it, turned on the water and no water is being pumped into the unit from the water release valve in the dishwasher. I then checked all the cycles and everything works except for the pump. Then I checked to see if any power/volts was going to the pump and there is none. Could it be a wiring problem or could it be the circuit board?? please help. thanks


You will have to check all the connections visually. Since you know how to use a meter, see where the current stops. See if there is current coming from the control board to the pump. the water inlet solenoid valve should "free flow" water into the m ... GE 24 in. Profile PDW7800 Built-in Dishwasher

My dishwasher's buttons will not work at all. Nothing is lighting up. I have already checked the breaker (not tripped, but I turned it off and then on again just to rule that out)... I assume that it is some control panel (the manufacturer said that it is a covered part... but I will have to pay the tech to come and install). Just trying to determine if it would be something that I can do myself and save some $. the unit is only 3.5 years old...


... KitchenAid Architect? II U SERIES KUDS03ST Stainless Steel Built-in Dishwasher

Unit won't pump out, checked the lower impeller and it was very loose, is there a drain valve on this unit? Model 587.14249991 The upper impeller is a fixed unit right to the motor but it appears the lower impeller is a push fit over a rubber sleeve. I only saewa check valve in the drain hose, is there any thing else I should check? hose is clear and the switch for the float is working ok.


At the bottom of the unit where the hose goes is a check valve. check to see if clogged. ... Dishwashers

I have a General Electric Potscrubber dishwasher. When the cycle is finished, the water does not drain into the sink.I turned the unit upside down to look into the bottom. The motor turns freely. The instruction sheet I found in the bottom of the unit said to remove the filter screen and check the piston valve. I looked at what I thought was the piston valve, but I'm not sure how to check it. The line to the sink seems to be clear. The model of my unit is GSC3230Z03WW. The serial number is AZ627


... GE Dishwashers

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

Hi! We just installed our LG LDF8812WW built in dishwasher. We ran our first cycle and after the wash cycle the dishwasher displayed error code OE. I read that it meant there is a problem with the drainage, and to check the hose if it is kinked. Well, the hose is not kinked and we have no idea why it would have a problem with the draining. We have the hose set up per the installation instructions. How can we check to for something clogged? Any suggestions?


I actually own an LG LDF8812 myself, except mine is stainless steel, not white. So be it. :-)\015\012\015\012Anyway, it sounds like you have just unboxed the unit and it is brand new, not just new to you. I am also ... LG LDF8812 Stainless Steel Built-in Dishwasher

Just installed an estate TUD6710S and on the first run it is leaking from the check valve. It is leaking from the pump side of the valve. There isn't any leak where I have the drain connected. I do not have a garbage disposal, so, there's not a problem there. The drain connection is 20" from the sub-floor... don't know what else to check.


... Estate TUD6710 Built-in Dishwasher

Water not entering unit. Have checked water valve


Hi,Here is a tip that I wrote about that problem...http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_enterin ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Model JPX-300H, the unit does not fill, but it will drain if you fill with water from a bucket. Also when the unit drains there is water coming from under the unit. How do I check the fill valve for proper operation. Thanks


The fill valve is easy just take the coil off and there is a hole in it put a metel screwdriver in the hole and turn the unit on if it pulls the screwdriver like a mganet it works is more likely i bad diaphram now as for the draining it drains bu ... Jackson 24 in. JPX-300H Built-in Dishwasher

Unit would not drain, found soapy water in unit. Checked for obstructions...None found...start cycle then hit cancel/Drain and nada...no noise, no drain...nothing...Entered the diagnostic mode on the unit and reads E1 which describes a heat problem?????Pretty proficient at fixing things, need a little guidance...Please help...


Hello,\015\012\015\012Welcome to Fixya.\015\012\015\012\015\012I can provide you with a complete service manual in a "pdf" attachment, but I`d requre a email address.\015\012\015\012I know what the problem is ... Bosch 24 in. SHE44C05UC Stainless Steel Built-in Dishwasher

Hi, I'm working on a KUDI02FRSS0 for my neighbor. She complained the door flew open one day during a wash and the door had been very heavy since. A quick check on the internet, and I thought it would be simple... I installed an 8194001 balance kit. Both cords had broken. However, the door was very hard to close, and once you did close it, it would tend to pop open by itself shortly thereafter. When the door popped open, thanks to the new balance kit, it would not fly open as it had p


Is it possible that the door hinges or springs are installed backwards or upside down? Just a guess. Good Luck to you. ... Dishwashers

FDB750RCC1 When I start the DW, the motor hums loud then soft then loud then soft...if I advance the dial some sections of the cycle nothing will be running and others the motor is on, but no water is getting into the unit. I just replaced the inlet valve and solenoid and that didn't change anything. I can see water in the recirculating pipe running up the unit, but it will just try to make it up and fall back down. Not sure how to proceed...my thoughts would lead me to the main motor, but


Can you hear the water solenoid click when it calls for water? If so, check that the water source valve is on and water comes out of the valve. Check the entry hose for kinks. Remove everything under the lower arm down to the deck keeping track ... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

Hello, My GE dishwasher stopped draining. Model Number: VSD2304JOOWW I emptied out the dishwasher of the liquid, removed the cover and checked the filter. (Didn't look bad.) Checked the drain pipe under the sink and there was a little debris (slime) but very minimal. The garbage disposal was installed at the same time as the dishwasher 3 years ago (brand new place). What else could it be? Any advice would be helpful as my new home seems to be falling apart and it is getting pretty e


Drain pump either disconnected or jambed ... GE Profile PDW8400J Built-in Dishwasher

Our GE built in dishwasher Model GHD6310L18WW had no lights on and would not operate. i checked the breaker panel and found it was OK and 120vac were flowing to the unit. i then turned the braker off for 30 seconds then back on .this made the time remainig LED display sow 106 and the Normal wash Cycle LED is lit as well as the extra Heat LED . the unit will bot operate though


... GE Dishwashers

Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst


... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher

Water supply to my Bosch SHE43CO5UC/17 dishwasher seems interrupted and not being supplied to the unit. Water supply to the unit is checked and confirmed available. What are the possible causes, i.e. stuck solenoid valve?


Could be a dirty hose filter or faulty inlet valve. Ther could be a leak and the bottom of the unit has flooded activating the flood safety which will cut the water supply. The pressure chamber and/or the hose pressure chamber to sumo could be bloc ... Bosch Dishwashers

I recently replaced the water seals, V-packing & all six check valves in a CW-3504-4MGH pump on a MiTM 3504 pressure washer that had very low pressure. Usually this would fix most pressure problems on most machines, but in this case it had little to no effect. I suspect that the unloaded is the culprit in this case, but since I have had little experience in repairing unloaders (let alone adjusting them). I would appreciate feedback from anyone that has experience in this area. Thanks


Check the wand tip for a tiny piece of debris like a tiny rock or something stuck in the tip. ... Mi T M Pressure Washers

We have a bosch she4am dishwasher and just recently the unit doesn't rinse all the soap out of the glasses of the top rack and also a film is being left on the dishes. i have checked the top spinner and it works fine, cleaned out the drain, only use recommended soap tablets and use jet dry. we recently put in new counter tops but i didn't move the unit itseld only the drain- would this have any effect?please help


Check the top of the cabinet after the unit has started to wash the water droplets is the key. if you see water droplets on the very top all over then the unit circulation pump is working. If that checks out then check the jet dry compartment. here ... Bosch SHE4AM06UC 24 in. Built-in Dishwasher

DS603 Fisher & Paykel U1 error code ..(see our previous errors we've listed) we have now pulled out the yellow water valve that goes up behind the front panel and at the other end by removing the drawer and plastic protector thingy - we checked that there were no bedris or calcium buildup in the valves ends and filters and replaced it all. So we put it all back to gether as we could not see what would cause this error, only to find that it worked - water came into the machine but about 4 mins in


This product is total ****.\015\012Pull it out, call whoever sold the **** to you\015\012and tell the to come get it and shove it up their ***.\015\012Then buy a Bosch and live a happy life.\015\012The design is moronic. The machine is like the old\ ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

Drain problems I have a Kenmore 665.17292992 portable dishwasher. I've changed the filter and the seals however it still does not want to drain. It will drain but extremely slowly and since it's on a timer, it only drains maybe 10% of the water out. My next step was/is going to be the Check Valve... but I am at a loss right now. I thought for sure it would be the filter. Any advice would be appreciated. Thanks, PM


This may not be the solution, but look for an air in-take somewhere on the top/back of the unit. It's probably covered by a stainless steel cover that can be taken off. Unscrew this cover and see if the air intake is blocked with lint. This is usua ... Dishwashers

'Dead' DU1100XTP The dishwasher will not start - no lights at all - no indication that anything's working (although I confirmed the unit has power). I've seen numerous posts regarding the control board - is there a problem with these in general? My unit is just beyond the warranty (naturally!) so I'd like to know if there's been any concession made by the manufacturer due to the number of problems. I'd gladly replace the board if Whirlpool would send me one. Thanks.


This may sound simple but... make sure its plugged in all the way. ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

No pressure i have a karcher g 2600 vh i wasnt getting pressure and i found that my spill valve was faulty it was actually broken i bought a new one installed it and im still not getting much better pressure ive taken the pump apart and checked for build ups blew thru the valves wirh the compressor and there appear to be no blockages


... Karcher G 2600 VH Gas Pressure Washer

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1134 seconds